Santa Fe (CM - 2007-12) :: Inner Joint On Axle Gone Bad?
So now that it is becoming colder out (40's in the morning 50's in afternoon) I have been experiencing signs that an inner joint on one of my axles is going bad. When driving while the vehicle is still cold, and even when it is just warmed up, I have bad vibrations while accelerating. I've ruled out other things and even had the car in the air and had it checked out at a stealership but of course they couldn't reproduce any of the vibrations. It was warm out the day of the appointment.
View 6 RepliesCamry :: Changing Out Left Front Cv Joint Axle
Looking for info on changing out my left front cv joint axle.My boot is busted on the outter axle but iam going to change out the hold axle then my inner and outter are done the same time.Is there any body that attempted this on there own or a good thread that explains the steps to take on this job.My ride is a 2004 camry auto with the four bagger.
View 3 RepliesFord Excursion :: Rubber Seal Near Axle Joint?
I unstuck my front axles yesterday and while under the car spinning the front axles freely and enjoying my easy fix, I noticed a rubber seal (a thick squared edge round rubber seal) sitting loose and spinning freely. Its next to the axle joint, right before it disappears into the housing.
I'm guessing this is a dust seal of some kind. There is no fluid leaking out...
I'm wondering if I can just press fit this thing back into place or do I have to take the whole front wheel assembly (hub, bearing, axle, etc) to get the seal back into place.
I'm wondering if it broke off from a larger seal or if this is the whole thing? You can see how the seal isn't sitting quite straight. It actually just spins around.
Passat (B5) :: CV Joint Or Axle On Driver (right) Side Blew Out While Driving
Just to clarify, I've got a UK spec B5 wagon, manual, 1.8T (AEB, I believe) and it's a 2000. Last night when I was driving home, either my CV joint or axle on the driver (right) side blew out. Needless to say, I'm going to replace my axles or just the outer joints, but I've been shopping around and I'll find parts that will fit an A4 with a 5 speed and AEB but not a Passat, or parts that fit strictly AUG or ATW engine codes. How would I go about finding which axle will actually fit my car?
Here's a video so you can hear the noise : [URL] .....
Elantra XD (2001-06) :: Front CV Joint Axle Clicks When Going Around Corners
I just bought a 2003 Hyundai Elantra GLS, yesterday. 167k. Some faded paint on top areas, dead battery & in need of driver's front CV joint axle i believe, clicks when going around corners. Starts without hesitation, no smoke, no ticking, very clean and has only had 1 owner.
View 10 RepliesFord Excursion :: Leaking Axle Fluid After Ball Joint Replacement
Did ball joints this weekend and now have little axle fluid leaking out passenger side. was going to change axle fluid when i saw this so continued and when pulled the fill plug i would say 8oz or more came draining out. Did I mess up the seal inside the tube?
View 5 RepliesPassat (B6) :: 2008 - Driver Side CV Joint Removal
Looking for a good DIY video on removing drivers side cv joint, my joint broke and I removed it however the inner joint inner spline is still in the trans, there is a c clip on the shaft of the new cv joint that I'm assuming is holding it in. I just don't know if pressure is all I need to pull it out.
View 2 RepliesYaris/Scion & Vitz :: Ball Joint Or Control Arm Removal?
I have a bad ball joint? From the diagram it looks like you have to take the lower control arm off which looks difficult. It says don't raise the engine with the oil pan. I supported the engine with the oil pan when I changed a motor mount. How should you raise it? It says remove the two bolts and the nut but don't turn the nut. How are you supposed to remove the nut it if you don't turn it? [URL] .....
View 4 RepliesFord Excursion :: Circle Plastic O-Ring Behind U Joint Is Lose On Both Sides Of Front Axle
I noticed on my 03 excursion on both sides of the front axle there is a circle plastic o ring behind the u joint that is lose? Nothing is leaking and no signs of leak marks ever. Kind of looks lik a spacer ring of some sort because its at least 1/8th inch thick plastic. Also some time ago I posted about a whistling noise but never got a answer but its only there when im in 4wd there is a whistling noise from my right side and my locking hub when I turn it the hub seems lose and has a crunchy feeling to it. I just bought it a few weeks ago and now I am running into a whistling noise and noticed theres a piece of plastic that looks like a spacer....
View 14 RepliesFord Excursion :: Passenger Side U-Joint Is Shot And Axle Wiggles Around In The Dust Seal
Picture if you will...Removed tire, caliper and rotor. Removed hub, and knuckle containing the stub shaft/spindle with it's yoke for the U joint. You are now looking at the end of the axle tube, with the axle shaft in it, one end connected to the differential carrier, the other end has the yoke for the U joint on it. Just inboard of the yoke, is a seal. Apparently it's called a "dust seal" is there a bearing behind this, or is the first bearing all the way in at the differential? When I was doing my brakes, I noticed the passenger side u-joint is shot, and the axle wiggles around in the dust seal. Figured I'd replace the seal while I was doing the U joint. Also, how do I get the axle shaft out? Just pull, or do I have to remove a C clip from the inboard end? What is the right National part number for the seal? I have a 6/2000 Excursion.
View 2 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Frozen U-Joint In Driver Side Front Axle
I have a '01 F250 with a frozen u-joint in the driver side front axle. My question is can I put it together without the axle and drive it?
View 2 RepliesSonata NF (2006-10) :: Right Side CV Axle Removal
2006 v6 Sonota had the passenger side CV axle break apart. I have the wheel spindle moved away axle but off and all that. There is a bearing mid-way on the axle which I have removed 3 bolts attaching it to the motor. The bearing just seems to not want to come off the motor. This is how it's done right? How to remove this bearing and get the axle out?
View 6 RepliesFord Transmission :: 1995 - Left Axle Removal?
I have to pull the left front axle shaft on my 95 250 4X4 to replace one of the axle ujoints. Before I get into this project, I'm going to replace all wheel bearings and related seals while I'm at it. Are there any seals that go into the differential that would be accessible after the axle is removed? Any quirks about getting it apart?
View 7 RepliesFord Excursion :: Front Axle Gears Removal
Well the old ball ball joints are out, new ones are in and now I'm working on removing gear assembly so I can change the inner axle seals. I've been trying to get it out. It haven't had much luck. I've loosened the cap bolts, prayed, pulled, hit, and still no luck. The only thing I've been successful at is screwing up the first few threads of the bolt holes for the passenger side cap. Tomorrow I'll be getting a tap and chasing the threads to clean them up. Hope I haven't screwed it up too bad. How to get the gear assembly out?
View 8 RepliesSanta FE SM (2001-06) :: Passenger Side Drive Axle Removal
I have a 2003 3.5 liter, AWD and I'm attempting to remove and replace the drive axle on the passenger side. I have the one end out of the hub, but the transmission end will not come out. I removed the bolts holding the bearing plate, and have been trying to pry out the axle with no luck.
View 3 RepliesFord Super Duty (1999-2016) :: 2008 F450 - Front Axle Removal
How do I get the front axles out of of the knuckle? It seems like the seals are holding them in? Is there any trick to to getting them out,I am trying to do my ball joints
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Parking Brake Cable Removal From The Axle?
What is the procedure to remove the parking brake cable from the axle? It looks like the cable has a locking device like the fuel lines but heavier. How do you get that thing out of there without destroying it?
View 9 RepliesFord Super Duty (1999-2016) :: Terrible Noise When Hit A Bump / Front Axle Shaft Removal
I have a E99 F350 7.3L 4x4 I know some or most of you have already probably replaced this part and or pulled a front axle shaft out. So here is my question...In the pictures provided you can see what I think everyone is calling a "Dust Seal" and as you can see it is bad and making a very terrible noise when i hit a bump...I was wondering what parts I would need to replace this seal? I tried looking it up and just get lost in all of the other things....I have found write-ups for the axle being removed while changing ball joints but none by it self to just replace this seal.
[URL] ....
Ford Super Duty (1999-2016) :: 2007 - Replacing Ball Joints - Front Axle Shaft Removal?
I am replacing the ball joints on my 07 f250 4x4. got down to the removal of the shaft itself and it won't budge. What is the secret here. Have to go to work on monday, and the weather in Cleveland isn't going to be very good on Sunday.
View 10 Replies