Golf IV / Jetta IV :: EPC Light Has Come On - Car Will Idle At 1200 RPMs Up From 800
Recently I believe i got a tank of bad gas. Was having problems starting. Finished it off filled up used injector cleaner and dry gas to clean it out a bit more. Now as I was driving the car would basically stall out but kick back in as I was driving and the EPC light would come on. I've been reading up and most answers are a bad coil pack. I pulled them all out and checked them they all look pretty good. No codes are popping up for it a coil pack. Unless I need a specific VW model computer to check. I'm gonna check the volts on the coil packs today to see as well.
The EPC light does go off after the car sits a while. It comes back after a few miles driving. After the EPC light comes on my car will idle at 1200 RPMs up from 800 when its normal.
Passat (B5) :: RPMs Went Up To 1200 - 1500 At Traffic Light / Check Engine Light Came On?
I have a 2000 1.8t and I was on my way home from work, sitting at a traffic light and my rpms went up to 1200-1500 and then my check engine light came on.
View 7 RepliesLexus ES 2007-12 :: ES350 Rougher At Idle - Error Codes P0451 And P0455
Just turned 80k and recently noticed a bit rougher at idle. Other than that all has been fine. Plugs, etc. all original. Engine and VSC Light. Autozone ran the scan which turned up the above stated codes. They are defined as Evaporative emission control system pressure. He said it could be a loose gas cap. Checked it and its tight as a drum.
View 3 RepliesPassat (B5) :: Error Codes With Noise When Accelerating
P0302
P0301
P1545
P1300 X2
I have no clue what is wrong but I have an exhaust leak and when I am accelerating I can hear the loud shhh sound like the turbo is leaking but I still have power like normal.
Passat (B5) :: CEL On With Error Codes P0036 And P0141
So I have my CEL light on error codes are P0036 & P0141.... how do I fix it??
View 1 RepliesFord Escape / Hybrid :: 2006 - At Idle Engine Run Around 1000 Rpm - Error Codes P0113 And P2196?
Have a 2006 ford escape, at idle the engine will run around 1000 rpm's and then regularly dip down 500 rpm's. Through the intake i can here a distinct "thwap" when the RPM's dip.
Only codes are
P0113 and P2196
Problems accelerating sometimes, Took it too a shop they said bad exhaust valve on the backside of the engine either 1-2-3. They said needed engine work, but said they didn't know where the bad valve was so i don't even know how the made the determination. Vac gauge at idle also indicates bad valve.
However, when i give it even the smallest amount of gas possible the engine smooths out and vac gauge reads totally normal and steady.
Phaeton :: RPMs Goes To 1200 For About 30 Seconds Then Settles To 65 On Startup
On start up (Engine cold) my rpm goes to 1200 for about 30 seconds then settles to 650, is this normal ?
View 10 RepliesJeep - Grandecherokee :: 1995 Sputtering Like Running Out Of Gas At About 1200 RPMs
My 95 Jeep GC is a great car, but it is now behaving too strangely to ignore. At about 1200 RPMs, when I'm just lightly hitting the gas, the car starts to have a "sputter" feel to it, like it's running out of gas. Then, after running it on the highway for a couple of hours (I live 2 hours from the nearest city in Alaska) the turning radius practically disappears and there is a horrible clunking noise and feel when I try to make a sharp turn. This goes away after driving it slowly through town for a while. The sputtering only happens at 1200. I've had it at 3 different mechanics, and no one can figure it out. I've emptied the gas tank and filled it with Premium and added 'heat' to it. I've had all the fluids changed out. I see this as two seperate issues, but can not figure out the sputtering thing at all.
View 5 RepliesAcura - Tl :: 2004 6MT Shakes Violently When RPMs Go Between 1200 And 2000
My 2004 Acura TL with 6 speed manual transmission has an issue. When the RPMs go between 1200 and 2000 the car shakes violently as if the engine isn't attached or is trying to get away. At idle it's silky smooth and after 2000 RPM it feels fine too. The gear I'm in doesn't matter and this shaking happens whether I'm standing still or driving... it just happens in the 1200-2000 RPM range. Again, this is not a small amount of vibration, I'm talking about seriously shaking the whole car.
This is what I've done so far:
1. Replaced the three engine mounts two days ago, and double checked the transmission mounts and they seem fine. At the same time my mechanic discovered a few bolts on the subframe that were loose, and we tightened those.
2. Replaced O2 sensor that was causing check engine light and it's fine now.
3. Timing belt, clutch and power steering was done by previous owner maybe 3-4 months ago.
Accent LC (2000-05) :: Clanging Noise At Low RPMs (1200 - 1500)
I was climbing up a hill on the highway, and I was aware of my issue by the time I hit the top of the hill - my car far into the red zone on the temp gauge.
I pulled over just after i got off, let it cool for a few minutes, check oil and coolant and they seemed fine (from what i could, but it was dark. Drove home because it was only a few mins away, and it had cooled a bit already, but it started sounding really weird at low rpms (1200-1500) almost a clanging noise.
Just as i was pulling into my driveway, there were a whole bunch of weird noises, and at least one of them was me losing coolant from the cap. Turned off the car and the coolant overflow box was completely full, and the radiator cap had leaked some too.
Some other things i noticed - sounded like boiling water inside the large hoses, hoses felt empty, and the coolant box emptied all of a sudden after the hoses sucks everything back up.
Passat (B6) :: Main Beam Not Working - MFD Error Codes For Headlights
So I have MFD display errors for "main beam not working" on both sides but both of my headlights, lows and highs both work fine. this has been like this for a few months now. I can clear the codes with my VAGCOM and after a day or two they come right back. I do have LED license plate lights but for at least a year i only got the error code on startup for the plate lights but never headlights. A little confused as to what is tripping the headlight codes
View 3 RepliesPassat (B5) :: OBD Scan Giving Error Codes P1136 And P0441?
Shop said o2 sensor and they just want to replace one. I can get universals for around 80 each, will they work if this is in fact the problem?
View 1 RepliesPassat (B5) :: Got Error Codes 18062 / 17887 / 17536 / 16795?
I had the following errors:
18062 P1654 Check DTC Memory of control panel ECU
17887 P1479 Brake Boost Vacuum System: Mechanical Failure
17536 P1128 Long Term Fuel Trim mult.,Bank1 System too Lean
16795 P0411 Sec.Air Inj.Sys. Incorrect Flow Detected
Readiness status 01101101
Then I noticed that connection between Fuel pressure regulator and Intake monifold is broken. Fixed , now after 200 km no errors. Could it be the reason for above errors?
Passat (B6) :: 2 Error Codes - Tire Pressure Monitoring / Parking Brake
2006 2.0T 6spd.
Got an error for tire pressure monitoring. Is it just a bad switch?
Error for parking brake. Sometimes it works sometimes it doesn't.
Sonata NF (2006-10) :: Tach Surges 500 RPMs When Let Off Gas
Driving at steady speed, doesn't matter what speed, let off gas and the tach surges 500 rpms and the car keeps going on it's own for a while. also pulling a hill at freeway speed car bucks like a spark plug miss, but not with the cruise on and engaged. smooth as silk then. 2009 Sonata 4 cyl, 30k miles.
View 1 RepliesPrius (2010-12) :: High Pitched Sound - RPMs Go From 1200 Up To 3400 In 10 Seconds
I was driving today and had just gotten off the highway. I was going at no more than 10MPH when I heard some high pitched sound. At first I couldn't figure out what it was and thought maybe it was some outside noise. It quickly got louder over the span of the next few seconds and then I realized it was the engine. I had the pedal barely down so was definitely in electric mode.
I quickly glanced at my Scan Gauge and actually saw the RPMs go from 1200's up to 3400 in no more than 10 seconds. I have never had the car rev this high, probably just 2400s when I'm on the highway going 70's. By this time I was getting very perplexed and worried, and had my foot completely off the gas pedal. I immediately pulled to the side of the road and parked (hit the P button). The car seemed to go into park mode fine and then over the next few seconds the RPMs went back down to 992, and I made it back to the house no problem.
Phaeton :: Engine Missing / Hesitation Between 1200 And 2800 Rpm - Fault Codes
What the fault codes below could be indicating. Let me quickly bring you up to speed. I was experiencing and issue with my car running rough (engine miss/hesitation) between 1200 and 2800 rpm. My ESP and CEL lights both came on. Eventually, my car stalled on me while driving. After attempting to restart the car a few times, the engine finally started. I took the car to two dealerships and was told the Mass Air Flow sensors and Intake Manifold Runner were faulty and needed replacing. After reading some of the post on the forum, I deduced the intake manifold runner would not cause the car to stall. That said, I purchased two new MAF sensors and replaced them myself to no avail. I still had the problem. I took the car to an independent mechanic (who has experience with phaetons). He hasn't been able to identify the issue. He provided me with the fault codes below:
Address 01: Engine Labels: 4D0-907-560-BGH.lbl
Part No SW: 4DO 907 560 CS HW:
Component: 4.2L V8/5VG 0030
Coding: 0007873
Shop # WSC 01065 000 00000
VCID: 79F21F7E33C272C
6 Faults Found:
[Code] ....
What I should do next. My car starts fine and idles smoothly. After driving the car for a few minutes, the engine miss/hesitation shows up.
Golf IV R32 :: RPMs Rise To About 1300 Then Drops To About 300 And Back Up To 1200 Steady On Cold Start
It started snowing going down to 10-15 degrees during school hours. and whenever i go to turn my car on it starts but immediately the RPMs rise to about 1300 and then immediately drops to about 300 then immediately back up to 1200 but stays steady until it warms up then drops to normal about 700. i understand the cold start when it idles high until it warms up but why does it drop then come back up?
View 3 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Missing Between 1200 And 2000 RPMs
I have 2005 f250 5.4l 3v that was having miss problems between 1200 and 2000 RPMs. Changed VCT solenoids which worked, but then could hear chain hitting cover when powering down throttle on left side. Figured chain tensioner was bad, so tore down and removed timing cover. Found left chain was tighter than what seems normal, and right side had huge amount of slack. While taking off tensioner on left side, something happened to fast for me to see it, and still not sure if what happened wasn't just my imagination. I thought that the chain moved very fast for an inch or two. Anyways, I watched how to video on timing the 3v, but I am very confused about it. The left bank seems to line up on timing marks perfectly, but the right chain is off by at least 2 1/2 links. Not knowing any better, I removed three rockers on left bank (2 intakes and 1 exhaust) but only removed two intake rockers on right side. I don't know what I am doing and getting scared.
View 1 Replies