Ford Ranger / B-Series :: 1999 - 4 Wheel Drive Quit Working - Wiring Diagram?
My son has a 99 ranger and the 4 wheel drive quit working. Traced it to the front hubs not getting vacuum. If I jump around the vacuum solenoid(not sure if that's what it's called), the 4 wheel drive works. Looking for a wiring diagram that shows how this is supposed to work electrically?
View 5 RepliesFord Ranger / B-Series :: 2004 - 4 Wheel Drive Vibration At 40 MPH
I recently replaced the oil seal on the front differential where the front drive shaft connects to the diff. I believe it is called the pinion oil seal. I had to remove the drive shaft to do the job. Got the oil seal in place and then slipped the u-joint yoke on and hand threaded the retainer nut on to get it started. I did mark the relative position of the drive shaft to the front yoke and the rear yoke. I had previously noted that the retaining nut, before I took it off had about 2.5 threads showing. I had to remove it with an impact wrench.
So...I used the impact wrench to put it back on with about the same number of threads showing. I then reinstalled the little short fronmt drive shaft...the one that comes out of the transfer case. I got the front of it on to the pinion output on the front diff...and then had to reattach it to the transfer case end which, by the way an interesting affair with a sort of metal cone that is attached by 6 8mm fine threaded bolts about 2.5 or 3 inches long. Got all that done with much grunting an groaning - I'm laying on the ground - SO the oil, leak is fixed but now ...
There is a vibration at around 40 mph and higher. like something is out of balance. did i damage the front diff pinion bearing by using an impact wrench? this vibration occurs in 2 wheel drive. as i understand it the front drive shaft doesn't even turn when in 2 wheel drive. my question is does the front diff gears spin when in 2 wheel drive? perhaps the u-joint is bad on the front drive shaft? just a bit baffled. when the speed drops to below 40mph the vibration goes away...
Ford Ranger / B-Series :: 1999 - 4x4 Does Not Engage
I drive a 1999 ford ranger and can't figure out why my 4x4 won't engage. I have vacuum all the way down to the hubs and when I turn the switch it sounds like the transfer switch is engaging but the 4x4 still doesn't engage. What do you all think could be the issue? I thought about just putting a set of the manual locking hubs on it and just be done with it.
View 1 RepliesFord Ranger / B-Series :: 2004 - 4 Wheel Drive Kick In And Out When Driving
My 2004 Ford Ranger has 220,000 miles, runs great, and when I bought it this summer the 4 wheel drive worked great. Starting when the weather got cold when I engage the 4 wheel drive (no lockouts electronic engagement). I will drive and it will kick in and out of 4 wheel drive when it starts to slip or I have to accelerate.
When the 4 wheel drive kicks out I will let off the gas then it will engage again on its own, but will slip out again when on ice or I start to slip. When the 4 wheel drive engages it does NOT make any strange sounds, no clunking or nothing, it engages smoothly, and disengages properly.
What it could be? a connection? Any way to fix or diagnose the problem? I have been told that it probably is not the transfer case, because if it were it would not engage or stay in 4 wheel drive at all.
Ford Ranger / B-Series :: 2007 FX4 - Clunking Sound From Front End In 4 Wheel Drive
There is a clunking sound and feel from the front end of my 2007 Ranger FX4 when in 4 wheel drive. This happens sometimes but not always on engaging or disengaging 4 wheel drive, as well as sporadically while driving along. I took it back to Ford on warranty with this problem last year, and after a few attempts I had them admit that something was wrong and they finally diagnosed that it was the front drive shaft that was binding where it leaves the transfer case, this was replaced. I have now put maybe 50km (max) on in 4 wheel drive and the problem is back, I don't think the problem was ever fixed.
View 14 RepliesFord Super Duty (1999-2016) :: 2015 - How To Engage 4 Wheel Drive Correctly
I have just switched from GM to Ford and have a new F250 4x4 XLT. I am wondering how to engage 4 wheel drive correctly. I have the manual shifter and the manual lock hubs. However during my test drive I shifted the lever into 4H and 4L and it seemed to engage just fine. Do I need to lock my hubs as well? Or if im just in a wet spot can i just shift into 4h without locking my hubs? I know if I am in anything serious I need to lock the hubs. I just want to be sure before I get into a tricky situation. My 02 GM all i had to do was push a button and it shifted automatically.
View 7 RepliesFord Super Duty (1999-2016) :: No Outcome When Turn On The Switch On The Dash To Engage 4 Wheel Drive
I have a 2001 f250 7.3 powerstroke it is an automatic. It has the switch on the dash to engage the 4 wheel drive. When I turn the switch nothing happens.. no lights come on or anything. it has warren locking hubs. What my problem is???
View 2 RepliesFord Super Duty (1999-2016) :: 2003 - Locking Hubs When Trying To Engage To Shift Into 4 Wheel Drive
I recently purchased a 2003 F350 FX4 Dually with the 7.3L Diesel. It has locking hubs and electric shift in the cab.
I have had locking hubs before that you had to engage to shift into 4 wheel drive and I have had trucks without locking hubs.
My truck didn't come with a manual, so I am looking for instructions for the proper use of this system.
Ford Ranger / B-Series :: 1999 Truck Has A Delay When Put Into Drive Sometimes It Slips At Takeoff
I have a 1999 ranger 3.0 4x4 automatic the truck has a delay when put into drive sometimes it slips at take off unless I force it to downshift and stay in first and from second to third gear it shifts very hard at around 3500 rpm would an oil and filter change. I do not have the cash for a new trans and I can't afford a new truck. I love my little ranger...
View 10 RepliesFord Ranger / B-Series :: 1999 - Squeaking Front Wheel Bearings
4x4 1999 Ranger ... They are a squeaking and driving me crazy. How hard are they to do, do they need a press or can they be done at home?
View 7 RepliesFord Ranger / B-Series :: 1997 4X4 SXT - 4 Lo Won't Engage
97 automatic 4x4 SXT 4.0L. 4Hi will engage, but when I shift to neutral, press foot on brake, and shift to 4lo, nothing happens. No light, no sound. Occasionally it will make a sound, and even more rarely will light up, but it does not feel like 4Lo is engaged even when indication says it is. I pulled the shift motor and replaced, as well as verified that the transfer case could be shifted to 4 hi and lo by using an adjustable wrench. I have not put truck on stands yet, but I'm pretty sure 4 hi is truly engaging. I did attempt to engage with shift motor connected electrically but not mechanically, and it shifted. What is keeping 4 Lo from shifting? If it's a vacuum issue, wouldn't 4 hi not shift? I did check the vacuum lines and the vacuum reservoir and they seemed to be okay.
View 3 RepliesFord Ranger / B-Series :: 4wd Does Not Engage - Lights On The Dash Flash On And Off
I have a 1999 Ranger 4x4. My 4wd does not engage when I turn the switch to 4wd lo or 4wd hi. The lights on the dash flash on and off. I disconnected the battery and now the lights are clear. But if I try again to engage it, the lights return. I feel I have a vacuum issue but would like to know more about locking hubs. If I convert them over, how do I know that my system will work? There has to be something else that changes from 4wd lo to 4wd hi. How do I check to see if this is working properly.
View 6 RepliesFord F-150 - 1997-2003 :: Wheels Do Not Engage When Shifting Into 4 Wheel Drive
I have a 1998 F-150 and when shifting into 4 wheel drive (manual floor mount shifter) the drive shaft from the transfer case turns but the wheels do not engage.
Looking for a diagram of how the axle works?
Ford - Explorer :: 2003 - Push Button For 4 Wheel Drive Won't Engage
So my Push Button 4 wheel drive wont engage. The light on the dash wont light up and it doesn't shift into 4x4. Where to start? I would like to check the simple stuff first. O and my heat only gets hot when im giving the vehicle gas. This is all on a 2003 Ford Explorer.
View 2 RepliesFord Ranger / B-Series :: Hub Spins On Driver Side But Tire Won't Engage
1987 ford ranger loaned it out and they said the hub spins on the driver side but the tire won't engage so it has no 4 wheel drive. Soon as I get it back hopefully today will know more.
View 14 RepliesFord Ranger / B-Series :: 2000 - Trans Won't Engage - 4R44E Shift Cable?
I bought a 2000 Ranger 4x4 3.0L auto today from the neighbor guy sight unseen with a "bad tranny" for $400. I'm very unfamiliar with the Ranger family, but long story short:
When moving the shift lever, the trans doesn't engage. It needs to be engaged from underneath. Do the cables tend to stretch, or break? I can't find any adjustment on it anywhere.
S-10 :: 2001 4 Wheel Drive Won't Engage
I have an 01 s10 with the 3 switch 4x4. When I switch into 4hi I hear the click at the dash and I hear the switch on the transfer case but it doesn't engage in 4x4. The lights o. The dash act normal and says its in 4 wheel. I've had problems with the switch on the front of the transfer case in the past and was able to clean it and it was OK for awhile and now nothing. I replaced that switch and hear it working but still not engaging. I did notice a bad vac line on the firewall but not sure where it goes yet. Is there an order I should be checking components? What should I look for next? Also should mention in 2hi I get a whining noise like a shaft is spinning but when in 4hi the noise goes away and it drives like its in 2hi.
View 1 Replies4Runner/GX470 :: 93 4 Wheel Drive Won't Engage?
on a 93' 4 runner that will not engage 4 wheel drive. The 4 wheel manual shifter works fine, and the linkage underneath looks fine; however, the indicator does not light up - and it definately only has rear wheel drive.
View 5 RepliesLexus GX 2004-09 :: 4 Wheel Drive Won't Engage
After I push the switch for the 4 wheel drive, the light on the dash blinks but the front differential won't lock in even after driving around the block.
View 14 Replies