Ford Super Duty (1999-2016) :: Clunking Noise In Driveline When Come To A Stop Or Shift Into Park
I took my truck in for a clunking noise in the driveline as I come to a stop and sometimes when shift into park. It is now the 7th and I'm told parts have been ordered and the truck will be worked on when parts come in. I asked to speak to general manager and still no call back. I called customer relations and nothing they can do.
Honestly I think the have me on the back burner since I'm warranty work opposed to marked up repairs. Am I being unreasonable on my expectations of repair time? I called around and a ring and pinion job is quoted at 3 days at the most. Other repairs have been approved as well and parts are in for those, but they have not actually repaired them either.
Ford Transmission :: 1997 - Driveline Noise And Vibration
It's NOT a truck. But my '97 Town car happens to use the same 4R70W transmission and 8.8" rear axle that the F150 from the same era used to use....
I'm troubleshooting what I first thought were bad pinion bearings in the rear differential. On the highway the car makes a shaking/growling kind of noise that fades in and out from 55 MPH and higher. Also when you're on the throttle there is a howling type of noise that comes from the rear of the car, the harder you're on the throttle the worse it is.
I got under the car convinced that my pinion bearings were shot, looking for the smoking gun. But I can't find any noticeable play on the pinion shaft of the rear axle. Slid on up to the front of the driveshaft and there's noticeable play on the extension housing of the transmission:
2013 12 27 19 06 40 - YouTube
Any chance this is causing my issue, or am I in for some expensive rear end work?
Ford Transmission :: Driveline Vibration / Felt In Pedal When Accelerate From 50 To 65 MPH
I got my 77 ford truck w/four wheel drive half ton with a np435, 351M and i was wondering if a bad or worn bearing can cause vibration. i can feel it by the pedal when i accelerate from 50 to 65. I don't know if that's my trans or maybe the pilot bearing?
View 10 RepliesFord Transmission :: 1979 F250 - Clunking Noise In The Trans
I swapped in a manual trans in my 79 f250 4x4 about a year ago. i had the trans gone through before i put it in. I installed a new luk clutch, resurfaced the flywheel, new throw out bearing, etc.
Ever since i installed it there was always a clunking noise in the trans. I drove it and didn't think much about it until recently where im just fed up with it. the trans always shifted nice and tight with no grinding.
In the past few weeks i picked up a parts truck for the trans thinking that's what my problem was. I drove the truck before i pulled it and it mad no noises whatsoever. I had it gone through and reasealed it before i installed it. I pulled my old trans and it still looked good with no slop on the input shaft(which i thought that was the problem). I installed the new one and once again same noise.
I decided to pull the trans again this time pulling the bellhousing and checking the clutch. It looked like new to me still and i saw nothing abnormal. Put it back together and still the same. I swapped the transfer case too, checked both driveshafts all is good. I am thinking its coming from the bellhousing(maybe the clutch is bad)
So here is a video and you can hear what I am talking about it happens mostly when I engage the clutch and i am coasting. it is much louder now with no carpet and the trans hump cover off.
Np 435 transmission clunk - YouTube
Ford Transmission :: Clunking Noise When Barely Pressing He Accelerator
I need to pinpoint this clunking noise. I've recently noticed this noise on the highway, after I have been driving a while, when I stop and begin driving again, if I am barely pressing he accelerator, she will clunk along. The sound is accompanied by a movement that you can feel as well. I'm beginning to think maybe there is some slippage in the rear differential.
Also I was wondering how much repairs run for this diff, the numbers I got were:
D26W0
and
2148
I know its not the U-joints, I just had them replaced along with a new driveshaft.
Lexus LX 2008+ :: Crawl Mode - Transmission / Driveline Is About To Ruin Itself
Read the owners manual and didn't recall this bit of info on crawl mode...It sounds as if your transmission/driveline is about to ruin itself. Sounds exactly as if the fan is hitting the shroud periodically. After years of ownership and 35k miles I decided to try the crawl mode....for about 20 secs. After a quick call to my service manager he assured me "that's the way it sounds."
View 4 RepliesTouareg :: 2004 Transmission - Loud Clunking Noise When Getting Up To About 30 Mph
When driving, getting up to about 30 mph, a loud clunking noise and feeling seem to come from under the center armrest. I have looked underneath to see if something came loose or was missing, but nothing looks out of place. Increase in speed makes it get worse.
2004 Touareg V6 67k Miles
Ford Super Duty (1999-2016) :: Driveline Noise When Slowing Down In 4x4?
When I'm in 4 high and I coast I can hear something from the front drive line. It's a soft whirring/grinding type noise.
If I'm accelerating there is no sound . Only when the driveline forces reverse and the engine starts to slow the truck do I hear something.
With my hubs locked but in 2wd I don't hear anything.
Is this something to be concerned about or is it regular noise?
We have had a brutal winter so I've been in 4x4 75% of the time.
Camry 2012+ :: 2016 LE - Transmission Clunking Noise When Shift Into Reverse With Foot On Brake
I bought a brand new 2016 Camry LE. Sometimes when car sits for a while, and I shift from P to R, there is a clunking noise with foot on the brake. I tried with the parking break engage and it still does it.
View 4 RepliesSanta Fe (CM - 2007-12) :: 2008 - Hum Noise From Driveline
Have 2008 Santa fe with a driveline hum noise. Originally thought is was a wheel bearing so I replaced what I thought was the suspect ones (1 in front and 1 in the back). Noise still there! Carrier bearing on the drive shaft? Front axle shaft? I'm at a lose.
View 7 RepliesElantra MD (2010-15) :: Slight Bang Noise From The Driveline
I have been hearing a slight "bang" from the front of my car , mostly when I either step on the gas or let off. It's very faint, but annoying.
So last Monday I make an appointment for the car to be looked at, and after the dealership telling me I need two other things (recalls/TS done before they will even look at the problem I am calling about, I ask that a tech be available to ride with me to cut down on the diagnosing time. They tell me that all this work will take over 3 hours, and because I live 11 miles from the dealership, they won't give me a ride, I can either get a ride from someone, wait, or get dropped off at a local mall.
After dropping the car off they tell me, other than the banging, I need a ECM update and muffler clamps for the rattling heat shield. I tell them the heat shield was removed because it was falling off and I was on a long distance trip and couldn't stand the banging against the car. They tell me, don't worry, we'll fix it. I ask that a tech ride with me and was told that, if it's audible, we'll find the problem. So, my first mistake was that I trusted them, and I leave.
About 5 hours later I get a call telling me the car is all set. I ask about the banging, they tell me it couldn't be replicated by the tech after a 10 mile drive. I was a little upset. So I guess the whole point to this story, if having any kind of noise from the front end, or when shifting into park or reverse, it's probably the TSB for the driveline axle washers.....
Passat (B6) :: 2007 - Noise From Driveline Or Subframe Bolts?
2007 Passat 2.0T, 48,000 miles
Essentially, I get a clunky/pop/crinkle sound from beneath my feet in the driver's side footwell. This sound/feel occurs when I either get back on the gas after slowing down but before the car fully stops or if I take my foot suddenly off the accelerator without touching the brake.
VW told me after three tries that the "noise is from the driveline changing directions, making some noise because loads are changing on the driveline when going from deceleration to acceleration" and that it was normal.
I have seen some posts about the subframe bolts either being faulty or worn on this site and other VW sites...
Passat (B5) :: 2003 - Low Frequency Driveline Noise Started At About 35 Mph
I have been recently working on a 2003 1.8T fwd Passat that I have owned since new. I recently changed the front rotors, pads and CV axles. At low speed everything is great. No vibrations or unusual harshness. Starting at about 35 mph a low frequency driveline noise starts from the driver side and starts to get drummed out by engine noise above 60 mph. The noise is not very noticeable from the passengers seat. Initially I suspected a tire, but I swapped tires front to back and the noise didn't change. I have tried loading and unloading the front tires in 45-50 mph s-turns and the noise doesn't change.( I was thinking wheel bearings). I put the car back up on stands and tried hand spinning the wheels. No unusual noise was present. I have not found any clearance issues where there might be something rubbing. I got the axles from Raxles and am at a loss. Could this be a wheel bearing or a bad CV joint? How can I tell?
View 7 RepliesFord F-150 (2009-2014) :: 2013 - Transmission Clunking At 10-30 Mph?
Overall I love my 2013 F150 and it's been great. I noticed my truck's transmission has been slightly clunking at 10 to 30mph. Meaning, driving in rush hour traffic... slow down, speed up, slow down speed up, etc. I have NOT experienced the hesitation, shudder or shaking. Anyway I took it into the dealership for service.
The dealer applied a transmission Technical service bulletin. So I'm reading the dealer's service dept. paperwork and it says 'Applied TSB to the PCM/TCM.' So I ask the 'kid' behind the service counter specifically what that means and he tells me that they applied a software update to the 'power train control module and transmission control module'. These modules are learning modules and I should drive the truck another 500 to 750 miles before I return for transmission service?
Ford 6.0L Power Stroke Diesel :: Transmission Slipping - Clunking Intermittently While Shifting?
Hauled my last 2 cord of wood for the season, and I now have a pretty good 3-5 slip in and an intermittent bang/clunk when its shifting. So I've put this off for a long while now, and I want to fix it. I've done my research, and I don't really feel like I'm any further ahead than before I did my research.
I'm looking for recommendation's on what transmission and or kit is the best for my truck. I pull my 5er 10-15 times a year mostly up and down the east coast. We are looking to get a new 5er with a bunk house, my goal is to stay in the same weight neighborhood, I run 13-13,500 now depending on where we are going. The goal is to be able to get maybe another 3-5 years of use from the truck, maybe more, and then upgrade to a newer truck. So let me hear what you all recommend as I'm going crazy and probably over researching what I'm gonna do...as usual.
Ford - Ranger :: 1997 - Clunking / Rattling Sound In Manual Transmission At Random Times
I have a '97 Ranger with about 120k, 5 spd manual transmission, 2wd. For the last 2-3 months I'm hearing and feeling a clunking or rattling noise (I can't decide which it is) coming from the rear of the vehicle at random times.
I can't really predict or find a pattern of when the noise will happen, but it seems like it is most likely to happen when I'm either accelerating up a hill or when I'm braking relatively hard. It happens whether the clutch is in or out. Doesn't seem to matter. It does NOT happen when idling, only when traveling. I don't ever remember it happening at highway speed (65mph).
If I have my hand on the stick shift I can feel the shaking / rattling as it happens. There seems to be no impact on the performance of the vehicle - no additional trouble shifting into or out of gear, accelerating, or anything else.
On a recent trip I towed a 1,000 lb trailer and I did not feel or hear the noise at all during that trip (about an hour each way). Any guess as to whats going on?
Ford F-150 (2004-2008) :: Driveline NOT Binding In 4WD?
I've had occasional issues the last year getting my 04 into 4WD, but at 270K on the original IWE actuators, that's probably to be expected.
I had new actuators ready to install, but took the truck out for a drive before doing the job. On a gravel road the back tires spun easily in 2WD, I switched over to 4wd and it was much harder to spin the tires- you could tell it was in 4WD- or at least seemed that way. I left it in 4WD and tried turning on a tar road and it didn't seem like it was binding at all. (I have an open diff in the rear, assume the front is the same?)
Anyway, I installed new actuators last night and took it out for another drive afterwords. I put it in 4WD and could IMMEDIATELY feel the binding when turning.
What I cant figure out is why I could NOT feel binding while in 4WD prior to the install. Could I have been in 3WD somehow? (04 Super Crew, Automatic, 4.6L, XLT- pretty basic pickup...)...
Ford Excursion :: 2003 V10 - Driveline Has Been Vibrating
My driveline has been vibrating for some time now. I changed out the rear u-joints with no improvement. I found the spline to be sloppy. I think I need a new driveshaft.
View 3 RepliesGolf IV R32 :: Transmission Clunking In 6th Gear?
I was driving my r yesterday, cruising down the highway in 6th. I let off the gas and I heard a clunk from the tranny. The shifter moves forward with the noise after I let off the gas pedal. It does it most of the time and I didn't know if this was a problem with all Rs or something mechanically bad.
View 12 Replies