Ford Ranger / B-Series :: 1994 - Coolant Loss / Head Gasket Leaking
I am working on my buddy's 1994 Ranger with a 2.3L I4 that has been going thru a large amount of engine coolant. The trucks has approximately 180,000 miles on it. When I had it parked on concrete I have not seen any signs of coolant on the concrete or any signs of coolant leaking. The next place I checked was inside the cab to see if there was any coolant from the heater core and there was not. The water pump has been replaced a couple of years back. I replaced the spark plugs today and did not see anything on the plugs that I would have thought were signs of coolant in the combustion chambers.
With that being said I have not worked on a vehicle with a leaking head gasket before. Would there be any visible signs on the sparks plugs? If so what would I be looking for? When standing in front of the vehicle with the engine running there is a slight smell of antifreeze being "vaporized". Are there any noted issues with this engine that would cause this? Are there any other things I should check? Could it be a leaking head gasket causing this? If so how can I check for that?
Santa FE SM (2001-06) :: 2004 FWD Blows 50 Amp Fusible Link
We have a IGN 50 amp Fusible link that keeps popping out!! If I pull it out and put it back in the car will start for about 5 seconds till the fusible link let's go then it dies!! Pull it back out and replace it, it will restart for 5 seconds again!! I unplugged about everything under the hood and still pops the fuse!! Replaced the CPU and does the same thing!! Can't hear the file pump running so I unplugged it and if you unplug the IGN 50 link, then replace I only get 4.7 volts to the pump but the link still let's go after about 5 seconds!!
View 28 RepliesPrius (2004-09) :: 12V Battery Won't Hold Charge - Fusible Link Broken
About 4 months I accidentally reversed the polarity when jumping my car and fried my 12V battery and blew the fusible link. I replaced it with an Optima yellow top but due to other issues I haven't driven the car since about that time.
Last week I got most of the other issues resolved and tried starting the car, nothing. It was reading less than a volt on the voltmeter. I used my portable jump starter and got the car started. I only drove it to the gas station (1 mile round trip) to fill my tires and back. I went to start it the next day and nothing again. I thought maybe I didn't charge the battery enough since I hadn't been driving it.
I charged it overnight using a wall charger and again the next day it wouldn't start. Yesterday I jumped it again and drove it about 20 minutes, about half at low speeds (<30 MPH) and half at higher speeds. I got home put the car in park, but still on, and checked the voltage again, about 13.8 V. Turned the car off and checked again and I could see the voltage dropping like a rock. Within about 30 seconds it was down to 6V and within another 30 seconds it was so low that I didn't have any interior lights or dash lights.
It seems to me like the battery is bad. However after I "fried" the original battery I had similar issues. In fact the reason I had to jump it in the first place is because the battery died a few times in the same day. Could something be killing the battery?
Ford Ranger / B-Series :: Changing Stabilizer Bar End Link?
Is this hard to change out?
View 7 RepliesFord Ranger / B-Series :: Missing The Nut On Top Side Of Front Stabilizer Bar Link Bolt Assembly
Today while driving I noticed a knocking when turning right or going over bumps in the road. I finally got to look under the truck and noticed that I'm missing the nut on the top side of the front stabilizer bar link bolt assembly on the passenger side.
It's a '99 Ranger XLT 4x4. Is this unsafe to drive? Is there a bushing on the top?
Ford Ranger / B-Series :: New Alternator Not Charging Battery?
Is there a fusible link from the alternator to the battery? The new alternator that I put on and got tested is not charging the battery. Was wondering if it could be a fusible link but I couldn't find it. Where it is located on a 2000 ranger?
Also, I put a DC volt meter on the negative side of the battery and the positive side of the CHARGING wire that would be connected to the alternator and got the same reading as if I put the meter on the positive of the battery.
Does this mean the fusible link is good?
Ford Ranger / B-Series :: 2001 - New Alternator Not Charging / Showing Very Little Output
2001 ranger with 4.0, alternator failed and new alternator is also not charging, showing very little output. i've installed 2 new ones with no fix. the regulator is in the alternator, correct? I'm stumped and not sure where to go with this.
View 14 RepliesFord Ranger / B-Series :: 1998 - Charge Light Stayed On - Alternator?
98 Ranger 4.0..4WD ex CabXLT Automatic..started the engine yesterday and my charge light came on and stayed on. Checked the guage and it showed no charging and then slowly began to charge and the light went out. If I rev the engine above 2,000RPM's the charge needle starts to drop but if I keep RPM's below 2,000 charging is okay. Is this the sign of a failing alternator? The belt only has about 20,000 miles on it and tension seems oksy
View 4 RepliesFord Ranger / B-Series :: Blown Head Gasket?
I have read all I could find on replacing a blown head gasket and and after absorbing everything that TigerDan posted on here, I dove in and began. After disassembling all the topside junk I finally got the intake manifold loose and got down to the head. I began undoing the head bolts and found two broken bolts. The head won't budge so I am calling in a cherrypicker. I don't know what kind of mess I'll find when the head comes off. I assume the head will be warped or the block may be damaged.
View 6 RepliesFord Ranger / B-Series :: No Speedometer / Odometer After Alternator Changed - Code P0500
1998 Ranger... I started having Speedometer/odometer problems after a power surge when my alternator went out. I knew the alternator was going bad and I tried to limp home another 5 miles rather than pay a tow bill and the alternator overcharged for a few seconds before completely dying. Since that time the only problem I am left with is my Speedometer and odometer have not worked. Scan tool says p0500 and I have replaced the ABS sensor on the differential with an OEM part but still no speedo or odo. I have checked all the fuses and relays associated multiple times. I do suspect that the RABS resistor is bad but there is no ABS light and it doesn't make sense that this one resisitor is the sle key for the whole speed control circuit. It's a manual transmission and RABS only. I swapped out the Cruise Control Servo with no luck as well. I am running out of options before having to take it to a dealer because I have to pass inspection. I have also checked and there is no power coming to 679 (GY/BK) into the instrument panel. I have also checked continuity for the rear harness to the ABS sensor and it is good.
View 2 RepliesFord Ranger / B-Series :: 1999 - Torque Value On Head Bolts
I am missing my manual need to know the torque value on the head bolts 1999 ranger 3.0 flex.....
View 4 RepliesFord F-150 (2004-2008) :: Alternator And Fuse 23 Blew - 13 Diagnostic Error Codes
Within three days the alternator and fuse #23 blew. After replacing these and the fuel filter (because of stalling during acceleration), I took it for a diagnostic check at O'Reileys because the stalling while accelerating worsened, it wasn't shifting correctly and the O/D light began flashing on the shifter. It hit on these 13 error codes:
P7055
P0446
P0750
P0443
P0743
P0135
P0141
P0155
P0161
P2195
P2197
P0423
P1747
I have researched each code (definitions, what to examine/test, and the locaton of each part). My question is that with this many hits is it most likely a problem with the PCM, or should I just proceed with checking each connection, wiring and solenoid individually? The EGR Valve tested fine and the alternator is pushing 14.6 v...
Ford Ranger / B-Series :: 1991 - Bad Head Gasket - Leaking And Coolant In Oil
I have a 91 Ranger V6 4WD with 150K that has been sitting for 7 years. The last time I drove it (7 years ago) to a mechanic, who diagnosed it with a bad head gasket - leaking coolant and coolant in the oil.
What am I looking at as far as a project: besides redoing the head gasket, what else will I most likely need to do given that its been sitting 7 years?
Ford Ranger / B-Series :: 1995 - No Spark / Leaking Head Gasket
My 95 Ranger has been a good truck in the 6 years I've owned it. I had to pull the heads to replace a leaking head gasket and wound up having the heads rebuilt due to weak valve springs and worn valves. I replaced the gaskets, installed the heads, get it all back together.....won't start. Fuel pressure is good. Found that there is no spark. While putting the crankshaft position sensor connector back on I noticed it didn't look too good. I replaced the connector and that's all I did and no spark. Long story short, after a lot of research, the coil pack, cps and coolant temp sensor were replaced and still no spark.
Everything has the proper voltage to it. After a little more research I found a post with the same basic issue. His issue wound up being the ecm. So I removed the ecm....it's a used one from a salvage yard. I've owned the truck 6 years so I have no idea when the ecm was replaced. It showed up today and will get installed when I get home from work. I also ran across posts about the camshaft sunchronizer and they should be replaced at about 80K miles. Since the truck has 289K I'll replace it. Still no spark. I'm hoping it's the ecm.
Ford Ranger / B-Series :: 1994 - Jerking Below 3k RPM?
My 94 ranger, 3.0 v6 began to sputter and jerk about a month ago. It does this when ever give more then lite throttle up until about 3000 rpm. I have replaced plugs, wires, coil and cleaned the air flow sensor. I feel like this has worked a little but the problem is still definitely present. When I hit 3k rpm if feels lie the truck begins to run correctly and almost like it had a power ban much like a dirtbike, but again it's just the truck running correct.. And above 3k rpm it runs great... and every so often the problem will completely disappear for 5 minutes or so, then come right back.
View 1 RepliesFord Ranger / B-Series :: 1994 - Mpg Dropped - Fix?
I have a 94 2wd 4.0 auto 3.08 rear end it has 195,000 im gettin 15 city 18 hwy I used to pull 24+ hwy I changed plugs and wires no change? It has the 4.0 tick but its always had it....
View 7 RepliesFord Ranger / B-Series :: 1994 - Got Codes 218 And 998?
Working on a friends 94 ranger, 2.3 L with codes 218 and 998. Chiltons manual does not even show this code. Code is for Loss of Ignition Diagnostic Monitor (IDM)/left side. What exactly is this? Can't find anything that explains the IDM.
998 means a hard fault.
Ford Ranger / B-Series :: 1994 - Low To No Heat
1994 ranger 3.0 .. New: water pump, htr. hoses, radiator, thermostat, pulled & flushed htr. core. (2 year time frame) ....
View 5 RepliesFord Ranger / B-Series :: 1994 - Won't Start After Warm Up?
I have a 1994 Ford Ranger 4.0L 4x4, 130,000. I love this truck but about a year ago it started not starting after it warmed up short distances in the summertime? It start right up on cold crank...Runs smooth idles like a champ...but if i shut it off..wont start for 20 to 40 min??? It doesn't happen in the winter months??? So I changed the fuel pump, filter, relays. I feel like it has something to do with the Ignition Control Module. Would that come up in a code?
View 13 Replies