Prius (2001-03) :: Check Engine Light Started Coming On For Code P1636 And P3002
I have a 2003 Prius, I had an accident and after it was fixed the check engine light started coming on. It would go off after a couple of days. The first time I took it to Autozone and the codes were P3150 & P3130, but the next day the check engine light went off. A couple of days later the light came back on....went back off....next week it stalled on the highway, but it started back up, now the codes it's reading are P1636 and P3002. It still starts up and will drive, but I'm afraid to drive it.
View 2 RepliesAccent MC (2006-11) :: CEL / OBDII Code P0141 - O2 Sensor Heater Circuit Malfunction
CEL/OBDII code P0141 - O2 Sensor Heater Circuit Malfunction
So I just bought this car 64k well maintained but cant get rid of the check engine light. Replaced downstream O2 sensor with no luck. As soon as I get home I'll check voltage @ connector. Lets test the O2 sensor connection and test the pins to make sure there is no break in the wires.
Prius (2001-03) :: Codes P1636 And P3002 Keep Coming Back
Just purchased a Prius 2003 1st generation with 140,000 miles (224,000 Km)
P1636 and P3002 keep coming back
Aux battery came with car was almost new but after reading some post I replaced the battery with brand new Optima Yellow Top.
Hidden menu showing 12.4V~ 12.7V.
Car starts and run fine.
I am getting around 50 MPG.
No issues, car charging battery, goes in stealth mode.
No accidents.
In January dealer replaced the Airbag harness because the airbag light was on.
Prius (2001-03) :: 2002 - Getting Code P03120?
I've got a shop in Az. One of my customers has an 02 with 489,000 miles. The problem is when you drive it about 5-10 miles the "red temp" light comes on then it starts to lose power. Pull over and shut it off for about a minute or two then it runs fine for another 5-10 miles. took it to dealer today and they said it needs a trans axle.
My question is why would it need a trans if it runs good until the "red temp" light comes on? Could it be just a sensor? What has gone bad?
Prius (2001-03) :: 2002 - Fixing Code P3030?
I picked up a 2002 Prius with 164k, still on original battery. It giving code P3030 which evidently relates to a high voltage line snapped on the bus bar.
View 4 RepliesPrius (2001-03) :: 2002 - Code P3006 And Won't Start?
I just purchased a 2002 Prius from a government auction. The car had to be jump started at the auction yard. It ran for awhile and then died before I could put it on the dolly. I jumped it again, load it and towed it home. When I got home I jumped it and drove it off. I tried to charge the 12V battery on a 2 amp current, but it wouldn't charge so I replaced it with a new battery. Now the car won't start at all. Don't worry, I did not reverse polarity at anytime. Here's what is happening now....
View 2 RepliesPrius (2001-03) :: 2002 - Got Code 3025 - Shudders Very Badly - CEL Came On?
I own a 2001 prius and work on a lot of toyota . I am looking at friend's 02 prius that he got with a bad inverter . To make a long story short I checked the codes before we started and got code 3025 which can translate to a bad inverter if I am correct. The inverter pump was bad so we changed it and flushed the used inverter after we put it in. The "new" inverter seems to be working ,but we still have a major problem with the transmission I believe. The car will move , but it shudders very bad when you put it into drive and reverse both.
It appears like the engine is turning over with the transmission ,when the engine is hot and shut down and running on battery only. Yes the check engine light came on ,but have not had time to pull them yet.I know ,I know .its hard to give me info with no codes. The big question was ,is it possible for the engine to rotate when you drive the car in battery mode? It sounds like the engine is actually rotating and the engine will also rock back and forth with the car driving real slow. I know this will end up needing a transmission.
Prius (2001-03) :: 2002 Gen I Sputter And Completely Died - Code P3125
My 2002 Prius died the other day. Getting DTC P3125 when I ran it through my scanner, but I don't have an advanced enough one to get the sub-codes. It's got 215,000 Miles on it, so I would expect something major to be happening at this point.
Here's a detailed description of what happened --- I was driving down the freeway the other day and started noticing my car was sputtering a little bit and losing a slight amount of power. I pulled over to a restaurant to say hi to a friend; when I came back out I started the car and the check engine and battery lights came on. About 10 more miles down the freeway the car started heavily limping and barely was able to get me off the freeway, then the car completely died. When I would start it back up it would die in about 5 to 10 seconds. The 12v auxiliary battery, not the main hybrid battery, had completely died.
I figured it might have been just a dead old battery that needed replacement so I put in another new one. It ran amazingly for about five minutes around the parking lot, then the same thing happened again. It completely died just like before.
The 12v battery isn't getting re-supplied with the juice it needs. Something's wrong in there.
The either the inverter is shot, it's just overheating due to a faulty coolant pump, or the MG2 generator isn't putting juice back into the 12v system.
I checked the fluid reservoir. It looks like it's flowing, but there is a few bubbles floating to the top of the fluid. Is that normal?
Prius (2001-03) :: 2002 - P3125 Sub Code 325 With No Start / Inverter Failing
Pulling into parking lot and the triangle and exclamation light appear on dash. Drive about an additional hundred feet with what felt like lower power and no noises.
- Check 12V after about an hour and it reads 12.4 volts.
- Read codes and get P3125 sub code 325.
- Temperatures and HV battery numbers all looked good.
- Clear codes and immediately code comes back with no start, nothing. Did this many times.
This code and sub code lead to the inverter failing. Being that there was no noise as a MG2 stator failure this also leads to an inverter failure right as the MG1 motor starts the engine? Inverter pump still running good as it was recently replaced along with ATX fluid. Within the last two weeks two HV modules have been replaced.
Town Car :: 1999 - OBDII Code Is P0306 Cylinder 6 Misfire
I have a 99 town car with 78,000 miles. I filled the tank and have run about 1/4 tank when the engine started to misfire. Got the Service Engine Soon light so went to O'reily. The OBDII code is p0306 cyl 6 misfire. What would you check first?
View 3 RepliesPrius (2001-03) :: 2002 - Suddenly Get P1430 Code With Check Engine Light
Suddenly today, I get a "Check Engine" light while driving. Scangauge II says it's a P1430 error. I found two different suggestions, but where these are located on the car.
P1430-Electric Air Pump secondary Failure
P1430 -Vacuum Sensor for Adsorber and Catalyst System Circuit Malfunction
GTI 337/20th Anniversary :: 2002 - OBDII Scanner Won't Connecting Anymore?
'I'm having an issue with my OBDII scanner not being able to read my ECU. I've never had issues before. I've been using a generic OBDII scanner with the Torque Android app for years but now suddenly it just doesn't connect. My biggest issue here is I have a smog check due in a few weeks. I took it to a smog check station and the guy used two different OBDII scanners with no luck. What could be the issue? Is it a blown fuse or something? If so, which fuse is it? (And no it has no aftermarket radio installed)
FYI: 2002 GTI 337
Ford F-150 (2004-2008) :: OBDII Not Reading Code - Communication Error?
What would make the OBD II not read the code that is set on my truck. It says "Communication Error..." Fuse 41 grants power to the Diagnostics port and the cigarette lighter. The cigarette lighter is working. Any other reasons I can look at?
View 3 RepliesCamry :: 2002 V6 - ( P1135 Code) Air / Fuel Sensor Heater Circuit Response Malfunction
Just got a P1135 Code on the 1MZ-FE 2002 Camry.
My code reader pulls it up as (no typo below) : AirCFuel Sensor Heater Circuit Response Malfunction.
So I know it's a bad Air/Fuel sensor. Which one though? I replaced the rear sensor by the firewall about 6 months ago which fixed the check engine code (I don't remember the code). Would it make sense that the front one failed now or the back one failed again? Most of my research points me to a bad rear sensor however a lot of people also report that a code reader would report the sensor as "Bank 1 Sensor 1".
The rear sensor was replaced with a Denso 234-9042 Sensor.
I would play the replace and test game... however inspection is due within the month and after resetting the code, it usually takes about 50 miles to return. Being in college, 50 miles takes about 2 weeks.
Honda - Acura :: 2000 TL All Of A Sudden Stopped Starting - P1607 OBDII Code
I have an Acura 2000 TL. My car all of a sudden stopped starting. I called AAA and the tow truck driver did some repair like thing. The car started after this. He told me, there was a problem with the remote starter or security alarm issue. After that the car starts but the immobilizer light is completely off. It gives P1607 OBDII code. When I looked under the dash, I saw a black button and pressed on it. It gave some clicks and nothing happened. I pressed on it and turn the ignition switch on and off a couple of times and nothing happened. I pushed on the button while pressing on the brake peddle and released within 2 seconds etc. The car has a Code Alarm remote start with two button fob and it was disabled. I don't know whether the AAA driver enabled it causing the immobilizer bypass to actuate to have the P1607 code. The car starts ! What can I do to get the Code Alarm remote start to disable it?
View 8 RepliesSanta FE SM (2001-06) :: Code P2135 - Electronic Throttle Control System Malfunction
Back in March I started a thread regarding my 04 Santa Fe 3.5 which would not start after a spark plug change.
After a ton of research, & a smoke test on the intake I came to the conclusion that there was an issue with the throttle sensor as I unknowingly opened it when I was removing the intake to get to the last bolts behind the manifold. Shortly after my post, I decided to bite the bullet & buy a junkyard TB out of another Santa Fe 3.5.
After installing the new TB, the car now starts but runs extremely rich. I am now getting the code p2135 for Electronic Throttle Control System Malfunction.
Luckily up until this point I haven't needed the Santa Fe as it is mainly a winter vehicle. However, winter is quickly approaching & I would like to have her running before the snow starts to fly.
Elantra XD (2001-06) :: Stuck In 3rd Gear - Code P0760 And P0755 / Malfunction Shift Solenoid B And C
I have two codes P0760 and P0755, malfunction shift solenoid B and C, today I took it to Hyundai here in queens ny, I was told that It would cost e 2684.00 to fix my issue, I can't believe that if those two codes are the problem why would it cost 2684.00 ? Where are these solenoids located?
The car feels like your one of the flintstones, it's stuck in 3rd gear and cant get out, then it jerks when it tries to shift, tranny oil is fine not burnt like if the clutches are gone.
Santa FE SM (2001-06) :: Code P0320 - Ignition / Distributor Engine Speed Input Circuit Malfunction
I have a 2003 Santa Fe, V4, 2.4L.
So the other day, my CEL and I got it scanned: p0320, or "Ignition/Distributor Engine Speed Input Circuit Malfunction."
It was accompanied with two symptoms:
1. The car will sometimes sputter on startup, and the tachometer will be zeroed out. I have to turn the car off and turn it back on, and it will start normally, albeit with a bit of a misfire on idle.
2. The car will sometimes die while at a stop. Just like the first symptom, if I turn the car off and turn it back on, it will work normally.
I looked on here, and it seemed like everyone solved a p0320 by replacing the Ignition Failure Sensor. So that's exactly what I did. But nothing changed; I still have the symptoms, and the CEL came back on and is still reading p0320.
What should be my next step? Could it be faulty wires that give power to the Ignition Failure Sensor?
Prius (Gen 2) :: 2004 - Error Code C1310 / Malfunction In HV System
I have a 2004 Prius with 80k miles. Always has been a workhorse. Recently had a bad cell in the HV battery. Battery rebuilt with new cell and now works great.
Now it runs about 20 miles and then displays dash lights of red triangle and small exclamation (brake?) and VSC.
I took it to Advance Auto and their scanner reads C1310 'Malfunction in HV system'.
I actually replaced the entire HV battery again with the battery from my friend's car, and the 12V battery too, but no luck. Same error.
If i disconnect the 12v battery for a while, it will clear the code and the car runs fine for about 20 miles and then dash lights come on again.
Car runs perfectly, over 50mpg even with the dash lit up. What that code is?