Ford Super Duty (1999-2016) :: Conversion Of Leaf Spring To Coil Spring?
Conversion from the dana 50 to the newer dana 60 with coil spring? My Dana 50 has called it quits so while my front end is already off the vehicle already why not make improvements. Ford used the 50 for 1999 to 2002 then upgraded to the 60, I'm guessing it was for a reason!
I've read this article on a similar project but the dana 60 had leaf springs as well: Dana 60 Conversion for F250 years 1986-1996 .: Articles I'd prefer coil spring, nothing more then personal preference with a bit of better ride quality. The donor vehicle is a 06 SRW F250 This is not what I'll be getting but just as an example of the parts I would get.
Ford Super Duty (1999-2016) :: 2002 - Driver Side Front Leaf Spring Snapped?
I just realized my driver's side front leaf spring on my 2002 F250 has snapped. I checked the weight sticker on my truck and it weighs 5200lbs in the front. My question is the heaviest springs I found only support 2630lbs a piece, so being a 7.3 is 5200lbs a correct weight for the front of this truck? also why would Ford make springs that support only 60lbs more than the front weight? Hell I weight more than 60lbs.... Did I snap the damn thing just by climbing into the cab?!?!
View 6 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Front Passenger Leaf Spring Just Broken
My front passenger leaf spring just broke on my 2000 f-350. My front springs are T code, but I was wondering if a could replace the broken one with a code X spring as a temp fix until I get a leaf spring replacement delivered?
View 1 RepliesFord Super Duty (1999-2016) :: Width Between The Spring Perches On Leaf Sprung Front Axle?
What is the width between the spring perches on leaf sprung 99-04 front axle. I searched and cant seem to find a dimension listed anywhere. i tried the dana60 bible on the pirate site as well, but it doesn't list the spring perch dimensions, only for the pre 99 styles
View 2 RepliesFord Super Duty (1999-2016) :: Spacing On Rear Leaf Springs?
I have a 99 SD 250 diesel, I also have a broken rear leaf spring. My truck has a 3 1/2 in. block between axle and leaf. My question is this. Can I remove the block and install 4" lift leaf springs without messing up my pinion angle? The blocks look square. But someone toldme once they are made to a specific angle for rotating pinion for better u joint alignment. Sounds like it could be true.
View 9 RepliesFord Super Duty (1999-2016) :: Replacing Rear Block - Axle Won't Separate From Leaf Springs?
I decided to go ahead and do a rear block replacement. I'm going to install the Ready lift 4 inch blocks.
I have both u bolts and nuts off of both sides. Rear stabilizer bar disconnected and both shocks disconnected. However, when I raise the rear of the truck, the axle raises as well. What could be holding it on still? I noticed there's a nut in the middle of the leaf springs. Do I take that nut off? I just don't know what could be keeping it from separating.
Ford Super Duty (1999-2016) :: 2003 - Clock Spring Has 8 Spring Wire?
Adding cruise control to F350 XL I just bought. I got a steering wheel with the buttons. But I am having problems with the clock spring. Mine has an 8 wire plug with only 6 pins on the big plug and all of the clock springs I have found have only a 6 wire plug for the big one. Without changing my clock spring I have no where to plug in the cruise wiring. All have been for right year model with cruise and even tried different years but none will plug in under the dash.
View 3 RepliesFord Super Duty (1999-2016) :: Wheels Rubbing The Leaf Springs
This is my dads f250 build date of 9/03. I know these wheels are not the factory xl wheels. I also think they changed something with the wheel back spacing somewhere around this time. He is running 285/70/17 bfgs and is rubbing the leaf springs pretty good. He ran this same size on his previous 02 model with no rubbing. Can he get away with 1/4 spacers? What years these wheels are from? And the backspacing differences, if any. His 02 had the chrome large bullet hole style wheels.
View 5 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Clunk In Front / Leaf Springs Bad?
As the title says are my front leaf springs bad? I got this truck 2 years ago and replaced all the ball joints, shocks, sway bar links,front hubs, rotors and brakes along with all the seals. I have a clunk in the front and I can't figure out what it's coming from. Could my leaf springs be clacking together? Truck
is a 2000 F250 SD v10.....
Driverside front
Rear spring
Ford Super Duty (1999-2016) :: 2000 F350 - Softer Ride On Leaf Springs
I have a 2000 F350 that was once a work horse. Its now just my daily. The leaf springs in the rear have 2 broken on each on and the front need to be replaced due to 344K miles on them too. My question is how do I soften up my ride on leaf springs though? Theres a local shop that will do the work, but my rears have 7 leafs / front 2. It used to tow daily but I dont tow anything with it. could I go to 5 in the rear to soften it?
View 14 RepliesFord Ranger / B-Series :: 2008 FX4 - Rear Leaf Spring Squeak
I've got an '08 FX4 that has developed quite a loud and annoying squeak from the rear leaf springs. It happens when I'm slowly applying power and going over bumps such as speed bumps or similar. More so when I'm going up hill.
I initially thought it was a u-joint going bad, and had my driveline mechanic take a look at it. He discovered it was the rear leafs making the noise. He sprayed them with an aerosol light grease and the noise was instantly gone. The problem is, the noise comes back after the grease spray has worn off (usually after driving in the rain) which happens a lot in the Vancouver area.
This is my 3rd Ranger and I have never had this problem. I don't drive in unusual places (beach, sandy, dusty areas) so I don't know why this is happening. It does look rusty in the areas that I can see in between the individual leafs. Is this a common problem for this vintage of Ranger?
Ford Super Duty (1999-2016) :: No Signal From Rear ABS Speed Sensor
I went to have the code read, and it was no signal from the rear ABS speed sensor. I replaced the sensor, and the light is still on. Also my speedo is off a bit. It is reading about 7-10 miles an hour faster than what it should. The mechanic can't seem to find the issue. I have a 06 F250, Powerstroke.
View 2 RepliesFord Super Duty (1999-2016) :: Rear End Wobble At 40 - 50 MPH Until Speed Up Or Slow Down?
Ive had this 2009 F250 4x4 Super Crew, 6.4 for 2 years now. Bought it the way it sits with a 6" ProComp lift and 37" Yokohama Open Countrys. Recently, once I get up to 40-45 mph, the rear end starts vibrating violently until I speed up or slow down. There isn't any clanking noise and it's silent. I look in the mirrors to see if it's the tires but they appear to be rotating smoothly. It's never done this before. It's like a tire is out of balance but it shakes much harder than that should be at that speed. It rides smooth as can be at any other speed all the way up to 80 mph which is the faster than i drive. What this could be? I've done searches but can only find info on the front end death wobble which is not the case here.
View 4 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Tire Rubbing On Plastic And Front Leaf Springs?
I just put some toyo at2 295.75.16. On my 04 250. And I've got some rubbing on the plastic and front leaf springs. If a 2.5 " spring left will take care of the rubbing or will I need wheel spacers.
View 3 RepliesFord Super Duty (1999-2016) :: 2007 - Inconsistent Shimmy From The Rear At Highway Speed
07 f250 has a shimmy from the rear at highway speed. Has new tires is worse with a load. What am I missing here?
View 3 RepliesFord Super Duty (1999-2016) :: ABS Light Came On And Throwing A Rear Speed Sensor Code
I've got a 2006 F350 5.4L.
The ABS light came on and it was throwing a 'rear speed sensor' code. I searched around and it seemed to be a common issue that the sensor goes bad and needs to be replaced.
I bought a sensor and replaced it, but in doing so, I saw that while the sensor was indeed bad (cracked) the wire right at the connector was corroded.
I replaced the sensor but the ABS light is still on the dash. Is it possible that they code simply needs to be cleared? I was able to read it with my OBD2 dongle and Dash Command App, but maybe I'm not able to clear it?
Or is it more likely that the corroded wire on the connector is the issue? (it wasn't fully corroded and I cleaned it up and sealed it.). It didn't look like I could pull the wires out of the connector, so I assume I'll need a new connector. What is the part number?
Ford Super Duty (1999-2016) :: 2003 F250 - Front Tires Leaf Springs Rubbing Even On Slight Tight Turn
I got an 03 f250 with a 10 inch lift on 40x14.50 tires on 20x10 fuel hostage wheels. They rub my springs pretty bad when trying to make even the slightest kind of tight turn and the sound they make when they rub is even worse than them actually rubbing. My question is should i stay with this tire and wheel setup and try to get some 6061 billet aluminum 2 inch spacers? (I'm not sure about going that route though because of what i heard about spacers) or go down to some 38s with a 20x14 wheel that hopefully would push the tire away from the hub like spacers would do. I'm leaning more towards going to 38s because of the rubbing and also because I feel they might look better on the 10 inch lift rather than the 40s but dont know whats the best thing to do.
View 12 RepliesFord Super Duty (1999-2016) :: F250 - Front Spring Spacing?
I am looking at a set of SD axles for my 92 F250. I have been looking for the last 2hrs and have found measurements for seemingly every axle in existence except for the SD D50/60.
What the center to center width is on the spring pads of the front axle. Wouldn't hurt to know the same measurement for the rear either.
Also, a bit more trivial, but still need to know, what is the size and taper of the draglink joint that goes in the pittman arm.
Ford Super Duty (1999-2016) :: How To Lift Suspension To Change Out Spring Bushings
2003 f250 6" lift on 35s. How to lift the suspension to change out spring bushings? Was thinking using two chain falls on tow hooks on the front, any easier, safe, cheaper way. I have a farm jack but need to weld a plate on bottom of it for more support...
View 5 Replies