Ford Super Duty (1999-2016) :: 2011 F350 - Pinion Seal Leaking?
Pinion seal on my truck is leaking. At auto parts store they gave me National seal part number 4278. It does not fit it is too small.I went back and other seal they have is too big. What is the part number?
View 11 RepliesFord Super Duty (1999-2016) :: F250 - Engine Rear Main Seal Leaking
Changing out the rear main oil seal on my 1999 F250 Super Duty. I have a 7.3L diesel with 6 spd manual trans. with 98K miles. This past week it has developed a very slow engine oil drip where the engine meets the transfer case. Is it necessary to remove the engine or just the transmission? What does a transmission/transfer case combo weigh? What special tools would I need?
View 1 RepliesFord Super Duty (1999-2016) :: 2015 F350 - Rear Axle Pinion Seal Leak
I was looking underneath the truck yesterday and saw that the rear end pinion seal was leaking. Looked like it had been for a while. Truck has 35,850 miles on it. Unscrewed the fill plug and a lot of pressure is released. So I'm assuming the breather is clogged somewhere along the line. I have an appointment at the dealer on Friday to see whats wrong. What is supposed to be at the end of the breather tube? Mine has a barbed 45ish degree fitting on the end of it. Its a SRW by the way.
View 5 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Rear End Differential Fluid Change
I have a quick question. I am gonna change the fluid in my 01 f250 rear end. it has 410 gears and a limited slip diff. if i use full synthetic gear oil do i have to add the limited slip additive or just the 75w-140 full synthetic gear oil.
View 14 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Rear Pinion Bearing Replacement
I am working on my Dads 01 super duty with a 5.4, automatic, and the pinion bearing has seized up due to a lack of fluid from a rusted out rear diff cover. The tag on the diff cover had a 10.5 stamped on it and has 12 bolts. Is this known as a ford 10.5"
I have changed gears and pinion bearings in a Dana 70 before is this the same process? What are part numbers for a new pinion bearing and seal? Gears are in fine shape.
Ford Super Duty (1999-2016) :: 2002 - Dana 80 Rear Diff Ratio Change - Adjusting Speedometer Readings?
I have a 2002 F450 2WD AT with the common Dana 80 4.88:1 posi rear diff. If I change the ring & pinion to 4:10 do I need to change the carrier or does my current carrier fit 4:10 & lower [4.63,4.88, 5.13 etc]? Will I need to adjust my speedo readings & if so how is this accomplished? Electronically via the diagnostic port?
View 5 RepliesFord Super Duty (1999-2016) :: Rear Hub Outer Oil Seal Leaking / Replacement Part?
The rear hub outer oil seal on my 05 350 is leaking. The 350 Super Duty Twin Cab was never imported into the UAE so can I use the same seals as the Excursion or another Ford vehicle?
Failing that do we know the name and part number of a seal manufacturer whom I might be able to source from in Dubai? Ford don't make the seals them selves so there must be an alternate source for these things surely?
Ford Super Duty (1999-2016) :: 2000 F250 - Rear Hub Seal Leak?
I have a 2000 F250 4x4 7.3 - About a month ago I drove across town and then noticed a strong hot brake smell from the rear of the truck. When I drove home about 2 hours later it was gone and didn't return until today. Today I stopped at a light with my window down and got the same hot brake smell, looked in the mirror and saw smoke coming from my drive's side rear wheel.
I carefully drove home (the smoke was now gone, all i did was cycle the parking brake release a couple of times) and pulled the wheel off. Rotor was really hot but smooth and clean. Brake caliper and pads looked great (no sign of the pads glazing or dragging, dry as a bone). The inside of the rotor was wet with oil. The brake shoes and components were soaked with the same fluid/oil.
Does this sound like a typical hub seal issue? Excuse my ignorance since I haven't had the rear hubs apart before but does the gear oil in the rear diff go into the axle tubes? I know the front tubes are dry but I didn't know if the rears are different. The amount of fluid on the brakes seems to be more than the little bit that is inside the hub. I need to pick up the parts and rent/purchase a couple of tools to replace the seal so I want to be as sure as possible that I'm on the right track...
Ford Super Duty (1999-2016) :: Vibration / Pinion Seals Leaking
Well, I am getting a vibration In 4x4 99 f250 sd, pinion seals leaking and it has a little bit of movement. I have done a pinion bearing in a crown vic I had before. But not a dana 50. What am I in for, I searched but couldn't find a step by step , how long does it take a back yard guy.
View 2 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Power Steering Fluid Leaking From Lower Portion Of Gearbox
OK so my 2001 F250 was leaking power steering fluid from the lower portion of the gearbox (where the pitman arm attaches).
I found a thread on this forum where it showed how you could change the seals out WITHOUT taking the gearbox out.
So I got the pitman arm off with a heavy duty puller. Then I scraped out the 1st rubber seal hoping to reveal a snap ring behind it. Well, the seal is 99% scraped off, but there is not evidence of a snap ring. It does seem like there is some metallic ring holding another rubber seal in behind it. But again, I can't find the little open spots that you put your snap ring pliers in to get snap rings out.
How do I get this metallic thingy out???? I already broke a small drill bit trying to drill it out. It just doesn't seem like the best way to go about it.
Ford Super Duty (1999-2016) :: 2005 F350 - Rear Passenger Side Is Leaking Brake Fluid
I have a 2005 F350 XL Heavy Duty 6.0L truck that has 68,XXX miles. I recently changed the rear brake pads and about a week later the rear passenger side is leaking brake fluid. The fluid is slowly dripping from the bottom caliper bolt but i am not sure if there are seals in this area. the driver side is fine and the fluid is only leaking from the bottom caliper bolt not the top.
View 2 RepliesFord Super Duty (1999-2016) :: 2002 F250 V10 - Oil Leaking From The Rear Of Pan
If you look at the top of the picture you can see the two bolts with fresh oil on them.
I have a 2002 Ford F250 V10 Pick up. I noticed oil leaking from under the oil pan. I wiped off the pan and bolts to see where it was coming from. The oil seems to be leaking from the rear of pan. There's always fresh oil on the rear bolts that hold the pan and I also noticed oil coming from one of the two hoses that go from the radiator to where the oil filter mounts.
But don't those hoses carry radiator fluid and not oil? I bought this truck in July and no oil leaking from underneath. It seemed to have started after I did my first oil change on it. I used regular Vavoline 5W-20 and motorcraft oil filter.
Ford Super Duty (1999-2016) :: Rear Pinion Angle - Vibration In The Truck Around 65 - 70 Mph
Trying to figure out my rear pinion angle should be. I still have vibration in the truck around 65-70 mph and sometimes around 80mph if i go that fast. I checked my rear axle last night and its at 8.5 degrees on top of the pinion snout is that correct???? And i forgot to measure the rear driveshaft angle but i can do that after work when i get home. Truck is a 2004 ext cab short bed 4x4...
View 7 RepliesFord Super Duty (1999-2016) :: Rear Diff Cover Replacement?
I have a 99 F-250 superduty and my rear diff cover is pretty rotted and i need to replace it. I am on a college budget and i need a cheap one that will get the job done...
View 7 RepliesFord 7.3L Power Stroke (1999-2003) :: F250 - Changing Rear Diff Fluid?
I am changing the rear Diff fluid in my 1999 F250 Super Duty with limited slip differential. I have read in the manual that 8 ounces of friction modifier is required, ford dealer said it only required 4 ounces. I bought 8.
Also I asked for a inspections plate gasket and ford said use silicone... When I removed inspection plate it had a gasket. So, silicone or gasket or both? Differential capacity is 6.9 pints 75w/140w synthetic.
Ford Super Duty (1999-2016) :: Front Axle Seal Leaking?
I noticed the other day after my truck was parked on a bit of a angle there was diff oil from the passenger side on the ground. reading a bit on here i learned the axle seals are way in the front housing close to the front diff. and yesterday driving a heavy load around my front brake driver side got stuck on a bit and over heated and was smoking, couldn't even touch the rim it was so hot. anyway about this axle seal i got the hub off right now but cant seem to pull out the axle assembly through the knuckle but i see i have to pry and most likely wreck that seal. Looking for a link of piuctures or how to replace the axle seals in the housing.
View 11 RepliesFord Super Duty (1999-2016) :: Crank Seal Leaking At 88k Miles
Just had my truck in for an oil change at dealership and wanted them to check for oil leak seeing as I started getting drops on my driveway. When I pick up the truck they told me the front crank seal was leaking and possibly the rear main seal. Front was gonna be 650 bucks and the rear was gonna be 1020. Ended up taking truck to local diesel shop and they replaced front crank seal for 300 and said the rear main looked fine. Tech also told me the old seal looked worse than some that came out of engines with 3 times as many miles. 6.4L ...
View 1 RepliesFord Super Duty (1999-2016) :: 2003 F250 5.4L - Axle Leaking On Passenger Side Rear Rotor And All Over
Here's my problem while replacing brake pads i found that my axle has leaked fluid on the pss,side rear rotor and all over .. I been looking for any info on repairing it myself . I found Everything for every other truck just not for this truck.
It's 2003 F-250 w/5.4L all Stock rear axle has 12 bolts and gears are 7.73 ... I believe its a Dana 60. No tags or markings on the Axle to go by..
I live in the Freak-en woods here so i like to order all the right parts once and do over the weekend .. its my only ride so once apart im stuck here.... I did check the Vent Tube its fine..
Ford Super Duty (1999-2016) :: 2003 F250 - Leaking From Rear Of Passenger Side Head Gasket
So I've put about 1000 miles on my 03 F250 since buying it, and just the other day it's started leaking from the rear of the passenger head gasket. Enough to drip on the driveway and exhaust, and have some exhaust smell. 126,000 miles, 5.4
I've checked with my local ford dealer, and It also needs passenger exhaust manifold and studs, so the dealer price to tack that on would be a whole lot more too since there are already a couple studs broke. It would be best to get it done when the head is pulled.
I've checked with several local mechanics, and none of them are interested in pulling the head on this engine. That has me concerned about doing it myself too..especially since it fits in my garage with only a few inches to spare..