F Series :: Code P2135 - Electronic Throttle Body Replacement
Throttle body failures on the 5.4L 3v are more common than you think, luckily it will pop a code for the throttle body more often than not working with diagnosis. Symptoms include start and dies, no start, a really rough idle, surging idle up and down more so in park, poor brake assist due to rpm fluctuation and wrench light on. How to change the throttle body and reset the pcm to learn the new idle trims. [URL] .....
View 2 RepliesFord F-150 (2004-2008) :: Code P2135 - Electronic Throttle Body Replacement
Throttle body failures on the 5.4L 3v are more common than you think, luckily it will pop a code for the throttle body more often than not diagnosing. Symptoms include start and dies, no start, a really rough idle, surging idle up and down more so in park, poor brake assist due to rpm fluctuation and wrench light on. If you find yourself in this situation I show you how to change the throttle body and reset the pcm to learn the new idle trims.
Ford F150 F250 5.4L 3v Electronic Throttle Body Replacement P2135 - YouTube ....
Ram / SRT10 :: 2003 - Electronic Throttle Control Malfunction
I have taken it to 3 different dealer service centers, and everytime they charge me to update the computer software. They still haven't fixed anything, and everytime I leave the dealer after "getting it fixed", within 25 miles the problem reoccurs. According to my owner's manual the electronic throttle control malfunction warning light is only on the Hemi Rams.
The problem causes the truck to jerk, idle improperly, the engine loses power and shuts off at low speeds usually when turning, and sometimes when the truck accelerates after a complete stop, it hesitates causing the tires to screech when it finally builds up enough RPM to move, this last one has caused me several explanations to police officers on why I am "laying rubber" on their city streets, as if the Hemi emblem doesn't attract enough unwanted attention from the local highway law enforcement officers..
Golf/GTI VI :: 2000 VR6 - Throttle Position Control Malfunction / Code P1545
I have a 2000 GTI GLX VR6 and when I start it in the morning (ie cold) after the initial "choke" and the revs drop it becomes erratic. Sometimes it will stall out. If I restart the car it will throw a check engine light and go into limp mode. If I let the car warm up it runs fine. If the car has been driven and is relatively warm it runs fine. Initially there were several codes but after replacing the MAF and the fuel pump relay the only remaining code is P1545.
My mechanic seems to think it may be the coolant temperature sensor. The code seems to indicate the problem is the throttle. "Throttle position control malfunction". Not sure why warming it up makes a difference (unless of course it is the temp sensor). When I replaced the MAF sensor I did clean the throttle body. I was very careful in doing so. Problem existed prior to my cleaning it as well. After changing the fuel pump relay things were better for a few days but then the problem returned.
Passat (B6) :: 2006 - Parking Brake Control Head Electronic Malfunction
I've read as much info as I'm willing to digest and everything seemed to point at the switch. Replaced switch. I went through a recommended adaption sequence and I'm back to square one. warning light for [P] - traction control light - display says Parking Brake Fault See Owners Manual. And there are codes for Parking Brake Control Head Electronic Malfunction...
View 4 RepliesFord :: Electronic Throttle Control Light Came On While Driving Through Puddles
I have a 2008 Ford E250 cargo van with the 4.6 V8 (186,000 miles) I drove through several puddles of high standing water last week, The last one did the job so to say. I thought I could make it through but I didn't. I managed to get the van through the puddle but not without ticking, The electronic throttle control light came on in addition to the check engine light (PO 103 code) The air filter got wet and the engine oil looks like milk chocolate.
View 6 RepliesFord F-150 (2004-2008) :: Electronic Throttle Control Light On
I took it to a mechanic, he just told me to sprayed some carb cleaner on the throttle body and butterfly valve, and to wipe it with a rag. He did not hook a computer to it, to diagnose. and he said if the light comes on again to buy a new throttle body... I am thinking of getting throttle body sprayer taking off the throttle body replace the gasket, and hope this fixes my problem. I forgot to change my air filter btw.
View 1 RepliesPassat (B5) :: Code P1296 Cooling System Malfunction / P1654 Check DTC Memory Of Control Panel ECU
I am getting to check engine codes and I can't figure out what is causing them, one is P1296 cooling system malfunction, the other is P1654 Check DTC Memory of control panel ECU, any clues as to why I'm getting these, I did have a bad thermostat i changed that and it's still on, I also used the new prestone antifreeze for all makes and models, cause I am about 200 miles away from a dealership for g12.
View 6 RepliesSanta Fe (DM - 2013+) :: CEL Code P2118 - Throttle Actuator Control Motor Current
I just got a check engine light today too! I wasn't sure if I should start a new thread but I found this one first so I'll see if I get any responses. Anyway, the diagnostic tool showed P2118: throttle actuator control.
I'm not sure myself if I should be worried especially since my wife and little one year old will be driving the SF long distance this week.
Ford Wiring/Electrical :: P1451 Code - EVAP Control System Canister Vent Solenoid Circuit Malfunction
I'm not too knowledgeable about wiring and electrical systems. I'm getting a P1451 code (EVAP Control System Canister Vent Solenoid Circuit Malfunction) on my 99 4.2. I've read that it could be a bad solenoid, bad wiring, or a blown fuse. So far I've;
- checked (and changed) the related fuse
- checked the wiring for damage at the connector
- checked voltage at the connector (12 volts)
- checked the resistance at the solenoid (around 60 ohms)
- actuated the solenoid with a 9V battery (can hear it opening and closing)
I haven't had a chance to check the wiring all the way back up the frame to yet, but I noticed that the ground at the trailer wiring harness has broken off the frame. Would this potentially cause a fault in the upstream wiring? I'm going to slap a new connector on and bolt it back down anyway, but as it's Labour (Labor) Day I'll have to wait for the stores to be open tomorrow.
Ford F-150 (2004-2008) :: 2005 - Electronic Throttle Control / Wrench Light
2005 Ford F-150 FX4 5.4 V8
So my battery died the other day when I was working on the radio and I ended up having to jump start the vehicle. After the jump start the Wrench light came on the truck or the ETC light. (After doing research I have discovered you are not supposed to jump start a vehicle with ETC)
I have taken the car to the auto parts store and it does not seem the code readers they have can read codes for the ETC light.
I have also disconnected the battery cable to try and reset the light, but it still always comes on about 10 seconds after starting the car.
I have had no issues with the vehicle despite the light. No rough idle, no starting issues, or acceleration issues at any speed. What I can do to resolve this light or what part I fried when I jump started the car?
Santa FE SM (2001-06) :: Code P2125 - Throttle Position Sensor Replacement?
Getting code P2125. Read on here to get some electric contact cleaner and see if that works by cleaning the connections.
If I do end up changing out the Throttle Position Sensor, what voltage value do I look for when installing the new one ?
Santa FE SM (2001-06) :: Check Engine Light Came On - Code For Throttle Position Open
My check engine light came on the other day and the code stated the the "throttle position is open" so after researching and everyone telling me that i need to change the sensor. I did everything after was fine running better but today only after 3 days replacing it i get the same problems. car has no get up and go hardly can push to 20 mph and when in idle i press the break it starts to bog down and almost want to shut off! and can be really loud...
Santa fe 05' 3.5L ....
Santa FE SM (2001-06) :: Code P0320 - Ignition / Distributor Engine Speed Input Circuit Malfunction
I have a 2003 Santa Fe, V4, 2.4L.
So the other day, my CEL and I got it scanned: p0320, or "Ignition/Distributor Engine Speed Input Circuit Malfunction."
It was accompanied with two symptoms:
1. The car will sometimes sputter on startup, and the tachometer will be zeroed out. I have to turn the car off and turn it back on, and it will start normally, albeit with a bit of a misfire on idle.
2. The car will sometimes die while at a stop. Just like the first symptom, if I turn the car off and turn it back on, it will work normally.
I looked on here, and it seemed like everyone solved a p0320 by replacing the Ignition Failure Sensor. So that's exactly what I did. But nothing changed; I still have the symptoms, and the CEL came back on and is still reading p0320.
What should be my next step? Could it be faulty wires that give power to the Ignition Failure Sensor?
Passat (B5) :: 1999 - Throttle Body Malfunction Code P1545
I'm an Mk3 guy but I've gotten the hang of these beasts when I started to fix my brother's '99 B5 AEB. I got a VCDS scan from a friend and got this.
5 Faults Found:
18010 - Power Supply Terminal 30: Voltage too Low
P1602 - 35-10 - - - Intermittent
17953 - Throttle Valve Controller: Malfunction
P1545 - 35-00 - -
17953 - Throttle Valve Controller: Malfunction
P1545 - 35-10 - - - Intermittent
17952 - Angle Sensor 1 for Throttle Actuator (G187): Signal too Large
P1544 - 35-10 - - - Intermittent
16507 - Throttle Position Sensor (G69): Signal too High
P0123 - 35-10 - - - Intermittent
Readiness: 0110 0101
I'm thinking either the throttle body is toast or maybe the ECU.
Lexus GX 2004-09 :: GX470 - Low Voltage Warning And ABS Control System Malfunction
C1241 is low voltage warning and C1223 is an ABS control system malfunction.
Are or could these be related? Where should I start to troubleshoot the issue?
Dodge - Neon :: CEL On - Transmission Control System And Shift Solenoid B Malfunction
I recently acquired a 2003 Dodge Neon and have also aquired a problem with the automatic transmission.The check engine light was on so I read the codes and they are noted below
P0700 Transmission Control System Malfunction
P0755 Shift Solenoid B Malfunction
Based upon some very basic research, I checked into replacing the Transmission Control solenoid.It sounded like this is a pretty common problem for this transmission, so hopefully this would fix the problem.
I was able to get the old one pulled off without to much trouble, but prir to installing the new one I was wondering if there would be a way to test the old one to verify that it was actually bad. I would prefer to not install the new $150 part only to find out that this was not the problem. (and then I could not return it once it had been installed) Maybe some low air pressure on the ports and verify that the ports / flow changes if 12 VDC is applied to the right pins?
A little more information in regards to the "failure" mode. The transmission appears to act the same no matter if it is placed in 1,3 or D. (reverse works fine) I would have expected that it would limit out with the motor taching up pretty high at about 20 MPH in 1(low). It goes down the road fine up to about 55 mph and then the engine starts taching up.
I also tried to reset the error codes with my "craftsman" code reader and it would not do it. I seem to recall seeing something about needing to reset codes before the new solenoid would work. Will pulling the battery for an hour clear the code? Do I need to clear the code?
Caravan/Voyager :: P0700 And P0740 - Trans Control System / TCC Circuit Malfunction
The first is a trans control system malfunction and the 2nd code(0740) is tcc circuit malfunction- but what exactly do these codes mean? and the o2 sensor needs to be replaced, it said bank 1 sensor 1- does that mean the one BEFORE the catalytic converter?
View 4 RepliesFord F-150 (2009-2014) :: P2135 Code - Stall At Idle After A Highway Trip
2010 4x4 F150 Lariat 5.4 L, have been working on throttle response problems off and on for a few months. Initially got p0404 codes, and replaced the accel pedal assembly, now graduated to p2135 code, and stall at idle after a highway trip. Wondering if this may be a issue with aftermarket air filter causing misread errors on sensors. Had it to the dealer, with out any real remedy.
View 2 Replies