Camry 2012+ :: 2013 - Metal Flakes In Oil?
Bought a 2013 Camry from local dealer last fall with just over 12k miles on it. I recently did my first oil change and there was sizable metal flakes in the oil pan. I'm not 100% positive they came out of the oil pan. I'm going to change the oil again after 5k and see what it looks like. The car is a Toyota certified vehicle.
At any rate, do you think I should take it in to Toyota and have them look at it? I just want to be covered if there is an issue with the engine later on.
Ford Transmission :: Rev Without Engaging If Overdrive Is On - Metal Sludge In Pan
I need to decide what to do with my transmission. I just acquired a 2007 F150 Supercrew 2WD 4.6L truck with 184k miles. While in Drive the automatic transmission (4R75E) runs ok thru 2nd gear and then; if O/D is on it will rev without engaging and if O/D is off it will just stay in 2nd gear.
I was hoping the problem was a broken retainer clip, as are so many others. So I removed the pan, and the valve body. All of the retainer clips seem to be fine, but, there is a lot of metal sludge on the magnet of the pan. See pic.
Should I buy a complete rebuild kit and take the tranny out of the truck? Is it just a problem with the valve body? I need to get the truck going so I can get to work. I am uneducated in the transmission department.
Ford F-150 - 1997-2003 :: 2000 - Copper Colored Flakes In Overflow Tank?
I have a 2000 expy with the 5.4 just turned over 200k. I bought the upper and lower radiator hoses awhile back and finally gotta chance to change them out. I noticed i got the wrong bottom hose so I only swapped out the top hose. I filled it back up with 1.5 gal of distilled water. After I drove it about 60 miles I checked the overflow tank and noticed copper colored flakes in it. Im assuming the previous owner put some stop leak in it but not sure Ive never had any problems as far as overheating or losing coolant. What else could it be? Im going to get the right bottom hose and do a flush. Can I use the bottom hose I have, its got the two extra hoses for the oil cooler? I was just going to connect the two hoses together but not sure if that will cause a problem.
View 1 RepliesToyota - Solara :: 2003 - Metal On Metal Sound Near Driver Side Of Engine
I have a 2003 Toyota Solara 4 cyl. auto. transmission. I recently had the head replaced. Now it is making a metal on metal sound near the drivers side of the engine. It makes the sound during idle, when I change gears, and the sound increases when I rev the engine. What could it be?
View 8 RepliesFord F-150 - 1997-2003 :: Metal On Metal Noise Coming From Rear After About 25 To 35 Mph
My father's 1997 F150 with the 4.6 two wheel drive, has me stumped again. I have a lot of mechanic knowledge but this one has got me wondering whats going on. Here is the run down. When you are driving down the road, it rides just fine and makes no noises from 0-20 MPH, after about 25 to 35 mph it makes like a metal on metal noise that is coming from the rear, and forces the truck to slow down, when you try to accelerate through this problem it has a bad bang and it wont allow you to speed up anymore, it does not seem like a brake issue (but I could be wrong) since it does not actually pull to one side or the other.
It seems like an equal force trying to stop the truck. I have heard rear ends that were going out and they make clunk noises or whirring noises etc, but its still some what driveable. I have checked the rear end oil and it does have oil in it, and its probably about an inch from the full level (but that shouldnt cause this issue im sure). My father wants a definite answer before we start tearing this thing apart to try and fix it. Since its mostly used to take trash off, and also get the kids down the dirt road to the bus stop.
Camry :: 2003 / 2.4 - Metal On Metal Sound When Driving Through A Tunnel
I have got this noise which sounds like a light skimming of metal on metal. It sounds like a roller (airport baggage) spinning. It can be heard mostly when driving next to a wall or past parked cars. I suspect it being the bearing in either the water pump, idler pulley or even alternator. The car has 330000 kms but it is serviced regularly in which all fluids have been changed over time. I just want to drive through a tunnel and not hear any non harmonic sounds coming from the front.
View 10 RepliesFord 7.3L Power Stroke (1999-2003) :: Metal-on-metal Wear Between Impeller And Water Pump Housing
I am in the process of replacing my water pump. After I removed the pump, I found quite a bit of metal-on-metal wear between the impeller and the water pump housing. Is this common?
I've been running a coolant filter on my system for years now, so hopefully its been effective at collecting some of the metal that has clearly been worn away. Either that, or this is a sign that the filter isn't working at all!
I'm a little worried that the new pump will scrape the scars left from the old pump.
Passat (B5) :: 2003 / 1.8T - Oil Sludge Building Up In The Engine
My 2003 passat 1.8T has been in and out of the shop for the past few months all for the same prob oil sludge was building up in the engine the first time around tried to avoid pulling the oil pan and just ran some flush to clean it out needless to say that didn't work so i had to have my mech pull the oil pan and clean up the mess...... even though this is a known issue that vw is well aware of the refuse to fix the prob unless u have all of your oil change receipts which I do not have because i have my stepfather change my oil I now know that I need to run full synthetic in it......
View 24 RepliesCamry :: 2003 - How To Remove Gunk And Sludge From Engine
My 2003 camry had black oil when I bought the car. I flushed the engine with motor flush two times. Very dark oil came out both times. But when I did third time oil was clear.
I do not have any oil pan or valve cover leak. Do I need to drop the oil pan to clean the gunk if there any?Do I have to clean the oil pick up also?
If the oil is dirty and black does it mean gunk built up in oil pan and oil pick up strainer?
I peeped through the valve cover but I did not see any gunk in the cylinder head.
Camry :: 2003 With Sludge 3mz-fe - Check Engine And Oil Indicators Came On
My wife has a 2003 Camry LE with the 3mz-fe V6. First, from what I have seen, these engines appeared in 2004 models, but that's what's in it. Anyway, she doesn't take care of her car and the other night the check engine and oil indicators came on. Having been through this with a VW Passat (known sludge engine) myself, I immediately suspected a sludge issue. The next day, I had a mechanic come over and check it. He pulled one of the valve covers and sure enough, there was sludge everywhere, some of the oil journals completely occluded.
So, the question is what to do? As I said, I've been through this myself. When it first happened, I had to have main bearings replaced and they flushed the motor well enough to get normal oil pressure. It wasn't 3 months before the same thing happened. They flushed it again enough to get the oil pressure back to normal and I got rid of it that weekend. I know flushing the Camry could solve the problem, but could just as easily push sludge into other parts of the engine and give me a nice deja-vu. The other options are to have the motor rebuilt or buy a used motor. The car has 80K on it so I'm thinking a remanufactured engine.
Toyota - Yaris :: Peeling Off Of White Flakes
there is peeling off of white flakes, mostly on top of the car. what is this? what to do?
View 2 RepliesPrius (Gen 3) :: Metallic Flakes In Engine Oil After Wide Open Throttle
I've been using full synthetic 0W-20 oil since it was new(2010 Prius. It is an early build). Last time I had an oil change was about a year and a half ago, oil has 8,000 miles on it. I ran the car hard today at wide open throttle around town. Never driven this way for the past 68,000 miles/5 years. All fluid levels are normal. When I went to check the oil dipstick after running the car at WOT a few times, I noticed a few flakes on the dip stick. Nothing big, just a 1-2 flakes very small flakes every time I reinsert the dip stick. Flakes are about the size of a single dust particle. It's 86 degrees out, which supposedly 0W-20 should protect the engine.
View 19 RepliesHonda - Accord :: 2003 - Excessive Oil Consumption
I bought this car off the showroom floor with about 1,200 miles on it. Since just past 70,000 miles or so, this car has been using more and more oil between changes. It now appears to be up to about 1 quart per thousand miles, maybe just 800 miles. I don't see any sign of a leak. There now are 201,000 miles on this engine. The V-tech solenoid had to be replaced about 30,000 miles back. Timing chain has never been replaced; nothing else major has been repaired. Last new PCV valve was put in about 30,000 miles back. It didn't seem to slow down oil consumption. This oil problem is the only problem with this car, except for the V-tec before, and some rattles. Otherwise it is as reliable as any car I've ever owned, and I've been around a while.
I've read many blogs and other web pages on this, and it's a common problem with this particular Honda engine. Is there any chance that this oil usage is something besides worn piston rings? Some people seem to think it might be worn valve seals, and/or worn camshaft seals? how expensive is that to get fixed? If it's any of these things, is there really any practical solution other than a new engine, or maybe a rebuilt?
Short of thousands of $ in repair costs, would a different type of oil reduce oil consumption? I read some people saying to stay away from synthetic (why would that matter?); some talk about oil treatments; one honda service manager says he puts good old STP in a high mileage, Honda, he owns. I tried that with this car, just one application, and I didn't notice any drop in consumption, but I drive a LOT, in all types of conditions, so I don't know that I gave it a real chance to work. In such an old engine, if I experiment with these, is there any chance of doing further damage to the engine? For that matter, would switching to 5W-30 or maybe a 10-weight, possibly slow down this excessive oil usage? I really don't want to buy a new car.
Lexus GX 2004-09 :: 2008 AC Vents Spitting Out Charcoal Like Flakes / White Dust And Fibers
My AC vents have charcoal like flakes (disintegrate if you rub your fingers together) in addition to white powdery dust and fibers coming out of them. I have had the car to the dealership 3 times. The first time they replaced the drivers side left vent (claimed deterioration of the vent) - the second time they sent it back with nothing and the third time they replaced the evaporator coil. I'm still having issues with this material coming out - I've had the car for about a year and half and really don't want to get rid of it!
View 4 RepliesPrius (2010-12) :: Metal On Metal Grinding Noise At High Speed Above 75mph?
I commute 180 miles a day, 6 days a week. I noticed metal on metal grinding noise(more noticeable) at high speed above 75mph especially on asphalt road. I'm sure noise is there at low speed but not enough to notice. My car has 50,000 miles. Tires? Electric motor?
View 7 RepliesSonata NF (2006-10) :: 2007 - Metal On Metal Sound When Turned Right - Wheel Bearing?
I have a 2007 hyundai sonata, this car is my daily driver. I put 180 miles on it a day around trip. Currently has 180,200 miles on it. Last Friday on my trip home when i turned right I heard a metal on metal sound. I slowed down went straight and it went away. Talked to a few people and I think it may be the wheel bearing. Even if I hit a road reflector it starts up. It's the front left wheel. Get on the breaks it goes away.
So my question is... Wheel bearing??? And can I replace the whole hub and fix the problem or do I have to try and press the bearing out?
Sonata NF (2006-10) :: Metal Hitting Metal Noise From Front Driver Side
I got some coilovers installed last night, they are ksports. i have them on fairly low height as of now but i have noticed every time I hit bumps, I hear a kthunk (metal hitting metal noise) from my front driver side. is it from the coilover nuts itself or something wrong with my control arm? the sound ONLY comes from the front DRIVER side.
View 4 RepliesFord Super Duty (1999-2016) :: Metal On Metal Ticking Sound
I thought i heard this yesterday when i left work but i was tired and said its in my head, THEN i go to leave right now and sure enough its a real sound, you can hear it very well through the front grill and then if you turn the volume up you can hear a ticking sound ever half a second or so, it also speeds up when i was pulling on the throttle cable. And after the truck fully warms up it goes away.......
View 14 RepliesFord F-150 (2009-2014) :: 2011 - Grinding And Metal-on-metal Contact In Front
I replace my brake pads and rotors in the fall of 2015 with EBC parts. Now almost 13,000 miles later, I started hearing grinding and metal-on-metal contact in the front. So I went out and got PowerStop pads to replace the EBC (EBC had way too much brake dust). I took off the front wheels and noticed that the DF pads had about 1/32 left on them, ok I guess its time to change them out. Onto the PF pads, I find that there is almost no material left, in fact I could scrap off what was left of the material. I decided to do a rotation while I am at it and noticed that the rear brake pads on both sides look like I never used them!! Is it really that possible to have 2 stuck calipers, both on the rear at the same time?
View 2 Replies