Golf/GTI VII :: Harder To Shift From Neutral?
I have 1500m on my 6m and all of a sudden it feels like it take more effort to move the shifter from neutral to hear and vice versa. Specially first gear but the others as well.
View 12 RepliesFord - Ranger :: 1996 - Clutch Won't Depress
1996 Ford Ranger 4-Cyl. 90,000 miles. 5 speed manual transmission. When the truck is driven 10-15 miles and heats up the clutch will seize in the up position. Once the engine is turned off then it can't be turned back on because the clutch won't depress. After the truck has completely cooled down the clutch and the transmission again work fine, as long as I keep any use under about 10 miles.
View 6 RepliesSubaru - Outback :: Whining Noise When Depress The Clutch Pedal
I've got a 2008 Subaru Outback with a 5-speed standard, 50K on it. Lately, when I depress the clutch pedal, it makes a whining noise, in any gear or even in neutral. It goes away when I release the pedal. But it also stops making the noise when the engine warms up. That's the part that confuses me.
View 4 RepliesAccent MC (2006-11) :: Brake Pedal Won't Depress - Seized Clutch Bearing
2007 Accent pedal won't depress. Bearing making noise for a few months. Is tranny snout toast or is it fixable?
View 2 RepliesFord Ranger / B-Series :: 1997 - Clutch Pedal Hard And Could Not Depress It
This is unusual. After driving into town for new tires, the clutch pedal was hard and I could not depress it after the tire tech parked the truck. It did finally depress with a pop, though the pedal functioned there after the clutch did not function properly.
At times it seemed to be ok at other times it seemed weak. I stopped by Autozone and checked the fluid, seemed low and I added some. Continued home not completely confident that I would make it. Had to make one stop along the way.
Once again the clutch pedal was stuck at the top and would not depress. I finally slid the safety switch up the clutch shaft to start the truck, when the engine started the pedal depressed. I was able to continue home but the clutch is not functioning properly.
Cadillac - Deville :: 1999 Won't Shift Into Gear When Depress Gas Pedal
I have a 1999 Cadillac Deville. when you start the car, it must warm up and then a signal appears on the dashboard that says to depress brake pedal and shift into gear. HOWEVER, after the message appears and I depress the brake pedal, it still will not shift. Now I have the world's largest paperweight sitting in my driveway, because I cannot even get it to a repair facility. What is wrong, How do I fix it?
View 1 RepliesImpala - Chevrolet :: 2008 - Interlock Shift Button Would Not Depress
I have a 2008 Impala that has been having interlock shift issues for about a week. The interlock shift button would not depress. I was able to remove the center console and take a look at some of the wiring. It there's a bundle of wires and there is a black wire that appears to be severed. From what I've read, this is a common problem with the Impala models from 2006 through 2008...it should have been a recall, but for some reason was not. How can I do a low-cost DIY repair on this that's going to be solid and prevent recurring problems?
View 3 RepliesNissan :: 1997 - Growling Noise When Depress The Clutch Pedal With Engine Running
For a little wile now, I have had a growling noise when I depress the clutch pedal with the engine running. It mostly does it when the truck is cold and goes away after a few uses but was getting worse and taking longer to go away. The transmission shifts normally, the clutch operates normally and it does not make the noise if I put the transmission in neutral and let the clutch out. So I'm thinking dry throw out bearing.
I did an oil change Monday, and while it was up on the ramps, I decided to check the transmission oil level, I mean its got a 181k on it so its about time to check, right. Bone dry. I put about 2 qts of gear oil in the transmission that the service manual says has a 4 1/4 pint capacity. I took it out for a drive today and the noise is gone. Go figure.
I only drive the truck one or two times a week, sometimes less so in a couple of weeks I will check the transmission again for a leak, but there was no sign of a leak when I was under there Monday. But is still shifts smoothly, makes no noise.
GTI 337/20th Anniversary :: Clutch Pedal Is Soft At First And Then Gets Harder
I keep finding air every time i bleed my clutch. I am not losing fluid but i can not figure out whats causing my problems. The pedal is soft at first and then gets harder and it sometimes needs pumped before i change gears or to even get into gear. I am afraid its the slave but i also just may have air in the system.
View 8 RepliesGolf VI R :: Clutch Malfunction - Hard To Shift In / Out
Today, driving the car around town it was suddenly really hard to shift in/out of first when the car was stopped. Driving, no problem at all. Then within the ~15-minute drive, it got progressively worse.
Got the car home, checked and noticed that my HPA short shifter was wearing out (the splines), so I threw on the stock piece and figured everything would be ok... not the case. Here's what's going on:
- When the car is off, I can shift through all gears easily (and into the proper gears as far as I can see.. which tells me that shifter alignment should also be fine)
- When the car is off, and (for example) I have the car in 1st - I can let off the ebrake and the car doesn't roll (it's in gear), when I press the clutch, it will roll
- When the car is RUNNING, I can't shift in/out of any gears at all. This morning it was just really tough, and it was actually easier if I didn't have the clutch pedal all the way to the floor.. but now I can't at all if the car is running
- No signs of anything leaking under the car
- The car is APR Stg 3 and I have about 50k miles on a stage 2 clutch. Prior to this, I didn't notice any slipping, weird noises when shifting, etc.
Sound like either master/slave clutch cylinder? Or more like a clutch issue itself?
Golf IV / Jetta IV :: Clutch Never Came Back Up When Trying To Shift
So i was driving and I went to shift and my clutch never came back up. Long story short after searching the forums i think it might be my slave cylinder and throwout bearing. There was a puddle of fluid under the car.
I was planning on using this DIY : [URL] ....
Just wondering if all i have to do is follow this up to step 48 and replace the throwout bearing and slave cylinder.
Saturn - Sl :: 2002 - Transmission Failure / Progressively Getting Harder To Shift
I have a 2002 Saturn SL with nearly 170,000 miles on it, but the manual transmission has gone seriously wrong... I was driving today and I noticed that it was progressively getting harder and harder to shift. By the middle of the afternoon I was strong arming it. Yanking it into as well as out of gear. By around early evening I could no longer get it into gear at all. I was at a stop sign when this happened and ended up stuck there. Now here's the weird part: When I shut off the car the shifter would slide right into gear. In fact, it would go into all of the gears no problem. As soon as I started the car back up I couldn't get it into gear. So what ended up happening is that I put the trans in gear then started it and limped it home in 2nd.
View 6 RepliesCamry :: 2011 - Shift Lever Harder To Move Than Normal And Would Not Go Into Drive
I had something unusual happen recently... I backed out the driveway and went to put the car in drive and found the shift lever harder to move than normal and it wouldn't go into drive. It would go into park and reverse easily enough. After some manipulation it went into drive and ran with no problems to my destination. At first, I thought something fell down into the mechanism and was causing it to bind. AND of course, when I showed it to a pal, I could not recreate the issue. The next morning it worked fine, but it happened again later in the day, but it took much longer to get it into drive.
On the way home, the check engine and traction control lights both came on. I dropped it off at my mechanics and he diagnosed error code C1201 P0705 and claims that the remote starter (shop installed after market) is interfering with the transmission control module. I contacted the installer of the starter and he says it is not possible, but I know something is wrong... Now, I can't get it to act up and the idiot lights are gone. I need to rely on my vehicle and can't afford to be stranded somewhere. I feel it would be pointless to take the car to the installer, since the warning lights are gone and there are no shifting issues now.
Golf IV R32 :: Whine Sound When Press The Clutch To Shift At High RPM
My R is stock. When I accelerate hard and shift, I can hear like a whine noise when I press the clutch to shift.
Its like something continue to spin fast when I press the clutch at high rpm.
Golf/GTI VI :: High Revving When Shift Into Neutral Or Push In The Clutch
I just brought my gti in for the 20K oil change etc... I have noticed something weird... when I accelerate hard or have been driving for a while, and then shift into neutral or push in the clutch, the engine revs up to almost 2K, then back down to 1K once or twice, then finally settles to 700rpm's. It doesn't do it cold, or when I have the AC running.
I have no CEL's, and the dealer just said they ran a fault check, and it was clear. I do have an APR exhaust and a K&N intake (I think stage1 tune)... I asked about the PCV valve, and they said that would throw a code... They said they could do additional diagnostics out of warranty, since they think it has to be part of my aftermarket stuff.
I don't know if it's related, but if I really jump on it, in 5th gear or so, I can hear the car losing a little rpm's then around 4K just for a second, then it's goes back to normal... This only happened once or twice, so maybe it was just in my head...
Ford Transmission :: 1989 F350 - Harder To Shift / Grinding Noise Like It Doesn't Want To Go In Gear
I have a 1989 F-350 7.3 IDI with a ZF-5 trans. Lately, I noticed that it was a little harder to shift my truck through gears while driving than it normally is, and when I'm stopped and try shifting into first gear or something it like vibrates and makes like a grinding noise like it doesn't want to go in gear. For a while, I've also had to push on the clutch very hard in order for it to I guess hit the linkage and start, but I never had problems shifting until lately.
Today though, I went to start my truck, I pushed on the clutch as hard as I could, and the switch would not engage so I couldn't start it. So, I guess the switch was farther to link than the pedal could possibly go. I went under the dashboard and engaged it by hand then it started. I drove home and the shifting was still iffy. How can I make the switch engage normally again so its closer I guess and so I don't have to push so damn hard on the clutch to get it to start? And could the switch linkage have anything to do with the shifting being funky lately, or could that only be the clutch itself?
Camry 2012+ :: Harder Acceleration With Harder Push On Brake
I normally drive my 2010 Prius. But I have been driving my wife's 2012 Camry XLE the last couple of days. (My Prius was clean and hers was not.
Well twice in the last two days I started her car and put it in drive to find it was accelerating uncontrollably! The harder I pushed on the brake the harder it accelerated.
After taking my foot off of the brake I discovered that my size 13 EEE shoe was on both the brake AND the accelerator.
Now knowing this, the same thing happened the second day! Luckily They both happened in parking lots and NO damage was incurred!
This has never happened in my 10 Prius or my 08 Prius. maybe the pedals are not as close or the Prius's low end power was not noticeable.
It would be ironic if all the BS over the floor mats came down to big feet or improperly placed pedals. My feet have been the same size for 50 years and many cars and NEVER had this occur before.
Golf/GTI VI :: 2012 - Spongy Brakes / Pedal Taking Longer To Depress Before Stopping
I've got a '12 GTI (bought 10/1/12) with just over 20k miles on it. Everything on the car is stock and original - pads, rotors, calipers - and the brake fluid hasn't been flushed yet. The last few months I've noticed an increasing sponginess to the brakes, the pedal taking longer to depress before I feel significant stopping.
Pads and rotors still look good. Fluid level's normal. At best it feels like maybe some air pockets might've worked into the fluid lines. At worst it feels like maybe a leaky master cylinder. I'm wondering if it's a common problem.
Golf IV / Jetta IV :: 2001 - Brake Pedal Engages At Normal Depress Spot Then Depresses More?
2001 2.0
251,xxx km
Noticed here lately that my brake pedal is depressing further, and can go to the floor if I press it hard enough.
If I press the pedal quick (panic stop) it engages quickly and in the correct spot (I can feel the front tires almost lock up) then it depresses more almost to the floor. the brakes still work perfect however.
What should I try first?
I use my hand brake, and have pumped the brakes and pulled the handbrake to set the rear pistons in place.
I replaced the two rear calipers about a year and a half ago and bled them obviously. Have not bled the front brakes and will do that, but was just looking for more insight, and common problems, vacuum leak, etc.
Reservoir is full as well, and no brake line leaks that I know of.