Passat (B6) :: 2007 - P0171 / P0507 And Multiple Misfire Codes From All Cylinders
2007 Passat 2.0T ... I just purchased this vehicle and after about two weeks of driving it has gone bananas. I found a ton of oil in the spark plug holes, and installed a new valve cover gasket...It no longer leaks. I am getting P0171, P0507 codes and multiple misfire codes from all cylinders...
View 6 RepliesGolf V R32 :: MAF Or Battery Related Codes P0068 / P0101?
Got a CEL a couple days ago and had it scanned by the dealer. Threw two codes:
p0068 - throttle position correlation
p0101 - mass or volume air flow circuit range performance intermittent
The dealer thought the MAF was dying or dead. I replaced it with a Bosch one from ECS Tuning this afternoon. I went for a test drive around the block but it seems that the problem persists. The idling seems rough, almost like there is a misfire or something. Perhaps on a related note I am still running the original battery that came with the car. I asked the dealer about the battery when they checked the MAF and they said the voltage was low and they recommended replacing it before winter. Is it possible that the battery is dying and it's throwing these two codes?
The service manager said to drive it a few days to see if the CEL clears itself or have it cleared (they can do it or I can do it via borrowing someone's VCDS). I'm tempted to just go and get another battery tonight and install it and see if that's the problem.
Golf/GTI VI :: CEL After Intake Install - Codes P0101 And P150A
Installed Forge Twintake on my GTI, CBFA engine code. Have had it installed for 2 weeks now, it was running funny ever since, idling was weird and every time I shifted I felt it through the clutch. Throttle response and acceleration was fine though. Yesterday driving to work the CEL came on, I scanned it today and got P0101 MAF VAF and got P150A idle speed control. I was thinking about cleaning the MAF sensor to see if that was the problem but it doesn't seem like that would solve the problem of it running weird. Was also considering reinstalling the stock intake and seeing how it ran then and or if the CEL went off.
View 6 RepliesGolf IV / Jetta IV :: Car Won't Go Into Boost, 2 Error Codes Detected
I was having an issue with my car not going into boost so I plugged my code reader in and it had 2 codes 1 was p1200 n249 malfunction and the other was diverter valve malfunction so I did the quick easy one and got a new factory diverter valve but it still doesn't go into boost and still reads p1200 n249 what do I need to replace or should I do the n249 bypass it's a bone stock jetta 5 speed.
View 5 RepliesGolf IV / Jetta IV :: CEL Is On Throwing 3 Codes - P0171 / P2637 And P0420
What I need to do to fix these codes
p0171 system too lean bank 1
p2637 torque management
p0420 ...
GTI 337/20th Anniversary :: After Installation Of Intake Getting Codes 16485 / P0101
I am having an issue after my intake install, it was working fine all day and last night i get a light on the dash bored (looks like the one when you take off the esp) and I get this:
code 16485 Mass Air Flow Sensor (G70) Implausible Signal : P0101
Static - No
What could be the cause of this because i ran this intake before no issues I only took it off and put the stock intake back in due to the rain but now since the rain is gone i decided to switch
Golf VI R :: Engine Error Codes - Random / Multiple Cylinder Misfire Detected
I recently found these codes. My car is APR 1+. The car seems to run fine so I'm not sure what is going on. I changed the plugs at ~60K miles and now have 72K miles.
Address 01: Engine (CRZ) Labels: 06F-907-115-CDL.clb
Part No SW: 5K0 907 115 M HW: 8P0 907 115 B
Component: 2.0l R4/4V TFSI 0020
Revision: 5BH20--- Serial number:
Coding: 0403010A180F0160
[Code] ....
Golf IV / Jetta IV :: Codes For Random Misfire And Small EVAP Leak Detected
Okay, so a few weeks ago, my tire blew out on the freeway. Of course my spare wasn't in there and when I got one I couldn't get the lugs loosened. My 4way was too big on all sides. It was late, I am a single mother of two young kids so I had no choice but to drive slowly to get it off the freeway. The next morning I came back fully prepared, got my car in to get a new tire. I have been driving with ONE code for my CEL, but at the shop (where I use to work) I used the scanner and it threw 5 codes.
P0300 Random misfire
P0442 Small EVAP leak detected (this one was already there)
P0420 Catalyst system below threshold bank 1
P0301 Misfire cyl 1
P0303 Misfire cyl 3
My beautiful love is an 02 Jetta 2.0 4 Cyl. Now, since 4 of these codes popped up AFTER my first blowout (I turn 30 next month, knock on wood)
Did driving my car at 5 mph about a mile and a half (everywhere up until the gas station was NO PARKING) do something to my car? All of a sudden, any in town driving ESP IDLING makes my check engine light blink and my car has no power I just have to pull over wherever I am. I checked the car out myself on the side of the road and my cat was glowing. After this I do not drive my car.
So, what should I do. I did a tune up. Should I replace the 02 sensors then the cat?
Saturn - Sl :: 2002 - SES Light Has Been On Constantly - Codes P0172 / P0300 And P0507
Saturn 2002 SL1 5-speed. My SES light has been on constantly for about a year (was intermittent before that) with the codes P0172, P0300 and P0507. The car also idle high (2500+) occasionally at stops. My mechanic said it is likely an intake gasket but would need a full diagnostic to determine and that is not a safety hazard to drive but that I am getting less mph. I can't afford to fix it now but I have an emission test due. Is there a way to turn to light in the mean time?
View 1 RepliesGolf/GTI VI :: CEL On With Code P0101 After Apr K04 Upgrade
So i recently upgraded to a apr k04 from a apr stage2 tune and I'm getting a P0101 CEL. I've triple checked all my piping, and sensors, everything is nice and tight. I did however install the turbo with a GFB DV+ using the spring. Do you guys think the fact that the spring in the DV+ holds an amount air in the intercooler that it's throwing off the readings with the MAP and causing that CEL? I was going to give it a week or so and maybe see if the ECU can adjust itself enough to the DV+ and hopefully solve the problem. If not then i guess ill check for more leaks, but i doubt there is any. Boost holds real good throughout the whole rpm range...
View 3 RepliesGolf/GTI VI :: RPM Needle Going Up And Down Nonstop - Code P0101
I started my a while ago and the rpm needle was going up and down non stop and the car was jumping a slight bit, I plug it into my scanner and got code P0101 what does this mean...
View 7 RepliesPhaeton :: What These Codes Mean P0171 And P0174
So the check engline light came on, and i hooked up a basic OBD II reader to the car. Out came codes P0171 and P0174 and it read "system too lean (bank 1)" and (bank 2) respectively. What does they mean?
View 4 RepliesPassat (B6) :: CEL Comes On / Codes P0441 And P0171
So one day when I was driving, the CEL comes on, and then I go to autozone to get my free diagnosis. I got codes: P0441 and P0171
My engine is running fine and everything else seems to be in order. However, I have to get a new canister purge valve and new oxygen sensors, in order to be in the clear.
For the Oxygen sensors, I have AN IDEA of where they're located; somewhere underneath the car, by the catalytic converter (the converter is in between the two connectors, apparently). I have yet to do this and would like some opinions on what to do for it.
For the Canister Purge Valve, I have no clue where to look. I pop open the hood and I notice a diagram with labels. Great, but there are just too many other pieces to look at...I do not know if it is visible as soon as I pop open the hood, or if I have to dig deeper, or even if I have to remove the fancy plastic thing that covers the engine.
Phaeton :: 2007 - VCDS Codes Detected
I tested my new VCDS today a HEX-USB+CAN. I got CAN: Not Ready. But that's impossible.
My guess is that the OBD2 interface I got is faulty.
Camry :: 2008 LE V6 - CEL And Codes P0174 P0171
I just did an oil change at my vocational school on my grandpas car, 2008 LE V6. On the way back it threw a CEL. Codes are listed in the title. Now googling those codes i found info on other car manufacturers i.e ford, dodge etc.. But i found nothing in regards to a gen 6 camry. It seems like this code has something to do with the engine running lean. Bank 1 and bank 2. What could cause these codes and what could be a possible remedy. P0174 and P0171 were both pending and setting a cel don't know if maybe they were pending before i did the oil change.
View 14 RepliesFord - Taurus :: Keep Getting Codes P0171 And P0174
I have a 1996 ford taurus lx dohc v6 3.0.. I keep getting codes p0171 & p0174 System Too Lean (Bank 1 and bank 2. I check for air links and i did not find any..I never got that code tell i replace the MAF sensor..
View 7 RepliesVenture :: DTC P1860, 0758, 755, 740 Error Codes Detected
My van stumbling upon acceleration. Well now I am getting the following codes and the van barely has enough power to move. The codes are: P1860 Enhanced: Tcc Pulse width modulation sol ckt electrical, P0758 Shift sol B ckt electrical, PO755 Shift Sol B malfunction, PO740 TCC ckt malfunction
View 7 RepliesPrius (2004-09) :: Triangle Of Death Came On, No Codes Detected
2005 with 123,000 miles. I have owned for a few thousand miles. Car was dealer maintained at every recommended interval. Car runs perfect.
After car sat for a week or so, I drove it and the red triangle popped up along with PROBLEM statement and take to immediately to dealer symbol. Red Triangle and other warnings repeats every once in awhile - will go a day without, and then will come on and off within a couple miles. Car continues to run fine. There are no other check engine lights. I have checked all the fluids and they are fine.
The battery charges fine, and holds the charge overnight. I have a generic code reader and there are no codes. I have read other posts, and there are always problems that seem to come with the Triangle. Gas mileage is fine as well.
Passat (B5) :: List Of Codes Detected / 9 Faults Found
Have a 2000 Passat V6 5spd. Recently ran the codes, and this is what I came up with under engine.
9 Faults Found:
17833 - EVAP Purge Valve (N80): Short to Ground
P1425 - 35-10 - - - Intermittent
17880 - EVAP Leak Detection Pump: Short to Ground
P1472 - 35-10 - - - Intermittent
17843 - Secondary Air Pump Relay (J299): Short to Ground
P1435 - 35-10 - - - Intermittent
17938 - Camshaft Timing Adjustment: Short to Ground
P1530 - 35-10 - - - Intermittent
17829 - Secondary Air Injection Solenoid Valve (N112): Short to Ground
P1421 - 35-10 - - - Intermittent
17923 - Intake Manifold Valve (N156): Short to Ground
P1515 - 35-10 - - - Intermittent
17529 - Oxygen (Lambda) Sensor Heating Circuit: B2 S2: Short to Ground
P1121 - 35-10 - - - Intermittent
17525 - Oxygen (Lambda) Sensor Heating Circuit: B1 S2: Short to Ground
P1117 - 35-10 - - - Intermittent
16486 - Mass Air Flow Sensor (G70): Signal too Low
P0102 - 35-10 - - - Intermittent
Readiness: 0000 0000
Do these components share a common ground, or connector, I imagine it is a simple fix. just wiggle fuse, or ecu connector?