Santa FE SM (2001-06) :: 2004 4WD Idles Rough / Brake Pedal Not Working
I have a 2004 Santa Fe 3.5L 4WD. It's been running rough on occasion for quite a while now, but it's only been an occasional thing. I replaced the front passenger side axle and went for a test drive and the vehicle was barely running. I put the throttle to the floor and it does nothing more than idle. I barely made it home and am afraid to pull it out of the drive. I started it up this morning and it seemed to be idling just fine. I pushed the brake to put it in gear and it started stumbling. When I put it in gear, same thing, pedal not doing hardly anything.
The check engine light did come on and I had a buddy bring down a scanner to check it. I don't know if these are Hyundai specific codes or not, but here's what he pulled: P1110, P2127, P1173, and P1192. I'm thinking throttle position sensor, but am unsure. I've put a lot of time and money into this vehicle lately. I've spent some money and a lot of time trying to figure out why it was showing abs and traction control lights. Turned out to be the exciter ring on the axle was broke.
Santa FE SM (2001-06) :: No Crank After Battery Replacement
I remove the battery of my Santa Fe 2005, cleaned cable, added grease, placed a brand new battery, reconnected the cables. But, when I tried to start nothing happens. The Radio, lamps, etc.. are working, so the car is powered, but no cranking, nothing.... I tried to reset ECU by disconnecting the battery cables for a while to empty the condensator. But it does not work. I also tried to connect the batteries NEG and POS poles together to reset the ECU but no success... I need my car to work....
View 3 RepliesSanta FE SM (2001-06) :: 2004 2.4L Engine Running Rough And Shakes After Timing Belt Replacement
I recently replaced timing belt and balance belt on my 2004 santa fe 2.4l and now the engine runs like crap and shakes badly. I went over all timing marks again and again and I am at a loss.
View 9 RepliesSanta Fe (CM - 2007-12) :: 2011 - V6 Idles Rough At Red Light / Stop Sign While In Drive
I have really taken care of this 2011 SF Limited with the 3.5 V6 but it has always seemed to idle rough at a red light/stop sign while in drive. Is this common for all the 3.5 V6 engines? I run a fuel cleaner through it before every syn oil change and also use top tier gas. It drives nice but like I said, at a stop in drive it seems to run rough at around 500-550 rpm's.
View 10 RepliesCivic - Honda :: 2001 - Idles / Runs Rough At Certain Rpm?
Have a 2001 Civic DX, Manual Transmission, 228K miles. 1.7L SOHC.
Recently changed front motor mount and timing belt on the same day.
I noticed the car running rough and is only rough at certain RPM. Here are the rpm ranges it runs rough, 700rpm which is idle, 2200-2400rpm and 3400rpm approximately. It idles at 700rpm which I believe is the idle rpm on my car, so thinking my timing is not off. One more thing I noticed is if I have AC on and reving down in rpm it sounds like it is about to shutoff (never shuts off) and get a stronger vibration and same thing when I turn the AC on at idle. With ac on my rpm are 720rpm give and take a few. I been driving with above symptom for 300mi+ so far, even got it upto 95mph, don't know if it is an indication of anything. Got new spark plugs installed at 220K miles.
Could it be the motor mount or my harmonic balancer is out of balance. I did have to use 3/4" impact wrench to knock the harmonic balancer bolt loose. It is a little rusty given I got 228K miles on it.
I am just dreading the thought of my timing being off by a tooth, me and my friend checked the timing marks per oem manual, he checked the cam shaft pulley marks and I did the crankshaft. When we installed the timing belt I only turned the engine counter clockwise so I would not cause a problem with timing belt slack. My AC belt may be a little too tight as well.
The motor mount I put in was an aftermarket one that I bought from amazon. But I have put in aftermarket mount before on the same car and never had anything like this. I am planning to loosen the motor mount, shake the engine, tighten them back up and see if it makes a difference. May be the engine is not seated properly.
Santa FE SM (2001-06) :: Car Starts Up And Idles At Around 2,000 Rpms
This all started out when I wanted to change my original plugs that had 200k miles on them. I have that part done now and new wires. Then it wouldn't start without me starting it while holding the gas pedal down. Then I would have to press the pedal down or it would die.
I may need to clean the throttle body. I bought some Valvoline Throttle Body Cleaner and cleaned the throttle body it was black inside and now it's nice and clean. After that the car starts up fine except on the first try. It starts up and idles at around 2,000 rpms. When I press the brake it drops to 1,000, then back up to 2,000. The strangest part is I have no acceleration power now. I can press the pedal to the floor and it will only go to 3,000 rpms. It will slowly get faster as I drive but there's no immediate response when I press the pedal down.
Why would cleaning the throttle body do this? It throws a code when I first start it and it dies the P1110 code but I think that is because the rpms are at 600 when it catches it. No misfire codes or anything, so I think the plugs and wires are working. Just the faster than normal idle now and no power when I press the pedal down.
Would the throttle body cleaner hurt the throttle position sensor?
Golf IV / Jetta IV :: 2001 VR6 GTI - Idles On 3 Or 4 Cylinders / Runs Rough
2001 VR6 GTI....
Already done:
Replaced the coil pack and plugs
Measured resistance of plug wires (all at about 6K Ohm)
Replaced front O2 sensor
Replaced purge solenoid valve
Replaced coolant temp sensor
Replaced fuel filter
Replaced fuel pressure regulator
Replaced MAF sensor
Cleaned the throttle body
Cleaned the throttle position sensor
Ran a tank of seafoam treatment (injectors were new 6 mos ago.)
Checked running voltage of battery
It was smoking and stinking bad with a rich mixture. It improved with the MAF change but still runs like a farm tractor. Now it idles on 3 or 4 cylinders, runs rough through 3000 RPM then runs cleaner at above 3000 RPM, but only at light throttle. CEL is either on or flashing when driving.
Don't know what to do next - nice car not fun to drive like this. What this could be and how to test it?
Jeep - Cherokee :: 2001 - Engine Shut Off / Idles Rough?
After I start up and drive my jeep around town and then shut the engin off. Then I get back inside the jeep, start it up the engin idels rough. Some times the engin light comes on. I had a coil pack installed and still the same symptoms. What do you think?
View 2 RepliesOldsmobile - Alero :: 2001 - Engine Idles Rough Till It Stalls
I have an 01 olds alero, I been having problems with the engine stalling out. i was told it may need a new fuel filter so I replaced filter and now it idles rough till it stalls. What to do next? I replaced the plugs 2 years ago also.
View 1 RepliesSanta FE SM (2001-06) :: Losing Power And Hesitant - Idles At 1500 To 2000 Rpm
I have an 02 Santa Fe with the 2.7, 4x4. This started a few weeks ago. When it is first started, it cranks over for a few then starts, idles 1500-2000 rpm. It is a little hesitant at first, but will eventually run fine. If I go to the store after it is warmed up, shut it off, then go back to start it again after shopping, it does the cranking over for a few, and when it starts, you can smell gas (strong smell). when you go to take off, it hesitates real bad, backfire rumble through the exhaust, has no power, bucks, and you have to feather the throttle to keep it running. If you put your foot to the floor, it does nothing, 20 mph if your lucky. if you can keep it running long enough without it stalling, which it has done, and hit the highway, and get going, it will eventually work itself out and run ok again. There is NO CEL. It is getting worse.
View 1 RepliesPrius (2001-03) :: Red Triangle After Hybrid Battery Replacement
well I saw one other thread on this topic but no resolution. I replaced the hybrid battery like the codes told me too on my 2003 prius and it now drives great but as soon as it start it shows a problem and the red triangle stays on. No check engine light, no codes, no driving issues just a red triangle. How to diagnose a red triangle when there are no codes.
View 16 RepliesSanta FE SM (2001-06) :: Blower Switch Replacement
How to remove center panel in order to replace faulty blower switch?
View 1 RepliesSanta FE SM (2001-06) :: Valve Cover Gasket Replacement
How difficult is it to replace the valve cover gasket on a 2001 Santa Fe with a 2.7? Can I just do the 'front' valve cover? Are there any tutorials with plenty of pictures while doing this?
View 4 RepliesSanta FE SM (2001-06) :: 2.4L Engine - Crankshaft Oil Seal Replacement
Replacing the crank shaft and camshaft oil seals on a 2001 - 2006 2.4L engine?
I'm in the process of installing a timing belt kit w/water pump, pulleys and all seals. My engine has 190,000 Km with no signs of oil in the timing area, but I figure the oil seal would be worn and or cracked/dried so it would make sense to change them, plus it was included in the kit.
Santa FE SM (2001-06) :: AC / Heater Blower Motor Replacement
How hard is it to change the A/C/Heater blower motor. I know about the switch problems but this is the blower motor. I'll probably clean it out and spray something in it before I replace it but I just wondered how hard it is to get to. On another note, this 4 wheel drive Santa Fe rocks in the snow! I can't believe what good traction it has!
View 3 RepliesSanta FE SM (2001-06) :: Crankshaft Position Sensor Replacement
After heavy rain yesterday my 2005 2.7 Santa fe wouldn't start today. Had it towed to nearby dealer. The crankshaft position sensor needs to be replaced. He claims its melted to the block and oil pan needs to be dropped to remove it.
View 5 RepliesSanta FE SM (2001-06) :: Balance Shaft Oil Seal Replacement?
I have a 2001 4 cylinder Santa Fe. And atm I'm trying to replace the balance shaft oil seal but am having major problems getting it out.
View 2 RepliesPrius (2001-03) :: Hybrid Battery Replacement - Warning Triangle Shown
I replaced my hybrid battery of my NHW10 a year ago. now recently it shows the warning triangle. Once it went off after a long drive but now its permanent. is there a way to Diagnose what is the cause of this? If its a Hybrid battery issue, will it go off if i replace the bad cells?
View 3 RepliesSanta FE SM (2001-06) :: AC Compressor Replacement - Shaft Seal Is Leaking
After 9 solid years of service, my a/c compressor finally failed. According to the shop, its leaking at the center seam of the compressor. If the system is charged, then the compressor will operate until the low pressure switch shuts it down. My question is this: Can this compressor be rebuilt? If so, where can I get the parts (I'm assuming the shaft seal is leaking).
Also, a quick search on eBay provides several compressors that fit my car; however, some of them are listed as HS-17 compressors and others are HS-18. My car (according to the A/C sticker on the hood) says I have an HS-18 compressor. Are these two interchangeable? I'm asking because if the current compressor can't be rebuilt, then I will have to buy either a reman. or new unit.
Car: 2002 Hyundai Santa Fe, GLS, 2.7L V6