Passat (B5) :: CEL Came On With Two Codes P0B33 And P1136
Alright so my check engine light had came on today and i got home and scanned it and got 2 codes which were ... P0B33 AND ALSO P1136
What codes are these ? and what is causing them to give me a CEL ? and how could i fix the problem ?
Passat (B5) :: CEL Throwing Codes P1136 And P1113
My girlfriend has a 2000 B5 and it's been throwing a p1136 (Fuel trim too lean: probably a vacuum leak) and p1113 (B1, S1, pre-cat O2 sensor) for about two weeks now. How long can she feasibly leave this stuff before doing any real damage?
I just don't have time to check her manifold for vacuum leaks for at least a few months (summer) or deal with the O2 sensor. I mean she doesn't need to get it inspected until Nov 2007, so, all she has to put up with is that really annoying beeping and "emissions workshop" lightshow every time she starts her car up.
Prius C :: Check Engine Light Came On / Error Codes Are P0441 And P0445
Just tried to leave for work and my check engine light came on. Luckily I just got a scangauge and the error codes are P0441 and P0445. I checked online and for regular Prius is says it could be the fuel system, fuel cap, etc. I'm scared to drive it now and wonder if I should call Toyota Care to tow my car to service.
View 6 RepliesPassat (B5) :: Engine Codes - P1136 Running Rich At Idle / P1250 Low Fuel Level
I just had my check engine light come on and checked the codes and they were P1136 running rich at idle and P1250 low fuel level. My fuel level is 3/4 full and I just installed a K&N panel filter in the airbox. While I was installing the filter I also cleaned the mass airfow sensor and then cleared the codes. The codes have come back after 2 days.
View 4 RepliesPassat (B5) :: 2001 - Getting Error Code P0343 While Using Scan Tool?
2001.5 1.8t, I have this p0343 code when I used the scan tool at murrays or oreileys whatever the h they are now (it means something like cam angle sensor high input). The t-belt was due for service a while ago , am I looking at a sensor problem or a wiring problem or a timing/engine problem? How should I check and where? I hear the timing belt can be a pain on the 1.8s, I have done a mk4 trans and a bit of other stuff but I do have a lot going on right at the moment and I'm not sure if I have time. I have a feeling if I take it in for service they will probably find blow through from the turbo and pull the engine because of "sludge".
View 2 RepliesPassat (B5) :: CEL Came On Giving Error Need New ICV
so we scanned it, the funny thing is I called up VW and 30v v6's don't have an Idle Control Valve?
View 1 RepliesPassat (B6) :: CEL Comes On / Codes P0441 And P0171
So one day when I was driving, the CEL comes on, and then I go to autozone to get my free diagnosis. I got codes: P0441 and P0171
My engine is running fine and everything else seems to be in order. However, I have to get a new canister purge valve and new oxygen sensors, in order to be in the clear.
For the Oxygen sensors, I have AN IDEA of where they're located; somewhere underneath the car, by the catalytic converter (the converter is in between the two connectors, apparently). I have yet to do this and would like some opinions on what to do for it.
For the Canister Purge Valve, I have no clue where to look. I pop open the hood and I notice a diagram with labels. Great, but there are just too many other pieces to look at...I do not know if it is visible as soon as I pop open the hood, or if I have to dig deeper, or even if I have to remove the fancy plastic thing that covers the engine.
Passat (B5) :: Error P0441 Will Appear When Get Into Stop And Go Local Street Traffic
I have had this error come up in the past (P0441) and have reset it. At one point I replaced the purge flow valve.
Lately, when I'm running at expressway speeds I have no issue. When I get off the expressway and get into stop & go local street traffic, the error will appear again, sometimes. Recently, in the past 3 weeks it has done this 2 times in this stop and go driving scenario..
I've been keeping the gas tank above 1/4 tank, to make sure pressure stays up in that system. Even passed the emissions test where they clamp the gas gap with their machine to make sure it's holding pressure. What could be going on with my 1999 V6 passat?
Passat (B6) :: VW V6 2002 Giving Error When Try To Start (Immobilizer Activated)
I have problem in my VW Passat v6 2002. When insert car key to turn on start Engine, The screen shows an error message: "immobil activated" That means: Immobilizer is activated! And after that car is auto turn off then the Engine shut down in one second with flashing key light! As the fuel tank is empty..
But When I try to start again after an hour / two hours it's works!! This situation comes up if the car was parked from last night until the moment of start on in the afternoon!!! What is strange that this problem does not occur only at the time of day warm, Between 5 and 11 o'clock in the afternoon hot days!!! Because this problem is not never happen in the evening and night.
I go to the Workshop for dellership Car Agency. They re-programmable keys, But the problem is still continuing.
Ford Aerostar :: Truck Does Not Accelerate Properly - Scan Error 128
I have a problem I could not solve. 1994 Ford Aerostar my truck does not accelerate properly, the scan shows:
VID 20150624 235001 - YouTube ....
On my list reads. I cannot find how to solve this.
Touareg :: 2008 - CEL Comes On / P0327 And P0441 Codes
Just bough a new (to me) Touareg yesterday...2008, 75k miles, good service history. Drove home from the dealer no problems. Driving that same night (last night) the CEL comes on. Ok, I've had VWs before, CELs don't really make me panic.
Get home and scan the car and it comes back with P0327 (knock sensor 1 circuit low) and P0441 (evaporative emissions system incorrect purge flow).
I have a feeling it's got less than premium gas in it....I'm gonna throw some octane booster in the remaining 1/2 tank and see what happens. Anything else I should do?
Prius (2004-09) :: CD Indicator Giving CD Error?
Driving to work today, was changing from one CD to another with the steering wheel controls, when the current CD indicator started flashing and the error message "CD Error" appeared. Unlike other, similar threads I've seen, the CDs were all able to be ejected, reloaded, and ejected again, but will not play.
View 10 RepliesPassat (B5) :: Error Codes With Noise When Accelerating
P0302
P0301
P1545
P1300 X2
I have no clue what is wrong but I have an exhaust leak and when I am accelerating I can hear the loud shhh sound like the turbo is leaking but I still have power like normal.
Passat (B5) :: CEL On With Error Codes P0036 And P0141
So I have my CEL light on error codes are P0036 & P0141.... how do I fix it??
View 1 RepliesPrius (2001-03) :: Got These Codes P0440, P0441 And P0446?
I recently picked up a 2001 Prius to learn more about it. I've been trying to resolve the following codes: p0440, p0441, p0446. I used a new OEM gas cap & did a smoke test and smoke is coming out of the perimeter of the filler mouth and what seems to be a plastic ring with slots around the mouth.
My question is this:
1. Is this normal?
2. Does this indicate that the filler neck is bad?
3. Does this indicate that the charcoal canister is bad?
4. A bad VSV by charcoal canister?
5. Is it something else?
Accent LC (2000-05) :: CEL Fault Codes P0304 And P0441
Car - 2004 Accent auto.- 1.6l - 97K miles
After battling a few months to get my check engine light - fault code P0304 to go off I finally remedied the problem with 3 bottles/fill ups of STP Gas treatment. This was about 1500miles ago. I go to DMV Inspection station and sat for an hour then wait anther 20minutes for the test to end and was given the big fat rejection sticker, she failed because the check engine light came on with fault codes P0304 & P0441.
Now what the heck happened here? Just bad luck and coincidence or did their test set it off? Anyway the P0441 code is new and researched it is the Evaporative Emission Control System Purge Valve. Okay where is it, the HMA manual is not specific? In relation to the intake manifold where is it? Easy fix? And will this solve my P0304 code?
Camry :: P0440, P0441, P0442, P0446 Codes Detected
2003 Camry LE, 4 cyl, 165k miles – Got all of the above codes. Obviously checked gas cap and no issues there. Checked both VSV underhood and had clicking. Checked VSV at canister under vehicle and no clicking. Used a Dremel oscillating tool with flat metal blade to cut off rusted Philips head screw. Removed VSV and checked by jumpering to battery. No clicking, but did draw a tiny arc. That told me it was “trying” to actuate. Sprayed PB Blaster into hose fittings of VSV and mowed the lawn. Came back to VSV and it now actuated – but very slowly and delayed. Sprayed electrical contact cleaner in hose fittings with the VSV jumpered and open. Activated VSV several times and sprayed contact cleaner through the hose fittings several times – both directions. VSV began to active quickly. Put VSV back on vehicle. SES light went out by itself after it ran the EVAP test.
View 3 RepliesToyota - Corolla :: 2007 - Getting P0441 And P0455 Fault Codes?
I've been having P0441 & P0455 codes showing up on my 2007 Corolla CE. My code reader tells me the areas that need checked. But, I can't find the vacuum switching valve on it so that I can check it for problems. Somebody said it's under the hood, but I can't seem to locate it.
Is is possible that it's mounted on the vapor canister (which I have located above the rear axle)?
Passat (B6) :: Main Beam Not Working - MFD Error Codes For Headlights
So I have MFD display errors for "main beam not working" on both sides but both of my headlights, lows and highs both work fine. this has been like this for a few months now. I can clear the codes with my VAGCOM and after a day or two they come right back. I do have LED license plate lights but for at least a year i only got the error code on startup for the plate lights but never headlights. A little confused as to what is tripping the headlight codes
View 3 Replies