Ford Ranger / B-Series :: 1998 2.5 Auto - Stumbling On Takeoff
I've been through this same scenario quite a few times before but I cannot narrow it down to the exact problem. I've got this 1998 Ranger that's maintained well, tune-ups, oil changes, and everything else maintenance wise. The past few months randomly driving anywhere from 200-300 miles every once and awhile it would hesitate taking off from a stop or accelerating after letting off the gas. It would throw up a P0171 code so I thought the fuel pump was bad. So I replaced with a new fuel pump assembly. That worked, fuel pressure is now within specs. 65-69psi. Still every 200-300 miles it would throw up a P0171 code, then a few weeks ago it kept coming up more frequently.
I found out it was a broken vacuum hose from the purge valve to the intake manifold tube so I replaced it. Now it doesn't come on anymore. But before I noticed that hose I assumed the mass air flow sensor was bad so I cleaned it with CRC Mass Air Flow cleaner. Since that time it's gotten worse and now stumbles and hesitates every time you stop and takeoff. Sometimes it even chokes the motor out with the a/c on and you come to a stop. I knew the ignition coil also causes the same issues so I checked them. The front coil pack had a burned electrode leading to number 4 cylinder intake side. I replaced the coil cleaned that end of the wire and it still is stumbling and hesitating. I tried the trick of unplugging the mass air flow sensor and driving to see if it was better. No change at all.
After I replaced the coil a few minutes ago I test drove it and stopped and then turned a corner and gave it full throttle with a/c on and it actually shut off. But still there is no check engine light and no codes present. What's going on? I looked at the back coil and didn't see any corroded terminals. It started happening all the time upon takeoff right after I cleaned the mass air flow. But when I unplugged the sensor and drove it around nothing changed at all. Is there something else to check? I had the timing belt changed last week and had the shop check to see if timing is good and they said it was right on. It still drive good you just have to tap the gas twice when you take off to overcome the stumbling.
Ford Ranger / B-Series :: 2004 - Slipping In Park Position With Clunk Noise As If Popping Out Of Gear
So my new/old 2004 has another issue. Parked at the grocery store tonight on a very slight incline backwards. Put the Ranger in park (automatic shift) and before I could fully engage the parking brake it began to roll back with a clunk, clunk, clunk as if popping out of gear.
Need less to say I moved to another spot that was more level. Just an hour before I parked the same way on a steeper incline and did not get this. Now I need to watch this carefully until resolved. How to remedy this issue.
Ford Ranger / B-Series :: 1998 - Won't Disengage Out Of 3 Gear?
I have a 1998 ford ranger and it will not disengage out of 3 gear. The truck still starts but if you let of the cutch. Of course, It stalls. I'm doing the work myself but where I should start looking.
View 1 RepliesFord - Ranger :: 1999 - Takeoff And Drive After Loud Clunk Sound
1999 ford 4x4 ranger,auto trans and abs. My pick up would not move in either drive or reverse until i gave it a lot of gas. then after a loud clunk sound from underneath, it took off and drove normally. my mechanic said if the tranny is a quart low it will do that. i checked the fluid and it has too much fluid
View 4 RepliesFord Ranger / B-Series :: 1998 - Gear Shift Indicator Is Wrong
98 Ranger 4x4 4.0 L Supercab. Today I replaced my instrument cluster lights. When I put everything back together i noticed my gear shift indicator is off and I cant shift into 1st or 2nd. What did I screw up?
View 5 RepliesFord Ranger / B-Series :: 1998 Truck Couldn't Get Any Speed In Gear / Code P1131 And P1151
I have a 98 ford ranger with a 3.0 v6 it has 228,000miles standard tranny but I keep the truck running great. I did the plugs and wires about two weeks ago and it was running fine, actually great. This morning I got into the truck to start it this morning and it barely started. It fired up but barely stayed idling. I would get into the petal and it wouldn't raise rpms. I had to get to school so I headed out. I couldn't get any speed in gear the truck wouldn't gain speed. It would sputter and pop and then all of a sudden it would go ok but then start popping again. I took it to a buddy shop and his scanner showed p1131 and p1151 both codes. I don't know what to do?
View 13 RepliesFord Ranger / B-Series :: 1998 - Whining Sound In First Gear And Reverse That Varies According To Engine RPMs
I am looking over a 1998 Ford Ranger. Very low miles for its age (67,000) and kept in very good shape. When I took it for a drive, I noted an issue.
- there's a whining sound in first gear and reverse that varies according to the engine RPMs. I thought it might be the power steering pump, as that whined when I turned the wheel.
However, the noise went away when I shifted to the higher gears. Been a while since I drove a stick - my Bug back in 2003, IIRC.
What I might be getting into? I really like this machine, aside from that issue, and I would like to nail the problem down ASAP...
Ford Ranger / B-Series :: 2003 - Intermittent Growl On Takeoff
Ok, basic rundown. Stop at a red light, turns green, when i go it gives a strange grindy-growl from the rear. Lasts maybe 2 seconds then its gone. its very uncommon. But it is something i am interested in getting figured out. Doesn't happen any other time, only on complete stops.
View 2 RepliesFord Ranger / B-Series :: 1996 - Squeak / Chirp On Takeoff - Not At Idle
There's a small but clearly audible chirping/squeak coming from my truck whenever I pull out. It goes away after the truck gets hot, but for the first 10 minutes or so, it squeaks only when moving. Not at idle. It is worse at low RPM's in 1st gear. And it's particularly bad in the mornings. I was thinking it is something in the idler pulley or the belt tensioner.
View 7 RepliesFord Ranger / B-Series :: 1998 - Loud Thumping Noise From Dash
Ok I have a 1998 Ford Ranger XLT 4.0L automatic 4X4 with A/C my problem is i just had the timing chain,water pump, thermostat, upper and lower hoses, and front crank seal replaced. I got it back and right away noticed a thumping noise at idle only... My gauge was always steady at the same spot it had always been. but the thumping was loud when idling. Now the sound seems to have moved farther towards the engine instead of the dash and tonight when i popped the hood noticed the top hose was collapsed and i could feel no pressure. the thumping noise seems to be coming from the area of the thermostat. I have no oil in the coolant and no coolant in my oil! I tried to get the air bubble or pocket out if thats what is the problem by running the engine till hot with the radiator cap off but it made just a huge mess. it did seem to push a huge air pocket out but still does the loud thumping. This all started the day i got it back from the mechanic so I am assuming its an air pocket. I planned on changing the thermostat tomorrow.
View 14 RepliesFord Ranger / B-Series :: 1999 Truck Has A Delay When Put Into Drive Sometimes It Slips At Takeoff
I have a 1999 ranger 3.0 4x4 automatic the truck has a delay when put into drive sometimes it slips at take off unless I force it to downshift and stay in first and from second to third gear it shifts very hard at around 3500 rpm would an oil and filter change. I do not have the cash for a new trans and I can't afford a new truck. I love my little ranger...
View 10 RepliesFord Ranger / B-Series :: 1998 - Ticking Noise Under The Hood As If Lifters Sticking
1998 ranger 5spd... I have 117k miles on this little ranger and I recently took it on a little trip and since that trip it has a ticking noise under the hood as if the lifters were sticking. I believe it has hydrolic lifters in it. I put some sea foam in it 200 miles ago and changed the oil about 50 miles ago. I used Valvoline full synthetic and it seems like it has lessened the tick and it drives a lot smoother, in my opinion. Is there any thing else I can do to relieve that ticking? It is more noticeable when the engine first starts and is louder if i push down harder on the gas. It is not preset if i do not put that much pressure on the gas.
View 6 RepliesFord Ranger / B-Series :: 1998 - Engine Noise / Sound Coming From The Lifters
I have a 1998 ranger 2.5L engine. I took it to a Ford garage and they told me I have a rod knock..........I took it also to a good mechanic and he said the sound is coming from the lifters.
There is 172000 miles on motor and the noise started at 131000, and is getting worse. Should I drive it till it blows, or is there a way to tell what the problem is?
Ford Ranger / B-Series :: 1998 4x2 2.5L Auto - Whistling Noise Coming From Rear Only Sometimes
My Ranger has 296,000 miles on it. Most everything has been replaced except the u-joints. It's a 2wd 2.5L with an automatic. The motor was replaced at 228,000 with a used motor with 52,000 miles. The transmission has about 60,000 miles on it. All the bearings in the rear end were replaced about 20,000 miles ago. It has the most annoying whistling noise coming from the rear only sometimes. I don't know if it's the brakes being misadjusted or a bearing with a burr in it. It happens at random times but it's such a high pitched whistling you know everyone on the road can hear it too. There is also a driveline vibration, very minor though when over 60. However, I've had the drums checked and even had the wheels balanced many times. My friend said the ujoint grease could be dried up, but the whistling noise only happens at random, the virbation is anytime you're at highway speeds. It's not a violent vibration just enough to tell that it's not a brand new truck anymore. What it could be?
View 2 RepliesFord Ranger / B-Series :: Ringing Noise When In Gear At Idle
I noticed recently that when my Ranger is sitting idle in gear (drive or reverse) it's making a high pitch ringing noise. It doesn't do it in Park or neutral. Just had the truck inspected last week so it's driving OK. I don't think it does it while I'm moving with the RPMs up, but maybe the sound of the engine is masking it, I don't know. Anyway, what this could be? Something with the transmission since it only does it in drive and reverse? It doesn't do it all the time but a lot of the time.
View 1 RepliesFord - Ranger :: 1998 - Clunk Upon Acceleration
When stopped and accelerating normally I hear an audible clunk, but feel nothing. If I gently accelerate from stop it does not occur. 1998 ford ranger 4x4 ....
View 1 RepliesF Series :: 1998 - Squeaking Noise In First Gear At Low Speed
I have a 1998 F-150 and I have a squeaking noise and I can only hear it when I am in in first gear at low speed and when I'm in reverse backing up and goes away when I press the clutch pedal. I'm thinking its either my U-Joints or Throwout bearing.
View 3 RepliesFord Ranger / B-Series :: 2003 - Clunk When Driving In The Snow
I've been dealing with this for 2 years now and its going to snap my axle shaft one of these days. I am scared to take it out in a snow storm because the truck will clunk and then release. Its a split second thing but its enough to notice and make me worry a lot. I cant figure out why and ive done the plugs and wires but that didn't solve the problem. It only happens when its snowing or when I drive though a gust of wind that has stired up some snow. I know it must be something electrical because it only happens when there its cold and wet and not all the time. In the rain it does not matter but when it snows i just wont go out at all. The truck is a 2003 4.0 4x4 with a manual. Not a function of the 4 wheel drive it happened in 2wd as well.
View 14 RepliesFord Ranger / B-Series :: 1997 - Rear End Clunk Only Under Power?
Only clunks under power. Push in the clutch and it's fine. I haven't pulled the diff cover just yet....
View 14 Replies