Prius (2010-12) :: Burning Rubber Smell After Short Bursts Of Wide Open Throttle
Sometimes you have to put pedal to the metal to pass slowpokes blocking 2 line roads (I'm talking city/suburb driving here). but, i noticed that the smell follows. first couple of times, i thought it was coming from some other car, but this time, I realized it was me.
No, it's not burning tire due to the insane acceleration (not in this car). What else could be? should i worry about the car bursting in flames?
Ford F-150 (2009-2014) :: 2010 - Engine Running At Wide Open Throttle With No Input From Pedal?
I got in a work truck yesterday, sat down, put my seat belt on and started the truck. Just as I did that another employee drove by and waved, all I could do was nod back at him because my hand was still starting the truck. This took my attention away for a split second, then as I put the truck in gear, my foot still on the brake, I noticed that the tachometer was pegged and the engine was racing. I instinctively pushed harder on the brake pedal, then looked down to be sure that I was pushing on the brake pedal and I was. Right then then rear of the truck started shaking violently and as fast as I could I turned the key off and put it back in park. This all happened in about 1 second, maybe 2.
The shaking was caused by the sheared off driveshaft. And it was sheared off because the center section of the rear differential had broken the spot welds that hold it and place and rotated on the axel housings. It is now pointing upward towards the bed of the truck. Have a drive by wire truck run the engine at wide open throttle with no input from the pedal? 2010 F150 4.6L...
Camry 2012+ :: SE V6 - Strong Smell Of Sulfur At Wide Open Throttle
Experience a strong smell when WOT? Seems like every time I put my foot down hard through a couple of gears it stinks for a few minutes. The car only has 28000km, fresh oil change and running great.
View 5 RepliesLexus GS 2006-11 :: 2010 - Rumbling Noise When Accelerate From Dead Stop With Wide Open Throttle
So of course the dealership isn't going to diagnose this since "the car's not supposed to be driven that way" - but I get a nasty rumbling noise when I accelerate from a dead stop with wide open throttle. It only lasts for the first few thousand RPMs in first gear, and after that it is gone.
I was guessing that it might be the transfer case or something like that, but it's really hard to tell. I do have AWD. I did not have any such problem in my previous GS, which was a 2007 (current is a 2010). It's worse when I accelerate around a corner, and it also makes a small noise when I'm going above 80ish mph, which of course the dealership isn't going to diagnose either.
Golf VI R :: When Wide Open Sputters A Bit
this has just started recently. when ever i am wide open the car sputters a bit when at the top of the rpm range say 4,000 and above. this one has really got me scratching my head... list of upgrades are dual port blow off valve set to atmospheric, 3 inch downpipe back to the stock mufflers with no cats and the neu speed reflash.
View 9 RepliesPassat (B5) :: Turbo Spooling Wide Open Upon Start
Every time I start my passat after it sits for more than 4 or 5 hours (overnight, workday) it sounds like the turbo is winding up at full rpm for about 10 secs. and then stops. It only happens on cold starts. I've had it in two shops with no luck what so ever.
View 8 RepliesFord F-150 (2009-2014) :: Bed Seams Wide Open
I noticed today all the seams in my bed are wide open, no seam sealer was put in them before it was painted! Are they all like this or was mine not finished properly? Check your beds. I can see daylight and the ground at all the seams!
View 14 RepliesGolf IV / Jetta IV :: 2003 - EPC Light Came On And Gas Is Stuck Wide Open
Today I was leaving my buddys house when I got in my car it started fine then I let off the brake and the epc light came on and the gas is stuck wide open unless I have my foot on the brake unplugged the plug that goes to the gas pedal and it was fine but the epc light was still on plugged it back in and the same thnig so i put my gas pedal on my buddy jetta and it worked fine on his car. Its a 1.8t jetta 03 wolfsburg edition 119000miles
View 2 RepliesLexus GS 2006-11 :: Left Front Axle Boot Is Torn Wide Open
I have an 06 gs300 awd. My left front axle boot is torn wide open. I've called multiple parts stores, looked online. And I can't seem to find one anywhere but the dealer. I have found one for gs350. So my question is will that one work in my gs300? What is the part number from the dealer is different between 06 and 07?
View 5 RepliesHonda - Cr-v :: How To Get Throttle Plate Open To Clean Throttle Body
2006 Honda CRV, throttle by wire. How can you get the throttle plate open to clean the throttle body etc.
View 4 RepliesSanta FE SM (2001-06) :: Check Engine Light Came On - Code For Throttle Position Open
My check engine light came on the other day and the code stated the the "throttle position is open" so after researching and everyone telling me that i need to change the sensor. I did everything after was fine running better but today only after 3 days replacing it i get the same problems. car has no get up and go hardly can push to 20 mph and when in idle i press the break it starts to bog down and almost want to shut off! and can be really loud...
Santa fe 05' 3.5L ....
Prius (2004-09) :: Metallic Noise At The Top Of Engine When It Is Engaged
Our 04 Prius makes a really scary metallic noise at the top of the engine when it is engaged. All maintenance has been performed within 100 miles of the warning light. We are the original owners and the car has 160k miles. No pulleys are touching their surroundings. Make no mistake, this a LOUD noise that has been growing with time. No warning lights,,,oil level is fine,,,and no metal visible on the dipstick. Sound is originating at the top of the engine and is not a "knock". It is more of a metal on metal type of noise.
View 4 RepliesPrius V :: Engine Ping (rattling Metallic Sound) Under Load
When accelerating up a steep grade the engine will ping (rattling metallic sound) when reaching a certain RPM, but stop pinging as I continue to push the accelerator down and increase the RPM. Should I be concerned? Could it be something else, loose exhaust heat shield or something? Or is this normal behavior for a gasoline engine? My old Honda Fit never had engine ping/knock that i can recall in its 200,000km of service running the same 87 octane gas.
View 15 RepliesPrius (Gen 3) :: Wide Wear And Shallower Bars After Rotating OEM
I just rotated the OEM Ecopia tires at near 40,000 miles. They still have some life left (5000-10,000 miles). I noticed that there are wide wear bars and I'm 1-2 mm from reaching those, but there are also other narrower and shallower bars. Is this wet or snow type of indicator?
There are arrowheads next to the real wear bars and not next to the smaller ones, so they are not really wear bars.
Ford Super Duty (1999-2016) :: Extra Metallic Rubbing Sound When Letting Off The Throttle
Got some snow tonight and was driving home from work around 35-40 mph in 4x4. You can tell that everything is engaged by the feeling and noise. Just not sure if this is abnormal. When letting off the throttle there's an extra metallic rubbing sound that goes with the drivetrain speed. Not sure if I'm just hearing the driveshaft from being in 4x4 of if something is up?
View 14 RepliesFord Excursion :: Freaking Heat Shield - Nasty Metallic Sound On Throttle And Making Left Hand Turns
I got a heat shield that just will not stop causing me grief. When I installed the headers and pipes I had a heat shield that was too close to the passenger side pipes. I bent it down some to clear the pipe and got rid of a nasty metallic sound I had on the throttle and making left hand turns. Well that little sound returned last week and I crawled under and looked and sure enough the heat shield was touching again.
Who knows why maybe a bit a spring sag. So yesterday I bent it down a little more. Today I start getting a nasty clunk on dips and especially when on a bump why turning. I crawl under there too look and find the same heat shield now has a huge gouge on the under side of it where the leaf spring near the rear bushing is smacking it. I'm sure Ford put it there for a good reason so hate to remove it.
First pic of the hacked up bend job I put on it.
Second pic of the gouge in the bottom of it where it's hitting.
Toyota - Yaris :: Peeling Off Of White Flakes
there is peeling off of white flakes, mostly on top of the car. what is this? what to do?
View 2 RepliesCamry 2012+ :: 2013 - Metal Flakes In Oil?
Bought a 2013 Camry from local dealer last fall with just over 12k miles on it. I recently did my first oil change and there was sizable metal flakes in the oil pan. I'm not 100% positive they came out of the oil pan. I'm going to change the oil again after 5k and see what it looks like. The car is a Toyota certified vehicle.
At any rate, do you think I should take it in to Toyota and have them look at it? I just want to be covered if there is an issue with the engine later on.
Camry :: Throttle Body Valve Was Stuck Open
About, one month ago my car shut off while driving(pretty scary at the time). I pulled of the road and attempted to start it again. Everything looked good there, but as I was making my way home from work it started to act funny. It would not acknowledge me depressing the accelerator. When I got home, I ate supper, then went to have a look.
The car would turn on, but not acknowledge me pressing the accelerator at all, It did however go up to 30 mph at a snails pace as if it was coasting down a hill. I plugged in my code reader, and it read that the Throttle Body Valve was stuck open. I took it off and tore into to it a bit. I noticed the gears inside the TB itself were corroded and the butterfly valve was locked up.
I replaced the part, and tried to turn my car on with the new TB. All the dash lights are in working order, however upon turning the ignition to crank the engine, the whole car system shuts down. No lights no nothing, besides the car door open sound. The car will remain like this regardless of the key position until I have reset the batter(take off the terminals and put them back on) to which the process repeats itself.
The code reader says no codes are stored because I obviously reset the battery. So now am at a standstill.I believe the old TB froze up, because I had to run in through 3 ft standing water during a storm, and then deployed shortly after(I'm in the service) for a few months while letting the car sit.