Ford - E150 :: 1995 - Acting Like Running Out Of Fuel - Fuel Pressure Regulator?
Today, my 1995 E150 suddenly started acting like it was running out of fuel Lucky for me, this happened close to both a parts store and my usual mechanic's shop. Unluckily for me, it happened on Saturday, and my shop can't get to it until Thursday. So here I am, hoping to do a fix in the meantime.
At first, it seemed that it must have been the fuel pump, because I couldn't hear it come on when I turned on the ignition. Then, a guy who said he was a mechanic told me he could hear the pump cycling, and that my problem was the fuel pressure regulator. So he managed to start the vehicle after a few tries, then it crapped out again. He did this twice. Then he went away.
I called every parts store in town, and none of them had a fuel pressure regulator for my vehicle, and the earliest any of them could get one was Monday. But I knew I was due for a fuel filter, and I'd changed filters on this vehicle before, so I got one of those and put it in. To my delight, the van started right up and idled beautifully. In fact, it ran beautifully for about 15 minutes, until I came to a slight rise, then it crapped out again. It still started up and idled smoothly, and even revved up smoothly, until it reached a high idle speed, at which point it crapped out. I did manage to limp into the parking lot of my shop - which, again, can't get to it until Thursday.
So my question is: does this sound like a fuel pressure regulator to you? If so, is that a job which somebody with a reasonable mechanical aptitude (i.e., at least good enough to change the fuel filter) should be able to feel safe doing? If the answer to those two is "yes" (or even if it's "no")....
Ford - Freestar :: Replaced Fuel Pressure Sensor And Now Won't Start
I replaced the fuel pressure sensor in my freestar...I drove it around for a minute then noticed a strong smell of gas. I stopped and then put the old sensor back in and now it won't start.
View 6 RepliesFord Excursion :: Replaced Battery And Fuel Pump Relay / Only Crank / Won't Start?
Black Beauty finally gave up. Replaced battery, replaced fuel pump relay. Would only run with starter fluid sprayed into the air intake. She'll crank but not start. Here she sits at the dealership.
View 14 RepliesFord - Explorer :: Loss Of Power To Fuel Pump / Crank But No Start
I have an 04 Ford Explorer XLT 4.0 Flex Fuel. There has been loss of power to fuel pump. Relay and fuse both good, replaced the inertia switch...still nothing. Could a FPDM (fuel pump driver module) have anything to do with this issue? Or what should I check next? I am definitely at a loss as to what the issue could be! I know it is fuel related because I used starting fluid and it started right up and run for just a few seconds, so that should rule out ignition I think.
View 3 RepliesFord - Explorer :: 1994 - Crank But Won't Start - Fuel Pump Relay?
Sometimes after running my 94 Limited, it doesn't want to start - it does crank - like it's not getting fuel. I have found the work around and want to know if it would be fixed by replacing the fuel pump relay.
The symptom is just after starting, it starts to run poorly, and then dies out, then will not start at all. I use to keep trying to start it for 20-40 minutes and suddenly it seemed to work.
It seems the work around is to turn the key to on for about 5 seconds and then turn it off - then it starts and runs as good as ever.
So, is this a symptom of a bad relay? I thought I'd start there because of the cost of the relay is fairly cheap. 1994 Explorer Limited 4x4?
Santa FE SM (2001-06) :: 3.5L 4WD Not Starting / Replaced Crank Position Sensor
We bought a 2006 Hyundai Sante Fe with the 3.5L and 4 wheel drive about two months ago, it has 94,000 miles on it. It was purchased from a dealership, and they had to work on it for a month before we took it from them because of some lights that were on, resulting in some sensors being replaced. We had it about a month when we took it to the grocery store, when we came back out I started it and it made a terrible noise, but was running, I immediately turned it off. Upon further inspection, the main serpentine belt had snapped, causing some damage to the secondary belt. We towed it home and I began to fix the belts.
When I pulled off the passenger side wheel and access cover, I noticed the remains of the belt were stuck behind the harmonic balancer, I tugged on it with about 5 pounds of force, and the entire pulley fell off of the harmonic balancer. I'm not sure if the belt stacked up behind and pushed it off, or if it just went bad, but the rubber between the portion that connects to the crank and the pulley was ripped, and missing in some spots. I replaced the harmonic balancer, and both belts, good to go, everything is running fine.
About a week later, the TCS etc. lights came on, but no check engine. I researched it a bit and came up with three possibilities:
1. Fuse
2. Tone wheel cracked/broken
3. Crankshaft position sensor
I checked the fuses and nothing was burnt, I never lifted the truck up to check the tone wheels.
Ford F-150 - 1997-2003 :: Truck Won't Start - Fuel Pump Regulator?
How do you test the fuel pump regulator, the truck wont start. I tested the schrader valve and it does have pressure but didn't seem like much. (need a gauge) I replaced fuel pump a few years ago so was wondering about the regulator. Is there a test procedure?
View 7 RepliesFord - Explorer :: 2007 - Misfire On 4 - Replaced Fuel Filter - Gurgling Noise While Removing Gas Cap?
Problem started when the fuel supply was low, she had to floorboard it to get on the interstate, keep getting cel, misfire #4.....I replaced fuel filter, had a little water causing the plug to arc....had a mechanic replace the plug.....at startup cold, cel is off and it doesn't miss, after it warms up, light comes back on and starts to miss. I have ran every type of fuel cleaner in it, even used a three step cleaner for throttle body, vacuum system, and tank. I just poured sea foam into the tank and trying that, I noticed a gurgling noise when I removed the gas cap. I'm thinking #4 injector is stopped up.. I recently replaced all the coil boots.....kept getting condensation in the boot (she has been washing the underside at the car wash).....the truck has the 4.6 and has 85,000 miles, it is an 07 sport trac.....
View 2 RepliesFord Super Duty (1999-2016) :: 2002 - Gas Engine Won't Start After Replacing Fuel Filter / Pump Relay / Air Filter?
After replacing fuel filter, pump relay, and air filter for good measure my 2002 f250 v10 gas engine still wont start. What to do?
View 13 RepliesFord Ranger / B-Series :: 2003 Turns Over But Won't Crank After Fuel Pump Replaced
Just replaced fuel pump and now it turns over but won't crank. I have checked the fuel rail. Pressure is fine. Checked coil pack I'm getting spark. Still won't crank. Checked inertia switch it wasn't tripped. What next? 2003 Ranger edge...
View 1 RepliesFord - Explorer :: 1995 - Can't Hear The Fuel Pump?
I'm working on one of our fleet vehicles here, a 1995 Explorer. about 2 months back, it stalled out. Got it back to the shop and turned the key on .... I couldn't hear the fuel pump. I replaced the fuel pump and the fuel pump relay. Vehicle started right up and seemed to run O.K. About 2 weeks ago, it stalled out again, same symptoms, acts like it runs out of gas and can't hear fuel pump.So, I have been playing with it and find that it starts up great in the cool mornings. In the afternoon when the temps are hotter, it won't start (can't hear fuel pump). The following morning when temps are cool, it will start right up and can hear the fuel pump. I almost wrote this one off as a defective fuel pump, but I'm not sure on this one.
View 7 RepliesFord Fuel System :: Replaced Filter - Won't Start
Ok, I've replaced the fuel filter today and my truck still won't start. Checked fuses, and Fuel relay (19th slot). I've found the red fuel switch and it doesn't depress so I suspect it isn't tripped. I'm out of my league if I have a fuel pump problem.
View 6 RepliesVolvo :: 1990 240 Will Not Start - Whirring Sound Coming From Fuel Pressure Regulator
My '90 240 will not start. When I turn the key to Acc. or Start I hear a whirring sound coming from the fuel pressure regulator so I assume the fuel pump is not an issue. The engine will not even crank. I assume it is the ignition coil or the starter but I am unsure. As an FYI, the battery and plugs are good.
View 1 RepliesFord - Explorer :: 2003 - No Fuel Pressure / Pump Will Not Run
I have a 03 explorer sport trac that has no fuel pressure the pump will not run. It is a bew pump just replaced it amd drove 4 miles cut it off filled up with gas now it wont run I replaced the pump again thinking I might have got a bad pump but it still wont run. I've checked the relay and inertia switch I have the 5 pin connector on the fuel pump module. 1 wire has good power to it but the pump won't run...
View 6 RepliesFord - Explorer :: 2003 - Fuel Pump Pressure Drops?
I have an 03 Explorer that had a starting issue. Long story short, it had no fuel pressure. So after testing the relay, I switched out the pump with an Airtex unit . All seemed fine...for a while.
Became hard to start again, checked Schrader valve with the key on, and not running, no pressure. Strange though, it would run.
So got the fuel pressure gauge on it. Turn the key and pressure will go to about 5-10psi and then drop to zero. Turn key off and on again, up to 5-10psi, then drop to zero. Turn the key to start and pressure goes up to 10psi, then starts, then goes to 30 while running and you can drive it around. Shut off motor and pressure goes down to zero.how the sending unit is supposed to hold fuel pressure and not release it? Is there some kind of check valve in the sending unit assembly that can be cleaned or does it need a whole sending unit with another pump? I already spent the $100 for the pump, and it is working if you can drive it!
Ford - Explorer :: 1995 Will Not Start / Zero Pressure
1995 Ford Explorer, 4 ltr. engine, pushrod. Will not start. Replaced fuel pump, fuel filter, every relay, pressure regulator, and the crank position sensor. I realize there's a whole bunch more parts under the hood, but I am ready to give up. Before the fuel pump would not run. Reason for replacing the parts. Now it won't stop running and you can feel the fuel by-passing at the pressure regulator. When checking the pressure at the rail I get zero !! I used a tire pressure tester for this. And, like I said no pressure. This vehicle has around 170,000 miles on it.
View 4 RepliesFord Ranger / B-Series :: 1990 - Broken Fuel Line At Fuel Pressure Regulator?
I have a 1990 Ranger with a 4.0L that I just changer the intake gasket on. I broke the fuel line at the Fuel Pressure Regulator. Cant seem to find one anywhere. It is a nylon inside/rubber outside with a cloth mesh and quick connect fitting line. Where to get one? Can I hose clamp it the FPR by cutting off the connector that broke?
View 1 RepliesFord 6.0L Power Stroke Diesel :: 2005 F350 - No Start / Crank Position And Cam Portion Sensor Codes
I have an 05 f350 6.0 that I recently bought. It was fine until a few weeks ago when it died while I was driving down the road. I pulled to the side and it started right back up like nothing happened and kept driving like normal. Skip to last weekend it did it to me twice but the second time it would not start so I plugged my programmer in and it showed p0336 crank position sensor and cam portion sensor codes (I can't remember the number of the second code) I have read a few posts that said maybe it's the icp sensor so I went ahead and replaced that with no luck. The batteries went dead from excessive cranking which I know isn't very good for my starter but I was getting a little upset.
View 11 RepliesGolf IV / Jetta IV :: Installed New Crank Position Sensor Now Car Will Not Start
After installing a new crank position sensor on my 05 GTI 1.8T would I have to recalibrate my ECM, my car will not start.
View 2 Replies