Ford 6.0L Power Stroke Diesel :: Oil Pressure Switch (Sending Unit) Location On E350
Will the oil pressure switch (sending unit) on my E series van be in the same location as on an F series truck even though the van's oil filter is under the engine instead of on top? I'm referring to the single wire sender for the dash gauge.
View 2 RepliesFord F-150 (2004-2008) :: 1996 E150 - Oil Sending Unit Location?
where is the oil sending unit on a 1996 ford, E150, 5.0 motor.
View 1 RepliesFord :: 1999 E-150 4.2L - Lost Oil Pressure Sending Unit
The oil pressure gauge is dancing on my 4.2L '99 Ford E-150 (V-6) and at times the oil light comes on but there's no rattling or other signs of oil deficiency in the engine. I'm pretty sure it's a problem with the sending unit and did an oil change today but for the life of me couldn't find where it's located. I looked all around the filter when I replaced it but to no avail. The Haynes manual and internet pics I find are not recognizable parts in them to reference. I can't tell if they're looking under the car, on top, driver's side etc.
View 11 RepliesCorolla / Matrix 2009-13 :: Oil Pressure Sending Unit?
know where the Oil Pressure Sending Unit is located on a 2011 Corolla. I am planning on taping into that so that I can attach a bypass oil filter that will slow filter the oil down to 2 microns. Although in doing that, I will not ever have to change the oil again, but only change out the filters and top the oil off. I will occasionally need to send in an oil sample to make sure that there is no degradation in the oil.
View 5 RepliesGolf IV R32 :: Small Oil Pressure Sensor Sending Unit
Looking for a "small" sending unit that works with an electrical gauge. When I mean small I'm talking smaller than 2 inch diameter and 3.25 inches long.
I have a sending unit with those dimensions and would like something more compact if at all possible. The range needed would be 0-100psi.
Trans Sport :: 1993 - Oil Pressure Sending Unit / Best Way To Access It
1993 TransSport 3.8: Where the heck is the oil pressure sending unit, and what is the best way to access it? What size of OPSU socket does it take; 1", 1 & 1/16", or 1 & 3/16". Do I need the 3/8" or 1/2" drive; extra deep or other wise? The van has a gauge on the dash.
View 6 RepliesCelica :: 92 - Can't Find Oil Pressure Sending Unit / Blinkers Don't Work
I have a 92 Celica 1.6L STX, first of all I can't seem to find my oil pressure sending unit, second none of my blinkers work! I've replaced the fuse, the flasher, and the bulbs they still don't work.
View 2 RepliesFord Ranger / B-Series :: 1997 - Oil Pressure Switch Location?
Apparently, top secret location of the oil pressure switch on the 1997 Ranger 4.0?
View 3 RepliesFord Ranger / B-Series :: 2000 - Fuel Pressure Regulator Location?
I have a 2000 Ranger with the 3.0. Was wondering where the fuel pressure regulator is located on it. I like pictures.
View 1 RepliesFord Ranger / B-Series :: 2000 - Fuel Injection Pressure Damper Location?
I have a 2000 Ranger with the 3.0 in it. Trying to find where the fuel injection pressure damper is located. I was told it's on the fuel rail. Just making sure I'm looking at the right thing.
View 3 RepliesDodge - Ram :: 1998 - Location Of Oil Pressure Sending Units?
It sounds like oil pressure sending units are an issue for these trucks.. where is it located? 1998 dodge ram 5.2 L ...
View 4 RepliesFord Ranger / B-Series :: Coil Is Sending Spark But Cylinders 4 / 5 And 6 Not Firing
Al right i have a 94 ranger 4.0 4x4 auto 186k ... The truck has new bosch double plat plugs gaped .054, new wires, MAF, TPS, FPR, O2 sensors, ECTS and I checked the intake air charge sensor and is fine ....
My issue is cylinders 4,5 and 6 dont fire... the coil is sending a spark, i can pull the plugs one at a time and watch them fire (strong blue spark)... All fuel injectors do not leak and spray a perfect cone out of all 4 holes and noid light test is good ...
The truck runs like crap back firing and no power under 4k and i can pull off all 3 wires for bank one and it make no difference and when i unplug the injectors no more back fire....
Prius (2004-09) :: Oil Pressure Sender Unit Location
Where the oil pressure sending unit is located? And could that be the cause of your low oil pressure when you still have almost full oil on dip stick?
View 6 RepliesFord - Windstar :: 2000 - Temp Sensors Or Sending Unit?
My question is about a 2000 ford windstar with 3.8 engine. Does this vehicle have a coolant temp sensor and sending unit or just a sensor?
View 7 RepliesFord - Explorer :: 1996 - Replaced Sending Unit - Overheating?
I had to replace the temp gauge in my 1996 Explorer. I also replaced the sending unit. Now, it is overheating, badly. I replaced the thermostat, twice. Filled the coolant and removed the air in the system. It seems to get good water flow, and there are no coolant leaks. The radiator looks clean, and the cap looks ok. But, as soon as the engine warms up, it goes right past the midline on the gauge all the way to hot - at idle. It gets worse if I drive it. I have grounded the gauge and it seems to be working fine. What could the problem be?
View 5 RepliesFord Ranger / B-Series :: 2011 - OEM Radio Unit Replacement
I have a 2011 Ranger. It came with Sirius radio which works with the AUX button on the head unit. This setup is not what I am use to. Anyway I want to replace the OEM unit with an aftermarket. My question is will this AUX connection effect an aftermarket radio connection?
View 11 RepliesFord 6.7L Power Stroke Diesel :: DEF Tank Removal And Sending Unit Replacement
I figured I would try my hand at making a video because I find them useful.. Anyway, if you plan on dropping the DEF tank and /or replacing the heater/sending unit.
2011 -2014 Ford DEF tank removal / sending unit replacement - YouTube
Ford 7.3L Power Stroke (1999-2003) :: Fuel Sending Unit Connectors
I recently dropped my tank and one of the connector clips broke taking it off. How can I find anther connector or clip, I have looked at the ford dealer, napa and oriellys with not luck. It seems as if they don't exist. The ford dealer wants me to buy a new fuel line. Also I did something that now I know is not good but I cut the connector out to take to the parts stores and they said that it can not be put back together. Is this true?
View 8 RepliesFord 7.3L Power Stroke (1999-2003) :: Temp Gauge / No Voltage At Sending Unit
I've read some treads on the temp gauge sending unit but I'm a little foggy on where to look for my problem. I just purchased a 2000 F250 7.3, temp gauge not working. It has a new sending unit. I read some threads about the voltage at the plug but I have no voltage on either side of the plug. The way I understand it red/white wire goes to the battery. Is there a fuse between them and which one is it? and if fuse is ok is there a cronic problem that someone might know of that I can look for?
View 7 Replies