Ford Ranger / B-Series :: 2000 / 4R44e Transmission - Hard Shift From 2 - 3 Gear
2000 Ranger 4R44e transmission.Hard shift from 2-3 gear and when i run about 35-40 mph and brake then acelerate it downshifts hard . Whats wrong with it?
View 14 RepliesFord Transmission :: 4r44e - No Reverse After Changing Rear Spark Plug On Passenger Side
After changing the rear spark plug on the passenger side of my wife's truck ,the reverse went out. Its a 2000 4x4 ranger with a 3.0, and I think the 4r44e trans. Any way she said the check engine light came on and it was running rough. I determined that it had a bad plug changed it and she ran fine. I put her in reverse to see if the motor was still stumbling.
I could her the trans shift to reverse and the motor stayed running smoothly. When I took my foot off of the brake she was barely moving, like it was in 4 low. I stopped to see if there was a vac line that might have been pulled off , or any wires unplugged. Nothing. I started her up and put into reverse. no sound no anything it was the same for neutral. you cant hear any click nothing. I drove her and the forward gears are fine od works drive to 2nd has a engine brake feel. and 2nd to 1st has a engine brake feel.
I have never had a issue with this truck till I changed the spark plug. I think that it is a coincidence that that happened or I unplugged something. Any other way before I pull the pan off.
Ford Ranger / B-Series :: 1998 - 4r44e Transmission - Randomly Losing Power While Driving Like It Would Not Shift
Ok I've got this 98 Ranger with the 2.5L and the 4r44e automatic. The engine is used and has about 100,000 miles now and is it a good state of tune - so I think. The transmission was a remanufactured I bought a few years ago that was built with the shift improver kit, Kevlar bands, extra planetaries, 4wd pan, and external cooler. It's now got 92,000 miles on it and it's been serviced every 30,000 with a fresh 4wd filter and Mercon V fluid. It's outlasted the last 3 transmission I've had in my Ranger. I've got 315,000 miles on the body. For awhile it was randomly losing power while driving like it wouldn't shift, almost like it dropped a couple cylinders, then as you kept your foot on the gas it would recover and rev up and shift.
Then sometimes randomly at stoplights it would shake at a stop and have no power at take off until it hits 30-40 mph. Sounds like a converter, is what I thought. But now it's doing it more often but not the shaking at stoplights as much as randomly losing power while driving normal speeds. Last night I drove it about 50 miles after doing a fresh filter and fluid change and this time it did it so much it threw a code up P1131. Even though that's a O2 sensor code, could it be hidden by a transmission valve body problem? One transmission shop said it could be a valve hanging up just by me describing it to him. Could this be ignition or fuel related or is it all tied in with the transmission problem, if it is even a transmission problem?
Ford Transmission :: 1977 F250 - When Lock Into 4L It Goes Into Low Range But 4wd Does Not Work
I have a 77 F250 with a NP 205, when I lock it into 4H the 4wd works, when I lock it into 4L it goes into low range but the 4wd does not work. What the problem could be?
View 1 RepliesFord F-150 (2004-2008) :: Range Of Transmission Fluid Temps
What is the range is on these temps. Reason I ask is because long story short My truck did not come with a factory tow package and I have added the hitch and seven pin wiring, I am lacking the HD trans cooler. Recently purchased a travel trailer and am a little worried about getting the tranny too hot. I have an Edge tuner and set the gauge to read tranny fluid temp. Without the trailer I have been seeing temps that range in the 130's to 150's, with the trailer I have been seeing temps in the high 160's, with a spike to 176 when going up a hill. I plan to add the tranny cooler but cash is little tight at the moment. Just wondering how hot is too hot.
View 14 RepliesFord F-150 - 1997-2003 :: Transmission Range Sensor Replaced - Got Code P0705?
I have replaced the transmission Range sensor (with OEM) and it is adjusted correctly, however This did not clear the. Code P0705... I am stuck ....
View 1 RepliesFord Ranger / B-Series :: 2003 - Code P0708 For Transmission Range Sensor
Got a code of p0708 on 2003 ranger flex-fuel 3.0.. Which is I believe is Transmission Range (TR) sensor. Not sure where to find that on truck...
View 1 RepliesFord Ranger / B-Series :: 2000 - Trans Won't Engage - 4R44E Shift Cable?
I bought a 2000 Ranger 4x4 3.0L auto today from the neighbor guy sight unseen with a "bad tranny" for $400. I'm very unfamiliar with the Ranger family, but long story short:
When moving the shift lever, the trans doesn't engage. It needs to be engaged from underneath. Do the cables tend to stretch, or break? I can't find any adjustment on it anywhere.
Ford F-150 (2004-2008) :: Transmission Bang When It Shifts And RPMs Drop To Lock Up Range
Truck is 04 supercrew with 5.4 and 140,000 miles. I have the typical shutter when cruising 55 - 60 and just ease on the throttle to pass someone. I chalked that up to the torque converter unlocking, if I punch it instead of easing into it, it will not shutter. As of yesterday, it acts like the converter is going to full lock up almost immediately. It will bang when it shifts and rpm's drop to lock up range. A few times it has killed the engine when I shift into D. No codes at all, I removed the programmer and installed the stock tune, no change, unhooked battery, no change, fluid is good, and twice after leaving stop signs it worked perfect until the next stop. I believe that it is an electrical control problem.
View 9 RepliesFord Transmission :: 4r70w - No Forward Gears Only Reverse
I have a 98 expedition with a 4.2 liter 4x4 and what I believe to be a 4r70w transmission (u code on the door sticker)
The original transmission went at 105k miles and was replaced with a new factory ford transmission by a ford dealer 3.5 years ago. The new transmission only has 10k miles on it.
Now the new transmission only has reverse. reverse works like normal but no forward gears. the idle will change when i put if in gear, but will not move, acts like it is in N . There is no strange noises.
It's hard to believe a new trany is shot already, no towing, or off road use.
My question is : is there ANYTHING that can go bad that would cause this? The trany fluid is clean and clear bright red, and no burnt smell.
I want to check everything I can before calling a tow truck to have it looked at. I will have it repaired if needed, but I don't think I want to replace another tranny.
Ford Transmission :: 4R100 Grinding - Now No Forward / Reverse?
A friend just bought a 99 Navigator, with what wikipedia says is the 4R100. Previous owner allegedly rebuilt the trans but used the old converter
It was apparently slipping a bit, or something, when he got it. Then on the way to my place so I can drive it and see what I think, it started making nasty grinding noises once he hit 4th gear. He got off the highway and made it to my place just fine.
Put it reverse to turn around in my driveway and it started the grinding noises again. Forward gears initially had some grinding as well after that, with no forward motion. Now there's no grinding, and the engine free revs in any forward/reverse gear
Fluid is full, still red, but smells nasty.
I don't suppose the three feed bolts above the valve body being loose would cause this? I imagine he's looking at a rebuild, which neither of us really want to do.
Ford Transmission :: 4r100 Will Now Go Into Forward Gear But No Reverse
Early 2000 F250
Originally the truck would not go into any forward gear, but had reverse all day long. So I had a rebuild kit ordered (new bushings, seals, frictions, steels, a washer and flat bearing kit, a sprak kit, and the od piston)
After rebuilding it, taking my sweet time double checking everything, it will now go into forward gear but not reverse. So I dropped the pan. The small 3 bolt plate was torqued to spec. When I got to the third bolt in the smaller section of the valve body (upper valve body) I heard a click like maybe a valve returned to its place but I'm not sure. I removed the valve body and accumulator and all the valves were free and had tension. When I had it apart the first time one valve stuck for a split second but I never could get it to stick again.
Finding nothing there I uninstalled the tranny and took the barrel apart all the way down to the L/R piston and could not find anything wrong.
After the build and me running the truck for about 10-20 min there was metal on the magnet (part of the reason I took it all back apart) however I could not find anything worn or chewed up. Could have been the tc I prefilled with 2 quarts in stead of filling all the way.
When I initially rebuilt the 4r100 I took apart the pump to replace the bushing and seal but did not take apart the valves. I've heard the pump is directly related to reverse but I'm not sure. Could something gone wrong in the pump when I took it apart? How would I know? If I new all parts of the reverse system I could then test them.
Ford Transmission :: 1995 E40D - No Forward Gears
Had tranny fluid and filter replaced a couple months ago. It's in a 35 foot motorhome (F53 chassis). The motorhome is within it's GCWR. Climbing a 6% grade at 3,500 rpm, little more than half throttle, like all the other climbs. 80 degrees out. Engine temp was on the letter "R" on the word "NORMAL". All of a sudden my engine redlines as if it popped into neutral. I let off, put it into neutral, and try "D" again. Nothing.
At this point it's uphill so it's naturally slowing down and I try "2". Nothing. Even slower and I try "1". Nothing. Pulling over blocking the right lane on a blind curve on a grade is scary. Had pylon cones out, waving traffic to warn them down a ways, etc.
No fluid on the ground, no slipping prior to this. I have reverse. I see no obvious linkage or electrical/wire issues underneath (from road debris, etc). It's at a shop but I want to know all I can so if they come back with something outrageous I can make a decision. I never pulled the stick, as I was coordinating traffic, highway patrol, a tow truck, etc.
Ford 6.0L Power Stroke Diesel :: 2007 F250 - Getting Codes Abut Transmission Range Sensor Circuit
I have a 2007 f-250 6.0 liter turbo diesel. I was pulling a trailer with a golf kart on it and was not in tow haul. I was going up a hill and it shot up into 5th gear. I pulled into my house and shut it off and refired it and it acted fine. I went on a little test drive to see if it was going to do it again before I went on my trip. As soon as it shifted into third gear the tow haul light started to flash on my dash and went to 5th gear and would not down shift even if I did it on the column.
I scanned the truck with my snap on modus and it gave me these codes. P0706-transmission range sensor A circuit range/performance, P0707-transmission range sensor A circuit low input, and P1702-transmission range sensor circuit intermittent. I put a transmission harness in it and started it up and it ran fine and the codes were gone. I went for a test drive around the neighborhood and as soon as it hit 3rd gear it did the same thing as before. Today I put the old one back in and checked the codes so I could write them down and there weren't any so I went for a drive and it shifted through all the gears great and downshifted fine as well.
I pulled into my drive way to check for codes once again and there weren't any. I was gonna go for a ride in tow haul to see if it would do it and as soon I put the truck in reverse it started to idle high and the tow haul light started to flash again. I put it in drive to pull back into my drive way and it immediately shifted into 5th gear and threw the same codes...
Ford - Taurus :: 2000 - Sudden Transmission From Stop To Forward
It seems like a sudden transmission, happens JUST a MOMENT after I start to go forward from stopped, like at a light. It might be worse if I did a jackrabbit start, but I don't.
It's a pretty hefty "jerk" and I would think the car is already in first (automatic) but it feels like a crappy shift on a manual trans.
Ford Transmission :: 4R70W Trans Stuck In Forward Gears
I have a 1997 Mercury Mountaineer with a 4R70W trans behind a 5.0 liter. Vehicle sat for about 5 months. Went out to put it back on the road, and now the trans seems to be stuck in a forward gear no matter what the selector is in, park, reverse, neutral. Dropped the pan and replaced the filter and replaced what fluid was drained. no difference,.
View 3 RepliesFord F-150 - 1997-2003 :: Transmission - No Forward Gears Or Reverse
The truck is a 2002 f150 4x4 5.4l... I was driving down the free way last night in 2wd doing about 90kpm when there was a loud bang like a ran over something. Speedo went to zero and abs light came on. Pulled over and shut it down. Crawled underneath to check so damage and couldn't see anything. Stared it back up put it in drive and it just revs. No forward gears or reverse. Fluid level is good, bright pink. Dropped the transmission pan, pan is clean and magnet has next to nothing on it.
View 14 RepliesFord F-150 - 1997-2003 :: 1999 2wd - Transmission / No Forward Gears
I have a F150, 2nd 4.6, 122,000 miles. No forward gears. When put in drive, you can feel it trying to engage, but doesn't engage completely. Reverse is a solid engagement. Replaced filter and fluid, same issue.
View 12 RepliesFord - Explorer :: 2003 - Transmission Forward Gears Are Slipping
2003 Explorer with a slipping transmission...codes are P0731, P0732, P0733... Just had a new solenoid pack installed last week when O/D light came on and truck was clunking into reverse. Now, after new pack was installed the forward gears are slipping all over the place!
View 5 Replies