Honda - Accord :: Metal On Metal Contact When Turn Steering Wheel / Front Left Pad Sticks When Braking
Honda Accord 2005 ... Just bought a new used car. All seems ok, but I have two problems.
(1) when not moving, i have slop in the steering and I can hear metal on metal contact when I turn the steering wheel. I pulled the tire and with basically no force I can move the rotor back and forth by hand. what it is and how to fix it?
(2) when braking, it appears that the front left pad sticks. Pads are not excessively worn down. Can't figure out how to get to the caliper pins ( thought they might be sticking).
Could the two be related?
Ford - Taurus :: Metal On Metal Grinding Noise While Failing To Start Up
I have an '02 Taurus. For the last year or so it has intermittently produced a metal on metal grinding noise while failing to start up. I'm told this is due to teeth being missing on the flywheel between the starter and the transmission. It's taken as many as six tries to get the car going. But the car has always started in the end.
My questions are: Is the problem flywheel worth replacing at this point at this price? Is it likely to fail totally any time soon?
Also, might the March '09 replacement starter be implicated?
Ford F-150 (2004-2008) :: Intermittent Metal On Metal Grinding Noise
I have intermittent metal on metal grinding noise. Seems to happen when I am at highway speed. Seems to go away when I put it on 4 wheel drive or slow way down. On one occasion though, the grinding noise did not stop even after putting on 4 wheel drive - had to stop completely before it went away (did not come back after I drove off again). Diagnostics so far....
Unhooked the vacuum lines on passenger side actuator and hooked up vacuum gauge. Vacuum held at 20 psi and drops and raises slightly as the truck is being revved. Takes about 10 seconds for vacuum to drop to zero once truck is stopped. Putting it on 4 wheel drive drops it to zero immediately. Exact same scenario on the passenger side.
This leads me to believe my IWE solenoid is ok. So also my check valves. Next opportunity I get, I will raise one wheel, remove the vacuum line on that wheel and apply vacuum with my pump. Want to see if it will turn my half shaft.
2004 F150 FX4 ....
Prius (2010-12) :: Metal On Metal Grinding Noise At High Speed Above 75mph?
I commute 180 miles a day, 6 days a week. I noticed metal on metal grinding noise(more noticeable) at high speed above 75mph especially on asphalt road. I'm sure noise is there at low speed but not enough to notice. My car has 50,000 miles. Tires? Electric motor?
View 7 RepliesPrius (2010-12) :: Light Metal On Metal Grinding Noise
I have a 2011 Prius with about 32K miles on it. I've been hearing light metal on metal grinding noise for a few days now. So I decided to take it to a stealership and they told me my ceramic pads and brake rotors both need to be replaced for all 4 wheels. I thought Prius brakes don't need to be replaced for 100K miles.
View 7 RepliesGolf V R32 :: Clunking / Metal On Metal Grinding Sound
This morning on my way to work, pulling into the parking lot around 20mph. I hear a metal on metal grinding noise. (almost to the sound of a muffler dragging on the ground type noise). Then that disappears for a bit, hear a loud metal clunk then some high pitched sound. All within say 30 seconds. Definitely coming from the back, but can not tell from which side.
Things I've checked in the parking lot:
Nothing hanging low, exhaust seems in-tact
It doesn't look like the brake shields behind the rotors are bent or touching
Sounds still happening if on or off brakes , on or off throttle.
It seemed to happen only at lower speeds. Disappeared once I got up to 50mph
Just took it out for a drive, that loud metal clunk happened when I put it into reverse, drove around, no other sounds. I just don't have a warm fuzzy feeling that this will just disappear.
Ford Super Duty (1999-2016) :: Metal On Metal Noise From Front End
What we have is a 2011 F-350 with the ambulance package (obviously) and it has started making a very annoying sound from the front end. It has been into two different Ford Dealerships and they have not been able to remedy this issue. What happens is, when we are backing and turning, the front end makes a bad metal on metal grinding noise. When going straight down the road no issue just turning while backing. I know this is an ambulance and has the ambulance package but I think from the cab forward should just be all ford right?
View 2 RepliesSonata I45 (YF - 2011+) :: Metal On Metal Sound When Approach Stop Sign
My 2011 2.4l Sonata made a metal on metal sound suddenly the other day. About 4 days ago, I drove about 2 hours away from where I live, Mostly highway, about 80mph to a go kart race. Got out of the car for a while and came back in and was pulling away to run the store and as i started to approach the first stop sign maybe 500-600 ft from where i was parked, i heard a bad metal on metal sound, came to a complete stop at the sign and it stopped. Went back to the race after driving to the store about 5 miles away.
Got in the car to leave and same thing, just to the stop sign 500-600ft away. Drove home like i said mostly highway, and didn't hear a thing. Today, about 4 days later, I drove to Chicago O'hare airport, about 30min away, and it was fine the whole way there. However on the way back, after about 20-25min, I heard it again. So I came to complete stop as I was forced to by a traffic light as I was taking my exit off the highway, and It started making that sound again. So i came to a complete stop at the light and started moving again when it turned green and couldn't heard a thing.
Lexus IS 2014+ :: Metal On Metal Noise Coming From The Rear?
When driving in my parking garage, I can hear a slight metal on metal noise. An extreme example would be sharpening a knife on a sharpener, its not as loud or predominate.
-I've checked the lugs, they are secure.
Car has springs and spacers.
Honda - Accord :: 2009 - Metal On Metal Noise When Driving
My 2009 Accord is making a metal on metal noise when I drive. It's not all the time, probably about 1/3 of the time or so, and only when I'm accelerating/cruising, not braking. It's very loud, and when I took it to a mechanic they just took it for a ride, didn't hear anything, and told me to come back when it's more consistent. What it could be? I'm nervous even taking it out now.
View 7 RepliesSonata NF (2006-10) :: Metal Hitting Metal Noise From Front Driver Side
I got some coilovers installed last night, they are ksports. i have them on fairly low height as of now but i have noticed every time I hit bumps, I hear a kthunk (metal hitting metal noise) from my front driver side. is it from the coilover nuts itself or something wrong with my control arm? the sound ONLY comes from the front DRIVER side.
View 4 RepliesPrius C :: Front Steering Wheel Thunk Like Metal On Metal
I have a question about my C Four with 16" wheels. When the steering wheel goes all the way to a stop there is a thunk that feels like metal on metal. It is like there is no rubber bump stops. If this is normal. I am used to cars that have a nice cushioned bump at the steering limits.
View 1 RepliesSonata I45 (YF - 2011+) :: Metal Grinding Noise When Braking?
My car is making metal grinding noise when coming to a slow stop when you are stuck on traffic or going into your driveway. You can hear the sound and feel the sound.
I had this issue a year go and i took it to the dealer and they told me that i need to replace my rotors and my front brake pads.
A year later the noise came back and they told me that i need to replace my pads. I replaced my front break pads and a month later the noise is back. I went back and checked my pads and the pads were still new.
I only hear the sound when braking after driving in a heavy traffic or on a stop and go traffic. I don't hear the sound when i start to drive or driving in a non traffic condition.
Ford F-150 (2009-2014) :: Bed Sounded Like The Metal Was Cracking
I had a couple people in the bed of my new F150 SCrew with the 5.5 ft. bed and it sounded like the metal was cracking as they walked around in the bed. Is that normal? It didn't sound good.
View 7 RepliesFord F-150 (2009-2014) :: Sound Like Two Metal Parts Unbinding Under Pressure
When turned left to lock. Sounds like two metal parts unbinding under pressure. Truck had 3600 miles on it and 2" leveling kit. Retorqued everything,still there.
View 2 RepliesLexus SC300 :: 1993 - Sharp Metal Contact In The Left Rear When Suspension Begins To Load
I have a 1993 Lexus SC 300 and have met all maint milestones. Recently had both rear shocks replaced and am getting a SHARP metal contact in the left rear when the suspension begins to load. Mechanic spent afternoon looking in shock mount, trunk, spare, jack, spare and antenna mast-can't find it. New tires. New rear brakes-told me that was it. Still there.
View 2 RepliesGolf V R32 :: Occasional Metal Grinding Noise Coming From Front Driver Side
A year ago I heard occasional metal grinding noise coming from the front, sounding like front driver side. Sounded like CV joints that I heard before. The mechanic said it's transfer case/transmission problem, so I replaced the transmission but the noise came back a few days later. The mechanic said to drive it for a while and the noise may go away, if getting worse he can fix it since it has 2-year warranty.
Now a year later the noise becomes predicable and easily reproducible, I went back and asked them to check. They said it may be passenger side axle. I am feeling being manipulated.
Buick - Regal :: 2003 - Front Left Wheel Metal Grinding When Turning?
Car : 03 Buick Regal
Recent Repairs : Installed new brakes, rotors, and bearings a month ago
Problems/Symptoms:
1. When going forward grinding noise ONLY when turning wheel to the right, becomes a tad louder when applying brake.
2. When going reverse cannot turn at all without hearing an AWFUL grinding noise and the tire seizing up.
3. Front left rotor (where noise is coming from) is beginning to wear heavily on the upper-outside portion in a 2" band.
Possible Solution that I thought of:The metal brake pad clip is somehow bent/not installed right so it is grinding on the rotor.
Why Can't I Check Right Now : Do not have hydraulic jack currently to get my car up. Waiting until Friday.
Today, I took the car to the shop today and they actually found that my sway bar needs to be replaced, but unfortunately they did not open up the brakes to check out the grinding noise. So when I left, I got to thinking about the brake pad clip.
Ford Super Duty (1999-2016) :: Metal On Metal Ticking Sound
I thought i heard this yesterday when i left work but i was tired and said its in my head, THEN i go to leave right now and sure enough its a real sound, you can hear it very well through the front grill and then if you turn the volume up you can hear a ticking sound ever half a second or so, it also speeds up when i was pulling on the throttle cable. And after the truck fully warms up it goes away.......
View 14 Replies