Prius (2004-09) :: 2005 - New Battery Installed Now Car Will Not Start
My mechanic installed a new Hybrid battery in my 2005 Pruis using the repair manual and a video that showed him how to do it. He also replaced the harness and the ECU battery. When he tries to start the car all of the lights light up on the dash but no ready light on the start button and the car will not start. The instructions did not say anything about this issue so he is lost! He thinks the smart key and the ECU have to be synced in some way but doesn't know how to do it.
View 6 RepliesPrius (2004-09) :: Installed New 12v Aux Battery - Engine Won't Start
I purchased a new 12 volt battery from Toyota and installed in my 2009 Prius. My car wouldn't start. So, next I tried to jumpstart it. I pressed the Power button (the light was GREEN) but it wouldn't start. I pressed the Power button again (The light was AMBER) and the hybrid drive engaged and the CHECK ENGINE light came on; however, the engine didn't start, the dashboard didn't light up and the READY indicator did not appear.
Next, I grabbed the Owner's Manual and went through the Troubleshooting sequence. Engine still wouldn't start.
Prius C :: Possible To Have A Remote Start Installed?
I wouldn't do it myself, but I was wondering if it was even possible to have a remote start installed.
View 6 RepliesPrius (Gen 2) :: New Hybrid Battery Installed Now Car Will Not Start
My mechanic installed a new Hybrid battery in my 2005 Pruis using the repair manual and a video that showed him how to do it. He also replaced the harness and the ECU battery. When he tries to start the car all of the lights light up on the dash but no ready light on the start button and the car will not start. The instructions did not say anything about this issue so he is lost! He thinks the smart key and the ECU have to be synced in some way but doesn't know how to do it. (none of the books covered this.
View 1 RepliesPrius (2004-09) :: VSC Light Comes On After New Clockspring Installed
Just installed a new clockspring on a 2009 Prius base model because half the buttons on the steering wheel weren't working and the airbag warning light was lit up all the time. I took a guess on the airbag light being caused by the clockspring since the buttons were dead on the steering wheel and the cruise control was usually dead also. The good news...airbag warning light is off and the buttons and cruise control are all back! Bad news is...now the vsc light comes on after going less than a mile down the road.
View 5 RepliesPrius (2004-09) :: Newly Installed HID Won’t Dim / No Low Beam
Just replaced the HiD bulbs in our 2005 Prius for the first time. Unhappily, though both bulbs operate, the driver’s side bulb has no “low beam.” Could this be a defect in my installation? (Of course, I realize that I can resort to the old bulb-swapping routine, and I will do this if necessary, but given the effort required to perform that trick I thought it best to ask here first!)...
View 2 RepliesPrius (2004-09) :: Magnetic Bumper Stickers Won't Stick Anywhere
I recently got a magnetic bumper sticker. To my surprise there seems to be no place that it will stick to on the back of the Prius. I don't really want to put a real sticker on.
View 1 RepliesPrius (2004-09) :: Fixing Cracked Bumper At Two Spots?
so, i hit a deer that was already in the road dead, and it cracks my bumper in two spots, i got the insurance claim done but I'm wondering how to get out of it cheaper. the plastic engine guards under the front have come undone and are hanging down to where i scrape going over small bumps in the road.
View 1 RepliesPrius (2004-09) :: New 12v Battery Installed, Vent Tube Elbow Missing
I decided to install a new Optima yellow top battery because I performed the battery check and found the voltage low and therefore believed my 2008 was still running on the original OEM 12v battery. Much to my surprise I found a non-OEM battery installed and the vent tube elbow missing!
View 10 RepliesPrius (2004-09) :: Tire Light Warning Turned On After New Tires Installed
Got the new tires the other day (Thursday) from a tire chain store. As I was driving off, I noticed the tire light warning turned on and then moments later, it turned off. I thought maybe it was just that. Today (Saturday) the tire light went on again. Brought the car back to tire store and the service manager checked the pressure, the tires were all low pressure, 29-30 psi instead of 35s. He re-inflated them all but the tire light will not turn off. So next step was he used a scanner tool which he attached close to all the tires.
View 6 RepliesPrius (2004-09) :: Horn Starts Blowing Nonstop When New 12v Battery Installed
Just put in a new 12v battery but when I try to connect the ground cable, I'm getting sparks, indicating a current draw. And the horn starts blowing nonstop.
View 6 RepliesPrius (2004-09) :: Rear Bumper Cover Became Detached To Left
I was recently in a fender bender where I was rear ended. My rear bumper cover became detached on the left side and the spoiler underneath it (left side and center parts) became detached. I lost several pieces of hardware in the crash. I was able to clip the bumper cover back in on the left side, and aside from that, I don't believe any bolts, screws, etc. are missing for the bumper cover. However, the spoiler seems to be missing about half of its hardware.
View 3 RepliesPrius (2004-09) :: Clock Spring Installed In Steering Wheel - VSC Indicator Light On
I recently had to put a clock spring inside the steering wheel. I aligned it and calibrated it, however, after this change, the VSC light keeps coming on. I have disconnected the battery, I have used the paperclip on the obd connector and calibrated, but it keeps coming back on after driving a few miles. The car runs great. Along with the VSC light, the vehicle warning light comes on also.
View 1 RepliesPrius (2004-09) :: Turn Off Red Triangle After Control Valve And Inverter Water Pump Installed
I had the red triangle pop up on my Prius. I codes I got P0A93 and P1121 I needed a new control valve and inverter water pump. I installed both the valve and the inverter pump filled it with new coolant and bled both systems.
I went into maintenance mode so I could run the motor and bleed out all the water. My question is the red triangle is still on in my car when I start it up.. Is there some way to clear the red triangle or does it just go away on its own? Not sure what to do.
Prius (2004-09) :: Large Puddle Of Water Under Car - Dripping From PS Front Bumper Area
I have a 2005 Prius. I came home the other day and parked the car in the garage. I came back out the next morning to find a large puddle of water in the garage and the car still dripping. The drip is from the PS front bumper area just ahead of the front PS wheel. This is not the typical AC water puddle; we have two Prius so I am familiar with that one. I searched here and found a few threads on water pump issue but the description did not quite match what I have going on.
View 7 RepliesPrius (2004-09) :: Black Discoloration On Driver Side Entire Corner Of Bumper?
Attached are a couple of photos. The first shows the strange black discoloration on the driver's side that is slowly growing to take over that entire corner of the bumper. Looking closely, it may be noted that some paint is missing below the (cracked) taillight. This paint is missing I believe from when we were rear ended in a hit and run while parked.
View 2 RepliesPrius (2004-09) :: Front Bumper / Left Front Fender And Driver Door Replacement
Looking for info on these replacements and is there any manuals out there to assist with the process?
View 1 RepliesFord Fuel System :: Installed Holley 4 Barrel Installed But Won't Run - Carburetor?
i just got my edelbrock performer rpm intake and my holley 4 barrel installed but it won't run...the only way i can get it to hit and run at all is to floor it like it's flooded...then it'll run for a second but will never rev up and get going like it should...so i watched some vids on youtube for setting mixture on holley's wich i was pretty sure about anyway...turned the idle mixture screws in to snug and then out 1 and a half turns. is this a symptom of a bad vacuum leak or is it something to do with the carb maybe not enough fuel?
it's a holley 4160...list-6619...which is 600 cfm...it's on a 302 with 3 speed.
Lexus GS 2006-11 :: GS430 Won't Start Once New ECU Is Installed
My father has a 2006 GS430 that just started to have an issue when he slows down, it feels as if the car is braking itself. I've read that people have changed their ECU to fix this issue and that it works. I bought a new ECU(same part number) and installed it but the car tries to start but doesn't. I swapped back the old ECU and the car starts. I swap back the new ECU and it doesn't. I'm wondering if the ECU has to be recorded at the dealership.
View 4 Replies