Ford F-150 (2004-2008) :: Ground Wire Rear ABS Speed Sensor?
So when it rains sometimes my ABS will go off till I drive it down the road a bit... Where is the location of the ground wire for this thing? I've checked up under it and no wires are cut or burnt... just wonder where this thing grounds to... if I can find that I may be able to clean it and fix the sensor.... because something makes me believe the sensor isn't bad, because some times it works for a half mile or so... before it goes back on.
View 6 RepliesCherokee :: Color Of O2 Sensor Wire That Goes To The Computer?
In my 1999 Jeep Cherokee, with a 4.0L inline 6, I need to find the color of the wiring harness wire from the pre-catalytic convertor oxygen sensor. I think it's the black with dark green strip, but I have found conflicting information on the internet and in my Haynes book.
View 4 RepliesPrius (Gen 2) :: 2001 - Transaxle MG1 Sensor Wire Position?
I'm still trying to get my project 2001 Prius to attempt to start the ICE. I can drive the car around electric only, so MG2 is OK. I see a pulse of current going to MG1 as it does it's startup tests. So I'm thinking maybe the MG1 position sensor is faulty. Where on the transaxle the MG1 position sensor wire is located?
View 9 RepliesGolf/GTI VI :: Get Tyre Pressure Sensor Wire Through Firewall?
Trying, to retrofit the TPMS 'clearing' button for the system that uses ABS. Easy enough to fit the button, but need to run a wire to the ABS module. Took out the glovebox/cubby hole hoping it would reveal where the main wireharness goes through the firewall, but there is a big plastic unit behind the glovebox. It would have made life easier as the ABS is right in front of the glovebox but guess I'll need to take another route.
View 2 RepliesCamry :: 2008 - Squirrels Eating Wire Connected To Sensor?
I have a 2008 XLE Camry. I have/had problems with squirrels eating wiring in my vehicles. I checked my Camry the other day and noticed the wires were eaten off a sensor.
The damaged connector is behind the engine cover and located on the left side of the black plastic cover directly behind the engine cover.
The connector is white plastic, has two thin wires black and black/white. This connector is attached to a large yellowish nylon base on the end of this black plastic cover between the engine cover and firewall.
What is the purpose of this connector. Everything works on the car although gas mileage dropped off about 2, which could be attributed to this winter blend ethonol.
Ford - Explorer :: 2001 - Oxygen Sensor Wire Harness?
I have a 2001 ford explorer sport and realized that the oxygen sensor on the passenger side behind the cat was unplugged from the harness.
I am unable to find the harness and dont know where its supposed to go.
I would like to get this fixed right away but can not find a diagram anywhere, or a manual...
Golf IV / Jetta IV :: 2005 - O2 Sensor Wire Disappears Above The Heat Shield
Didn't touch the downpipe during engine swap of my BEW TDI.
After swap, have code:
17524 - Oxygen (Lambda) Sensor Heating; B1 S1
P1116 - 000 - Open Circuit
The O2 sensor wire disappears above the heat shield above the exhaust. I am used to (Audi 1.8T, 2.7T, 2.8) seeing the O2 sensors coming up with plug on firewall.
Where is the O2 sensor wire going to.
I normally by the generic Bosch O2 if the SENSOR is bad (cut and splice), but suspect that maybe the problem (open circuit) is further 'upstream'.
Obviously, I am a TDI (and Golf/transverse engine) newbie, so bear with me.
Ford 7.3L Power Stroke (1999-2003) :: No ABS Sensor Wire On The Front?
I have an new to me 1999 4x4 F350 that I was giving a good once over today on the front end since it wanders a little bit. but anyways I didnt see a abs sensor wire on the front. the plugs are there behind the inner fender well and it looks like there is a plug when the sensor should go in the wheel bearing. was 2 wheel abs an option on these trucks? is there anything else this changes front end wise?
View 14 RepliesFord Ranger / B-Series :: 2000 - Wire Color For Engine Temp Sensor?
I need to know what the wire colors are for a engine temperature sensor connector (2-wire) are and the correct wiring diagram to get the temperature gauge to work again
View 1 RepliesGolf IV R32 :: Cam Position Sensor Or Engine Speed Sensor?
I took the car out for a little spin about 8 miles. We where about .5 of a mile from the house and there is a section where you have to stop on a little bit of a hill. I stalled the car due to the new Dm clutch then headed to the house and the car started to run like crap. I hooked up VAGCOM and had this code:
17748.P1340 camshaft position sensor-G40/ Engine speed sensor-G28: incorrect allocation(#1)
I swapped out the 2 cam position sensors and cleared the code and started the car and it still ran like crap. I just happen to have a new Cam position sensor(hall sensor) so I swapped it out in both cam positions one at a time and cleared the code and the car still runs like crap.
Is there a way to check(test) with vagcom to see if its one of the engine speed sensors?
Dodge - Intrepid :: 1996 - Throttle Position Sensor Signal Wire Producing Voltage
Background: Check engine light indicated a problem with the throttle position sensor (unfortunately, don't have the exact code). The TPS on my model ('96 Dodge Intrepid 3.3L) is the non-adjustable type. There are three wires going to the TPS -- a power source, a signal wire, and a ground. The TPS acts as a potentiometer and depending on the throttle position, sends a voltage signal down the signal wire to the computer.
Here's my question/issue: After disconnecting the TPS, I tested the three wires with a multimeter. Power source (5V) and ground were fine. But I'm getting a voltage reading of about 4.35V on the signal wire. It's my understanding that with the TPS disconnected, I shouldn't be getting any voltage on that wire. Does that sound correct? If so, what would be causing me to get a voltage reading there? I'm assuming some type of problems with the wires, maybe an exposed wire on the signal wire somewhere?
Prius (2010-12) :: Loose Wire Symptom After Speed Bumps
Saturday, I parked the car and tried to lock the doors with the fob. The car held a constant beep but would not lock the doors. They locked fine from the driver's door.
Later as I was going over a speed bump, the car bleeped, the cabin light came on and off, and the display showed 'key found' in a period of 10 seconds. This speed bump anomaly happened twice later that day. Dark, I want to wait until dawn before getting serious into the debug.
My first thought is a loose ground wire or 12V connector. The last work was the brake accumulator recall. If the technician did not torque down the ground connector, there would be high resistance leading to the key fob lock problem as well as the speed bump triggered reset.
I also have a miniVCI so before doing any work, I'll use it to look for error codes. There are more than one connector that could be loose and having the codes could give us a clue if it happens again.
Lumina :: Identifying A Tube / Hose?
There is a tube/hose going from the air intake duct to the rocker arm cover.
I need to replace it but don't know what it's called to look it up.
Volvo :: Identifying A Tube Around The Motor?
1991 Volvo 740 Turbo
200K miles
I was examining EGR valve and found a huge crack on a tube that stems out from the head of the EGR valve and goes into the EGR vacuum controller. I need to find out what this tube with steel core is called so that I could order new one at a dealer. Or can I get this from Autozone or Pepboys too?
[URL]
Lexus ES 2007-12 :: Identifying A Rogue Headlamp?
scavenged this awesome Lexus Headlamp whilest scrappin with gahbage in a junk pile clean up job The problem is.. I cant identify it. I googled just about every 'model' number on the back.. no go.
Looks like the 2005-2009 ES 450 Headlamps on ebay,( except its got a light tan color on the back) and different shape that leaves it resembling something Matel might have molded esecial up for a Milenium Falcon Lifesize model Redux, (minus Harrison Ford in a speedo).where to pull a number off this thing?
Prius Plug-in 2012-15 :: Identifying Bumper Parts For Replacement?
Yesterday I came home for 20 minute stop. I parked with my front end sticking out of the garage.. Big Mistake! My 10 year old daughter sees the garage open and hits the button to close the garage door and walks away. Worst part is! I could hear the door closing from inside the house and could not get outside fast enough!
I've spent the last 24hrs trying to find replacement parts on the net and all I have obtained is more confusion. Is it all one assembly or am I looking for multiple part numbers??
Camry :: 2006 4 Cylinder / Identifying Power Steering Hose Part Number?
I have a 2006 Camry 4 cylinder. The bigger rubber hose coming out from the power steering fluid reservoir has been leaking for quite some time now. I've tried putting a second clamp on it which has worked but hasn't stopped the leak completely. As far as I understand, the big hose has a certain bend to it so I can't just get any rubber hose from an auto parts store and chug it in.
It is leaking all over the nearby surface:
I need to identify the part number for that power steering rubber hose so that I can replace it once and for all. Once the power steering fluid leaks out, my steering starts groaning whenever I turn it.
Suburban :: 96 - Location Of Speed Sensor
I need figuring out the speed sensor on my 96 ,k1500 series,5.7,4*4,automatic.. Where is it located...
View 1 RepliesCelica :: Speed Sensor Removal
I have removed the 12mm bolt and disconnected the speed sensor. The problem is that the speed sensor will not come out of the transmission. Is there a pin or something else that needs to be done to remove this speed sensor?
View 3 Replies