Ford Super Duty (1999-2016) :: 2005 F350 - No Start - Not Enough High Oil Pressure
I have a 2005 f350 6.0 has 585000. Installed new hpop and lpop and new ipr .pressured oil system with air don't hear any leaks. After truck done started then put truck together no start same problem as before. No oil pressure on dash. All checks goqd except not enough high pressure.
View 2 RepliesFord Super Duty (1999-2016) :: F250 V10 - Leak From The High Pressure Hose On Gearbox?
My uncles 1999 v10 started to leak from the high-pressure hose on the gearbox. Replaced the hose which lasted for a short time but is now leaking at the same spot. The hose swivels, is this normal, seems like a dumb design for a pressure hose. Also is there a certain trick to doing this hose? He also insists on using PS fluid instead of the ATF it calls for. Could this cause a problem with the seal?
Edit: Also the truck has been lifted on 35s since 16k miles and its now roughly at 170k. He tows with it as it is his work truck. But the truck is well taken care of.
Ford Super Duty (1999-2016) :: 2005 F350 - Recommended Cold Tire Pressure
I have a quick question regarding tire pressure. Where we work, we have a 2005 F350.
Stock tire pressure for stock tires 275/70R18 states 65 PSI for the front and 75 PSI for the rear.
The truck currently has 295/65R18 tires all around. They are some sort of Wrangler tire, not sure of exact model, but they are more of a all-terrain tire. The truck sticks to the road though.
What would be the recommended cold tire pressure with these? Can I stick with what the stock tires would be?
Ford Super Duty (1999-2016) :: 2005 F350 - Vacuum Leak - Manual Locking Hub?
So I have an 05 f350 5.4 with the shift on the fly and the auto/manual locking hubs.. I already know I have a leak with the vacuum and I just use the hubs manually, then shift on the fly to activate the transfer case.
I went to use the 4wd the other night in a snow storm and I have no 4wd, light on the dash comes on and i can hear the transfer case clicking in when i hit the switch between 2wd and 4wd.
So I got under the truck while it was on the ground and manually locked the passenger side, Then tried spinning the axle and it wont spin freely, so obviously its locked.
Tried the same thing on the driver side and the axle spins freely while the hub is locked, So obviously the locking part of the hub is no good... So i guess my question is, even with just 1 wheel locking in the front, shouldn't I pretty much get 3wd? or am i missing something...will it not engage at all because both sides arent locked?
Ford Super Duty (1999-2016) :: 2005 F350 - AC Will Not Cycle / Blower Only Blow On High
2005 F350 Lariat ..... I cant get my AC to work in my truck.
AC will not cycle on, Originally thought the system was low because I jumped the pressure switch and it cycled fine (But did not cool inside the vehicle). Checked the pressure and it was in the 40lb range on the low side. My blower will only blow on high but I assumed it was a defective fan speed control.. Possibly an issue with the climate control?
Ford Super Duty (1999-2016) :: 2000 F350 - No Oil Pressure When Truck Started
So I went to start the truck this morning around 8:00 and it was 7 degrees outside, when the truck started the oil light came on and oil gauge was on low? So I turned it off right away. few hours later I tried it again and still nothing I thought maybe the oil was frozen. After I started the truck the oil was higher on the dipstick so I am assuming the oil pump is functional. What could be causing this? Could it be the the gauge is not working? The truck is a 2000 F-350 V-8 5.4 gas. I'm hoping it is something simple I am suppose to work this afternoon
View 14 RepliesFord Super Duty (1999-2016) :: F350 DRW - Oil Leak Out Of Front Housing
I noticed an oil leak out of the front housing of my 2016 350. I have 3 Ford dealers nearby and all 3 can't get me in until 8 August. It looks to be just a few drops daily. Is it safe to drive pulling a 5th wheel until they get me in? The leak is at the bottom of the housing.
View 3 RepliesFord Super Duty (1999-2016) :: F350 - Water Leak By Fuse Box
I got water leak after wash my f-350. My lock stopped work and when I opened fuse box I found lil water on fuse box cover. I'm wondering about any other solution before I try replace the seals on windshield
View 2 RepliesFord Super Duty (1999-2016) :: 2006 F350 - Vacuum Leak When In 4x4
When I put my 06 f350 in 4x4 my ac defaults to defrost. I assume this means a vacuum leak. My question is, is the white tube supposed to be open for air intake or plugged off with something?
View 5 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Gas At High Altitude
I've got a 2000 F350 crew cab with a camper I bought in Chile and I'm going to be driving it from the tip of south america back to the US. It's a 9 month epic family road trip. It'll involve crossing the Andes several times and going over 15,000 ft. There are roads up to 19,500 ft in various places.
My question is am I going to have problems with the altitude? What can i do about it? I've got another truck which is a unimog, it's slow as hell but has a special kind of booster gas you can inject in to the engine to get it started in very cold weather and at high altitude. I chose the F350 for the truck instead of the unimog because a unimog is slow as hell (think 40mph max speed), but it handles extreme conditions well.
Ford Super Duty (1999-2016) :: F350 V10 Fan Switch Only Works On High
1999 F350 Crewcab 4x4 dually V10. Fan switch only works on High. All fuses and relays look Good. Is it a bad speed control switch? What can it be?
View 8 RepliesFord Super Duty (1999-2016) :: F350 Missing At High RPMs
I have a miss at high rpms.. I pulled this engine, manual trans, and 4x4 axle and put them in my F350 Majestic motorhome. 156,000 miles on the engine. Slightly dusted engine with good compression 375-400 (cranking and corrected for altitude). Has a little bit of a long start.
No smoke on start up unless 10 degrees or colder
No smoke when pulling either.
Glowplugs ...Good
GPR... Good
Checked resistance from IDM to injectors ...Good
History of some ether for starting before I got my hands on it. I have AE with the ford enhancement. But I am new to working on a powerstroke and new to AE.
ICP ...new
CPS...new
Oil ....new
EBP...new
Installed a pressure gauge to the drivers side upper port on my fuel bowl:
60 psi at idle
55 psi at WOT 2500-3000 rpms under a load
HPOP stabilized pressure is 2750 @ 40% duty cycle
Truck still misses (semi-intermittently) at higher rpm with a load.
Rechecked codes KOEO: None present
I visually inspected valve movement while running (idle). Did the buzz test when cold.... All injectors sounded the same when tested individually.
Did a cct when not completely warm:
P0266
p0272
Repeated the test at normal operating temperature:
P0266
Torque values on rocker arms bolts and injector holds are good. Fuel quality isn't an issue since this problem has remained for 5 tanks of fuel. What I should do next?
Ford Super Duty (1999-2016) :: 2011 F350 - Tire Pressure Monitor Light Is On
Just got larger tires on my truck and tire pressure monitor light is on. How would I go about resetting this?
View 14 RepliesFord Super Duty (1999-2016) :: 2011 F350 - Tire Pressure Monitor Fault
I've looked at this 10 ways to Sunday, but the play on words have me questioning if it is the same thing. My truck says Tire Pressure Monitor Fault. I have a 2011 F350, if that makes a difference. I checked all my tires, they are about 80psi each, front and back. What could be the problem? Is it something to take to a Ford Dealer or something I can fix myself?
View 7 RepliesFord Super Duty (1999-2016) :: 2012 F350 6.7l - EGR System Torque Specs
Replacing EGR cooler/ EGR valve. Are there torque specs going back together with the EGR system? or is there a forum that has all the torque specs id need to complete the job.
View 4 RepliesFord Super Duty (1999-2016) :: 2006 F350 - Cannot Find AC Freon Leak
I had a new engine put into my 2006 F350 SD 5.4 last year and ever since then I can't keep the freon charged in my ac. The mechanic said all he did was lay the compressor out of the way and didn't disconnect anything ac related. I have 2 different shops keep my truck for a couple days and neither could find a leak. Yet a month later, freon is low. I think I have more dye in my system than freon.
I put 2 of those ac leak sealers, the ones you have to ask for behind the counter and can keep my ac working for maybe 45 days, then throw 3 cans in it. No dye is showing up nor will the sniffer find anything. I hate to go to the dealer because I figure they will want to replace everything. Any tips other than try another shop and maybe they can find the leak.
Ford Super Duty (1999-2016) :: 2003 F350 - Minor Coolant Leak
03 f350 5.4. Very minor coolant leak at the moment. Valley behind water pump looks a little damp and leak has shown a little on the passenger side block above the starter. Shows on the tranny bell housing and hits the y pipe every once and a while. I am thinking its the hose that runs under the intake manifold but wanted to check in here for some wisdom. Can it be bypassed or rerun without pulling everything.
View 12 RepliesFord Super Duty (1999-2016) :: 2002 F350 - Gas Oil Leak At The Back Of Engine
I have a 2002 V10 F350 6.8L that I recently purchased at auction and am fixing up. I've made good progress already and replaced many of the suspension components so that the tuck drives straight. It does however have an oil leak that seems to manifest of heavy acceleration.
I'm not sure exactly where from as I have not crawled under the car, but I can see a drip land right on the Y pipe coming out the exhaust manifolds. There is enough of a drip to create quite a smoke storm under the hood. Any common areas to look for?
Ford Super Duty (1999-2016) :: 2003 F350 V10 - Exhaust Manifold Leak?
2003 F350 short bed 6.8L V10---On start up a slight tap sound, almost like a cranky lifter, but it is an exhaust manifold leak. At the bolts, I am not sure. This has been this way for 5 years, no better no worse. After I run about 2 to 3 minutes it seals itself. Not a hint of noise. Due to heat, something is expanding to seal it (aluminum).
At my annual PA. State Safety Inspection the Tech says 'that has to be corrected if it worsens', but It does not fail inspection. This puzzles me.
How is the call made for correction. A flip of the coin, a guess and is it serious enough to fail inspection. Is this normal with the 6.8L or V10s. I know the cost involved for a fix is big league, but can it be justified. TRUCK RUNS GREAT !---