Ford 6.7L Power Stroke Diesel :: Manually Shifting 6R140 Transmission
I was reading yesterday where someone was wishing for a tuner that would allow you to skip 1st gear. I realized today that you can do that in Manual mode and was even surprised to find out that it would even let you start in 3rd. Driving around without a load, 1st gear does seem a bit of a nuisance. You can't really get on the throttle until you get 2nd! Playing around with it a bit, starting in 2nd, and even 3rd around town was really nice and I didn't miss the shifts. The other thing I noticed that when in manual, it will down shift based on speed, but not throttle position, so if you're going fast enough, it will maintain that gear without downshifting as you apply more throttle. I'm assuming that Ford put some thought into this and won't let you shift in a manner that will cause damage. It would be nice, however, if it would bypass 1st if not in Tow/Haul mode and not make you do the manual shift thing.
View 5 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Transmission Won't Shifting Properly?
In my 2011 F-250, 6.7, auto....it seems that at certain times went the tranny shifts from 2nd to 3rd and I pause with acceleration, for some reason the tranny seems to go into a slip mode and then slams into 3rd. Now I read about 8 months ago that there was a computer upgrade via Ford. Which they did when I was having some work done on the truck at the dealership.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2006 F250 - Soft Shifting Transmission
I have a 2006 f250 6.0L with 76,000 miles on it. And it just started to shift softer then normal under light throttle. The first to second to third shift are softer then normal. And the third to fifth gear shift seems to have a lot of what I would call overlap and some times it feels like it is slipping. Gets better under hard acceleration but not as firm as it used to be. I have always changed the trans fluid and filter every 25,000 miles. Trans temp runs about 150 to 160deg. I checked the fluid today and it's bright red and does not smell bad. And I don't have any coeds. Could it be a solenoid going bad ?
View 9 RepliesFord 6.0L Power Stroke Diesel :: Solenoid Stuck / Transmission Not Shifting Out Of Second Gear
Transmission was not shifting out of second gear set a code stuck solenoid cleared code seems to be working now....
View 4 RepliesFord 6.7L Power Stroke Diesel :: Intermittent Transmission Shifting Stutter When Truck Is Cold
For those of you tuned and deleted......intermittent transmission shifting stutter is gone now? Mine sure is. Never once since the mods have I had that annoying stutter when the truck is cold and I'm easy on throttle between 2nd and 3rd gears. What a relief it is to have it shift NORMAL ALL THE TIME!!! Stutter no more after H&S Tune and Delete, for about two months now.
View 9 RepliesFord 6.7L Power Stroke Diesel :: Auto Transmission - When Shifting Truck Will Go Into Neutral State For 2 - 5 Seconds
When taking off the 1-2 shift and the 2-3 shift the truck will go into a neutral state for 2-5 seconds. when this occurs, the rpms will rev since your foot is on the accelerator. Once you let off the accelerator the rpms come down and the gear will catch. I have had the truck in the shop a few times without any luck. part of the problem is no codes are thrown so the dealer has no clue what to look for. This is extremely dangerous when in my case i pull out on a 6 lane hwy with 55mph speed limit. Ford more or less said to pound salt until a code is thrown or until something else happens. this nearly caused a nasty wreck 2 weeks ago.
View 14 RepliesFord 6.7L Power Stroke Diesel :: 6r140 - Transmission Slams Hard Into Reverse / Shifting From 1 To 3 Is Awful
I'm having problems with my 6r140 in my 2011, the truck is an early build around 8/2010 I believe.
After cold soak when shifting into reverse after allowing engine to warm a bit the transmission almost always slams hard into reverse.
After that shifting from 1-3 is awful, the transmission will try to go into 3rd but downshift to 1st then fail to go back into 3rd multiple times. This situation is extremely dangerous when trying to pull into traffic.
Oh and once the transmission gets into 3rd it will skip 4th and go right into 5th. There is only 94k miles on this transmission/truck.
I just bought this truck about a month ago, does this sound like an issue with the solenoids in the valve body?
I'm very mechanically inclined and can swap them if need be but now we're talking few hundred in solenoids and then getting the trucks pcm flashed right?
Also fluid has been changed and I used mercon lv.
Ford 6.0L Power Stroke Diesel :: Transmission Started Shifting Badly - Codes P0976 And P0755
Recently picked up a 2004 Ex 6.0L. Drove great for a bit, then it started shift badly, then finally the Tow/Haul light came on. The original codes were P0976 and P0755.
P0755 being shift solenoid B, and the P0976 being SSB Control Circuit low. I replaced Solenoid B and that code went away.
P0976 stayed with no change in how the truck drives. Replaced the internal harness today, and again no change.
At this point I'm at a loss. I'm wondering if it's something between the PCM and the transmission?
Ford 7.3L Power Stroke (1999-2003) :: Tranny Slipping And Not Up Shifting Then O/D Started Flashing
I spoke with a few people here before about my 4r100.. it threw a code a month ago for P0750.. i replaced solenoid and it continued to do it even after clearing codes numerous times.. then all of a sudden it was perfectly fine for over a week, no codes, i ran a few brick hauls with it and ran it for over an hour straight.. i went to fl and upon return i took her for a drive and wouldnt you know, the code has returned.. i did hammer down a little but not from a dig, i just got on it a little playing with a neighbor and his truck and all of a sudden it did its thing slipping and not up shifting then the O/D started flashing again... i cant understand why the code would come back all of a sudden, there has to be a wiring problem correct?
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: Trans Slipping On 25hp Tune Up High In RPM Band And Shutters When Up Shifting
My excursion's trans is slipping on the 25hp tune up high in the RPM band and shutters when up shifting. I have dropped to stock most of the time, but I know i am on borrowed time.
I had a JW trans in my e99, and there is no question on the durability and performance of the transmission. The price has gone up a lot, but that's maybe not the big issue.
I live in the mountains and spend a lot of time pulling and just driving in that 40 to 60 mph range over mountain passes. That is basically where I spend ALL of my time.
The distance between 3rd and 4th is driving me CRAZY! I have researched everything from swapping to a manual, to PCS controllers, to trying 4.11 gears, to overdrive units.
Swapping Manual: ZF6 is the obvious candidate, but I have read the swap is not probably something I have the skills or tools to do. I have also read that the performance of the ZF6 is sub par. But it seems like it would give me my 3.5 gear that I am looking for.
PCS Controller: Looks cool for a way to have control besides using the tree shift. Maybe a compromise on not swapping in a manual.
4.11 Gears: I get pretty excited thinking about the low end torque etc. I go off road almost every week, and like I said, I hardly go over 75 mph. But once in a while I do. Right now, the truck turns about 2300- 2500 rpm at interstate cruising speed. Looking for 4.10s rpm in that range to compare? Also, how bad of a fuel economy hit would I take? What is the cruising rpm of 4.10's between 60 and 65 mph, or in general what is the rpm change?
Overdrive Unit: I have always been interested in more gears, but I read about someone who installed one behind a 7.3 and didn't have they great of results. To the point where he said it wasn't worth it.
Ford 7.3L Power Stroke (1999-2003) :: Transmission Slipping When Put It In Drive
My tranny is acting odd. I put in drive and seems to slip a lot in 1st, barely even move at some times. If I put it in 1st with the shifter it goes in and grabs then I can shift up to 2nd or drive and there aren't problems. It drives normally when not from dead stop.
Transmission has 50k miles on it since replacement. Fluid level is normal. I don't tow and drive it particularly hard. I will have to go back and look at miles since last fluid change. I should be right around 30k miles since last change.
Ford Transmission :: 2005 Escape - Slipping When Shifting To 3rd
2005 Escape CD4E gone...157,000 miles. Previous owner said it was slipping when shifting to 3rd. During test drive the vehicle would hardly move. Only code was for the output shaft. There were metal shavings on the sensor magnet as well as the magnetic drain plug. The drivetrain is now out of the vehicle.
Questions:
1. After a bit of research it seems like there are a lot of tweaks that should be done during a rebuild to make this tranny live longer. Is there any point to having a local trans shop try to rebuild it?
2. Given the reputation of this trans I assume it makes no sense to look at used ones, correct?
3. Any other options?
Ford 7.3L Power Stroke (1999-2003) :: 2000 F450 4x4 Transmission Slipping
I have a 2000 Ford F450 7.3 4x4 dully with a PTO driven winch 108,000 miles. The truck has develop a transmission slip.
I have changed the transmission fluid twice and it drives better but it slips badly. I can drive it up to highway speeds but it has problems getting from 0 to 10 MPH. The transmission runs hotter then normal but nothing major maybe around 205 degrees
Do I need a complete rebuild? This is a beater truck that I use to tow mainly. It is not worth a major investment. I need the PTO gear and 4x4.
I have several 2000 through 2003 7.3 E350 and E450 short school buses. Does the transmission from these has a PTO gear? I am thinking of pulling the transmission from one of them and swapping it.
It looks like the transfer case just bolts to the back of the transmission; I believe that a 2wd van 7.3 transmission will work with the 2000 F450 setup.
Ford 6.7L Power Stroke Diesel :: When Cold Diesel Engine Sound Intermittently?
It only happens on a very Rare occasion.
When Cold, and when I start out as I open the throttle, it suddenly sounds like there is not a piece of quieting stuff on the engine. I mean its like I can hear right into the engine itself.
I back off, It goes away then I dont hear it again for another Month or two.
Ford 6.7L Power Stroke Diesel :: 2012 - Tranny Slipping When Towing 5ER?
Took my first camping with 2012 King Ranch F350 and 37 feet Challenger 12k fifth wheel trailer over the weekend.
I noticed there is lot of transmission slips in first gear. Once it enters 2nd gear, no more slips.
My previous Chev 2008 2500HD diesel didn't slip much with same trailer.
Is this normal for this F350? My rear ratio is 3.55. No slips without hauling.
Maybe I need to ask dealer to check 1st gear towing?
Ford 7.3L Power Stroke (1999-2003) :: F250 - Transmission / Torque Convertor Slipping
My son bought a 1999 F250 Diesel about a year ago. The seller gave him receipts showing that the 4R100 had been rebuilt and a new T.C. installed 25k miles before the sale. The problem is that it is slipping. He says it started with 2nd gear, now it will hardly move in 1st.
Fluid smells a little burnt. We pulled the transmission pan expecting to find lots of friction material. It does not have as much as I thought it would, not as much as I have found in the the pans of the few other auto trans I have seen with worn out frictions. Below are pics of the inside of the pan.
Or, is it the T.C. that is slipping. I have never had a vehicle with a bad T.C. How do you diagnose it? I have experience rebuilding (GM) Turbo 400's and 4L60's. Never had a ford AT apart.
Ford 6.7L Power Stroke Diesel :: 2011 - Clunking Noise While In 4x4
My 2011 SD started clunking while in 4x4 this weekend. I was on an icy road for about 120 km driving about 60-80 kph and once or twice noticed a random clunk. Didn't think much of it.
Fast forward to following day - get truck on an icy hill where I had to make a sharp turn. Put truck in 4x4, turn off ATC by holding button 8 seconds. Only rear wheels engage. So then try 4 LO. Same thing. Straighten wheels, shift to park, engage 4x4 again and she hooks up and drives out no problem. Further down the road (still in 4x4), it fish tails slightly and then check 4x4 light comes on. In order to get 4x4 re-engaged (was spinning at a stop light on a slight incline) I had to shut truck off and restart it. Then it seemed to work normal and light went off.
Little further down the road I had to go up a steep incline and at a steady 40-50 kph I started hearing (and feeling) a noticeable clunk every few hundred feet. Seems to be coming from rear of truck but honestly cannot say for sure. Goes away when in 2wd.
I have 7000 kms left before warranty expires luckily.
Ford 6.0L Power Stroke Diesel :: Trans Slipping / Hard To Shift - Code PO671
My tranny is slipping all over the place . I recently less than 1500 miles ago changed tranny fulid, tree branch and TP filter, ford filters, and 8 to 9 quarts of mercon SP. My truck is shifting like a bucking bronco. Came up with PO671. So should I replace just the 1 solenoid. Or all the valve body? I plan to run a gauge in cab to see shift pressures for testing purposes to aid in troubleshooting for current issue... reason for fluid change is history unkown.
2004 6.0 f250 4x4 tourque shift OdO is 163,800...
Ford 6.0L Power Stroke Diesel :: 2006 - Overheating - Water Pump Impeller Slipping?
have a 2006 f250 with the 6.0 Powerstroke diesel started overheating yesterday the ECT and EOTcheck fine with the scangauge always ran with in 8 degree's of each other. Thought maybe water pump impeller may have been slipping so it is new with no change. Fan kicks on like it should. Heater works good so don't think it is a thermostat.
View 13 Replies