Ford 6.0L Power Stroke Diesel :: 2006 - Wiring Harness For Windshield Wiper Circuit?
Looking for an electrical schematic and or wiring diagram of the windshield wiper circuit for a 06' Super Duty?
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: After Wiper Motor Replacement Some Electrical System Won't Work?
I just replaced my Wiper motor last week and noticed something strange. For the last year or so when I turn on the key to start the truck, once in a while my radio, gauges, and other electricals such as windows wouldn't work for a bit, anywhere from a couple seconds to maybe as much as a couple minutes. Since my wiper motor was on the fritz, I pulled the fuse and the radio,gauges,ect. wouldn't work until the WTS light went out, then everything worked just fine, even after I started the truck and the glow plugs come back on.Since I replaced the motor everything works as soon as i turn the key. Coincidence? Or could one of the internal relays on the motor being stuck cause that?
View 5 RepliesPrius (Gen 2) :: Right Side Windshield Wiper Blade Motor Replacement
Is this easy to do? I can get the part fairly cheaply, but if I can save on the labor I would like to. I bought my prius new in 2005, and I still have it, even though I also have a tacoma. Because the Prius is my "second vehicle" now, I am trying to save on repairs.
View 2 RepliesFord 6.7L Power Stroke Diesel :: F250 - Windshield Wiper Sprayer Not Working
6.7L ... Just traded in my F250 on a 2011 F350 Lariat. Love it. Period. Except that my windshield wiper sprayers will not work. I don't hear anything when I hit the button. No click or motor running. I can't figure out what fuse it is because I don't have an owners manual.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Wipers Not Working - Only A Click In The Cowl At Wiper Motor When Turn On
I have no wipers or windshield washer. when I turn on the wipers I can hear a click in the cowl at the wiper motor. fuses are good #106 30amp fuse and #33 15 amp fuse. I have 12volts at the wiring on the motor left side with key on and 4.5 volts on the green wire with key off. I replaced the wiper motor and same thing, just clicks when I try wipers. I connected a jumper wire to the ground and no luck.
View 11 RepliesFord 6.0L Power Stroke Diesel :: 2006 - EGR Valve Replacement?
From what I understand it should be dry where the valve goes. I would call it moist not wet but fairly moist. The top groove had the most wetness, the middle groove was dry and the bottom was nearly dry. Where do I go from here - the video I watched said to scrape out and vacuum - not dry enough.
[URL]
Ford 6.0L Power Stroke Diesel :: 2006 - Power Steering Pump Replacement
When replacing the power steering pump on my 2006 should I go OEM on the pump or save some money and get a Napa or aftermarket remaned unit with the pulley installed? Also, whar is the fluid capacity of the power steering system?
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2006 - 4WD Front Hub Bearing Replacement
I am looking for the known good replacements. Almost made the 200,000 mile mark before getting a groul out of the driver side. Ball joints seem good with very little movement.
View 7 RepliesPassat (B5) :: How To Replace Windshield Wiper Motor
The windshield wipers aren't working properly. I can hear the motor trying to work, and either blade will try to work but get stuck against each other. I checked the fuses and nothing is burned out. I'm not sure if it is related to the problem but yesterday my husband was washing the car and I noticed that he had pulled the wiper blades away from the windshield so they were sticking up in the air. We filled the wiper fluid. I'm wondering if something got broken when he opened the hood without putting the blades down? They seem out of sync. He also did an oil change. Could he have done something to cause this problem while doing the oil change?
I want to open up and take a look at the motor functions, but I'm not sure where it's located and how to get to it.
Ford 6.0L Power Stroke Diesel :: 2006 F350 - Head Gasket Replacement
I'm going to be doing head gaskets on my 2006 F350 6.0. I know I need the head bolt tool and head lifting fixture. I have the tool to release the injector wiring plug from the head. Are there any other specialty tools I need? I saw in Hot Rod magazine a few months ago there was a new head gasket for the 6.0. Unfortunately I don't have the magazine anymore. I can't remember the brand of gasket. I know everyone in the past has said use OEM Ford head gaskets. Lastly, can I do the head gasket job and put studs in without pulling the cab or HVAC box?
View 7 RepliesFord 6.0L Power Stroke Diesel :: 2006 F350 - A/C Condenser Leaking - Replacement?
Is the A/C condenser pretty simple to replace on the 2006 F350? Replaced the compressor but then noticed the condenser was leaking. Looks simple just wondering if there are any quirks to it.
View 14 RepliesGen 2 Prius :: Taping The Windshield Wiper Motor For 12V Source
I'm setting up a 9v 20mA 5mm LED array for some DRLs, but I'm worrying a little too much about my power supply. I remember reading about a year ago to tap into the windshield wiper motor for a 12V source. I know I'll need to get some resistors for that.
View 1 RepliesChevrolet - Trailblazer :: Windshield Wiper Motor Start On Its Own
I've 2007 Chevrolet Trailblazer, around a month ago the front Windshield Wipers started to start on their own, when I got the car checked the technician told me that I've to replace the Windshield Wiper Motor, I wonder if this is correct? and what would make the motor to starts on its own?
View 11 RepliesMazda :: After Motor Replacement Wiper Blade Stuck?
I have replaced the wiper motor and the wiper blades stop vertical on the wind shield. Readjusting the position of the wipers does not work. The wipers wipe the hood when that is done. I have done something wrong.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: 2010 - Replacement Of Lund Visor And Windshield?
So when I bought my rig in 2010 it had a Lund visor on it, granted I may not have chosen to put on one but it is on there......
Windshield is busted and I need to have it replaced......the company that came today said they needed the Lund removed and all my gauges removed in order to do the window.......I get the gauge pod (above mirror) that isn't that big a deal, pull it down and pull the wires off the gauges.....
But I am very hesitant to disturb the Lund visor.
Have to confirm the visor indeed needs to come off? I am worried it will never be as well attached and I'm going to end up with body work being done on the roof to fix it.
Ford 7.3L Power Stroke (1999-2003) :: Transfer Case Motor Replacement
Do we need to drain the fluid to change the transfer case motor?
View 3 RepliesFord 6.7L Power Stroke Diesel :: Turn Signal / Wiper Switch Failure
Started truck, used windshield washer and noticed High Beam Indicator was lit on dash. Headlight switch not on. Drove to Ford dealer, turned off truck, high beams would not shut off. Dealer replaced the Turn Signal/wiper/High beam switch assembly. Dealer had one in stock. Service manager said they have replaced a few of these Switches. So if your High Beams come on without the headlight switch on you cannot turn them off even if you shut off and exit truck. Also the "You left your lights on warning chime" does not sound when you exit truck.
View 14 RepliesFord 6.0L Power Stroke Diesel :: Windshield Washer Loss Sprayer Power?
I have a 2004 Super Duty with a 6.0 diesel. Recently the windshield washer seems to have lost some of it's spray power. It still sprays, just not very hard. I know it's not frozen, as it started this before it got cold.
View 3 RepliesFord 6.0L Power Stroke Diesel :: Trim Around The Windshield Coming Off
The black rubber trim around the windshield is coming off on the top of the windshield. Vibrating away at an extremely annoying tone.
Been that way for a while just a small section, I'd just super glue it down and it would hold for a 1000 miles or so, then I would just do it again until it came off about 1/2 way across. At that point I just used Gaffers tape across the whole top - looks okay dark area of the truck and Dark red paint makes it so you cant notice the black tape at a glance. now that its getting hotter that's not holding but for 500 miles, which is about a week for me and gets annoying to have to stop on the fwy to fix it.
So its time to fix it right, but how?