Camry :: Installing Engine Air Filter?
I got a new frame engine air filter as recommended by the book, tried to install and the cover will not close properly.
View 2 RepliesCamry :: Fan Vibration Noise After Installing New Cabin Air Filter
I installed a new cabin air filter and I am getting some fan vibration noise. Gets really noticeable around speed 3 or 4. What could be causing it? It is the TY brand filter.
View 4 RepliesCamry 2012+ :: Still Smell After Installing New Cabin Air Filter
I have a 2013 Camry XLE V6, and it now has almost 17,400 miles on it. About a month ago, I replaced the Cabin Air Filter (was definitely dirty) and the Engine Air Filter (was somewhat dirty). I made triply sure that I installed the Cabin Air Filter the correct way (the Air Filter is easier, as there is only one way to put it on).
In any event, after the car sits a while, and I start it up, whether I let air circulate from the outside or not, when I press the fan button for the A/C, initially a "musky" smell is present, but it does go away fairly quickly. (I have not tried this in "heat" (non A/C) mode yet). Why this happens? Seems somewhat strange (by the way, I used the correct STP filters that I previously purchased at AutoZone).
Aerio :: 2003 - Suzuki Idles After Cleaning MAF And Installing K&N Filter On CA
Some time late last year a branch or something managed to rip my filter off my cold air intake.. the check engine light came on and I ignored it, simply thinking I had not tightened the gas cap.
So last week, I went to get my 2003 Suzuki Aerio SX, with 160K miles inspected, and they told me it was through a code that the mass air flow sensor was bad.. Later they find out my filter is just missing.. the clamp and a section of the rubber was still on the tip.. but the rest of long gone.
So I have been driving, 4 or 5K miles with no filter. I buy some mass air flow sensor cleaner, spray it and now my car idles at just under 2K RPM but slowly creeps up to around 3K RPM. It drives fine, but when I pop it out of gear or hold the clutch down. it starts to go nuts.
I put a brand new K&N filter on, I didn't add any oil to it as it didn't say it needed any and it wasn't dry, but not soaked either.
Now when I went to remove my Mass Airflow Sensor, I did remove a couple other parts first by mistake. I fiddled with the temperature sensor inside my cold air intake, but I couldn't get it out due to the rubber ring around it holding it in and sealing it. I also removed the Fuel Injection Manifold Pressure Sensor but I am pretty sure I put it back on fine. and I did remove the Throttle Position Sensor.. so maybe thats my issue?
what should I do to troubleshoot it?
I sprayed wd40 on the throttle above the engine, not sure if it was it or not but my engine was idling at a lower 1800 rmp for a while, still high but not as bad, I took it for a ride around the block and when I got back it was at 3K again, it did run at a steady 20 mph in second gear with my foot off the gass completely.
Subaru :: 2009 - Drastic Mileage Drop After Installing New Air Filter
I've got a 2009 Subaru Impreza Outback Sport. I went in to a Jiffy-Lube type of place for an oil change, they showed me I had a dirty air filter and I had them change it. I went in averaging around 25 mpg (between high 24's and mid 25's), and after I left, I began averaging around 20 mpg, it currently reads 19.5. I went back to see if they had installed it incorrectly or left plastic packaging on it or something, but all seemed okay.
View 14 RepliesPassat (B6) :: Airbag Light Came On After Installing Dash DVD Player?
well installed my new in dash dvd player...everything went smooth...turned the car on....AIRBAG LIGHT IS ON...WHAT DID I DO?!?!?!? WHAT DO I DO?!?!?!?
View 21 RepliesPassat (B6) :: 2008 - Installing HID Kit
Okay, this is my problem. I bought a HID kit for my 08 Passat and did a little searching and found that I need to get into the computer and change the settings to where it thinks I have the Xenon lights already. If I didn't do it, that it would burn my ballast So I spoke to someone who knows about Vw's. Was told to download the software from Ross-tech and instead of paying the $300 for the VAG-COM, that I could get one off Ebay and I would be good to go. But to my surprise, I downloaded everything, got my OBD-II wire but I keep on getting error codes and cant get into the computer to change anything. I have installed and deleted the program, spent hours trying to fix.
View 5 RepliesPassat (B5) :: Installing A B5.5 Front End?
Need to know if this is a bolt on affair or what possible fabrication may be needed?
View 3 RepliesPassat (B6) :: Installing Bi-xenon Lights?
Putting factory bi xenon lights in new 2.0? Is it something that can be done?
View 11 RepliesPassat (B6) :: Installing Grill Emblem?
I just bought this grill [URL].... and it fits great. However, the grill does not come with a emblem so I was just going to put mine from my 06 Passat on but it is a lot smaller than the opening on the new one. Am I just missing something here, or are there different size grill emblems on some cars? Or is my new grill just messed up?
View 3 RepliesPassat (B6) :: Installing Foglights Using VAGCOM?
I know how to install everything and which pins to connect and all that, but do I really need to use VAGCOM to let my car know it now has foglights?? Can I just use a relay light I did on my 03 Jetta??
View 5 RepliesPassat (B5) :: 1998 - Installing Stock Radio
What were the stock radio options for the Passat?
My 98 came with a JVC aftermarket; don't like the look. I consider putting a stock radio back in.
Passat (B7) :: Installing Megan Racing Coilovers?
I picked up some Megan coil overs with plans to install them today, but can't figure out where one part goes. It looks like a spring spacer. The instructions are terrible and make no mention of what it is. My guess is it goes with the rear springs but...? [URL]....
View 24 RepliesPassat (B7) :: Installing LEDs On Dome Lights
I'm trying to install my leds on the dome lights. The back one was quick and everything but the front dome light cover doesn't want to come off. Only the passenger side one wants to pop out. While the driver side of the dome doesnt wanna budge. It seems like ts actually stuck to the inside of the compartment. It just doesn't wanna pop off all that i getting is scratches.
View 5 RepliesPassat (B6) :: Installing Factory Satellite Antenna?
Installed the factory antenna on a car without one from the factory?Is the wire already in place?
View 8 RepliesPassat (B6) :: 2006 - Installing Auxiliary Port?
I'm looking to install an auxiliary port into my 2006 Passat 3.6L 4motion and I was wondering what plug in converter would be best to get, what other cables I would need, and where I can buy a flush 3.5mm aux cord for installing in a blank plastic piece next to the gear lever. I'm not looking to buy a converter that charges an iPod.
View 3 RepliesPassat (B6) :: Battery Died After Installing Rosen System
After installing my Rosen system hours later my battery was completely dead. Nothing unusual about the install. Used factory harness with rosen harness.
View 19 RepliesPassat (B6) :: 2007 - Installing RNS-510 / Sirius Module Location?
So I'm about to install an RNS-510 and I can't figure out where the Sirius module location is so I can install the extension that you need.
It's 2007 with 6 discs in dash changer with Sirius.
Passat (B6) :: 2012 - Installing HIDs - Removing Headlights?
My DDM HIDs came in the mail today and fellow vortexer D.Passat00 was kind enough to meet up with me and do the needed vag-com adjustments. So firstly a shout out to him, he's a solid dude and really nice
Now: Is there a DIY for headlight removal? I can't seem to find one, and without removing the headlights I'm afraid there just isn't enough room to install the new HID bulbs without dinging/touching them.
I have a 2010 2.0t Passat and I got the 35w 6000k DDM HID kit