Santa FE SM (2001-06) :: Stalling And Running Rough - Codes P1166 And P1167
My 03 Sante Fe is running a little rough and is stalling. My Mechanic said this P code was going to run me $1300. I'm not very mechanical , but this just seems very high. He said that aftermarket sensors would not work and only Hundai parts for the fix.........
2003 Sante Fe, LX, 3.7 l engine
Elantra XD (2001-06) :: Code P1166 After New Alternator Installed And Stalling
Code P1166 showed up after I have new alternator installed from coolant leaking onto it. I dont think that is the cause though. In the fall I found some acorns in the air box and just recently in the heater fan. In December, after the acorns were found, the car had a low idle a seized alternator and a broken belt.
No acorns are in the air box anymore, or in the heater fan. Car has more of an erratic idle and stalls now that it is parked on an incline.
Santa FE SM (2001-06) :: 2002 Shutdown When Driving - Code P0340
So my wife was driving our 2002 santa fe 2.7L and it shutdown. I went with the scanner and saw one code, P0340. I towed it home, changed the Crank Position sensor, which really sucked. I put it all back together and still no start. Same code.
View 15 RepliesSanta FE SM (2001-06) :: CEL Came On - P0741 Code
CEL came on today and when I ran the codes I got P0741. Torque converter CKT Performance or Stuck Off. What the next steps are.
View 1 RepliesSanta FE SM (2001-06) :: P0031 Code Came On
About 2 months ago, the check engine light came on and I had the code read, it came out as P0031, which is the 02 Sensor. Today, I had this 02 Sensor replaced and had the code reset, but later on today the check engine light came on again. The mechanic said I needed to drive it for about 100+ miles before the car resets itself. I drove it for about 30 miles before it did come back on.
View 8 RepliesSanta FE SM (2001-06) :: What Causes Code P0421 To Come On
What this code may mean and what type of expense will I be looking at? Is it something I could fix or does a dealer need to perform this repair?
View 4 RepliesSanta FE SM (2001-06) :: Gas Smell After Fill-up Now Has CEL Code
Well, finally! After wanting a code to troubleshoot this low gas mileage and fuel smell (outside the car, usually, but sometimes inside the car also) for 3 months, I FINALLY got a trouble code.
Bad news is: it's P0457.
2001 2.7L. Where would you check first? I've already replaced the cap and pump (the old cap was fine). Pulled the EVAP can off today, no holes or anything that I saw to cause a leak. Where is this "two-way valve" located? Think it might be the place to look?
Santa FE SM (2001-06) :: CEL Code P0430 Popped Up
I have a 2005 Santa Fe with the 2.7l engine....during the last two summers I've had this code pop up only to disappear. Well, we're into the winter here in New York and the code popped up again and after a week its still on. What's causing this and are there any easy fixes? The wife loves the SUV, its got 120,000 miles on her, the engine is strong and the tranny was rebuilt this summer (that another story).
View 1 RepliesSanta FE SM (2001-06) :: Error Code P0446 Came On
I've checked the lines from the Purge Valve on the Passenger side of the Intake Manifold, Check OK
I've Checked that Valve OK
I've Replaced the Canister Close Valve
I've got the Gas Cap tight.
I've removed the rubber bushing holding the CCV to the Evap Canister, hoping to isolate the Filter and point the blame on it, no luck there!!
I'm thinking next is to drop the Tank and check over all the Goodies on top.... as much as I hate the thought of that, the two access holes under the seats, just don't allow access to enough of the tank!
any thing there that I could suspect, I see there's a check valve!
There's also the Fuel Tank Pressure Sensor, which may be at fault.
Santa FE SM (2001-06) :: Brief Hesitation When Driving
2003 Santa Fe GLS 3.5l with 170k.
Been working OK up until about 2 months ago when I would notice a brief hesitation every once in a great while when driving. It became hard to start - would crank well but just took about 5 seconds to finally start. Recently, I was on the highway and it jerked at about 65mph but did not cut off. Once when I was at a traffic light, it shut off completely but started right back up again. I was convinced that it was a crank or cam position sensor as I had dealt with a similar issue with another car years ago. It also seems to start right away when the temps are in the single digits - when they get higher than 25 or so, hard to start again.
I bought a new crankshaft position sensor because all the posts I've read point to that being the problem given the symptoms. I haven't installed it yet - still looking into this and wondering where it is! I'm thinking that it might be more fuel-related now though because after I started my car after work yesterday (it went all day without being started) it was hard to start but this time it was if I hadn't started it in 3 weeks. It kind of sputtered until I gave it the gas enough where it would settle out. Fuel pressure regulator? I hadn't thought it would be fuel-related (pump, pressure regulator) because 99% of the time, the car works just fine.
Santa FE SM (2001-06) :: Code P0302 Misfire In Cylinder 2
I just purchased a 2005 Santa Fe, 4WD, 2.7l..the engine has a miss...the code that came up was "misfire in #2 cylinder"..I checked the coil pack...and the wire harness just crumbled..so I replaced the coil pack...reset the code..and it was good for a couple of days...I got through inspection...today I put on the A/C..and the engine got rough..the check engine light came back on..same code..misfire in #2..I'm thinking the injector or what else could it be? plug? wire?
View 3 RepliesSanta FE SM (2001-06) :: Code P0430 - Bank 2 Cat Efficiency Low
05 santa fe/3.5L/ owned since new. Had a misfire problem and solved that by changing coils/plugs/wires...
Still getting a P0430 code (bank 2 cat efficiency low)
Following the Repair manual troubleshooting of that code says
Read H02S - got a scan tool and did that -
Comparing Bank 1 H02S1 and 2 show they are are different voltages and do not follow.
Comparing Bank 2 H02S1 and 2 show nearly identical traces.
I also checked the wiring harness around the sensors and check for air leaks...couldn't hear/see/feel any.
My conclusion based on the info obtained is that the bank 2 cat is bad and needs to be replaced.
Santa FE SM (2001-06) :: P1192 Code - Faulty TPS Sensor
My 2003 Santa Fe 3.5 is in limp mode, you can't change the gears and showing signs of faulty tps sensor, but my mechanic is telling me to change whole electronic throttle system , May be its only the sensor.
View 1 RepliesSanta FE SM (2001-06) :: Crank No Start And Code P0340
2002 Santa Fe 2.4L Automatic. Driving on the freeway when it lost power. Couldn't go over 65 even with the accelerator all the way down, even slower on uphill climbs. The engine wouldn't rev higher than around 3000rpms.
I figured it sounded like a loss of power due to weak fuel pump. I replaced it as well as the fuel filter, and verified it was pumping. Put the car together, and still the same loss of power. Drove home and parked it, but next morning it won't run at all. It cranks all day long but doesn't fire.
So far, I have made the following repairs and checks:
-Verified catalytic converter was clear and not plugged
-Verified fuel pressure
-Checked spark plugs - all are good and gaped properly
-Replaced crank position sensor (With the code, I thought this would solve it)
-Verified timing belt and cam belt in time - both have also been changed recently
-Checked all relays and fuses
-Battery and alternator are good - both are new
I still have a crank no start issue, and I'm going crazy taking things apart and putting them back together only to have this car not fire.
Santa FE SM (2001-06) :: 2003 - Error Code P1159
It seems that i'm most likely going to have to replace the entire plenum .
P1159 here are some details. [URL]..................
I've checked all connecting wires and none appear to be loose. When the issue started to occur and prior to discovering the P1159 code, I also replaced all coils. I replaced the coils because one was arching over to the metal of the engine. I assumed this may be my problem. The issue still persisted obviously. The check engine light never came on so I assumed I wouldn't get a code. I took it over to a friends house with a code reader and that's when I discovered that it was actually giving the P1159 code.
Are there any other model cars that utilize the same engine that I could use the plenum from? Getting this in working condition is going to be the difference in what I can get for it.
Santa FE SM (2001-06) :: Code P0715 / Keeps Locking Up In 3rd Gear
My brother's 2005 Santa Fe keeps locking up in 3rd gear. I've read around here that the P0715 error code that I have is for an input sensor, but I replaced that and it still doesn't work. I also tried the vehicle speed sensor as well and it didn't work.
I was with someone at AutoZone who pulled up a page here that said no I really needed to replace the transmission control module but I can't find that thread here.
Santa FE SM (2001-06) :: Code P0306 Came Up - Cylinder 6 Misfire
I have a 2004 Santa Fe with the 3.5. Today I started it and the check engine light came on. It was not on before this. (We had a lot of wind and rain from the storm but nothing major.) And seems to be running fine. I went to the auto parts store and they ran a diagnostic and the Code P0306 came up #6 cylinder misfire. They said probably Spark plug, wire or coil for #6, then went to look up code in computer and did not have my truck so they went with Kia or Domestic, which gave different possibilities for a code P0306.
They had me buy some fuel injector cleaner as injector was on the list. The light is still on so I guess the cleaner was not the magic bullet. I spoke to a lady at another auto parts store who is a wiz when it comes to cars and has been around them and fixing them a really long time. She says the Code P0306 is Spark Plug, wire, coil #6. She has a 4cyl Hyundai car not truck and she had the code for her #4 misfire in the past and she started her repair cheapest first, Plugs, wires her code was still there she then changed the coil and that did the trick for her.
I on the other hand can't do this stuff myself. Can't afford the dealer anymore or to have a shop do a tune up AND coil if I don't need all new plugs and wires just a coil as they will charge a lot to do a lot all. And it may not need it or even be any of those things. I also suspect the dealer and shops will want to still hook up their computers to do an costly diagnostic because the light is on, even though I know the parts store already came up with a code P0306 twice. Spoke to the dealer on the phone and he already basically said they would want to do that first for $100 plus the cost of repair.
I brought the truck new. It now has 91,500 miles on it and the dealer has already done two tuneups on it in that time, Plugs and wires. I hear it probably shouldn't have even needed these tuneups in this amount of millage? So the last one was probably about 2 years ago and a few thousand miles maybe a guess 10,000-20,000 miles ago. Do you think a plug and wire would be bad already in that few miles?
Santa FE SM (2001-06) :: CEL Came Up With A Code P0303 - Cylinder 3 Misfire
I got a check engine light. I went to Auto zone to get it read & they came up with a P0303 - Cylinder 3 misfire. Since I bought the vehicle a couple of months ago, I don't know when the plugs were last changed, so I decided to change them. However . . .
Is there a secret to getting the plug boots & wires out of the hole and off the plug without wrecking the wires?
Santa FE SM (2001-06) :: Code P0325 Knock Sensor
What is the possible, or most likely, cause of a Knock Sensor No 1 Circuit Malfunction reading??
View 1 Replies