Ford Super Duty (1999-2016) :: 2005 F350 - Vacuum Leak - Manual Locking Hub?
So I have an 05 f350 5.4 with the shift on the fly and the auto/manual locking hubs.. I already know I have a leak with the vacuum and I just use the hubs manually, then shift on the fly to activate the transfer case.
I went to use the 4wd the other night in a snow storm and I have no 4wd, light on the dash comes on and i can hear the transfer case clicking in when i hit the switch between 2wd and 4wd.
So I got under the truck while it was on the ground and manually locked the passenger side, Then tried spinning the axle and it wont spin freely, so obviously its locked.
Tried the same thing on the driver side and the axle spins freely while the hub is locked, So obviously the locking part of the hub is no good... So i guess my question is, even with just 1 wheel locking in the front, shouldn't I pretty much get 3wd? or am i missing something...will it not engage at all because both sides arent locked?
Ford Super Duty (1999-2016) :: 2006 F350 - Cannot Find AC Freon Leak
I had a new engine put into my 2006 F350 SD 5.4 last year and ever since then I can't keep the freon charged in my ac. The mechanic said all he did was lay the compressor out of the way and didn't disconnect anything ac related. I have 2 different shops keep my truck for a couple days and neither could find a leak. Yet a month later, freon is low. I think I have more dye in my system than freon.
I put 2 of those ac leak sealers, the ones you have to ask for behind the counter and can keep my ac working for maybe 45 days, then throw 3 cans in it. No dye is showing up nor will the sniffer find anything. I hate to go to the dealer because I figure they will want to replace everything. Any tips other than try another shop and maybe they can find the leak.
Ford Super Duty (1999-2016) :: 2006 F350 6.0 HPOP Leak And Fuel In Oil / Hot Crank No Start
I'm just a shade tree mechanic try to diagnose a hot crank no start condition on my 2006 F-350 6.0 that I purchased second hand about six months ago. I first took it to a diesel shop to have them fix it and the mechanic told me that the stand pipes and dummy plugs needed changing out but couldn't tell me 100% if that would fix the hot no start problem.. I have been reading a lot about this problem and it seems that the snap to connect fitting on the HPOP is the most common problem on these trucks. It seemed easy enough to do so I went after it only to find it was already replaced with the updated part.
I went ahead and changed it anyway but it obviously didn't work. So today I pressurized the system through the ICP port with my small harbor freight compressor up to 80 psi and forced the IPR valve closed with 12v. I then listened for a leak in the passenger side valve cover with a hose stuck in the oil fill cap, the driver side cover from some drain hole under the air filter housing and in the oil filter housing. I could hear a mild hissing from the driver side and the oil filter housing but it was clearly louder from the oil fill on the passenger side. This leads me to believe I have a top seal leak from one of the injectors on the passenger side, but not 100% sure. Should I be hearing anything at all from the driver side and from the oil filter housing if its a bad seal in the passenger side?
Another problem I just found out I have seems like maybe fuel in the oil. I done a oil change this week after 3500 miles since last change and drained out five gallons of oil!! The oil seemed really thin. My coolant level is still good so the only thing I can think of is fuel dilution. Could this possibly be the same o ring or injector that is causing my hpo leak or something else? Will a bubble or balloon test diagnose this?
I bought a cheap OBD2 reader that works on my Ipad with a app called Dashcommand so I can see what codes were stored. The codes are...
P0401- Exhaust Gas Recirculation A Flow Insufficient Detected (EGR has been deleted)
P0528-Fan Speed Sensor Circuit No Signal
P0670-Glow Plug Control Circuit/Open
P0683-Glow Plug Control Module to PCM Communication Circuit
P2290-Injection Control Pressure Too Low
So far my thoughts are to replace the injector and nipple cup seals to take care of the hpo leak. Once I have the valve cover off, clean the injectors real good and cycle the fuel pump with turning the key on and inspect the injectors for a fuel leak. Is there a better way than this?
Ford Super Duty (1999-2016) :: Vacuum Leak - 4x4 Won't Engage
How to diagnose a vacuum leak without a vacuum leak diagnostic tool.
My ESOF won't engage, AC/heat blowers default to defrost - classic symptoms. And while we can leave without AC/heat, we really need the ability to engage 4x4 low, especially as we get higher into the Andes and the roads unsmooth.
Ford Super Duty (1999-2016) :: Vacuum Leak Under Dash Under Acceleration
I have recently developed a vacuum leak on my 2002 F-350 V-10 under the passenger side of the dash. It is only audible when I am accelerating moderately to heavily or when the truck downshifts going up a hill. None of the vehicles HVAC or ESOF functions seem to be affected by this leak from what I can tell, but it's rather annoying to listen to this loud sucking noise every time I hit the gas moderately hard such as climbing a hill or merging onto the freeway. I don't know how I could search for this leak since it only happens when I'm driving and accelerating and not at a stop. What might be going on or where I should begin my search?
View 2 RepliesFord Super Duty (1999-2016) :: 2004 F350 - Vacuum Pump Not Running
I have a 2004 F-350 diesel. My vent selector is always on defrost so I suspected a broken hose but traced all out and all seem to be fine. I disconnected the line coming from the pump to the tank and no vacuum. The pump doesn't seem to be running but it's hard to tell with the engine noise and vibration. What tells the pump to run and how can I bench check it?
View 8 RepliesFord Super Duty (1999-2016) :: 2005 F350 4x4 - Vacuum Hubs Won't Disengage
I have a 2005 f350 with the power stroke I went through the hole vacuum system all new hubs, seals, vacuum actuator and fixed it all now I'm having the reverse problems everyone has my hubs are locked all the time as soon as I plug in the vacuum actuator the transfer case is still in 2wd and will switch 4x4 and work and disengage but the hubs are always in unless I unplug the actuator ...
View 6 RepliesFord Super Duty (1999-2016) :: 2008 F350 6.4L - Vacuum Pump Continuously Running
I have a 2008 F350 FX4 with the 6.4l diesel, a couple weeks ago I was reprogramming the ecm and noticed the vacuum pump was running and wouldn't stop, so after a bunch of reading and testing i changed the solenoid vacuum valve. I tested all the vacuum lines and found no leaks.
View 3 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Electric Vacuum Motor Stays Running
I have a 2000 F-350 diesel and the electric vacuum pump went out. I bought a new one from napa and it would not stop pumping. Checked for leaks and found none. If I unplug the hose from the vacuum can the next day, you can hear it suck air so it seems I am holding vacuum. Problem is I burnt out the new pump in two weeks from running all the time. Bought another one and same problem.
So now I plug the electrical in and let it build up vacuum for a couple of minutes and then disconnect it so it won't burn out and I am good for days on vent controls and 4x4. If there has been a bad batch of pumps out there? I also unplugged the hose from the pump to the holding tank and put my finger over where the pump sucks and it still did not shut off.
Ford Super Duty (1999-2016) :: 4WD Is Only Working Now When Manually Lock The Hubs - ESOF Vacuum Leak
I noticed that my 4WD is only working now when I manually lock the hubs in (they have that options!), and the air blows out the defroster when I shift, so it looks like I have a vacuum leak. Where are the typical leak points on a 2006 F250? What's the best way to confirm a leak (other than just replacing all of the hose)?
View 2 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Vacuum Leak But No Check Engine Light
2002 F250 SD 4X4 5.4L. 4.5 inch pro comp lift tire size 305/75/R16. K&N cold air set up. 208,000kms
I know the truck does horrible on gas but lately is been getting worse, maybe I am getting 350km to a tank. Mixed highway city driving. Sounds like I might have a vacuum leak somewhere but I have no engine light. I've had the truck since last year and put about 10,000km. on it done regular oil changes .. brake maintenance no motor work so far.
Ford Super Duty (1999-2016) :: Fault Code P0442 (EVAP) Be Caused By ESOF Vacuum Leak?
I have 2 issues and wonder if they are related. I don't have a CEL but I'm getting a P0442 DTC with my code reader - EVAP system leak detected
Also, my ESOF doesn't work. The hubs will lock manually. Can this be related?
I've already cleared the code and it came back. My ESOF hasn't been working for a while but I just haven't had the time or motivation to look into it until now.
I tried the HVAC Test and there may be a slow leak in the system. I can get the vents to switch from defrost to face vents but it switches halfway back to defrost, both are on at the same time for 20 seconds, then it recovers and goes back to the face vents.
My 4wd relays seem to work as well.
Ford Super Duty (1999-2016) :: F250 - Vacuum Leak / Air Conditioning Coming From Vents Switches To Defroster
My 1999 F 250 5.4 liter. I know I have a vacuum leak because whenever I accelerate the air conditioning coming from the vents switches to the defroster. So my question is how do I go about finding the leak? My hubs in the front are manual so I know I don't have lines going up there. I do have some mechanical capabilities I've changed water pumps alternators brakes etc. But never anything with vacuum lines or a/c.
View 14 RepliesFord Super Duty (1999-2016) :: 2000 F350 - No Vacuum Signal To Heat Controls / Slight Miss At Idle
On a 2000 F-350 with 5.4 engine, where does the vacuum line enter the cab? I got a truck in with no vacuum signal to the heat controls, and it has a slight miss at idle. Both of these are signs of a vacuum leak, but i can not find the line going into the cab.
View 5 RepliesFord Super Duty (1999-2016) :: 2006 V10 - Loss Of Vacuum While Towing
Having trouble with vacuum on my '06 CCLB V10. I only lose vacuum while towing, not sure why. Lines all seem like they're fine. I have no issues while unloaded. What could be causing this?
View 8 RepliesFord Super Duty (1999-2016) :: F350 DRW - Oil Leak Out Of Front Housing
I noticed an oil leak out of the front housing of my 2016 350. I have 3 Ford dealers nearby and all 3 can't get me in until 8 August. It looks to be just a few drops daily. Is it safe to drive pulling a 5th wheel until they get me in? The leak is at the bottom of the housing.
View 3 RepliesFord Super Duty (1999-2016) :: F350 - Water Leak By Fuse Box
I got water leak after wash my f-350. My lock stopped work and when I opened fuse box I found lil water on fuse box cover. I'm wondering about any other solution before I try replace the seals on windshield
View 2 RepliesFord Super Duty (1999-2016) :: 2003 F350 - Minor Coolant Leak
03 f350 5.4. Very minor coolant leak at the moment. Valley behind water pump looks a little damp and leak has shown a little on the passenger side block above the starter. Shows on the tranny bell housing and hits the y pipe every once and a while. I am thinking its the hose that runs under the intake manifold but wanted to check in here for some wisdom. Can it be bypassed or rerun without pulling everything.
View 12 RepliesFord Super Duty (1999-2016) :: 2002 F350 - Gas Oil Leak At The Back Of Engine
I have a 2002 V10 F350 6.8L that I recently purchased at auction and am fixing up. I've made good progress already and replaced many of the suspension components so that the tuck drives straight. It does however have an oil leak that seems to manifest of heavy acceleration.
I'm not sure exactly where from as I have not crawled under the car, but I can see a drip land right on the Y pipe coming out the exhaust manifolds. There is enough of a drip to create quite a smoke storm under the hood. Any common areas to look for?