Ford Fuel System :: Holley 4150 Choke - High Idle After Restarting?
I bought a new Holley 600 CFM 4150 with electric choke for my 79 ford F 250 with 400 engine. If I start the truck cold the choke works as it should and after driving 10 or so minutes it runs fine off choke. When I restart the truck after stopping for gas or food it goes back on high idle even with the engine temp at 180 degrees. Should it go on high idle even on a hot day fully warmed up every time i start it? I don't remember my last 600 doing it.
View 3 RepliesFord Fuel System :: 1977 F250 - Fuel Leak From Filter Attached To Carburetor
I have a 77 f-250 with a 460 engine and a 4bbl Motorcraft carb and its leaking a substantial amount of fuel out of the newly replaced filter that is attached to the carburetor. The fitting is tight and I even tried buying some small gaskets to seat it, but that didn't work either.
View 1 RepliesFord Fuel System :: Possible To Store Carburetor?
Thought I would check and see if it's possible to store a Carburetor. Have a Holley 4160 that I rebuilt and would like to keep as a backup. Thought since the carb has not been installed the gaskets and seals may not be an issue. Other option, swap the Carb on my truck every few months.
View 4 RepliesFord Fuel System :: Gas Leaking From Motorcraft Carburetor?
I have gas leaking from the pump diaphragm assembly cover of the motorcraft carb,2BBL,360,75,auto.Is this easily repairable,or is a new carb in my future?
View 4 RepliesFord Fuel System :: Location Of Ported Carburetor Spacer?
Would like to replace the 2 1/2" aluminum ported 4bbl spacer down to an inch or so. Finding it difficult locating 'ported' aluminum spacers, however, there are several brands of the 'composite' type?
View 4 RepliesFord Fuel System :: 1963 - 2100 Carburetor Won't Idle?
I rebuilt a 1963 ford 2B crburetor with manual choke. Put the carburetor on and it runs very rough. Won't go below 800 rpm or it dies and I need to choke it to start. Thought it was a vacumn leak so sprayed WD -40 and no change in idle. So pulled off the carburetor and put on the previous carburetor (with electric choke) and it runs great. I want to use the manual choke to hook up the cable though. I replaced everything in the carb. What do you think it is?
View 5 RepliesFord Fuel System :: 1974 F250 - Howling Noise Coming From Carburetor?
I have a 74 f250 with a 67 352 and a 2150 carb. I have noticed that after driving the truck for a while and when its nice and hot, if I shut it off I hear a funny "howling" noise coming from the carb. It does it for about 5 seconds, then goes away. I rebuilt the carb and it still makes the noise. Also when I am driving it, when I have the pedal at a certain point, I can hear a lot of vacuum, I have checked for vacuum leaks, and there are none. The other question I have is, the 352 was out of a standard shift truck, mine is an auto, so I have nowhere to hook my tranny kick down rod to. How I can fix that, besides replacing the carb?
View 3 RepliesFord Audio/Video System :: 2000 - CB Antenna Installed - Spot For Magnet Mount?
I just installed a CB antenna (Wilson 2000) on my truck to the truck bed rail behind the cab. I tuned the antenna and best I could get was 2.8. Wondering if there is a better spot other than going to magnet mount. Thought about going a foot or two back from the cab....
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: Won't Start Even Installed Fuel Filter?
Shut my truck off for about 15 minutes and wouldn't start back up. Installed new fuel filter. And gonna try changing cps. Torque says Rpm 180
Ipw. Bouncing between 600 - 3000 Hpop. 250 while cranking Voltage 10.9 while cranking. Ipr starts about 15% and slowly climbs to about 88%
Fuel pressure about 65%
Tried unplugging cps. Gonna check oil now though I check it every time I fill up and it never uses any.
Golf V R32 :: Remote Start System Can Be Installed On Factory Alarm?
Can a remote start system be installed on the factory alarm ?
View 11 RepliesPrius (2010-12) Fuel :: MPG Decreases From 52 To 43 After Installed Fog Lights?
I have my Prius II 2010 with 3700 miles. The avg MPG was around 52-54. After I installed the fog light, (I installed it myself), the MPG dropped to 42-44. I drive the same way as I drove before. I don't think the fog light would take 10 MPG in order to be turned on. What is going on?
View 19 RepliesPassat (B6) :: Airbag Fault And Tire Sensor Lights On After Sound System Installed
Why my low pressure light is on and why my mfd is telling me I have an airbag fault? Where would I want to start diagnosing this problem? I ran power and ground wire with no sensor issues, but once the remote and RCA wires were connected I got the sensor issue.
View 10 RepliesCivic - Honda :: Installed New Fuel Pump - CEL Came On After Hesitating And Bucking
I had a new fuel pump installed on my 1997 Honda Civic (145K miles) last week after it started hesitating and bucking one day and then the Check Engine light came on. I picked the car up last Thursday, and it runs and starts, but I still feel "something off"...it seems to have small surges of power/lack of power while I drive. Again, always starts and runs but it just doesn't feel right.
View 6 RepliesAccent LC (2000-05) :: Motor Stalls At Idle Intermittently - New Fuel Pump Installed
Motor has been stalling intermittently since May. Finally had the fuel pump replaced last Friday (8/17/12). have been driving the car back and forth to work since then with no problems until yesterday. Made a run to the local convenience store and the car was shut down for about ten minutes. Came back out and car would not start! Gave it about 10 minutes and then it started again. Got it into the garage and let it run for awhile and it stalled out. Got the check engine light (a first for that) so swapped the fuel pump relay with one of the same part number. Fired right up and did not stall out.
Also, check engine light went out on its own. Swapped relays back to original positions, motor started right up, stayed running and check engine light went out on its own. What could be causing my problem? Since check engine light came on then went out on its own, would there be any trouble codes to read? One other thing, original relay has pinkish residue on the pins. What could that be about? First time poster so I hope what I have typed out makes sense. 2003 Accent 4 door with 1.6L DOHC motor. Approx 79000 miles.
Ford Excursion :: Fog Lights Installed And Wired Up But Shorts
I finally got my fog lights installed and wired up. They're not working at all, and I've checked all the fuses under the steering wheel. I'll get the multimeter out and checked the Wires them selves in the morning, but shorts that I don't know what to do. I can't find a good diagram of the fuse box either so I don't know which one to check exactly so I just checked them all.
View 14 RepliesFord F-150 (2004-2008) :: With New Tip Installed Now Exhaust Popping?
All I did was cut off the straight section of tailpipe and install a 2.5" inlet, 4" outlet exhaust tip. It sounds a bit deeper at idle and a little louder when I rev it, but when I let off the gas it pops pretty loud.
I remember hearing popping on decel on videos of trucks where aftermarket exhaust/mufflers were installed, but not just from a new tip.
Ford Transmission :: 1979 - Installed New Clutch Now Pedal Won't Come All The Way Up?
Just installed new clutch and everything good except pedal doesnt comecall way up now have pull up with foot, ans grabs rt off the floor, i assume just need to adjust? Make adjust rod longer?
View 10 RepliesFord - Mustang :: 2001 Won't Shift Into Gear After New Clutch Installed
This is on an 01 Mustang with the baby 3.8l and a T5OD tranny. I installed a new clutch and now when the car is on, it won't shift into any gear. But I can start the car in gear and let go of the clutch and it moves forward just fine. I took everything back apart and checked the clutch plate and it is in there correctly. The clutch fork is completely on the little pivot ball.
The throw out bearing is the same size and everything as the old one. I pulled up on the clutch pedal to self adjust. Still not going into gear when the car is on.
I have heard that I might have air in my clutch line. But this clutch is cable actuated, not hydraulic. I have no master cylinder. Like I said before, I already pulled up on the clutch to self adjust and still no luck.
Ford Excursion :: 2000 V10 Won't Start / Just Clicking After Stereo Installed
2000 ford excursion limited v10 removed factory radio and put aftermarket stereo now wont start just clicking....
View 7 Replies