Ford Super Duty (1999-2016) :: 2009 F250 - Rear Diff Fluid Change / Pinion Seal Leaking
I just picked up an 09 F250 a couple of weeks ago and I was planning on replacing all the fluids since I'm not sure when everything had been done in the past, but it did pull a camper 5th wheel. It has about 93000 Km/57000mi on it
One thing I noticed when reading the manual is that a rear diff fluid change is not necessary on these rear axles unless they have been submerged in water or repaired etc..
Just after I got it I noticed the pinion seal was leaking. It was fixed under warranty but the dealer did not replace the diff fluid as they said Ford will not pay for it.
My question is do you think I need to replace the diff fluid or should it still be good, given the relatively low mileage.
Ford Super Duty (1999-2016) :: 2002 - Dana 80 Rear Diff Ratio Change - Adjusting Speedometer Readings?
I have a 2002 F450 2WD AT with the common Dana 80 4.88:1 posi rear diff. If I change the ring & pinion to 4:10 do I need to change the carrier or does my current carrier fit 4:10 & lower [4.63,4.88, 5.13 etc]? Will I need to adjust my speedo readings & if so how is this accomplished? Electronically via the diagnostic port?
View 5 RepliesFord Super Duty (1999-2016) :: 2002 F250 5.4 - Valve Cover Leaking - Gasket Replacement?
I have a 2002 F250 5.4with Air Conditioning. The valve covers are leaking and the gaskets need to be replaced. I am attempting the valve cover gaskets. I was able to get the drivers side cover off with some difficulty. For the passenger side valve cover. There is very little " no" room to get at the bolts. I read somewhere that I may have to drop the engine on that side. I will do that if I have to.
View 5 RepliesFord Super Duty (1999-2016) :: Rear End Cover Has Been Leaking Oil?
My rear end cover has been leaking and I don't have time to fix it right now. I was going to check the oil and maybe add some if needed but I cant find anywhere to ad oil or check it? Am I missing something? The add plug is the one Id like to find.
View 2 RepliesFord Super Duty (1999-2016) :: Locking The Diff - Clunk When Turned On / Off
When I turned it on for a second, last winter, I rem hearing a clunk, and then another clunk when I turned it off. Made sense to me.. So, I figured I'd just activate it again now, and roll up and down the driveway once to exercise it. BUT, when I turned it on this time, the light came on, but no clunk when it came on, or off. I went up and down the driveway anyway, and I THINK it felt like it was ON, but I didn't make any turns, because I figured that would be bad.
Any one that is silent when it locks? I think I saw a post where everyone said it's supposed to clunk on/off. Could it just be the season/temps, only clunks in winter? I have a 4x2 btw, so it's just a turn switch. I hope it's not stuck or frozen somehow already..
Ford Super Duty (1999-2016) :: Replacement Of Rusty Rear Bumper?
my rear bumper is pretty much eaten up, too.
How difficult is this to replace?
Good source for rear bumpers? Just something stock; don't need anything wild, crazy, lighted, etc.
It's a work/hunting/fishing/hauling truck. That's all.
Ford Super Duty (1999-2016) :: 2011 - Front And Rear Brake Pads Replacement
I'm gonna replace my front and rear brake pads. Any tips? Do I need to pull the rotor off and clean the axel? I've watched a couple of youtube videos but they leave me with a few answers. I have all the tools, what kinda lubricants will i need? Any recommendations? I hoping I can do a flawless job without and squealing...
View 13 RepliesFord Super Duty (1999-2016) :: Rear Power Sliding Window Seals Replacement
My 2006 F350 has a nasty air leak/whistle coming from the rear power sliding window, unfortunately I found the one of the vertical seals laying in the cab. Looking for some insight on if there is a replacement seal kit, where I can find one and how difficult is it to install?
View 2 RepliesFord Super Duty (1999-2016) :: Rear Hub Outer Oil Seal Leaking / Replacement Part?
The rear hub outer oil seal on my 05 350 is leaking. The 350 Super Duty Twin Cab was never imported into the UAE so can I use the same seals as the Excursion or another Ford vehicle?
Failing that do we know the name and part number of a seal manufacturer whom I might be able to source from in Dubai? Ford don't make the seals them selves so there must be an alternate source for these things surely?
Ford Super Duty (1999-2016) :: 2001 F250 - Rear Pinion Bearing Replacement
I am working on my Dads 01 super duty with a 5.4, automatic, and the pinion bearing has seized up due to a lack of fluid from a rusted out rear diff cover. The tag on the diff cover had a 10.5 stamped on it and has 12 bolts. Is this known as a ford 10.5"
I have changed gears and pinion bearings in a Dana 70 before is this the same process? What are part numbers for a new pinion bearing and seal? Gears are in fine shape.
Ford Super Duty (1999-2016) :: Rear Sliding Glass Motor Quit Working - Replacement?
Trying to replace sliding glass motor, quit working and had to cut the cable to shut it due to the rain. It appears I need to remove the seat belts & covers next.
View 4 RepliesFord - Explorer :: 2003 - Front Diff Cover Seal Leaking / Replacement?
How hard is it to replace the front diff cover seal in an 03? Mine is leaking like a sieve... On a better note, it's the only leak I could find under my new-to-me Explorer.
Also found a broken coil spring in the rear, explains why it's leaning to one side. That is getting fixed later this week.
Ford Super Duty (1999-2016) :: 2005 F350 - Changing Ball Joints - Can't Remove Axle Out Of Diff?
2005 Ford 350. I want to change the ball joints on the front axel and I cant remove the axle out of dif. to remove the ball joint housing. I have been prying and pulling and it just moves out a 1/4 inch or so .They tell me there is no ring to remove in dif before you can pull it out but why this trouble?
View 4 RepliesFord Super Duty (1999-2016) :: Rear Axle Breather Vent / Brake Line Bolt Replacement?
so while replacing the rear brake lines in my 2001 F-250. / 5.4, the flex line that drops from the frame bolts to the axle through the axle breather threaded vent line. The friggin thing crumbled on me and now I can't find a replacement for it. Where I can get it or what it's actual name / part number is so I can call the Ford dealer and hope it's not obsoleted?
View 3 RepliesFord Super Duty (1999-2016) :: Leak At PTO Cover On Manual Transmission
I see an oil stain on/surrounding the lower half of what I'm guessing is the PTO cover on the side of my manual transmission. (rectangular plate bolted to side of tranny) I couldn't find a gasket at any autoparts stores. Is there a gasket or did Ford just use a sealer? Would red RTV work ok here instead of a gasket? Or should I use something else?
2004 F250 SuperDuty 4x4 CC, V10, 6 speed manual tran
Ford Super Duty (1999-2016) :: Torque For Differential Cover Bolts
Torque on the differential cover bolts, 2016 F250?
View 6 RepliesFord Super Duty (1999-2016) :: 2002 F250 7.3L - Replacing Valve Cover Gasket?
I'm looking at replacing the valve cover gaskets on my 02 f-250, it's a 7.3L.
Looking at them on line there are many different brands. What have you used on your 7.3L, and which has worked the best for you?
Ford Super Duty (1999-2016) :: 2000 F350 - Leaking Oil From A Bolt On Passenger Side Valve Cover
My 2000 f350 is leaking oil from a bolt on the passengers side valve cover. it is one of the bolts on top of the valve cover. Can I just remove the bolt and put a rubber washer under it or do I need a new valve cover?
View 2 RepliesFord Super Duty (1999-2016) :: 2001 7.3 Won't Start After Replacing Valve Cover Gaskets - Code P1316
Ok I have a p1316 code so I was told to change valve cover gaskets so I did. Now starts for 4 sec and dies, what is going on....
View 2 Replies