Golf IV R32 :: Rattling Sound Like A Heat Shield
I have a major rattling sound from under my car... it sounds exactly like a heat shield. I have been up under my car 5 times and I can not find a loose shield anywhere. the cat insulator mesh is still in perfect condition and it now seems the sounds is coming from somewhere in the back of the car, perhaps the muffler area.
This car does have the flapper mod done... could there be something inside the muffler itself? the car only has 40k on the ODO and I have not hit anything or do not have a dented muffler. As a fellow VW'er I do not want to be the only one running around town rattling...
Golf IV R32 :: Rattling From Under Car - Heat Shield Continually Loosens
Looking for a cure for a heat shield that continually loosens, and causes a annoying rattle? I have been up under the car and re-tightened the suspected shield a couple times, the screw that holds the clip is not damaged, and the clip itself is not damaged... and on top of it all, I can never quite get that clip on tight enough to stop the rattle all together. is there a tool to get it tighter? i use micro needle nose pliers that fit and tighten it that way.
View 24 RepliesGolf/GTI VI :: Scrapping Sound Coming From Underside Of Car?
I drive my golf maybe 180-250Km everyday, and there are countless areas where something could occur but for about a month now I am hearing a strange sound coming from where I suppose the suspension would be, (I don't know for sure because I am in the car when I hear it) but its happening when i go over speed bumps, even going less than 10kph.... and when ever i hit a crappy road with a lot of potholes and bumps. it sounds like a scraping noise of like maybe the shock absorber or something along those lines. I would go to VW but the dealer in my area likes to void warranties, and is very difficult in giving away things for free/cheap. it getting consistently louder and is starting to worry me. should i be worried or is it a simple fix?
View 3 RepliesGTI 337/20th Anniversary :: Exhaust Rattling Against The Heat Shield
I have a 42 DD tb exhaust. And so far I've used a 3" exhaust clamp over the last hanger (after the muffler) which raised the exhaust all the way up against the heatshield, eliminating the rattle over the rear axle beam. But the exhaust was rattling against the heatshield.
So I bought 15 ft of exhaust wrap and wrapped the section that comes in contact with the heatshield. It worked a bit but it still rattles a little! I hate this rattling! How to get rid of the rattling? Should I just use more exhaust wrap?
Corolla / Matrix 2009-13 :: Rattling Catalytic Converter Heat Shield?
Got a rattle from the car, I think it's the catalytic converter heat shield. Looking for any pictures of what it looks like? I don't know if it is a full cover on our Toyota's, or a half cover. I will post a picture of what mine looks like now that it is rattling later today. Hoping it's an easy fix.
2009 Corolla CE 1.8L.
Golf IV / Jetta IV :: 1999 - Rattling Noise Comes From The Front Center Of Underside Of Car
My 99 Jetta is rattling. The noise comes from the front center of the underside of the car. It started out only when I was accelerating and would disappear when in neutral or after reaching 40mph. Now its when its idling and driving at any speeds under 40mph (I think it just gets drowned out above that speed). I looked under the car and saw that there might be a piece causing the noise but I can't figure out what it is. It seems to be in-line with the exhaust system and its a metal, cylinder looking piece that has uniform holes in it. I'm just trying to figure out what is causing the noise, if I can fix it easily or if this is going to be a pretty expensive fix. (It has 165k miles on it, is a 2.1 gas engine with the new body type).
View 1 RepliesGTI 337/20th Anniversary :: Loud And Annoying Rattle Coming From Heat Shield
Recently I have gotten a very loud and annoying rattle coming from my heat shield I think. I jacked the car up and tried to locate where the issue was but that wasn't successful. Do I need the heat shield by the muffler? And do you think it could be my cat rattling?
View 14 RepliesGolf VI R :: Heat Shield Noise After TBE Installation
Ordered my TBE couple of weeks ago, installed last week. I have been running the 100 octane tune for an entire week. Decided a couple of days ago to put it back to stock to see the difference. When I was running the 100 oct, I was pretty much on it the whole time. When I went back to stock I noticed some heat shield noise so I took it back to have them take a look. While on the lift I noticed a lot of soot in three different places.
View 19 RepliesGolf/GTI VI :: Noise During Acceleration - Heat Shield?
I have what I think is a heat shield rattling at around 2500-2700 rpm. or maybe not? It's not that noticeable but it's driving me mad
Is there a more simple answer that it could be? Keep in mind I claim very very little mechanical knowledge.
I am going to my dealer tomorrow for something unrelated and I kinda want to get a head start when I go to talk to the service dudes.
Golf VI R :: Heat Shield For Rear Of Engine?
I can't recall whos makes them. What are our options? I have the VMR intake if that matters.
View 16 RepliesGolf VI R :: How To Install Intake Heat Shield
I have a CTS Turbo intake and have recently purchased a heatshield. It did not come with instructions. I tried installing it this weekend and it was a no go. I'm assuming the pieces for the factory engine cover in the rear is what the heatshield needs to replace to bolt on. I couldn't get those off for the life of me.
View 5 RepliesSanta Fe (DM - 2013+) :: Hissing Sound Coming From Underside Of Vehicle
I have a 2016 SFS 2.0T.
For the past week or so, I've been noticing a hissing sound coming from underneath the car near the front driver side area.
It almost sounds like air being let out of a tire. It only happens when the car is turned on, and the sound is there when the car is in park or in gear.
Not noticing any change when driving the car.
Golf IV R32 :: Catalytic Converter - Heat Shield Rattle
The catalytic converter shield is tack welded on the front end but free on the rear end. There was originally some braided wire packing at the rear to keep the shield from rattling against the pipes. Mine was deteriorated and had been damaged, I think, when I sustained some oil pan damage last summer -- big jolt to the system when running over a muffler on the highway.
The fix is simple. Bought a foot of 3/16" braided stainless steel cable. I used about 8 inches and layed in the lower bead line on the catalytic converter shield (see picture below). You can see a bit of the cable thru the gap in the upper/lower shield on the left side. (1/4" cable would be a better fit, but this will work for a long time.) Cost: $1.84
The local VW parts man dug out an exploded drawing of the system but it showed NO parts or packing for this problem.
Golf IV R32 :: Heat Shield Rattle Noise In 4th Gear
I am very mechanically inclined and up until now I can usually hear a noise and know exactly what the problem is, given enough time to listen..
The best I can describe the noise I am hearing, sounds like a cross between heat shield rattle or a syncro somehow stretched out and is loosely spinning around once in gear.. Hard to explain, but all gears shift perfectly..clutch was replaced at 102K and I am currently at 130K. Also I might be crazy but it sounds like I am starting to hear the noise in 3rd as well. I would post a sound clip, but its so faint it doesn't show up on my iphone..
The reason I am throwing it out there, is because half of the seriously trusted mechanics I know say it sounds like a bearing in the tranny going out, the other half, (3 of 6) can't even hear what I am talking about but its there.
Lexus RX 2010-15 :: 2011 RX350 - Rattling Sound Coming From Inside Glove Compartment
I have a 2011 RX350 and recently noticed rattling sound coming from inside the glove compartment.
I think it comes from the plastic cover of the aircon filter at the back of the glove compartment. This cover seems bit loose even when installed back properly and the vibration (especially when driving over uneven roads) is causing the rattling sound.
I know it's a minor problem but the rattling sound can get irritating at times. My temporary fix is to push back the heavy owner's manual on that cover to prevent vibration.
Ford Excursion :: 2000 - Ticking Sound Coming From Underside / U-Joints?
Yesterday morning taking off out of my driveway I heard a ticking sound. Kinda metal on metal sounding. It sounds like middle of truck underside. Only on acceleration. It does also clunk at times or ping when I put it in gear.is this u joints? Hopefully not rear end. Its a 2000 limited ex. with the v10.
View 7 RepliesFord Excursion :: Freaking Heat Shield - Nasty Metallic Sound On Throttle And Making Left Hand Turns
I got a heat shield that just will not stop causing me grief. When I installed the headers and pipes I had a heat shield that was too close to the passenger side pipes. I bent it down some to clear the pipe and got rid of a nasty metallic sound I had on the throttle and making left hand turns. Well that little sound returned last week and I crawled under and looked and sure enough the heat shield was touching again.
Who knows why maybe a bit a spring sag. So yesterday I bent it down a little more. Today I start getting a nasty clunk on dips and especially when on a bump why turning. I crawl under there too look and find the same heat shield now has a huge gouge on the under side of it where the leaf spring near the rear bushing is smacking it. I'm sure Ford put it there for a good reason so hate to remove it.
First pic of the hacked up bend job I put on it.
Second pic of the gouge in the bottom of it where it's hitting.
Golf IV / Jetta IV :: 2005 - O2 Sensor Wire Disappears Above The Heat Shield
Didn't touch the downpipe during engine swap of my BEW TDI.
After swap, have code:
17524 - Oxygen (Lambda) Sensor Heating; B1 S1
P1116 - 000 - Open Circuit
The O2 sensor wire disappears above the heat shield above the exhaust. I am used to (Audi 1.8T, 2.7T, 2.8) seeing the O2 sensors coming up with plug on firewall.
Where is the O2 sensor wire going to.
I normally by the generic Bosch O2 if the SENSOR is bad (cut and splice), but suspect that maybe the problem (open circuit) is further 'upstream'.
Obviously, I am a TDI (and Golf/transverse engine) newbie, so bear with me.
Golf IV / Jetta IV :: Scraping Noise - Downpipe Is Touching Subframe Heat Shield
I just had a new downpipe installed and now I am getting a horrible scrapping noise when coming off a dead stop. I got under the car and looks like the downpipe is touching subframe heat shield. My question is should i take it back and have them make some clearance or is there a quicker solution. New downpipe and subframe heat shield.
View 2 Replies