Ford Ranger / B-Series :: 1996 - Power Steering Replacement
I'm in the middle of replacing my pump. With the new pump are a plastic washer and a small rubber o-ring but no instruction where they are supposed to go. They didn't know at auto zone and I haven't heard them mentioned on any youtube video. I found a crushed torn up washer similar to the plastic one in my catch pan. Maybe it is supposed to go in around the high pressure hose connection.
View 6 RepliesFord Ranger / B-Series :: 1992 - No Heat / Power Steering / AC?
1992 Ranger 4x2 with 2.3L stick shift no AC no power steering. Recently the temp gauge began fluttering in the cold range from far left to just below the normal range. The defrost and heater blows only cold air. I had a professional shop radiator flush done. No change. I changed the engine thermostat out for a new one but no change. The upper radiator hose feels hot, so I assume the thermostat is working.
Questions: Where is the temp gauge sensor located on the engine? Is there another sensor or shutoff before the heater that might not be working? Where do I take things apart to check if the heater blend door is working?
Ford Ranger / B-Series :: 1999 - Smoke From Steering Column
Within the last couple of weeks, periodically I see small amount of smoke coming from the steering column, from the hazard switch. It only lasts a couple of seconds. I've owned my 99 Ranger for about 7 years now, and since I got it, the dome light has never worked, even when installing new fuses. I'm suspicious it's the multi-function switch but not sure. What this means. I'm no mechanic, I just read alot, and from what I've read, this seems to be the issue.
View 3 RepliesFord Ranger / B-Series :: 2004 - Hard To Turn - No Power Steering?
My Daughters 2004 Ranger has about 195K the power steering reservoir is full it turns to the left as it should (assisted power steering) turning to right there is no power steering (manual Rack) I am thinking the issue is most likely in the steering rack..
View 2 RepliesFord Ranger / B-Series :: Power Steering Leak / Sensor On High Pressure Line?
I think I've tracked my power steering leak to some type of sensor on the pressure line, close to where it connects to the steering box:
I assume this is a pressure sensor? I got no CEL or anything like that when the fluid had leaked down to the level that the pump started whining pretty badly though. As far as I can tell by looking at pictures, the parts store replacement pressure lines do not have this sensor, or any provision to connect a sensor to it: Advance Auto Parts: Power Steering Pressure Hose by Powercraft - Part 71878
I may just put a replacement line on there and leave the sensor plug hanging and see what happens...
Ford Ranger / B-Series :: 1986 - Power Steering Shaking Then Spinning On Itself To Hard Left?
My 40 Ford pickup is on an 86 Ranger chassis and uses the stock Ranger steering gear. My question is about the connections on the steering box. I'm using a GM power steering pump and several steering gear vendors have told me that outside of needing to adjust the pressure for the correct feel, the combo works. I fired the truck for the first time tonight but the steering wheel went crazy, shaking around and finally spinning on it's own to a hard left.
Some quick research leads me to believe that I have the lines reversed but it would be great to know for sure. I did manage to find on e diagram of a Ford PS box on Google and it shows the lines reversed of what I have set up on my truck and I can't for the life of me remember how I figured out what the plumbing should be when I installed it. Which port on the box is the inlet and which is the return?
Ford Ranger / B-Series :: 2000 - Power Steering Pulley Wobbles Slightly / Belt Squeaking
I purchased a new 2000 mazda b4000 2 weeks ago and the belt was squeaking and I knew I had to change the water pump so I replaced it and the squeaking didn't went away... I thought maybe my idler pulley bearing was worn out cause I could see it wobble back and fourth when the engine was running... Replaced it, still squeaking! Change my belt still squeaking! look further turns out my power steering pulley wobbles slightly. I'm thinking about trying a gator back belt and see if the squeaking goes away. Could it be dangerous to run the truck as it with a slight misalignment in the power steering pulley? or it'll be a must replacement asap?
View 3 RepliesFord Ranger / B-Series :: 1992 - No AC And Power Steering / Poor Clutch Disengagement Resulting Hard Shifting
1992 Ford Ranger 4x2 with 2.3L engine and 5 speed manual transmission. 135,000 miles, no AC and no power steering. I am having poor clutch disengagement and resulting hard shifting. The shop added a little fluid to the reservoir last oil change and it is still looking full. I always park on concrete and never see any leaking. I don't know what may have been done before as I haven't had the pickup all that long. Where should I start? Is there probably internal bypass leaking in the hydraulic clutch as there seems to be no external leaking?
View 4 RepliesFord Ranger / B-Series :: 1993 - Power Steering Or Gear Box / Return Hose Leaking Where Rubber Meets The Crimp
Either one of my power steering hoses or the gear box is leaking on my 93 Ranger. It appeared the return hose was leaking where the rubber meets the crimp. So I decided I would go ahead and change the return and pressure hose to see if it stops the leak. It was a disaster. It's 2.3L manual transmission 4x2. I got the return hose off ok. I put the wrong size wrench on the pressure hose fitting at the pump but thought it was loosening but it was rounding the nut off. So I couldn't even change that hose. I installed the new return hose and retightened the pressure hose at the gear box.
Well it was a pain getting the flare fittings of the hoses into the steering box so I could tightened the flare nut down. I finally got them tightened, I think, but then when I started the engine fluid shot out of there like a water hose. It's coming from the fittings at the gear box that I thought were tightened. I reloosened and retightened them again and still it's shooting out everywhere. There is so little room getting a wrench on the hose fittings, it was slow going. What do you need to remove in order to get a good straight shot and installing these flare nut fittings and tightening them down right? If I remove the pump will it be easier to install the hoses on the gear box? I have to remove the pump now to change the pressure hose.
Ford Ranger / B-Series :: Power Steering Lost While Pulling Out Of Parking Lot Making A Sharp Turn - Fluid Leaking?
I was pulling out of a parking lot making a sharp turn when all the sudden I lost my power steering. I have a '94 Ford Ranger manual transmission. It didn't make any sounds. I was going to try to keep adding power steering fluid to it and try to get it home to my mechanic in my hometown - but it drips constant liquid when I drive it down the street (you can see drips) so I don't think that's possible. I've read a lot on here about gear boxes failing, but would this cause it to leak even if the truck wasn't running? (the puddle builds quickly when its just sitting there, engine off). I took it to a mechanic (I don't have tools), and they said they can't say anything for sure until they look around, it could be seals or a new gear box.
View 2 RepliesFord Ranger / B-Series :: 1999 - Power Door Locks Installation?
I'm finally bringing my 99 regular cab to Texas next month and I'm putting together my first list of upgrades to do it. On the top of that list is a remote start system. I am considering installing power door locks so I can install a nicer RS system. It would allow me double my starting distance and take strain off my already bad back since I won't have to lean across the cab to let people in.
View 2 RepliesFord Ranger / B-Series :: 1999 - Started To Loose Power When Driving Up A Hill
I was driving up a hill an it started to loose power. i got up to the top of the highway an stopped an it just shut down. got towed home i thought it could of been the alternator but dose not seem to be. took the belt off to spin the motor an its not spinning. drained the oil an there is no metal in it to see if the motor was done. i try to start it an it just dose a click click an that's it. Is the motor done or is it a transmission problem?
View 3 RepliesFord Ranger / B-Series :: 1999 - Lacking Power / Idles Erratically When First Start It In The Morning
ok so let me start by saying, my name is Tim, I own a 1999 Ford Ranger 6 cyl, 3.0L truck, I bought it brand new in 1999 and drove it for a few years and then took it off the road for 3-4 years then last year I went to put it back on the road and I couldn't get it running.
I took it to the dealer and they replaced a key switch module. since then the ranger seems to lack power. It also idles erratically when you first start it in the morning too.
not sure whats going on here but the engine light is on,
I get codes P0171 & P0174 (too lean bank 1 and too lean bank 2)
I would also like to note that I have replaced the fuel pump, fuel filter, transmission filter, MAF sensor, IAT sensor, PCV valve, EGR valve, TPS sensor, idle control solenoid, fuel pressure regulator & new plugs. I have also checked for vacuum leaks with no avail.
Ford Ranger / B-Series :: 1999 - While Going Uphill Cuts Back / Looses Power And Jerks?
I have a 99 Ranger 4.0 4x4. When driving on a hill, the truck cuts back and looses power. I can press the pedal and go into passing gear and it will pick up speed but that is the only way the speed will increase and not slow down. The truck jerks when this happens.
Things I have tried:
Replace all plugs and wires
Replaced Coil Pack
Replaced Mass Air Flow sensor
Replaced O2 sensor
Replaced throttle cable
Took truck out of overdrive
Changed to better grade of gas
Changed oil
I had Cat. Converter checked
There are no codes showing. Truck may drive OK on one trip but act up on the return. It seems to use a lot more gas when it is acting up. I now have run out of options that I know about.
Ford Ranger / B-Series :: 1999 - Electrical Malfunction - Burning Smell - Hard Downshifting - Power Window Quit Working?
I'm having some issues with my 99 ranger. It all started on my way to work one afternoon. Going down the road I started to smell some type of electrical burning smell. I looked at my instrument cluster and seen a trail of smoke come up between the steering wheel and ins cluster from under and gear selector covers. After that the O/D off light started flashing and downshifting hard. My pwr windows and dome light also quit working. Checked fuse #26 and all my fuses before going into work that afternoon, all of them were good and none blown. After shift was over that night going home I needed to use the wipers and they wouldn't work either. Also noticed then that my speedo, odometer and trip odometer not working. I've pulled my dash and steering covers off trying to find or see anything but nothing yet.
View 14 RepliesFord Ranger / B-Series :: Steering Rack Boot Replacement?
So I have ordered practically a whole front end for my Ranger. I decided to replace all the bushings, ball joints and shocks. Only thing not getting replaced are the springs, steering knuckles/hubs and sway bar. I did find that the lower half of the upper left hand sway bar bushing was completely missing along with the upper left ball joint boot. I was looking into replacing the Rack and pinion bellows/boot. I noticed that there is a line that goes up into the boot where it attaches to the body of the rack and pinion. What is that and does it need to be removed to replace the boot?
View 3 RepliesFord Ranger / B-Series :: 2002 - Knocking Felt In Steering Wheel
I have a 2002 Ranger 2.3L 5spd w/ 16,000 miles. Have noticed this problem for 6 months, been to dealer 3 times now. They say nothing is wrong. What I am "feeling" more than hearing, is a slight knock in the steering wheel, particularly when driving over dips and mild to moderate bumps. This is usually when moving in a fairly straight line, not much tension on the wheel.
It reminds me of problems I had on much older cars/trucks when there was a loose shock/strut or play in a ball joint or tie rod. It is annoying because it feels like something is wrong. Dealer can't find anything. Perhaps something not installed properly that loosens and bumps/knocks into other components thereby transferring vibrations through the steering column?
Ford Ranger / B-Series :: Steering Wheel Slightly Turned To The Right When Going Straight
I had a friend do an alignment on my truck yesterday. Afterward, we tried to center the wheel the best we could in the shop. But when I drove it home I noticed that when going straight, the steering wheel is ever-so-slightly turned to the right. Is there and easy way to adjust this without me going back to the guys' shop and bugging him again? I know the alignment is dead nuts, but the wheel is just a tad off.
View 4 RepliesFord Ranger / B-Series :: PS Leak And Pump Goes Empty When Steering With Motor Off
My truck lost its exhaust a few months ago and it's on the back list of things for this truck so I've been running it without it. However, my neighbors do not like it so, I frequently shut the truck off and coast in down my driveway to park it when it's late. But anytime I do that, I will park the truck and notice a puddle of ATF(ps) on the ground and the PS pump goes empty. Nearly no loss for a weeks when I don't turn the wheel with the motor off.
View 2 Replies