Ford Ranger / B-Series :: 1997 - 5R55E Slips In Drive And Rev?
I have a 97 ranger 2wd 4.0 with 5R55E. Drives fine in 1st and second. Slips in drive and rev.
View 6 RepliesFord - Ranger :: 1999 - Takeoff And Drive After Loud Clunk Sound
1999 ford 4x4 ranger,auto trans and abs. My pick up would not move in either drive or reverse until i gave it a lot of gas. then after a loud clunk sound from underneath, it took off and drove normally. my mechanic said if the tranny is a quart low it will do that. i checked the fluid and it has too much fluid
View 4 RepliesFord Ranger / B-Series :: Transmission Locked Out - Truck Would Not Move When Put In Drive
Last night I backed up out of a parking space and when I put it in drive it wouldn't move. It seemed like the transmission was locked up. What happened? The truck was running fine. It's a 2002 Ford Ranger 3.0 with auto transmission. Getting it serviced? I'm tempted to go to a dealer. What the problem is? Repair costs? The fluid looks good - no burning smell.
View 5 RepliesFord Ranger / B-Series :: 1997 - Truck Will Rev Up And Down From 500 - 1000 RPM When Rolling In Drive
I have a 97 Ranger 4x4, 4.0L, A4LD, 68k mi. with P0171 and P0174 codes, lean fuel mixture banks 1 and 2. The truck will rev up and down from 500-1000 RPM when Im rolling in Drive. When I accelerate, its fine, but when I let off the gas and roll it starts revving again causing the truck to shake. I replaced plugs and wires before the codes (1-2 months ago). After the codes came I replaced the fuel filler neck (not because of the codes), cleaned the air filter, cleaned MAF, changed fuel filter, and checked fuel pressure which was at 29psi so I replaced the fuel pump. Is there any common causes for this? Cures?
View 14 RepliesFord Ranger / B-Series :: 1988 Truck Will Not Pull In Reverse / Overdrive / Drive / Second Or First
I have a 1988 FORD Ranger with the 2.9 liter engine with the four speed automatic overdrive transmission. Several days ago the transmission went out. The truck will not pull in reverse, overdrive, drive, second or first. Usually most vehicles will usually have at least the reverse, A first or second when the drive and overdrive stops working altogether. What the problem could be?
View 1 RepliesFord Ranger / B-Series :: 1987 4x4 V6 Transmission Slips Out Of Gear
I have a 1987 ford ranger 4x4 2.9l v6 but my transmission slips out of gear and its auto im not sure why but ive been told im missing a over drive gear is this a possibility or what???
View 1 RepliesFord Ranger / B-Series :: 2003 - Intermittent Growl On Takeoff
Ok, basic rundown. Stop at a red light, turns green, when i go it gives a strange grindy-growl from the rear. Lasts maybe 2 seconds then its gone. its very uncommon. But it is something i am interested in getting figured out. Doesn't happen any other time, only on complete stops.
View 2 RepliesFord Ranger / B-Series :: 1998 2.5 Auto - Stumbling On Takeoff
I've been through this same scenario quite a few times before but I cannot narrow it down to the exact problem. I've got this 1998 Ranger that's maintained well, tune-ups, oil changes, and everything else maintenance wise. The past few months randomly driving anywhere from 200-300 miles every once and awhile it would hesitate taking off from a stop or accelerating after letting off the gas. It would throw up a P0171 code so I thought the fuel pump was bad. So I replaced with a new fuel pump assembly. That worked, fuel pressure is now within specs. 65-69psi. Still every 200-300 miles it would throw up a P0171 code, then a few weeks ago it kept coming up more frequently.
I found out it was a broken vacuum hose from the purge valve to the intake manifold tube so I replaced it. Now it doesn't come on anymore. But before I noticed that hose I assumed the mass air flow sensor was bad so I cleaned it with CRC Mass Air Flow cleaner. Since that time it's gotten worse and now stumbles and hesitates every time you stop and takeoff. Sometimes it even chokes the motor out with the a/c on and you come to a stop. I knew the ignition coil also causes the same issues so I checked them. The front coil pack had a burned electrode leading to number 4 cylinder intake side. I replaced the coil cleaned that end of the wire and it still is stumbling and hesitating. I tried the trick of unplugging the mass air flow sensor and driving to see if it was better. No change at all.
After I replaced the coil a few minutes ago I test drove it and stopped and then turned a corner and gave it full throttle with a/c on and it actually shut off. But still there is no check engine light and no codes present. What's going on? I looked at the back coil and didn't see any corroded terminals. It started happening all the time upon takeoff right after I cleaned the mass air flow. But when I unplugged the sensor and drove it around nothing changed at all. Is there something else to check? I had the timing belt changed last week and had the shop check to see if timing is good and they said it was right on. It still drive good you just have to tap the gas twice when you take off to overcome the stumbling.
Ford Ranger / B-Series :: 2000 XLT - Transmission Slips When Starting From A Stop
2000 Ranger XLT 4x4 3.0L Auto
So a couple months ago I had a transmission problem. It shifts high and hard all times and after the "od" light gets going (after it gets warm), the transmission slips (like riding clutch) when starting from a stop. If I went from drive to 1st gear with the selector and back, it cleared the slipping problem for a bit. I did an oil/filter change and about 50 miles later the truck is running fine, no issues. One day I hopped in it to go to work and it was like nothing ever happened. Fast forward 1,500 miles later. I start to notice the transmission is subtly shifting weird, like a small jerk when shifting. It gets worse over 50 miles and now I am back to the above problem. Is there a way this could be a sensor or solenoid problem? I never heard of a transmission correcting an issue then starting at it again so much later.
I don't like fixing or working on an issue unless I am at least 95% sure what the problem is. I also don't have $2k to plop down on a repair at the moment. Would it be worth it to take this to a dealership and see what trouble codes I am getting? I would try a transmission shop but it's not guaranteed they will have the test equipment to check a ford transmission. Also a friend said that AutoZone and other stores can't check transmission codes. So what's the best option here?
Ford Ranger / B-Series :: 1998 - Clunk Noise Only Happens In First Gear On Takeoff
I've been having this problem for about 2 weeks now, and I am trying to figure it out. I know the video is only 5 seconds but at least you can hear the sound, it only happens in first gear, on take off, about 2-5 seconds after the take off, and the sound is coming from the rear axle area. I cant figure out if its diff or brake related.
Ford ranger Rear end noise - YouTube ....
Ford Ranger / B-Series :: 1996 - Squeak / Chirp On Takeoff - Not At Idle
There's a small but clearly audible chirping/squeak coming from my truck whenever I pull out. It goes away after the truck gets hot, but for the first 10 minutes or so, it squeaks only when moving. Not at idle. It is worse at low RPM's in 1st gear. And it's particularly bad in the mornings. I was thinking it is something in the idler pulley or the belt tensioner.
View 7 RepliesFord Ranger / B-Series :: 1999 - Four Wheel Drive Will Not Engage
I bought a 99 ranger few months ago cant the 4x4 has not worked in the truck for about 4 years. Bought it off my dad. He hasn't figured it out the t case locks in the drive shaft spins but hubs will not lock in. Has new hubs in it and still not working. Trying to get it fixed so I can park the diesel for the winter and run the ranger.
View 3 RepliesFord Ranger / B-Series :: 1999 - 4 Wheel Drive Quit Working - Wiring Diagram?
My son has a 99 ranger and the 4 wheel drive quit working. Traced it to the front hubs not getting vacuum. If I jump around the vacuum solenoid(not sure if that's what it's called), the 4 wheel drive works. Looking for a wiring diagram that shows how this is supposed to work electrically?
View 5 RepliesFord Ranger / B-Series :: 1999 - Truck Will Miss / Sputter And Buck Randomly
1999 Ranger 4.0. I have an issue with my ranger. Sometimes the truck runs awesome.While driving along the truck will miss and sputter and buck, when this happens, I almost can't maintain my speed. Sometimes when this happens if I put the truck in neutral and shut it off and restart it. The problem will temporarily go away. Occasionally it will go away on its own. When it goes away on its own it's like someone flipped a switch and all power is returned and running smooth. When the truck is at idle it depends on the mood of the truck, sometimes it's fine and other times it wants to die. I got to make this truck last awhile longer.
View 7 RepliesFord Ranger / B-Series :: 1999 XLT Won't Crank Over - Truck Start When Manually Engaging Starter Relay Under The Hood
1999 XTL 4.0 auto, was doing fine, replaced Interior light bulb, now wont crank over!!! i suspect the anti theft system... how do i fix or ByPass the security system, i can start the truck by Manually engaging the starter Relay under the hood.
View 1 RepliesImpala - Chevrolet :: Transmission Slips During Takeoff
Cars transmission slips during take-off . 180,000 miles , does it need service, modulator valve or replacement?
View 1 RepliesFord Super Duty (1999-2016) :: Slight Delay Going Into Reverse From Drive
Today I noticed that our 5R110 was delaying slightly when shifting from drive to reverse. It was probably about a 1-2 second delay but it replicated itself twice in a row. There was no delay going from reverse to drive. It is just an engagement delay. We are running a Superchips Heavy Tow tune on the truck, it is a 2006 6.0 Powerstroke.
View 4 RepliesFord Super Duty (1999-2016) :: Transmission Delay When Put Truck Into Gear
I have a delay when I put my truck into gear. It only happens when I have turned the truck back on. It happens in forward as well as reverse. What is causing this? Syncros?
View 8 RepliesFord Super Duty (1999-2016) :: 2013 F250 - Drive Train Shutter Upon Takeoff
Having trouble with a shutter upon take off in there drive train. It only happens when I am going straight. It does not do it when I am turning or anything. I just bought the truck used sat. It has around 18000 miles on it. I haven't had a chance to put a load on it yet to see if it does it then.
View 14 Replies