Ford 7.3L Power Stroke (1999-2003) :: Fuel Filter Bowl Drain Valve Replaced - Emission System Warning Light
I just changed the drain valve on the fuel filter bowl. All went well and no more leak, but now I am getting an "emission system" warning light.
After I replaced the valve, I filled the fuel bowl with diesel fuel. Was there any other priming that needed to be done (if any)? What the emission system warning light may mean?
2002 F250 7.3L 4x4.
Ford Fuel System :: Changed Fuel Filter Now Just Cranks But Won't Fire / Start
2002 E-250 with the 4.6 V-6. Pulled the 30 amp fuse, replaced the fuel filter, replaced the fuse, now the truck wont start. Checked the fuse and the kill switch under the passenger kick cover, all ok. Cranks and cranks but wont fire. No problem prior to changing the filter. Even swithed out the relay with another, no luck.
View 4 RepliesFord - Explorer :: 1995 - Replaced Fuel Pump / Filter / Pressure Regulator / Crank Position Sensor But Won't Start?
1995 Ford Explorer, 4 ltr. engine, pushrod. Will not start. Replaced fuel pump, fuel filter, every relay, pressure regulator, and the crank position sensor. I realize there's a whole bunch more parts under the hood, but I am ready to give up. Before the fuel pump would not run. Reason for replacing the parts. Now it won't stop running and you can feel the fuel by-passing at the pressure regulator. When checking the pressure at the rail I get zero !! I used a tire pressure tester for this. And, like I said no pressure. This vehicle has around 170,000 miles on it.
View 8 RepliesFord Fuel System :: 1995 - Stalls - Now Stop Moving - Fuel Filter?
I have a 95 F150 4x4 reg cab long box with a 302 V8 and dual tanks... I was driving around yesterday when my truck started to lung and then the motor stalled... when I stopped moving I tried starting the truck and it started with no problem, so as i kept on my way, about 5 minutes later the same thing happened and it stalled again, (I have an automatic by the way). but this time before it stopped moving i pump the gas a few times and it fired back up and then stalled again... i switched from my front take to by back maybe thinking it could me my fuel pump in the tank but it did the same thing again about same time later... Would it be my fuel filter on the frame (like in line fuel filter) or why is it doing that? its EFI by the way.
View 14 RepliesFord Fuel System :: Fuel Filter Is Clogged When Turn Over The Engine
Is it fair to assume that my filter is clogged when I turn over the engine and fuel does NOT come out of the filter with the uphill line disconnected. I was able to disconnect the rear line from filter and fuel DID pump out of line when I cranked it over. Been dealing with a crank no start, I'm in the process of trying to test my CPS properly but not sure if I'm testing it right.
2000 f 150 4.2 v6 232,000 miles....
Ford Fuel System :: Leak / Dripping On Top Of Engine At The Fuel Filter
I'm dripping fuel on top of the engine at the fuel filter . Where the line ties into the filter canister, there is a small plate that's attached with small Allen screws its dripping between this plate and the canister .... I assume there is a gasket/oring that is causing it ...... What is the part number or correct description so I can go to ford dealer and get one. It's a 2007 Ford 4x4 6.0 diesel.
View 2 RepliesFord Fuel System :: 1994 F250 - Fuel Injector / Clean Or Replace Filter
I have a 94 F250 5.8 liter with 96K miles. Can I remove the fuel rail and clean or replace the filter that is placed at the top of the fuel injector?
View 10 RepliesFord Fuel System :: 1977 F250 - Fuel Leak From Filter Attached To Carburetor
I have a 77 f-250 with a 460 engine and a 4bbl Motorcraft carb and its leaking a substantial amount of fuel out of the newly replaced filter that is attached to the carburetor. The fitting is tight and I even tried buying some small gaskets to seat it, but that didn't work either.
View 1 RepliesFord Ranger / B-Series :: 1989 2.3L - Started Missing Even Replaced Fuel Filter?
The other day I was driving down the road on a long, flat section and all of a sudden my truck started missing out of the blue. Ever since it started missing it hasn't stopped. The truck is an '89 Ranger, 2.3l, 5 spd. The plugs and wires were replaced last year along with the timing belt and fuel pump. It has been running great since then until now. I thought maybe it might be a clogged fuel filter so I replaced that but it didn't work. Also, it doesn't miss all the time. It doesn't miss when its idling or if you are going down the road while it is missing and slowly release the gas pedal it reaches a point while you are letting the pedal up where it will even out. It definitely seems like it is an "under load missing" scenario. Also, the Check Engine Light is not on. Where should I start looking?
View 4 RepliesFord Super Duty (1999-2016) :: 2002 - Gas Engine Won't Start After Replacing Fuel Filter / Pump Relay / Air Filter?
After replacing fuel filter, pump relay, and air filter for good measure my 2002 f250 v10 gas engine still wont start. What to do?
View 13 RepliesFord - Explorer :: 2007 - Misfire On 4 - Replaced Fuel Filter - Gurgling Noise While Removing Gas Cap?
Problem started when the fuel supply was low, she had to floorboard it to get on the interstate, keep getting cel, misfire #4.....I replaced fuel filter, had a little water causing the plug to arc....had a mechanic replace the plug.....at startup cold, cel is off and it doesn't miss, after it warms up, light comes back on and starts to miss. I have ran every type of fuel cleaner in it, even used a three step cleaner for throttle body, vacuum system, and tank. I just poured sea foam into the tank and trying that, I noticed a gurgling noise when I removed the gas cap. I'm thinking #4 injector is stopped up.. I recently replaced all the coil boots.....kept getting condensation in the boot (she has been washing the underside at the car wash).....the truck has the 4.6 and has 85,000 miles, it is an 07 sport trac.....
View 2 RepliesElantra XD (2001-06) :: Replaced Fuel Filter Now Engine Won't Run
Replaced fuel filter. Got all 4 washers plus cap from old filter. Engine won't start. Saw there is a fifth rubber washer that nobody mentions anywhere and transferred that to the new pump. still won't run.
When I turn the key to On, I can hear the pump turn on for 2 secs and stop. if I do this 5-6 times and then try to start, engine will start and then die immediately. seems the pump is not pumping when the engine tries to run. it pumps only for two secs when the key goes from Off to On position.
There are two lines going to the pump. which one feeds the engine. if I disconnect that line, should I see fuel coming out when I turn the key and try to start the engine?? or is there a better place to disconnect closer to the engine??
Oldsmobile - Alero :: Died Even After Fuel Filter Replaced?
I have a broken gas gauge so i pretty much run it until its empty. Has been fine but just died about a week ago. Nothing else was wrong with it. Worked and ran great after for about a week then i went to start and it did the same thing. I have listened for the fuel pump and it sounds like its working. I have not checked the fuses...I am curious what else it could be if after one week with a fuel filter it would do it again
View 17 RepliesFord 6.7L Power Stroke Diesel :: Additional Fuel Filter System Install?
Installing the diesel site fuel filter / water separator system for our 6.7's . And If so how do you like it. and your pro's and con's besides price.
View 4 RepliesFord Fuel System :: Shuttering / Shaking After Replaced The Bowl Gasket
My problem is I bought an 85 motorhome with the 460. After getting it home I realized the accelerator pump was leaking. The engine ran great and I drove it home over 100 miles. After pulling the carb I replaced the pump and put it back on. Then I had a big leak from the secondary bowl gasket, but the engine still sounded great. When I replaced the bowl gasket then I got a leak from my metal fuel transfer line between the bowls. Engine still sounded and idled great. Pulled the carb again and this time replaced the front bowl gasket the 2 o rings on the fuel line and put it back together. Now I have no fuel leaks but the thing would kind of Idle but it shuttered the motorhome like crazy and then die. It would start right back up and do the same thing.
So I had a leak. Engine ran great. Then I replaced
Both bowl gaskets
Both o rings on fuel rod
Accelerator pump and that' s it
What could my problem be. I have only made one adjustment and it was to the IDLE screw to keep it from dying but it still has the shakes.
Ford Fuel System :: 1994 F150 Won't Start - No Fuel Comes Out Of The Valve
1994 150 300 6. parked truck after lunch finished work and it wont start no fuel comes out of the valve. Can't get the pump to work even when jumping the 6 pin. heard the relay click still nothing. Checked the inertia switch it wasn't popped. Took the pump out jumped it straight from the battery pump works . I know there has to be something i am missing...
View 7 RepliesFord 6.0L Power Stroke Diesel :: Fuel Filter Change Now Won't Start
Replaced both fuel filters same as usual. Cranked right up and I let her run while I put up the tools and look for leaks. Notice it started running rough, so I jumped in and started to back out of carport and it went dead. Ran battery down and it won't hit a lick. Replacement (racor) filter same as last few changes. Running just fine before change so it has to be something simple, but what?
2006 6.0 powerstroke
Ford 6.7L Power Stroke Diesel :: No Start Post Fuel Filter Change
Went and changed my fuel filters today... Primed the truck 6 times. Started it. Ran great, then got a low fuel pressure and reduced power notification. Turned it off. tried priming it 10 more times, no start, tried 15 more times. No start. Took off the outlet on the secondary filter, solid flow. Took off the return on the L/H fuel rail, pinched the line and put a hose on the rail... Once again solid flow. I can hear air somewhere under the hood but I don't know where... Driving the 7.3 to work tomorrow but this is driving me up the wall.
View 14 RepliesFord 7.3L Power Stroke (1999-2003) :: Won't Start Even Installed Fuel Filter?
Shut my truck off for about 15 minutes and wouldn't start back up. Installed new fuel filter. And gonna try changing cps. Torque says Rpm 180
Ipw. Bouncing between 600 - 3000 Hpop. 250 while cranking Voltage 10.9 while cranking. Ipr starts about 15% and slowly climbs to about 88%
Fuel pressure about 65%
Tried unplugging cps. Gonna check oil now though I check it every time I fill up and it never uses any.