Santa FE SM (2001-06) :: 2.4L Engine - Crankshaft Oil Seal Replacement
Replacing the crank shaft and camshaft oil seals on a 2001 - 2006 2.4L engine?
I'm in the process of installing a timing belt kit w/water pump, pulleys and all seals. My engine has 190,000 Km with no signs of oil in the timing area, but I figure the oil seal would be worn and or cracked/dried so it would make sense to change them, plus it was included in the kit.
Elantra XD (2001-06) :: Coolant Leak Coming From The Seal Between Housing And Block
I replaced my Radiator, Upper and Lower Hoses, Thermostat and the thermostat gasket yesterday. I am leaking coolant from the thermostat though, It's coming from the seal between the housing and the block. The gasket was brand new and seemed to fit fine. I don't see any damage around where the seal is made..
Going to run and get a new gasket when the store opens.
Toyota - Corolla :: Front Crankshaft Oil Seal Leaking
I've got to replace a leaking front crankshaft oil seal. Haynes shows using a steering wheel puller with the two bolts installed, but without the center screw. Insert a socket and extension through the center screw hole. Hold the body of the puller with an adjustable to keep the crank pulley from turning while you loosen the pulley bolt. I've got an air impact. Would that hammer the pulley bolt loose without having to hold the pulley? I've also got a chain vise-grip, but I'm not sure yet if it would clear the other pulleys. Assuming I get this far, should I pry out the seal with a flat screwdriver wrapped in tape? Would it work to cut the rubber out of the seal first?
View 3 RepliesFord - Fusion :: 2006 - Leak In Crankshaft Seal
I have a 2006 Ford Fusion SE (2.3L 4-cyl.) 5-speed Manual, with 280,000 miles on it. It's been a great car with very little repairs, etc. I've noticed a little oil on the driveway - nothing big, but certainly consistent. At my last oil change, they told me I had a leak in the crankshaft seal and that I should take it to an engine shop. I'm not a 'do it yourself' kind of person when it comes to big repairs. I'd love to keep the car going another year... If I don't fix it, should I avoid oil changes? The leak doesn't seem bad and it doesn't drive any different.
View 4 RepliesElantra XD (2001-06) :: 2003 - Front Main Seal Leaking
I replaced the front mail seal on my 2003 Hyundai Elantra. It was running beautifully until I put it gear to take a test drive. It dumped half the oil in about a minute. After reading online that there may be a problem with the thrust bearings, I pulled the oil pan and found a thrust bearing in the pan. Is this something I could fix without pulling the engine. Every thing looks good and there are no metal shavings or signs of wear. The car has 170k.
View 2 RepliesElantra XD (2001-06) :: Driver Side CV Axle Seal Started Leaking
So I have a 2004 Hyundai Elantra 5 speed. The driver side cv axle seal started leaking a few months ago and I finally got around to repairing it. Everything went relatively smooth until I got to replacing the seal...
The problem is, it will NOT fit over the cv axle. It just won't. When the seal is installed, not matter how much force I put on the axle it will not go in. Also, I even pulled the seal back out and tried to put it onto the axle out of the car and there is no way it is going on. This is the third seal (done the rounds to through the big name parts stores) and no go.
Now, some quick car back story, I generally do all of my own repairs, but over the winter in the midst of a family tragedy I had a friend (professional mechanic with a shop) do a bunch of work to the car. He replaced the boot and joint that goes into the transmission (he did not replace the entire cv axle assembly for some reason). What I am beginning to think is that he replaced it with the wrong part.
Now, what I am wondering, is this even possible? Is it possible that it could fit and work perfectly yet be wrong? This also appears to be what broke the original seal. The inner portion of the seal was totally blown out in a circle, but perfectly, like it was crushed or cut out, and I am wondering if this happened due to having extreme force applied to it (possibly when he reinstalled it?)
That, or is it just extremely difficult / next to impossible to get these seals on? Even with both parts out of the car, stretching and pushing down on the seal (oiled it up as well to see if that would work) with all my might yields no results.
The leak was not there for the first month or so that I got the car back and then showed up. I have put about 5k miles on the car since I got it back. With Monday quickly approaching, I am wondering if I should just blow the crap out of my budget and pick up a new cv axle? I could at least have them pull one and let me see if the seal fits, I suppose.
Elantra XD (2001-06) :: 2005 - Driver Side Outer Window Seal Detached
Just had the driver window glass replaced. This is the second repair as the first guy just glued it and I think he partially detached the outer window seal. Is there a way to glue it back or does it need to be replaced? Is that something I could do. Now that I've seen videos, I could have replaced the window glass myself.....
View 5 RepliesElantra XD (2001-06) :: 2004 GT - Check Engine Light Keeps Coming On
I have a 2004 standard Elantra GT. I had to get an emissions test and the CEL light will not stay off. My garage replaced two valves in the fuel tank and the neck to the tank and have done numerous "smoke tests" but can't find the leak. Now they are saying there is something wrong with the computer. They got it to stay off long enough to pass the test, but the light's on again. I see that there was a recall issued because of the cracked exhaust manifold, I think I had the catalytic converter replaced up at the cottage.
View 4 RepliesToyota - Camry :: 2001 - Crankshaft Pulley Out Of Alignment
The crankshaft pulley on my 2001 Camry in no longer aligned with the other pulleys, so my alternator belt does not stay on...
View 2 RepliesSanta FE SM (2001-06) :: Crankshaft Position Sensor Replacement
After heavy rain yesterday my 2005 2.7 Santa fe wouldn't start today. Had it towed to nearby dealer. The crankshaft position sensor needs to be replaced. He claims its melted to the block and oil pan needs to be dropped to remove it.
View 5 RepliesSanta FE SM (2001-06) :: Crankshaft Position Sensor Broken In Block
2002 My friend's 2.7L sante fe crankshaft position sensor went bad and I went to replace it. Removed bolt, it was stuck fast, tried to pry out and it broke off leaving the last 1/2 inch stuck in block. Tried drilling a hole in it and using a screw to get it out but no luck. Afraid to keep drilling that I might damage something behind it. How to get it out?
View 9 RepliesElantra XD (2001-06) :: Axle Nut Coming Loose
why would my axle nut come loose? not once but twice. I had a funny road feel so I put it up and found the front right to be loose.... surprised and bewildered I pulled the cotter pin and retorqued the axle nut... Tightened right up. no more loose. Now a month later I get the same road wander and sure enough it is loose again.... I have already replaced the bearing about 15000 ago and there is no noise from the bearing. The assembly design pretty much locks the hub to the axle with no play in it at all.... Is it possible that I am pulling the axle apart through the outer knuckle?
View 3 RepliesElantra XD (2001-06) :: Noise Coming From Compressor Only When AC Is Off
My dad bought this car some time ago and it didn't have those parts (AC belt pulley, belt and High line cap, that sky-blue thing) but we didn't care, looks like the previous owner didn't use the AC system that much. Well, I had some time to put things to work, so I put the AC belt pulley, bought the belt (4PK810), found the cap and guess what, the AC works just fine!
But... there's this noise coming from the compressor ONLY when the AC is off. When I turn the AC on, that "thing" on the compressor starts to rotate and the noise disappears, and it comes back when it stops.
The compressor's clutch is at fault here? I've read a bit about it and maybe is that thing.
Or maybe the compressor just needs some maintenance after not being used for so long... What do you think?
The compressor is a HCC HS-15, like THIS ONE. The model is different, mine being CD1AA-03 and that one AKTCC-04.
Santa FE SM (2001-06) :: CEL Codes For Crankshaft Position Sensor - Random Misfires
I am having a problem with my 2003 Santa Fe I have taken it to have the check engine light codes read and I have a code for the crankshaft position sensor, random misfires, something with gear 2 and 3 (not sure what it was exactly) it makes a loud noise when in 1st and 2nd gear when I shift out of 2nd the noise gets less and less until its gone and then does not come back until the car sits for a little while and cools down. Its running rough and does not have any power when accelerating. I had the timing belt changed a few weeks ago and it started running funny shortly after. I don't think the guy that did the timing belt knew what he was doing because I had to have someone go behind him and tighten the pulley.
View 3 RepliesElantra XD (2001-06) :: Radiator Fans Coming On More Frequently?
I bought my car last May and never noticed the radiator fans running, but over the past couple of months they've been coming on (or at least running at a higher speed) pretty much every time I take it for a longer drive. They appear to come on only when I'm idling and turn off when I start moving again. The temperature gauge is steady at just below halfway. I'm certain this didn't happen previously, or if it did the fans were at a low enough speed that I didn't hear them. In my inexperience I would have thought they'd be less likely to run in the winter, and we've been having continuously cold weather (<30 C).
View 62 RepliesElantra XD (2001-06) :: Dash Lights Coming On Every Once In A While Intermittently
I have a 2002 Hyundai elantra GT. Since I've got the car last year I've had this intermittent problem with the dash lights coming on every once in a while not really a lot at all. It never bothered me before because they would come on for maybe two minutes then turn off and didn't cause any problems whatsoever.? I think because they were coming on during the day. I never realized it happening at night time. In the last month the lights came on at night time and blew out all my headlights. I replaced them three times already. I read that maybe the alternator is overcharging. I haven't checked anything yet.. I'm very mechanically inclined. Just not with electrical...
View 3 RepliesElantra XD (2001-06) :: Knock Sound Coming From The Engine?
I have an 03 Elantra and before joining this I have never paid much attention to the sound coming from the engine but now that ive seen a few videos and looked at some threads I think the engine in my Elantra knocks a bit.
Here is the video i was referring to in comparison - YouTube
It sort of sounds like this but a little less intense. Its definitely knocking but not as loud as the video. It does it all the time, not only when its cold but when its warm too... Its always sounded like that but I haven't ever paid any attention to it.
Anyways... after a whole day of reading about gas and octane and all that fun stuff I am not sure whether to try midgrade or primium gas...
Elantra XD (2001-06) :: CEL Has Been Coming On And Off - 2 Codes P2626 And P0139
My 2005 Elantra GlS Hatch's CEL light has been coming on and off. Mostly on now, because of course it is 1 month away from needing emissions checked. I am getting 2 codes------ P2626 and P0139 . The first one is the upper O2 sensor and the second was is for the lower O2 sensor.
The problem is that I replaced the upper sensor a year ago because of the same CEL code. The lower sensor was replaced in 2009 ish under warranty. Why these O2 sensors are going bad so quick?
One of my guesses is that my wife only drives the car about 6 miles round trip to work and the car never reaches proper temperature. She never drives on the hwy but lately I've been driving it to work on the hwy and she drives our new 2013 Elantra. The 2005 only has 51,000 miles.
Ford - Escape :: 2001 - Alternator Light On Intermittently - Crankshaft Slowing Down The Belt?
The alternator light on my 2001 Ford Escape 3.0L comes on intermittently. I've replace the alternator, belt, tensioner, and battery. I've check the wiring and the ground and there are no noticeable issues. When I first start up it never comes on. After about 30-40 minutes of driving it will start to come on intermittently. I've noticed that it always shuts off when taking off from a stop. I have the most trouble with it coming on while driving around the city and little trouble while cruising on the highway. I'm completely stumped. Is it possible for one of the other pulleys to be causing this if for instance some bearings were going bad and it was binding up or problems with the crankshaft slowing down the belt?
View 13 Replies