Santa FE SM (2001-06) :: Crankshaft Position Sensor Replacement
After heavy rain yesterday my 2005 2.7 Santa fe wouldn't start today. Had it towed to nearby dealer. The crankshaft position sensor needs to be replaced. He claims its melted to the block and oil pan needs to be dropped to remove it.
View 5 RepliesSanta FE SM (2001-06) :: Balance Shaft Oil Seal Replacement?
I have a 2001 4 cylinder Santa Fe. And atm I'm trying to replace the balance shaft oil seal but am having major problems getting it out.
View 2 RepliesSanta FE SM (2001-06) :: AC Compressor Replacement - Shaft Seal Is Leaking
After 9 solid years of service, my a/c compressor finally failed. According to the shop, its leaking at the center seam of the compressor. If the system is charged, then the compressor will operate until the low pressure switch shuts it down. My question is this: Can this compressor be rebuilt? If so, where can I get the parts (I'm assuming the shaft seal is leaking).
Also, a quick search on eBay provides several compressors that fit my car; however, some of them are listed as HS-17 compressors and others are HS-18. My car (according to the A/C sticker on the hood) says I have an HS-18 compressor. Are these two interchangeable? I'm asking because if the current compressor can't be rebuilt, then I will have to buy either a reman. or new unit.
Car: 2002 Hyundai Santa Fe, GLS, 2.7L V6
Elantra XD (2001-06) :: 2004 - Crankshaft Seal Keeps Coming Out
2004 Hyundai Elantra. Working on crankshaft seal keeps coming out !
View 27 RepliesSanta FE SM (2001-06) :: Crankshaft Position Sensor Broken In Block
2002 My friend's 2.7L sante fe crankshaft position sensor went bad and I went to replace it. Removed bolt, it was stuck fast, tried to pry out and it broke off leaving the last 1/2 inch stuck in block. Tried drilling a hole in it and using a screw to get it out but no luck. Afraid to keep drilling that I might damage something behind it. How to get it out?
View 9 RepliesSanta FE SM (2001-06) :: CEL Codes For Crankshaft Position Sensor - Random Misfires
I am having a problem with my 2003 Santa Fe I have taken it to have the check engine light codes read and I have a code for the crankshaft position sensor, random misfires, something with gear 2 and 3 (not sure what it was exactly) it makes a loud noise when in 1st and 2nd gear when I shift out of 2nd the noise gets less and less until its gone and then does not come back until the car sits for a little while and cools down. Its running rough and does not have any power when accelerating. I had the timing belt changed a few weeks ago and it started running funny shortly after. I don't think the guy that did the timing belt knew what he was doing because I had to have someone go behind him and tighten the pulley.
View 3 RepliesToyota - Corolla :: Front Crankshaft Oil Seal Leaking
I've got to replace a leaking front crankshaft oil seal. Haynes shows using a steering wheel puller with the two bolts installed, but without the center screw. Insert a socket and extension through the center screw hole. Hold the body of the puller with an adjustable to keep the crank pulley from turning while you loosen the pulley bolt. I've got an air impact. Would that hammer the pulley bolt loose without having to hold the pulley? I've also got a chain vise-grip, but I'm not sure yet if it would clear the other pulleys. Assuming I get this far, should I pry out the seal with a flat screwdriver wrapped in tape? Would it work to cut the rubber out of the seal first?
View 3 RepliesFord - Fusion :: 2006 - Leak In Crankshaft Seal
I have a 2006 Ford Fusion SE (2.3L 4-cyl.) 5-speed Manual, with 280,000 miles on it. It's been a great car with very little repairs, etc. I've noticed a little oil on the driveway - nothing big, but certainly consistent. At my last oil change, they told me I had a leak in the crankshaft seal and that I should take it to an engine shop. I'm not a 'do it yourself' kind of person when it comes to big repairs. I'd love to keep the car going another year... If I don't fix it, should I avoid oil changes? The leak doesn't seem bad and it doesn't drive any different.
View 4 RepliesSanta FE SM (2001-06) :: 2004 2.4L Engine Running Rough And Shakes After Timing Belt Replacement
I recently replaced timing belt and balance belt on my 2004 santa fe 2.4l and now the engine runs like crap and shakes badly. I went over all timing marks again and again and I am at a loss.
View 9 RepliesSanta FE SM (2001-06) :: Auto Transmission Seal Keeps Blowing
I have a 2002 santa fe v6 all AWD. It has already had a used trans installed about 3 years ago. Just the other day the front main seal in the trans starts pouring. I took it to a transmission guy it cost me about 600 to have one put in it, he said that was the the problem he got it fixed he drove it and it was all good. Get in it driving it home and everything goes fine. Then after about 5 or 6 miles the trans goes crazy, so I am wondering whats up. I get out and look and its out of fluid because the seal done blew back out. I call him he said he fixed it not his problem it worked when it left his shop.S o my question is what would make the seal need replaced again 5 miles down the road is it a torque converter problem, or something in the trans bad, or did the guy just not do it right. He told me to bring it back and he would look at it but I've done spent all i had on it for him to fix it.
View 2 RepliesSanta FE SM (2001-06) :: Transmission Oil Leak On Driveshaft Seal?
I had the abs come on on dry pavement.. I changed the front ring gears,, Bought 2 new axles with ring gears all new on there.. fixed the issue.. Now i have a oil leak--transmission oil at the driver's side axle.. Is that the seal there in the trans that should be replaced? difficult? Why leak now if it wasn't leaking before..
View 5 RepliesSanta Fe (CM - 2007-12) :: 2011 3.5L Engine Oil Leaking From Rear Main Seal
Newly acquired 2011 Santa Fe GL. Recently had a 2008 Azera GLS.
We received the Santa Fe a week ago and have since put 600 km on her. I took her into my work (auto mechanic) to wash and wax, looked underneath the engine and noticed 2 drops of what appeared to be engine oil. Between the transmission and engine block there are 2 10mm vertical bolts. The drops of oil have accumulated on the head of the bolts. There is a small "plate" between trans and engine with oil "weepage". My guess is the engine rear main seal is leaking! Not a small repair and certainly at 600 km.
Aurora :: Crankshaft Position Sensors Replacement
Replacing the crankshaft position sensors on the 95-99 aurora? very difficult?
View 14 RepliesCaravan/Voyager :: 2002 - Crankshaft Position Sensor Replacement
I need to replace the crankshaft position sensor. On my 2002 Grand Caravan Sport 3.3liter. Where it is in laymans terms.
Is it better to approach from the underside Or from the hood side? I will know it when I see it but I haven't seen it yet!!
Santa FE SM (2001-06) :: No Crank After Battery Replacement
I remove the battery of my Santa Fe 2005, cleaned cable, added grease, placed a brand new battery, reconnected the cables. But, when I tried to start nothing happens. The Radio, lamps, etc.. are working, so the car is powered, but no cranking, nothing.... I tried to reset ECU by disconnecting the battery cables for a while to empty the condensator. But it does not work. I also tried to connect the batteries NEG and POS poles together to reset the ECU but no success... I need my car to work....
View 3 RepliesSanta FE SM (2001-06) :: Blower Switch Replacement
How to remove center panel in order to replace faulty blower switch?
View 1 RepliesSanta FE SM (2001-06) :: Idles Rough After Battery Replacement
I replaced a dead battery in my '05 3.5 v6 Santa Fe. Other than the dead battery the car was running fine. After replacing battery, at idle, the RPMs drop below 500 and then go back up to over 1000 and then drops back down to 500-600. It has almost stalled a few times. At the low RPMs it diesels a little. When the RPMs spike the car surges and if I wasn't heavy on the brake, I'm sure I would have rear-ended the car in front of me. No check engine, no codes. Is this normal? I replaced the battery about 4 years ago and don't recall this behavior. If not normal, what is going on and where do I look? Its my wife's car and don't feel safe letting her drive it until this gets resolved.
View 16 RepliesSanta FE SM (2001-06) :: Valve Cover Gasket Replacement
How difficult is it to replace the valve cover gasket on a 2001 Santa Fe with a 2.7? Can I just do the 'front' valve cover? Are there any tutorials with plenty of pictures while doing this?
View 4 RepliesSanta FE SM (2001-06) :: AC / Heater Blower Motor Replacement
How hard is it to change the A/C/Heater blower motor. I know about the switch problems but this is the blower motor. I'll probably clean it out and spray something in it before I replace it but I just wondered how hard it is to get to. On another note, this 4 wheel drive Santa Fe rocks in the snow! I can't believe what good traction it has!
View 3 Replies