Ford Super Duty (1999-2016) :: Rubbing / Grinding Noise When Turning Left Or Right
My dually has started to make a rubbing or grinding noise just about every time I make a turn, left or right. What this could be, truck has 8500 miles on it.
SD Dually
Ford Super Duty (1999-2016) :: Intermittent Grinding In Front End When Going Over Bumps / Stops When Switched Into 4wd
Long time reader and first time poster, first off the truck:
1999 F-250 super duty
130,000 miles
not lifted
stock minus warn premium manual hubs ... v-10
For the past couple of years now I have had a strange grinding noise which is coming from the front end of my truck, it sounds an awful lot like if i was driving over one of the strips on the road that is made to warn drivers they are veering off the road. It first happened a couple of years ago and I took it into les schwab to have them check everything out, of course it never made the noise for them while test driving and after a visual inspection of the front end no conclusion could be made.
After about a month it completely stopped making the noise when going over bumps and i thought that "hey maybe it fixed itself!" well it did not, about 6 months after no strange noises at all it started to happen again, and once again it stopped. Now after about 8 months of it not happening it recently started again and i am determined to figure the problem out this time, it doesnt seem to be any worse of a noise or vibration but is the same as when it first started about 2 years ago. It stops when the vehicle stops, or when i switch it into 4 wheel high on the dash.
After taking it to les shwab again a few days ago they found no problems in the front end, no wheel play or noises when making tight turns (possible signs of bad wheel bearings?) and overall everything checked out well and said that the hubs do eventually need to be replaced in these. 2 days later I took it to 4 wheel parts for an inspection, after all of 10 minutes of driving they assured me that i needed new hubs and that was the cause of the problem, after installing the new hubs (warn premium manual hubs) the problem seemed to be fixed.... 3 hours of driving after the istall and no problems! Until today when I ran over a sewer drain and sure enough the grinding came back, flipped it into 4wd with a quick flip of the switch and no more noise.
I found a few similar on this board before but with no definitive solutions..... Possibilities that I have heard of that would cause this:
-- spindle bearings
-- wheel bearings
-- auto hub hydraulics
-- stock hubs (replaced)
Again this truck is all stock minus the new hubs, taking it into shops has proven to be a giant hassle because it never seems to make the grinding noise while they drive it so they check for wheel play and tell me everything seems fine.
Ford Super Duty (1999-2016) :: Extra Metallic Rubbing Sound When Letting Off The Throttle
Got some snow tonight and was driving home from work around 35-40 mph in 4x4. You can tell that everything is engaged by the feeling and noise. Just not sure if this is abnormal. When letting off the throttle there's an extra metallic rubbing sound that goes with the drivetrain speed. Not sure if I'm just hearing the driveshaft from being in 4x4 of if something is up?
View 14 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Rubbing Sound Near The Front Axle
I have a 2001 f250 7.3 4x4 today I locked the hubs, put it in 4 low and got threw some mud to go hunting fine. got back out of the woods and took it out of 4x4 unlocked hubs and went in reverse 30 yards.. Now when i drive it makes a weird sound like a rubbing sound near the front axle. What this is?
View 5 RepliesFord Super Duty (1999-2016) :: Grinding Noise Constant In 2 Wheel Drive
I have a 2001 F350 with a7.3 power stroke, 6 speed manual with manual t case and hubs. I have a bad grinding noise when in 2 wheel drive. Similar sound as if you are trying to shift t case into 4 wheel drive too slowly. The grinding is constant in 2 wheel drive, but if I shift it into 4 wheel drive, the noise completely goes away. I have been driving around in 4 wheel drive (T case only, manual hubs not locked) for the past 2 days. If I shift back into 2 wheel drive, a constant terrible grinding noise returns. What could be wrong, and why it goes away in 4 wheel drive?????
View 3 RepliesFord Super Duty (1999-2016) :: 2001 F250 4x4 - Loud Whining Noise Found / Wheel Seal Rubbing On Inner Part Of Bearing
I have a really loud whining kind of noise found that its the wheel seal rubbing on the inner part of the wheel bearing. I was just curious if its safe to drive with the spindle removed from the axle?
View 5 RepliesFord Super Duty (1999-2016) :: Intermittent Grind Sound That Would Come And Go Randomly
While on the way back from the deer lease last week my '99 f250 sd 4x4 5.4l started a grind sound that would come and go randomly. Lasts about 1 second. Seems not to change the way it drives. The dealer had it for 2 days and couldn't find anything. This happens at freeway speeds 55-70 mph.
View 2 RepliesFord Super Duty (1999-2016) :: 2006 - Grinding / Humming Noise - Bad Wheel Bearings?
I have an '06 F-250 that's making a quiet grinding/humming noise from what sounds like the front end. It doesn't seem to be coming from any side in particular, just an omnipresent noise whenever the truck is moving. It's constant with speed, and most noticable between 30-60 KPH.
Truck has about 268,000 KM on it right now, and has been worked pretty hard for whatever that's worth as well.
Ford Super Duty (1999-2016) :: Intermittent Moaning Noise Coming From The Wheels
A few months ago I bought a used 2006 F350 superduty with manual/ auto 4x4. For the last few months I have had an intermittent moaning noise coming from the wheels. It happens when going at slow speeds (under 30mph) I have checked all calipers and made sure none were frozen. Brake pads have at least 75% life in them. I put the truck in neutral to spin all tires by hand and try to replicate the sound.
The front seem to spin easy. The drivers rear will spin but is hard to move and the passenger side I can barely move (I'm assuming it's because it's the drive tire? I believe it has something to do with the rotation of the tire because when driving it moans in intervals. Like it's at a certain point in the rotation something is rubbing. How to troubleshoot further? When going through parking lots it is quite noisy and I can feel the running in my brake pedal.
Ford Super Duty (1999-2016) :: 2012 F250 Grinding Coming From Front End
I've been noticing a grinding coming from the front end of my 2012 f250 4x4, mostly while turning. It seems like its worse over uneven terrain, bumpy dirt roads, things like that, but I have noticed it on occasion while on seemingly smooth roads. Also a couple times while turning and lightly braking I could feel it interfere with the brakes. They wouldn't grab completely and you could feel the grinding in the pedal. I've been crawling around looking for rub marks or any indication of what might be causing it but until recently I hadn't noticed anything. Today though I found this. I'm guessing bad ball joint or tie rod maybe? Maybe just need alignment?
Passenger side lower control arm ...
Ford Super Duty (1999-2016) :: Intermittent Wobble As Front Driver Side Wheel Is Going To Fall Off
Had the death wobble a couple of months ago. Changed all shocks, steering stabilizer to bilsteins; new tires (stock), ready lift stabilizer(stock, no lift) had it digitally aligned. All was perfect. Until my new intermittent steering issues. It appears to happen when making a 90 degree turn, say a right or left onto a perpendicular roadway. As truck straightens out, you'd think the front drivers side wheel is going to fall off(you'd think the lugs are missing).
Pull int a parking lot, drive in a few circles, and all back to normal. Can't replicate every time, force for s few days with no issues, then it might happen again. Other intermittent issue is sometimes, again out of no where, truck will pull and track to the right or left. Pull the steering wheel the opposite direction, it'll track the other way. Again, pull int parking lot, do a few figure eight circles and back to normal. Alignment shop and regular mechanic say everything is tight, ball joint look fine.
Ford Super Duty (1999-2016) :: 2002 F250 - Intermittent Noise Coming From Front End
I have a 2002 F-250 7.3. I was driving home from work on Tuesday (highway), I heard an intermittent noise coming from the front end, sounded like a rubbing/grinding noise. Yesterday on my way to wok, same thing, on and off. Yesterday on my way home the noise was constant, didn't go away. The noise comes at about 45mph and stays until I'm back under about 45mph, so mainly just on the highway. I put the truck in neutral and let off the pedal and the noise is still there which tells me it isn't engine related.
Yesterday after work I jacked up the front end, spun the tires, no noise. No play in the tires top/bottom or side/side. Took the tires off and what I did notice is the right axle u-joint is shot. I am hearing the noise in 2wd so I don't know if its the u-joint that's making the noise. Could it be a bad wheel hub bearing? Is it the u-joint? Maybe needle bearing??
Ford Super Duty (1999-2016) :: 2001 F350 - ABS Light Comes On - Metal Grinding Sound
2001 f250 7.3 crew
So, Saturday my abs lite comes on. Later that day I hear metal to metal sound for a couple of secs then it stops. Then the next day while driving I get intermittent sounds that sound like I'm dragging metal down the pavement. I see nothing but I'm thinking hub bearing. (Needle)
I remove the hub assembly from the knuckle and can find nothing wrong. I even picked up a new hub just on case. Now I'm stumped. Can't figure out what the sound was or is. Axle has a little play going into the housing but figure it would have due to the only thing holding it in place is the hub.
The only thing left in the area that could make the sound is major --the actual gears to to the front end. If the bearing isn't causing the metal grinding sound I've no other idea other than that....
Ford Super Duty (1999-2016) :: 2001 F350 - Faint Grinding Noise In Left Front Wheel
I got a 2001 f350 got a noise in my left front wheel i know its not the wheel bearings, it only makes the noice when the locking hub is unlocked i did jack the the truck up and spun the wheel got a faint grinding noises form what seems like the locking hub so my question is bad locking hub or needle bearing holding the axle shaft??
View 3 RepliesFord Super Duty (1999-2016) :: Grinding Noise At Slow Speeds - Clunk When Coming To A Stop?
Every once in a while, while driving my 06 350 SRW at slow speeds, I hear a grinding noise coming from the left side of the truck. It is almost like a winding grinding noise if that makes sense. It will grind slow to a stop, and then I hear a clunk.
This is a very intermittent problem. The tires are completely shot on the truck, and I thought that would be it, but considering it is intermittent and the clunk I hear as I come to a stop I figured it could be it.
Ford Super Duty (1999-2016) :: 2001 F250 V10 Won't Start And Makes A Grinding Sound While Turning Over
I have a 2001 Ford F-250 with the gas v-10. Yesterday it started just fine as always. Today I get into it and it starts to turn over just fine then starts to make a grinding sound and the truck won't start. I have had a fuel issue in the mornings with once it started you had to barely press the gass to keep it running. But never makes a funny sound and always runs fine. This only last for a couple of min and then it runs fine for the rest of the day. The grinding is not the starter. I took it off and had it checked and it was fine.
The truck had been using oil. When I checked the oil level it was low but it was still on the stick. "I know a motor needs oil to run smooth but it's my dads truck and well let's just say he is not the best on maintenance". Also I smelled the oil and it does have a gas smell to it. So it definitely does have some gas in the oil. I tried to light the dipstick with a lighter and it wouldn't light. So not sure how much gas is in it but that's what I did.
So the question is, would something just in mid crank go bad and then not let the motor crank. Truck made no weird noises before this so I find it hard to believe the barrings just went out in mid crank and now it is shot.
Also I just checked compression on front cylinders.
Driver side read 75lbs
passenger side read 100lbs
Ford Super Duty (1999-2016) :: Clicking Sound From Front Right Wheel When Hub Is Not Locked
2004 F350 150,000km ... I have a rattling/clicking sound from the front right wheel when the hub is not locked (Free) and I hit small holes or run over rough roads. the sound is gone when I lock the hub front hubs.
View 3 RepliesFord Super Duty (1999-2016) :: Steering Wheel Squeaking Sound Inside The Cab
Is there a way to grease the steering shaft or whatever is making the squeaking sound inside the cab when I turn the wheel? It's a 2001 F250 CCSB Lariat and it drives me crazy hearing sounds I shouldn't be hearing. This is certainly not coming from outside the cab but rather in the steering shaft within the cab somewhere. How I can lube that up?
View 1 RepliesFord Super Duty (1999-2016) :: Clunk Sound Seems To Be Coming From The Rear
I had a pretty good clunk going on and found the passenger tie rod was shot. The rest of the steer components looked fine. Fixed it and still get a nice bunch of clunks. Went over the steering again with someone rotating the wheel and didn't notice any crazy movements. The drag link twisted a bit but the joints looked solid compared to the tie rod which was completely shot.
So I decided to dig into it today. Looked again and nothing. So I took it into my back yard to drive over some humps left from stump grinding. Clunk, clunk, clunk. I stuck my head out the window and wouldn't you know it the sound seems to be coming from the rear! Took a pry bar to parts like the sway bar links, shocks, etc.... can't detect anything. Maybe a u-joint? Gotta dig in I guess.
Also my rear springs creak like nothing I've ever heard. Dirt roads it's just creak, creak, creak.