Ford F-150 (2009-2014) :: 2013 - Front Frame Bent - Replace Whole Frame?
Bought a 2013 FX4 two weeks ago to replace my 94 F150 and got to enjoy it for a whole 10 days before I got rear ended at a stop light. The car hit me doing between 30-40, fast enough to make her airbags go off, and it was hard enought to force the bed to hit the cab. Unfortunately, the damage is more than cosmetic body work. The bottom of the bed is pushed up under the bedliner and the frame is bent in front of where the leaf spring connects. My concern is that the adjuster will want to "fix" the frame and I will be stuck with a lifetime of alignment issues, suspension issues, etc. I know the rear of the frame is not as much an issue as if the front was bent, but I don't know how they could fix it without cutting it and welding in a new piece, and how can I know that the frame is true?
View 14 RepliesFord 6.0L Power Stroke Diesel :: Straighten Bent Front Frame Horn?
Any DIY way to straighten a bent front frame horn? The wreck pushed the driver's side horn about an inch towards the passenger door. The bend is right at the cross member.
Using a Porta Power hydraulic jack to push one of these? Not sure how I'd keep it from just bending the opposite, but can prolly figure that out. Just don't know if those are strong enough. I see 4ton and 10 ten models.
Otherwise, are there any other hillbilly methods for pushing or pulling?
Prius (Gen 2) :: Scangauge - DTC Code And / Or Freeze Frame Data
When I use the "scan" feature of my Scangauge II, sometimes the DTC code and/or freeze frame data will change on me. That is, I check it and it says "1 stored code" (without clearing it), then go back to "Gauge" and then check the scanning function again, sometimes the code has changed to something else! With the freeze frame data, sometimes it will even change as I'm scrolling through the different data fields. Very disconcerting....
View 3 RepliesPrius (2010-12) :: Side Window Frame Do Not Remove Any Fog From Outside
I have a 2011 Prius with less than 5000 miles on it. I keep the car outside and was wondering if this is normal. The side window scraper/guides along the bottom of the window door frames do not remove any due/fog from the outside of the car when the window is rolled up and down to clear it.
View 2 RepliesFord 6.7L Power Stroke Diesel :: 2012 F250 - Small Leak Puddle Under Front Driver Side Frame
I dropped the F250 (30k miles) off at the dealer yesterday- in the last several days I've noticed a small leak puddle under the front drivers side frame member. I asked the service writer if they had had many trucks in for the radiator leak and he said "no". He has heard the waste gate solenoid buzzing the last two times I've stopped in for routine service and had said they would fix it when I left it with them.
View 9 RepliesPrius (Gen 1) :: 2001 - Codes P3000 And P3006 Freeze Frame Data Uploaded
I would like to understand what this reports mean.
View 3 RepliesFord 6.0L Power Stroke Diesel :: 2004 - Rubbing Against The Battery Tray?
It appears mine is rubbing against the battery tray in my 04 6.0. It just flops around when I push on it. It's not bolted to anything.
View 8 RepliesFord 6.7L Power Stroke Diesel :: Rubbing / Squeak Noise While Driving
I have a weird rubbing/squeak noise from what it sounds like the rear. It occurs only after ive been driving for about an hour then it never goes away. Thought it was the pads so I put all new ones on. Maybe a bearing of some sort. I'm totally going nuts over this and cant pinpoint it!
View 14 RepliesFord 6.7L Power Stroke Diesel :: Tailgate Rubbing On Right Quarter Panel
I just identified an annoying squeak as the right side of the tailgate, right at the hinge, rubbing on the section of the rear passenger side quarter panel (one with FX4 decal) where it curls around to the rear. Any way to easily adjust the tailgate slightly to the drivers side? When the tailgate is up, the gap is noticeably smaller on the passenger side, and when down, the edge of the tailgate rubs the edge of the quarter panel, paint to paint.
View 1 RepliesCaravan/Voyager :: Windshield Wiper Arm - Blades Hang Up At The Bottom Of Return Stroke
After I changed to blade on the left wiper of my 2005 GC the blades hang up at the bottom of the return stroke. This pulls the end of the rubber from the holder on the end of the blade. Wrecks the blade and requires a new one. Happens with new blades so it must be the arm. I may have bent the arm a bit the first time I replaced the blade. Could this be the cause. Need a new arm?
View 1 RepliesFord 6.7L Power Stroke Diesel :: Turn Signal / Wiper Switch Failure
Started truck, used windshield washer and noticed High Beam Indicator was lit on dash. Headlight switch not on. Drove to Ford dealer, turned off truck, high beams would not shut off. Dealer replaced the Turn Signal/wiper/High beam switch assembly. Dealer had one in stock. Service manager said they have replaced a few of these Switches. So if your High Beams come on without the headlight switch on you cannot turn them off even if you shut off and exit truck. Also the "You left your lights on warning chime" does not sound when you exit truck.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2006 - Windshield Wiper Motor Replacement?
Looking for a video or directions as to how I replace a windshield wiper motor on a 2006 SD?
View 2 RepliesFord 6.7L Power Stroke Diesel :: F250 - Windshield Wiper Sprayer Not Working
6.7L ... Just traded in my F250 on a 2011 F350 Lariat. Love it. Period. Except that my windshield wiper sprayers will not work. I don't hear anything when I hit the button. No click or motor running. I can't figure out what fuse it is because I don't have an owners manual.
View 14 RepliesFord 6.7L Power Stroke Diesel :: 2016 - Rubbing Noise From Brakes After New Wheel?
I had a friend install 18" rims with 35x12.5 tires on my new 2016 F-250 CC SWB that had 18" stock rims. They came off my 2002 Ford 7.3. There is a "creaking" noise coming out of the brake calipers when moving forward slowly with the brakes applied. This never happened with the tires/rims on my 7.3.
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Front Tires Started Rubbing
About two weeks ago my front tires started rubbing. I've been running the same size tires as long as I've owned this truck, and the PO ran the same size too. The rub is more noticeable when turning up an incline, but I've heard/felt the run on flat ground too. What would cause this "out of the blue"? Are my springs wearing out? FYI...I replaced the shocks less than a year ago, and bought the tires in March.
View 7 RepliesFord 6.0L Power Stroke Diesel :: Rubbing Sound Can Be Heard Through The Turn On Truck
6.0L Forum - I've noticed an unusual sound on my truck. Upon driving if I make a turn more than 15 degrees a "rubbing" sound can be heard through the turn, no "knocking" is not present. Once the steering wheel is straight the sound changes to a "whir". If I turn less than 15 degrees a noticeable sound can not be heard. As the RPM's vary, the sound will also vary. If I get out of the truck and listen for this sound in the engine bay I can not hear it. The sound is only distinct within the cab. It sounds like a weak motor trying to move something or a pump running low, my guess in the dark.
I've checked the oil level - good
I've checked the transmission fluid level - good
I've checked the power steering fluid level - good
I've checked the brake fluid - good
I have read that a master cylinder could wear and create a rubbing/unusual sound. What else should I check for? The truck has 238,000 miles.
Ford 6.0L Power Stroke Diesel :: 2006 - Wiring Harness For Windshield Wiper Circuit?
Looking for an electrical schematic and or wiring diagram of the windshield wiper circuit for a 06' Super Duty?
View 5 RepliesPrius (Gen 2) :: Squeaky Windshield Wiper Arm
I finally had enough of the annoying squeak-squeak-squeak of my wiper blades every time I used them. Time for a fix!
First, I narrowed down the problem by making sure it was not the rubber wiper blade rubbing against the windshield. You can rule this out by simply lifting the wiper arms up to the locked position and turning them on. If they still squeak it’s not the rubber rubbing against the glass.
By carefully listening I narrowed down the squeak to be coming from under the large black plastic cover on the passenger side wiper. From what I have read other Gen II Prius owners have had this same problem. I discovered that you CANNOT remove that cover without removing the wiper arm assembly. But it’s not too hard.
Prius (Gen 3) :: Wiper Won't Stopped Without Powering Down The Car
It was raining where I live. (We may have a little snow later). So I turned on the rear wiper to the continuous setting.
When I got to work, and rotated the wiper stalk to turn off the rear wiper, nothing happened. So the wiper could be stopped only by powering down the car.