Passat (B6) :: Oil Leak Under The Hood Around The Front Of Valve Cover
Well I popped the hood to clean my air filter and noticed that the top of the engine looked to sprayed with oil mainly on/around the front of the valve cover. I haven't really "investigated" to see where its coming from. Where it may be coming from!! It has 32,XXX miles and auto.
View 4 RepliesGolf IV / Jetta IV :: Jacked Up The Car But Front Wheel Didn't Lift At All
Feel this is a bit stupid, but whatever. I was jacking up the front wheel of the car today on the pinch welds (one part of it got super bent) and while the jack was almost maxed out, my front wheel didn't go anywhere. I must've had almost a foot gap between the wheel and the fender..
Took some pictures of where I jacked, and the suspension/wheel of the car. What it could've been or how I'm supposed to properly lift it so the wheel comes up?
can see the pics here: [URL].....
Volvo - 940 :: Coolant Leak Near Firewall
Back again, with the 1994-ish Volvo 940 with many miles on it.
Symptoms reported by son: coolant leak near firewall (radiator hoses replaced a few weeks ago); maybe some pressure in cooling system; some oily stuff in the coolant in the radiator.
Shop's diagnosis: transmission cooler leaking. (Well at least it's not the head gasket!)
Recommend : Replace radiator, cap (sure), thermostat (all right, but we get rid of this car in six weeks), and ... flush the transmission (alarm!).
Usual advice is drain and refill tranny, rather than flush. However, seems to me that with high risk of coolant in trans fluid, flush is the right action.
Golf IV R32 :: Wheel Is Hard To Rotate When Car Is On The Lift - Front Caliper Piston Size?
One of the caliper does not fully retract when I don't push the brake, the wheel is hard to rotate when the car is on the lift.
I pretty sure it is the square ring the problem.
I know that those square ring worth only a couple of bucks.
Ford Excursion :: A/C Line Leak Coming From Near The Firewall
Trying to get the a/c working on the EX. Tried to pull a vacuum and heard a leak coming from near the firewall. After a closer look I could see the larger line was rubbing against the rear head stud. That line is a hard to remove and replace. So if you have a studded 6.0, take time to look at your lines to make sure they have proper clearance.
View 1 RepliesFord Super Duty (1999-2016) :: 2008 - Hood Won't Stay Up - Lift Cylinders?
I got to replace mine because the hood won't stay up on it's own and is heavy to lift. I was wondering if these things fail often. Mine is an '08.
View 5 RepliesSanta FE SM (2001-06) :: Power Steering Leak - Wetness Is Closer To The Firewall
My 2001 Santa Fe had a slow PS leak for over a year which I dealt with just by adding fluid several times a year. Then I let the car sit for a few months while I saved up for input/output sensors. I just replaced those and discovered that the PS leak is noticeably worse.
I searched the forums and found that the most common problem is a clogged reservoir screen, resulting in fluid backup that sprays the engine bay. I don't think that's the problem. The engine bay is dry and both reservoir hoses are dry. The spot where I've found the most wetness is closer to the firewall and much lower than the reservoir but I need identifying it.
Ford Super Duty (1999-2016) :: 2004 - Loud Rattle Under The Hood When Lift Off The Accelerator Pedal
I bought a 2004 F250 super duty 4x4 with the 6.0 a couple weeks ago and have a few questions. Hopefully all of these things are normal, but I thought I would ask you experienced drivers.
1) Occasionally while driving when I lift off the accelerator pedal I can hear a sort of loud rattle under the hood. I assume this is the turbo shutting down? Is that normal?
2) 4x4 and locking hubs... I have the 4x4 hi and low switch on the dash. Do I need to also manually lock the hubs to go into 4x4? After reading the manual it seems like I can just turn the dash switch and they should automatically lock, but I'm not sure. The hubs are not marked, but going by the pictures in the manual I think I know which is "lock" and which position is "auto" or off.
3) Front wheels hop at full turn. I expected wheel hop in 4x4 or with the hubs locked, but even in 2WD with the hubs in the auto position the tires still "hop" or knock a bit at sharp turns. Is this normal?
Golf IV R32 :: Front Suspension Becoming Loose At Mounting Points Under Hood
So I have had my coilovers in for a little less than 2 months now and i have been noticing that my front suspension is becoming loose at the mounting points under hood and needs to be re-tightened periodically. I will say that unfortunately i have to drive in and out of some steep inclines and funny angles where it puts the car into tripod mode regularly. I'm not rubbing anywhere (fenders or bumpers) upon entry or exit but I am very low and really getting every bit of movement out of each corner, lots of creaking and popping (all from front, rears are fine) until tightened then its quiet again, but it all comes back after 3 or 4 days. I haven't tried driving for a week without hitting the steep inclines so I'm not sure if this is even the reason. But its the only thing that i can think of.
View 10 RepliesFord Brakes/Suspension :: 1994 F150 - Possible To Lift Truck 6 Inches Only Using Lift Blocks?
I have a 1994 Black Ford F150 and i was wondering if i could lift the truck 6 inches only using lift blocks (or any other cheap way to get my truck off the ground)....
View 2 RepliesGolf/GTI VI :: Get Tyre Pressure Sensor Wire Through Firewall?
Trying, to retrofit the TPMS 'clearing' button for the system that uses ABS. Easy enough to fit the button, but need to run a wire to the ABS module. Took out the glovebox/cubby hole hoping it would reveal where the main wireharness goes through the firewall, but there is a big plastic unit behind the glovebox. It would have made life easier as the ABS is right in front of the glovebox but guess I'll need to take another route.
View 2 RepliesGolf IV / Jetta IV :: Hood Latch Broken / Any Way To Pop The Hood?
The latch thing that you pull on to pop the hood has broken, any other way to open the hood up?
View 24 RepliesFord Excursion :: Max Lift With Stock Front And Rear Drivelines?
I know 4" is still good, as that is what my 05 had. Just curious about my 00. Locally a guy is selling a pair of fab tech 5.5" front leaf springs. Just curious if I went that high if the stock drivelines would survive? We do not have a driveline shop on the island, so I would like to go as high as I can, without modding the drivelines. If 4" is all, that's fine. Just curious!
View 14 RepliesFord F-150 (2004-2008) :: 2005 - Torsion Bar Adjustment To Lift Front End
I wanted to put bigger tires on my truck, something more agressive. Is there a torsion bar? Can it be adjusted? How? If not what is the biggest tire i can put on with my stock 17" rims? 2wd 2005 f150...
View 2 RepliesFord F-150 (2004-2008) :: 2006 - Lift Or Leveling Kit For Front And Back?
I'm not too familiar with the difference between lift kits and leveling kits. I want to lift my truck 2" but in doing research do i need get a lift kit and a leveling kit? For the front and the back? I have a 2006 F150 4.6 V8 RWD I also haven't been able to find any good places to but the kits (also because I don't know what all i may need) It would be ideal to get a kit i can bolt on myself.
View 1 RepliesGolf IV / Jetta IV :: 2003 - Buzzing Noise Coming From Driver Side Lower Firewall Area?
A months or so ago, after turning off my car I noticed a loud buzzing noise coming from the drivers-side lower firewall area. I cranked the car up and the buzzing stopped immediately. The problem began as intermittent but now within 2 minutes of turning my car the buzzing noise always starts, and runs my battery dead! I have taken my car to 2 local shops that have good reputations and they both began guessing and throwing parts at the problem to no avail my last resort is a dealership but it is 100 miles away and I'm not sure if they would do any better. I feel like this is something simple that an expert should have no problem diagnosing.
I have been searching around the internet and never seem to find someone with the exact same problem - until today!
[URL]
Ford Super Duty (1999-2016) :: Front Drive Shaft Angle After Lift
I finally got my lift installed the other day from PMF. My question is how do I get my pinion angle corrected on the front drive shaft? I know Trevor sells a Tcase clocking adapter may have to go that route IDK Unlike the rear there's only so much pitch you can put on the front axle until it causes issues with steering. I was thinking of going with an aftermarket front drive shaft designed to handle harsher angles.
I live in the mountains and after installing the lift and pulling a trailer on some of theses steeper gravel roads I can feel a harshness or something coming from under to front of the truck. I'm unable to post pics since I'm back on the road but I can visually see the front drive shaft angle is definitely not in line like it was.
I'm currently running PMF 2.5 alpha with a 1'' spacer and 3 link kit up front and 5'' progressive leafs and traction bars out back. I was able to fix my rear shaft angle using shims on my carrier bearing ( not really a big fan having 1 1/2'' of stacked shims BTW ) ....
Ford Excursion :: Back End Lower Than Front And Drops Dramatically While Towing - Spring Swap On A Lift
So this may be a really dumb question, but here goes. I have a new to me 2001 v10 gas 4x4 ex. It has obviously been lifted in the past. The springs seem totally shot as the back end is quite a bit lower than the front and drops dramatically while towing. I am adding a helwig and have a wd hitch but have not set it up yet. So my question is can i do the spring swap? It would seem that i would need to address whatever changes are made from the stock ride but im not sure. I like the current lift and would be fine keeping it and adding the lift from the new springs.
View 14 RepliesFord Super Duty (1999-2016) :: Where To Put Jack Stands When Installing Front Lift Shackles
When installing front lift shackles, do you place jack stands under the axle, or the frame? I can't really find an answer. I assumed the axle, but i saw a thread and from what i could see it looked like it was supported at the frame and the axle was hanging free in the air. Just want to be sure before i start unbolting the stock shackles tomorrow and kill myself.
View 14 Replies