Santa FE SM (2001-06) :: 2002 - Code P0715 / Car Won't Shift Properly
My brother and father just finished with all of the small issues after throwing in both a "new" engine into the vehicle and a transmission..both have around 80K miles (chassis has around 180K). There were some issues with codes after both were installed, but then everything was diagnosed and fixed, vehicles codes were gone and vehicle was able to be registered, afterall.
Anyways, now the car threw a P0715 code and has issues with shifting. It appears that the Santa Fe is stuck in a single gear (appears to be a higher gear). The car won't shift properly, especially noticed at higher speeds in a main road. Using tiptronic does not seem to make a difference. After the car sits and is taken around the neighborhood, it seems to drive fine, until it is taken out into a main road...I'm guessing once it heats up?
So, what should be looked into? A sensor? Is it maybe because this "new" used trans was swapped in and all of the trans fluid was replaced with new fluid? What could the issue be? I guesss the car's been a headache but they're trying to get it finished to avoid any further codes/issues.
02' Santa Fe 2.7 FWD
Santa FE SM (2001-06) :: Code P0715 - Input Speed Sensor Location?
My Santa Fe indicated P0715 for input speed sensor problem. I purchased both sensors and based on forum input I removed the air box and battery to access senors. Output speed sensor is easy to see and access. I am having a problem locating the input sensor. I see wires going to a sensor under both the main wiring harness and shift cable. Is that the location of the input sensor? If so how do you move the wiring harness and shift cable to allow access? If not, where is the input speed sensor located? The Santa Fe is 2001 V6 2.7L.
View 8 RepliesFord - Explorer :: Hard Jerk While Changing Into 2nd Gear - Error Code P0715
The other day, my Explorer gave a hard jerk while changing into 2 (maybe 3rd?) gear. Never happened before. I was under 20 MPH & had just stared it. (My speedometer works as do all the dials.) My Check Engine light came on & when I had the code pulled it read quote "P0715."Transmission Speed Sensor circuit condition. Vehicle speed above 15 MPH while transmission output shaft speed below 60 RPM. Possible cause Failed transmission speed sensor or electrical problem"
I got a Transmission Speed Sensor, (which I haven't put in yet), and was told that this would solve the problem. My question is twofold: Is there ANY chance this is a false or misread code and the problem is something else? And could ANOTHER sensor attached to the transmission be the cause? (How many sensors are on the tranny?) All I've read about this problem, say's replacing the Transmission Speed Sensor is preceded by the SPEEDOMETER quitting, but mine works fine.
The truck is a 1997 Explorer 4x4, but I don't use 4x4. In fact I've driven it without the forward drive shaft ever since I had the BW4405 Transfer Case replaced.
Ford - Explorer :: 2004 V6 - Code P0715 - Input / Turbine Speed Sensor Circuit
2004 Sport Trac V6. Been having hard shifting and P0715: Input/Turbine Speed Sensor Circuit. Cleared the codes and still returns.
From my searches, readings and looking at the parts diagram. On the newer 5 speeds the sensor is the one on the inside of the tranny. This requires taking the entire tranny apart? Is there an external connector for the sensor that I can check or clean first? Replace this sensor. I know the older ones were mounted on top of the tranny. I think this one is mounted on the inside though.
Santa FE SM (2001-06) :: Passenger Door Locking Is A Bit Random
Just got the girlfriend a 2002 Santa Fe and the front passenger door locking is a bit random! Sometimes it unlocks and unlocks ok from the key in the drivers door or the lock/unlock buttons, other times it half locks / unlocks (the lock button on the door panel half moves!) and other times it just ignores me all together! The cabling and cable boot from the body to the door seems in good condition (my audi A4 had that problem and you really dont wanna know about the wiring nightmare i had to fix that!!! bloody Germans!!). My feeling is that its a worn actuator.
View 2 RepliesSanta FE SM (2001-06) :: Front And Back Brakes Locking On Intermittently
Front and back brakes heating up and locking on intermittently brake pedal feels normal this has happened 3 times over the last 500 km of driving pedal not sticking down break fluid ok no swelled lines today noticed front left and rear right rotors were hotter than front right and rear left once vehicle sits they release and all is good no abs lights or any other warning lights on.
View 1 RepliesSanta FE SM (2001-06) :: Lights Do Not Flash When Locking The Car With Remote Control
Santa fe 2004 - When locking the car with RC, lights did not flash. Cause was hazard light fuse. To verify this, activate the hazard lights, if they do not work at all, check the hazard light fuse. When I replaced the fuse all issues were resolved.
View 1 RepliesSanta FE SM (2001-06) :: Steering Locking Up If It Is Raining Or Drive Through A Puddle Of Water
I have a 2004 Santa fe and if it is raining or if I drive through a puddle of water, my steering is locking up, what may be causing it? I am afraid it will cause me to wreck.
View 1 RepliesSanta FE SM (2001-06) :: Driver Door Controls For Central Locking Does Not Unlock The Doors
I have a sante fe which has problems (suspect multiple) with central locking , intermittently locking itself - very annoying - even driving down the road.
Drivers door controls for central locking unlock button does not unlock the doors - button just doesn't do anything. Lock button works fine. In addition window controls on drivers door dont work - only control that works is the one for the drivers door.
Final piece of the puzzle - the red light in the drivers door does not work either nor does the drivers door button panels light up. Starting to wonder is there a fuse or quirky power supply problem somewhere.
Santa FE SM (2001-06) :: Stuck In 2nd Gear
Its not my car but my sister in laws. She stopped by our house tonight to pick up her kids and when she put the car in drive it showed both drive and 2nd gear. we tried disconnecting the battery so she could at least get it home (3 min away) but it didn't change anything.
She left with it still in 2nd thinking she could make the short drive without any problems but half way home it shifted down to first and it wasn't even driveable. Everything i have read on the web (which was not really specific to the santa fe) was say that its stuck in safe mode. What could have cause the problem? So far no check engine light has come on.
Santa FE SM (2001-06) :: Vibration When Goes Into Gear In Rev
ok, I had quite bit of work done, prob over yr ago All oem parts, timing belt, crank sensor, idler pulley, some other things while in that area. So when he was done I got this vibration when it goes into gear never in park only in rev. or drive but only in cold weather and after it warmed up it was go away. No Trans service was done. He kept it overnight outside, had the timing cover off rolled it in the garage, started it and seen that the belt was flapping crazy. So he thought it was that. well every cold morning I have to wait till it is warm to not hear that sound. it only happens during cold mornings never in summer. He had back in his shop 3 times after parts were installed. and its to this day isn't the same. its unfortunate that I didn't have many cold mornings when he had worked on it. but after I had it and the next cold morning it was there.
View 7 RepliesSanta FE SM (2001-06) :: Stuck In First Gear
2003 Santa Fe 41,000 stuck in first gear.
View 1 RepliesSanta FE SM (2001-06) :: 2003 Won't Start In Gear
Two times in the last month my 2003 Sante Fe would not start - the radio, air conditioning will come on but nothing from the engine - not even a click - no check engine light. Had it towed both times - as soon as it was towed it would start up. It seems to happen in 2 week intervals. Now I realize bc they had it in neutral to get on the truck that is what required to start. It hasn't happened in a week but I know it will again.
View 3 RepliesSanta FE SM (2001-06) :: P1528 Error - Gear Box Don't Go Up 3rd
I have Santa Fe 2002 v6 2.7 and it's have been in the mechanic for 2 months now.
Suddenly my gear box don't go up 3rd, the error that the diagnostic reader is P 1528. What it can be? How to Fix it?
Santa FE SM (2001-06) :: Drive Stays In 1st Gear
2003 Santa Fe, 2.7L V6
When placed into Drive, the transaxle (and indicator lights) behave as though the gear selector was in the manual gate and at 1st gear. It seems that no matter what I do (wiggle the selector, disconnect the battery, etc) will bring it out of 1st gear while in D. This issue first occurred about a month ago and it somehow corrected itself. I had hoped that it was a fluke, but it is happening again. Initially, I suspected that it might be a switch or something within the gear selector lever housing in the console, but I've done a bit of searching the webs and it looks like it may be more of a sensor(s) issue.
Santa FE SM (2001-06) :: 2nd Gear Normal At 110kmh (70 Mph)?
I've been having ongoing issue with lack of power uphill in my 2005 2.7L Auto and noticed during recent freeway driving that when its in cruise mode the car will shift down through 3rd then into 2nd to maintain cruising speed on a steep-ish slope.
That was with adult driver me and two kids in the car so no extreme load involved.
Does car needs to be in such a low gear at 110kmh/70 mph to cope with a slope?
Santa FE SM (2001-06) :: Hard Shift From 3rd To 2nd Gear
My Santa Fe 2001 model V6 4X4 Automatic shift gears down hard from 3rd in to 2nd. I checked transmission oil and its light brown. Should I drain and refill or not worth it.
View 7 RepliesSanta FE SM (2001-06) :: Shifter Pops Out Of 5th Gear
The shifter will not usually stay in 5th gear for very long. The clutch and flywheel were replaced a few weeks ago just before i purchased the car but this problem has only cropped up in the last week. Could it be shifter linkage adjustment?
View 3 RepliesSanta FE SM (2001-06) :: Jerk, Almost Like Sputter When Going Into Second Gear
I have a 2004 3.5L Santa Fe with about 170k miles on it.
Runs great. I am going to change the timing belt here in the next week or so.
I have started having an issue where going into second gear it will jerk, almost like sputter. Does not do it all the time. Seems like a sensor or computer issue because the rest of the gears shift smooth. And if was a problem with the internals of the transmission I would think it would always do it and never go away.
What the issue could be since I am already going to be digging deep into the vehicle might be worth replacing more parts, what it is.