Accent RB (2012+) :: Rattling Noise At Just Over 1500 RPMs
I've got a 2012 GLS manual with about 400 miles that now has a noise that concerns me. At just over 1500 rpms there is a rattling noise that sounds like its coming from the rear and underneath the vehicle. It sounds like metal vibrating. I think it could be the exhaust but I am not sure. It didn't do it on the test drive and it is fairly intermittent.
What it could be and if it might be normal? Should I take it in and get it checked out or would that be a waste of time?
Passat (B5) :: RPMs Went Up To 1200 - 1500 At Traffic Light / Check Engine Light Came On?
I have a 2000 1.8t and I was on my way home from work, sitting at a traffic light and my rpms went up to 1200-1500 and then my check engine light came on.
View 7 RepliesAcura - Tl :: 2004 6MT Shakes Violently When RPMs Go Between 1200 And 2000
My 2004 Acura TL with 6 speed manual transmission has an issue. When the RPMs go between 1200 and 2000 the car shakes violently as if the engine isn't attached or is trying to get away. At idle it's silky smooth and after 2000 RPM it feels fine too. The gear I'm in doesn't matter and this shaking happens whether I'm standing still or driving... it just happens in the 1200-2000 RPM range. Again, this is not a small amount of vibration, I'm talking about seriously shaking the whole car.
This is what I've done so far:
1. Replaced the three engine mounts two days ago, and double checked the transmission mounts and they seem fine. At the same time my mechanic discovered a few bolts on the subframe that were loose, and we tightened those.
2. Replaced O2 sensor that was causing check engine light and it's fine now.
3. Timing belt, clutch and power steering was done by previous owner maybe 3-4 months ago.
Accent MC (2006-11) :: Right Rear Banging Or Clanging Noise
I have been hearing a rattling or maybe more a banging clanging sound coming from the right rear of my 2007 3 door accent. It almost sounds like something is loose, but I have never identified anything. The tire tools are secure and there are no loose panels either.
It almost sounds like the strut is banging around. My wife did bend the rim on the right rear a couple of years ago. I thought maybe the sway bar was broke, until I realized this car doesn't have one.
Ford Super Duty (1999-2016) :: 2005 F250 - Missing Between 1200 And 2000 RPMs
I have 2005 f250 5.4l 3v that was having miss problems between 1200 and 2000 RPMs. Changed VCT solenoids which worked, but then could hear chain hitting cover when powering down throttle on left side. Figured chain tensioner was bad, so tore down and removed timing cover. Found left chain was tighter than what seems normal, and right side had huge amount of slack. While taking off tensioner on left side, something happened to fast for me to see it, and still not sure if what happened wasn't just my imagination. I thought that the chain moved very fast for an inch or two. Anyways, I watched how to video on timing the 3v, but I am very confused about it. The left bank seems to line up on timing marks perfectly, but the right chain is off by at least 2 1/2 links. Not knowing any better, I removed three rockers on left bank (2 intakes and 1 exhaust) but only removed two intake rockers on right side. I don't know what I am doing and getting scared.
View 1 RepliesAccent LC (2000-05) :: 2002 - When Restart Car Won't Get Past About 1200 Revs
My 2002 1.5td accent starts from cold every time but if drive about half a mile then stop when i restart it wont get past about 1200 revs. i leave it for 5 mins then runs fine...
View 1 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Vibration When Accelerate Pretty Much Any Load Above 1200 RPMs
I have a 2000 f250 crew cab short bed 7.3 on a 6inch bds lift and 37 inch tires. When I accelerate pretty much any load above 1200 rpms I can feel a vibration, kinda feels like it may be coming from the front left but I'm not sure. I have heard that a wheel bearing going out can cause this, would this maybe be what's causing it?
I thought wheel bearing because it kind of sounds like there's a howl when decelerating, probably when accelerating as well but the trucks too loud and I can't hear it. or also have heard motor mount gone bad, I've also heard ujoints but the ujoints were done this summer. the front ujoint is bad but the front driveshaft shouldn't be turning when out of 4x4 and hubs unlocked.
Accent MC (2006-11) :: Engine Stuttering Between 1500 And 2500 Rpms
My 2008 Accent started to stutter between 1500 and 2500 rpms. Now the check engine light has come on, and the engine is idling rough.
View 3 RepliesSuburban :: 1999 - RPMs Shoot Up To 2000 Then Back Down To 1500 While Driving
So the other day I was driving to my storage locker about 30 miles away. All of a sudden my rpms would shoot up to 2000 rpms then back down to 1500 . Slowly they would go up higher every time. On my way back I was about 2 miles away and I lost 3rd and 4th a presume. I would be going 20-25 and it felt like it would be shifting up to third but would shift down to 2nd running 3500 rpms. I had to go 20 the rest of the time. Finally I got home and realized my dipstick tube wasn't in the tranny and must have lost oil. So I got it back in and added more. Thought it was the filter and oil so dropped the pan and replaced it. Still nothing.
View 2 RepliesToyota - Camry :: Will Not Idle / Alternator Does Not Kick In Until 1500 To 2000 RPMs
My toyota will not idle. The last time this happened, it needed a new battery. The idle is controlled by the battery. The alternator doesn't kick in untill 1500 to 2000 rpms. The battery checks out OK this time. It's an 03 4cyl.
View 5 RepliesFord F-150 - 1997-2003 :: A/C Blowing Warm Air At 1500 - 2000 RPMs - Heater Core?
We got our first taste of fall weather in Houston this weekend, and with it I've discovered a new problem with my truck. After the engine was up to temp, I noticed that the heater would blow cold air any time I sat at idle. If you rev up the rpm's to 1500-2000, you can feel the air start to get warm again. I'm guessing this means my heater core needs to be backflushed.
View 4 RepliesFord Super Duty (1999-2016) :: Missing Between 1500 And 2000 RPMs In Every Gear While Accelerating
2003 F250. 6 speed. 5.4 2v. 4x4. 165,000 miles
When purchased, there was a vacuum leak and truck ran like crap and PO drove it that way for a while. I fixed the vacuum leak, discovered a miss between 1,500 and 2,000 rpms in every gear while accelerating. No miss at idle.
The truck has:
- no CEL
- new Motorcraft spark plugs that were not dropped, bumped, or over torqued.
- new fuel filter
- new air filter
- new alternator
*The miss usually does NOT happen in the morning on the way to work after sitting 14 hours.
*The miss almost always goes away after the truck gets up to operating temp.
*The miss ALWAYS is present after work on the way home after sitting 9 hours.
Fuel pressure?
Bad COP?
Fuel Injector?
Something totally different?
Accent LC (2000-05) :: 2003 - Idle Varies Between 800 To 1500 Intermittently Within Seconds
My car is standard 5 speed transmission, when my car is running my idle varys between 800ish to 1500 intermittently within seconds and if I don't drive it after starting the car it will stall on me (in neutral) after the rpms go up and down about 9 times.
The thing I found is if I disconnect my idle air control valve attached to my throttle body it stops the jumps in rpm. I have tried replacing the valve with one of my friends control valve Hyundai accent 2004 that works and fits perfectly on his doesn't work on mine. Right now I have my idle air control valve disconnected at the moment but i want to fix this issue because my rpms are at 1300 at idle.
Ford Excursion :: 2001 V10 - Ticking Noise At 1500 RPMs
I have a 2001 v10 with about 157k miles on it. Recently (within last 2 months) I am getting a ticking noise that is pretty constant. It doesn't seem to increase with rpms and I can barely hear it with the hood open- I hear it much better with the hood closed. It seems to start about 2-3 seconds after I start the car (when fan clutch engages?) and seems to be coming from the front middle of the engine. I do not see any broken exhaust studs. I do also occasionally have a ticking noise at 1500 rpms (only at 1500 rpms- not sure if it's related or not). I made a short video- not sure if you can hear the noise.
View 8 RepliesAccent LC (2000-05) :: 2002 - Code P0121 / Idle Surging Between 1500 - 2500 Rpm
I have a 2002 Accent 1.6L 72K miles, idle surging between 1500 - 2500 rpm after stopping from 50 mph, (with Code P0121) replaced TPS - No Luck . I reset the DTS error codes, ran it with a new TPS and same exact problem, Code P0121 came back, and surging continued, this happens when I decelerate from high speed- 50 mph or so and it will not go to normal idle, surges between 1500 and 2500 rpm when in park.
If I give the throttle pedal a good kick, the problem goes away, and it idles fine, nice and smooth and at normal rpm, the DTS code will clear, and stays cleared, mil light goes out. It almost seems like something is sticking, I know its not the throttle itself because when I do a live data, the TPS shows "0", if I manually push the throttle shaft closed at the throttle body, it is fully seated shut, so I know its not a sticking cable or anything. Can a sticking MAF sensor cause this? Maybe what I'll try tomorrow is rapping the throttle body with a rubber mallet while its surging, maybe something is not returning to its normal position in there.
Dodge - Ram50 :: 2010 - Grinding Noise At 1400 - 1500 RPMs?
I have a 2010 Dodge RAM Hemi Laredo pickup. Love it. Currently 34k miles. Have kept up with all maintenance. Since about 3k miles, I have intermittently heard a "grinding" noise at about 1400-1500 rpm. Usually while accelerating going up hill/inclines. Assumed it had to do with automatic gear shifting. Have reported this to dealer maintenance folks at each visit. They have reportedly not been able to identify the source, as they claim they do not hear it, despites numerous test drives. Everyone who drives with me has heard it!. I am concerned, as at 36k my full coverage for the transmission warranty expires. Incidentally, at 33,100 miles 2 broken studs were extracted from right exhaust manifold. A new exhaust manifold gasket and 2 new studs were replaced for a different niose. Are these related, or any clue about the "grinding" that I still frequently hear at 1400-1500 rpms?
View 9 RepliesCamry :: 2003 LE 2.4 Engine Groaning Noise When Accelerate Between 1500-2500 RPMs
I have a 2003 Camry 2.4 LE with 120k miles on it. It's been very well taken care of. As of now, here is the maintenance that has been completed at my dealership. By the way, I don't trust dealerships, but I do have one nearby that is actually beyond outstanding (and I know a little about cars):
- Regular oil changes, and always with 5W-30
- Radiator flush and thermostat replacement
- Tranny flush
- New front brakes, rear brakes cleaned, and lines flushed.
- Oil pan gasket replaced
- Valve cover gasket replaced
- Spark plugs replaced (at around 105k)
So, with this information being provided, here is my current problem. Lately, as I accelerate between 1500-2500 rpms, the engine has a louder than usual (but not too loud) groaning noise. Basically, the engine just sounds a tad louder than normal along with groaning noise. The engine also feels as though it is running kind of "dry" (if that makes any sense).
Now, above 2500 rpms, it's just fine. It's amazing on the highway, but I feel as though it has slightly lost acceleration in the city. The only issue with the car is the infamous greyish/blue smoke at startup, but that rarely happens and when it does, its a small amount of smoke, and it has never affected it's performance or gas mileage. Another thing is that I had to have that dreaded oil splash guard removed, because apparently the timing chain punctured it and it was about to fall off.
This problem has been recent within the last month. Just before this, the car has been on a roundtrip to Tucson from Tulsa, and Amarillo twice, complete with 32+mpg on the highway! So, what's wrong? Serptentine belt? PCV valve? Cam or something underneath the valve cover?
Golf IV / Jetta IV :: EPC Light Has Come On - Car Will Idle At 1200 RPMs Up From 800
Recently I believe i got a tank of bad gas. Was having problems starting. Finished it off filled up used injector cleaner and dry gas to clean it out a bit more. Now as I was driving the car would basically stall out but kick back in as I was driving and the EPC light would come on. I've been reading up and most answers are a bad coil pack. I pulled them all out and checked them they all look pretty good. No codes are popping up for it a coil pack. Unless I need a specific VW model computer to check. I'm gonna check the volts on the coil packs today to see as well.
The EPC light does go off after the car sits a while. It comes back after a few miles driving. After the EPC light comes on my car will idle at 1200 RPMs up from 800 when its normal.
Phaeton :: RPMs Goes To 1200 For About 30 Seconds Then Settles To 65 On Startup
On start up (Engine cold) my rpm goes to 1200 for about 30 seconds then settles to 650, is this normal ?
View 10 Replies