Ford Transmission :: 1995 F150 - Rear Axle Seal Replacement
How do you replace the rear axle seal in a 1995 F150?
View 14 RepliesFord Excursion :: Front Axle Gears Removal
Well the old ball ball joints are out, new ones are in and now I'm working on removing gear assembly so I can change the inner axle seals. I've been trying to get it out. It haven't had much luck. I've loosened the cap bolts, prayed, pulled, hit, and still no luck. The only thing I've been successful at is screwing up the first few threads of the bolt holes for the passenger side cap. Tomorrow I'll be getting a tap and chasing the threads to clean them up. Hope I haven't screwed it up too bad. How to get the gear assembly out?
View 8 RepliesFord Super Duty (1999-2016) :: 2008 F450 - Front Axle Removal
How do I get the front axles out of of the knuckle? It seems like the seals are holding them in? Is there any trick to to getting them out,I am trying to do my ball joints
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Parking Brake Cable Removal From The Axle?
What is the procedure to remove the parking brake cable from the axle? It looks like the cable has a locking device like the fuel lines but heavier. How do you get that thing out of there without destroying it?
View 9 RepliesFord Super Duty (1999-2016) :: Terrible Noise When Hit A Bump / Front Axle Shaft Removal
I have a E99 F350 7.3L 4x4 I know some or most of you have already probably replaced this part and or pulled a front axle shaft out. So here is my question...In the pictures provided you can see what I think everyone is calling a "Dust Seal" and as you can see it is bad and making a very terrible noise when i hit a bump...I was wondering what parts I would need to replace this seal? I tried looking it up and just get lost in all of the other things....I have found write-ups for the axle being removed while changing ball joints but none by it self to just replace this seal.
[URL] ....
Sonata NF (2006-10) :: Right Side CV Axle Removal
2006 v6 Sonota had the passenger side CV axle break apart. I have the wheel spindle moved away axle but off and all that. There is a bearing mid-way on the axle which I have removed 3 bolts attaching it to the motor. The bearing just seems to not want to come off the motor. This is how it's done right? How to remove this bearing and get the axle out?
View 6 RepliesPrius (2004-09) :: CV Joint Removal - Cannot Get Off The End Of Axle?
OK I need to replace just the boot, joint is fine. I have everything disassembled but cannot get the cv joint off the end of the axle. What am I missing here? All other CV Joints just come off with a few whacks of a hammer. Is there something special on these I'm missing?
View 14 RepliesFord Super Duty (1999-2016) :: 2007 - Replacing Ball Joints - Front Axle Shaft Removal?
I am replacing the ball joints on my 07 f250 4x4. got down to the removal of the shaft itself and it won't budge. What is the secret here. Have to go to work on monday, and the weather in Cleveland isn't going to be very good on Sunday.
View 10 RepliesSanta FE SM (2001-06) :: Passenger Side Drive Axle Removal
I have a 2003 3.5 liter, AWD and I'm attempting to remove and replace the drive axle on the passenger side. I have the one end out of the hub, but the transmission end will not come out. I removed the bolts holding the bearing plate, and have been trying to pry out the axle with no luck.
View 3 RepliesFord - Focus :: 2012 - Grinding Sound By Left Front Tire / Axle
I have a 2012 Ford Focus which infrequently makes an odd grinding, scratching sound by the front LEFT tire/ axle. It only does it when turning to the RIGHT. It usually does it as I'm coming out of the turn, not into the turn; so when the tire is moving back into the straight position. It's just the sound, you can very slightly feel it when it happens but really no stability or other steering issues. What is causing this sound?
View 3 RepliesHonda - Accord :: 1995 - Oil Pan Removal
My 95 Accord loses about a qt every 1,000 miles from a loose oil pan. I leave a little mess everywhere I park. I want to replace the pan gasket but can't reach the heads of two 10mm bolts that are partially covered by part of the transmission. How do I get them off? Are those babies actually holding on the pan, or are they not related?
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Front Left Outer Axle Shaft
Can I re-use this shaft or is that ring around it no good. The ring is around where the bearing sits. It is a circumferential hump all the way around.
View 14 RepliesCelica :: 1995 - Passenger Differential Axle Seal Leaking (Replaced Twice)
Passenger differential axle seal is leaking again. It was replaced twice already. My mechanic checked the seal...its not damaged. Its not a excessive leak. Both times, the seal were replaced with OEM. I don't want to buy another one and replace it.
Its a 1995 Celica, 5SFE, 5-speed MT. 98k miles.
Ford F-150 (2004-2008) :: Bottom Radiator Hose Removal - How Much Coolant Left In Engine
2004 4.6 V8 Trition ,two wheel drive, STX Pickup. By removing the bottom radiator hose, will that allow all engine coolant to be drained from engine? If not, about how much coolant will remain in the engine in terms of quarts or percentage of total vehicle coolant capacity?
View 1 RepliesFord Exhaust :: 1995 F150 - Removal Of Second Cat For Better Sound From Exhaust?
I have a 95 f150, Eddie Bauer, extended cab, 4x4, 302, 285 tires. My question is this... What happens if I remove the second cat. I am trying to get a better sound from the exhaust and have been told the second cat is making that impossible. There is no o2 sensor downstream of the second cat, so I'm thinking the computer will never know its gone. Also how well this affect power. With the bigger tires, it's kinda sluggish off the line.
View 5 RepliesFord Transmission :: Drums Seized Onto Axle Shaft
I purchased a 1964 9 inch from a Galaxie 500 to use in my 51 merc M1. The drums were seized onto the axle shaft and after trying everything, I was forced to break them up with a sledge to get them off. The axles turn freely and I have removed the 4 bolts that hold the shafts to the housing flanges. The axles should slide right out but the do not. Am I missing something? How do I pull them if they don't budge?
View 1 RepliesCamry :: Changing Out Left Front Cv Joint Axle
Looking for info on changing out my left front cv joint axle.My boot is busted on the outter axle but iam going to change out the hold axle then my inner and outter are done the same time.Is there any body that attempted this on there own or a good thread that explains the steps to take on this job.My ride is a 2004 camry auto with the four bagger.
View 3 RepliesFord Aerostar :: 1995 - Steering Feels Like It Is Bind When Turning To The Left
I've got a 95 Aero 4.0 awd. I've just replaced the power steering pump with a cardone. Wished I didn't cause of the noise but afterwards the steering feels like it's in a bind when turning to the left. It may have been doing it before, the cv axles were shot when i bought her. I'm suspecting the rack is going bad. How hard is it to replace it on the awd?
View 14 RepliesFord Transmission :: Rear Axle Swap - Slow Acceleration
Lets say I want to do rear axle swap, how I would go about this? Would I have to do anything to my tranny or transfer case? and all in all would it be worth it if I am looking for more speed out of my 460? the fastest I can go for an extended period of time is about 55 if i go above that for to longit wears on the gears and overheats the rear end. It has slow acceleration, and I am sure the low slow gears put out a lot of power, but they drink gas. And even though I am good at driving stick, its hard to take off because there's only about two inches of clutch travel that i have to take off, its not the clutch, its the gears.
View 1 Replies