Ford - F150 :: Oil Pressure Dies At Idle
I have a 6 cylinder '99 Ford E150 and though it has plenty of oil, the oil pressure gauge drops and the idiot light comes on whenever it stops and comes to idle. Pressure seems fine when driving but dips at a stop lights etc..
View 6 RepliesFord - F150 :: Clutch Pedal Drops To Floor - No Back Pressure
So this has happened a few times pedal drops with no back pressure then give a bit pull it back up by hand and it's fine has happened 4 or so times in the last year. I'm reluctant to replace slave and master cylinders could it be anything else? 87 Ford F-150 hydraulic clutch
View 10 RepliesFord A/C :: 2003 F150 - No Heat / High Back Pressure In Engine
Took truck to a mechanic he advised me that the no heat was because of high back pressure in engine...never heard of this before, is this a correct diagnosis? No heat, air blows through all vents, defrosters.
View 1 RepliesFord Transmission :: 1995 F150 - Clutch Pedal Losing Pressure?
I have a 1995 F150 with the 4.9L and it has 73000 miles on it. One morning recently (it was about 35 degrees outside) I went to start my truck to let it warm up. When I let off of the clutch it stayed on the floor. I shut it off and drove my car to work instead. I asked around at work and one guy mentioned that it was probably my clutch master cylinder...so that day we replaced it, and bled it until it felt like knew. Since then, we have had to bleed it three more times, because the pedal keeps losing its pressure making it harder to shift. I have inspected around the clutch line and the bellhousing for signs of needing to replace my slave cylinder, but everything looks fine.
View 8 RepliesFord Transmission :: 2001 F150 - Location Of Replacement Pressure Hose For Power Steering
2001 F150 Supercrew 5.4L ... Dealership unable to locate replacement pressure hose for power steering . I've returned 3 wrong parts. The hose in pic goes all the way up to the reservoir.
View 13 RepliesFord F-150 (2004-2008) :: 2007 F150 Sputtering After Fill Up - Fuel Tank Pressure Sensor
The ole 5.4l hit a snag today. I was on my way to fill her up and she started sputtering and damn near died! i filled her up and it was like nothing ever happened. Took her to AutoZone and the diagnosis was a Fuel Tank Pressure Sensor.
I have a connection with Bumper-to-Bumper to get the part for cheap but I'm not sure if i want to dive into either moving the bed or dropping the tank. I'd prefer to move the bed.
Ford - F150 :: 1998 - Throw Out Bearing Not Allowing Pressure Plate To Make Proper Contact With Clutch
I have a 1998 Ford F150, Manual transmission. It has set for 1 year. Upon driving it for the first time yesterday, it gradually came to a stop. The clutch never smelled hot or appeared to slip. Today I took the inspection cover off and found a rather large nest has been built in the clutch and pressure plate. My question is could this nest cause the throw out bearing from allowing the pressure plate to make proper contact with the clutch. The truck will move in 1st gear and in reverse as long as there is no resistance against the truck.
View 2 RepliesFord Fuel System :: 1989 F150 - Hot 28 Psi Fuel Pressure Shuts Off?
for the past week we have been trying to figure out what is wrong with our truck. We recently bought it and it ran fine. Then got in a minor accident just a fender bender and it started acting up so I got towed to garage. First it would run when cold, but when hot fuel pressure would drop to 28 psi.
So I put new fuel pump, it started but still did the same thing hot 28 psi fuel pressure shuts off. So I put regulator on it, then had 0 fuel pressure won't even start. So got a another regulator thinking I got a bad one, still 0. Checked relay, there fine. I'm gonna check lines and see where fuel stops at but everything is new on it.
Ford A/C :: 1999 F150 - Clutch Is Always Engaged
I bought a 1999 F150 4.6 4x4 recently that is giving me some problems. The current one is the AC compressor. The system wasn't charged when I bought it a month or so ago and last week the compressor started smoking. I replaced it with a brand new one, including the clutch and pulley, accumulator and orifice tube. I never got the chance to charge the system because the first time I drove the truck the new compressor started freezing up. I took it back and exchanged it and put the new one in. This time I paid attention and the clutch engages as soon as I start the truck. The AC controls are off and there is no freon in the lines.
View 10 RepliesFord - F150 :: 1999 - Fluttering Spun When Accelerate
1999 ford f150 makes a fluttering spun when I accelerate.
View 2 RepliesFord - F150 :: 1999 - Shakes When Stop - Bad Rotors?
I have changed the rotor, inner and outer bearings, and the brake shoes look pretty good. My truck still shakes when I stop, it acts like bad rotors, but they are new.
View 5 RepliesFord - F150 :: 1999 - Won't Turn Over And Frequently Stranded?
I have an intermittent issue w/ my 1999 Ford F150 which will not turn over and leaves me stranded at work which is 55 miles from home. Had air intake valve replaced earlier this year amongst other things. I have to admit, my Ford dealership has been good to me, but they had the truck for 3 weeks (gave me a 2011 Lariat loaner - awesome) but the truck started every day. No error codes. I have it back 24 hours and was stranded again. We replaced the fuel pump last time - obviously not the problem. 221,000 miles and has been great to me until this year.
View 2 RepliesFord - F150 :: 1999 - Battery Light Is Staying On
I have a 1999 F-150 4.6L V-8, and the battery light is staying on. Something is draining the battery. I have taken it to Auto Zone, and they tested the battery (brand new), starter, and alternator - all show good. The only error they can register is "C1226 brake light lamp short." What could be causing this? I had to get jump started at a gas station 2 nights ago. I have checked the alternator fuse, and it is ok. Could the wiring be bad somewhere?
View 4 RepliesFord A/C :: 1999 F150 - Heater Not Working / Air Blows Cold
I have a '99 F150 4.2 5 speed, my problem is, my heating isn't working. My A/C works fine, my blower motor does too, i changed my heater core about a year ago. I turn my truck on wait for it to warm up and once my gauge reads normal temp, i turn my control to the warm position but the air blows cold with just a very small hint of heat. I looked it up in my Chilton book and they said to check my hoses that go to the firewall/heater core. They say that both hoses should be hot and if one isn't to check it. i did that and the one on the left side(facing the truck) is barely warm. what could be my problem? heater core? my friend from Autozone said something about a vacuum control somewhere in the engine compartment but i don't know where it is, could that be a problem? Or would the flapper door be stuck?
View 7 RepliesFord Brakes/Suspension :: 1999 F150 - Getting Air Out Of Brake Lines?
I am having trouble big time getting air out of my brake lines. I put new front pads and rotors on and also had to replace the brake line coming from the caliper as it kind of crumbled and needed to replace the next line up that goes to the ABS block on the left front. After doing this, I bled that wheel only and at first it was ok until the brake line on the right front at the caliper also broke when I was pushing on the brake pedal with the truck running, spewing fluid all over. I have tried to bleed using a decent vacuum bleed setup from Advanced Auto but keep getting massive amounts of air coming out and when I start the truck and hit the brake pedal, it goes to the floor. Could the master cylinder be bad? I have checked every connection that I made and all other connections and there are no leaks at all. I am stuck in the garage! The truck is a 1999 F150 4x4 with 4 wheel ABS.
View 1 RepliesFord Wiring/Electrical :: 1999 F150 - Battery Light Came On
I have a 1999 Ford F150 6 cyl. 4.2, 2 WD with 160,000 miles. Replaced the battery May 2010.
Today battery light came on. Battery gauge did not look like it was discharging. Had battery checked they said it was a little low but OK. Then they continued test and tried to check alternator, test stopped and they said something wrong with alternator most likely.
I took alternator out and had it bench tested. They said it was OK, putting out 98 amp on 95 amp alternator. They said check wires, grounds, harness, connections. Checked connections and wires as much as possible, reinstalled alternator, light still on.
Have not checked fuses yet. Was told to start vehicle, disconnect positive battery cable and if engine continued to run alternator was good, if cut off alternator was bad and to replace. Should I try this and is it true?
What is the part on the fire wall that is between the alternator and the battery that the wire connection runs through? Can it be bench tested/checked?
Ford - F150 :: 1999 - Code P1131 / O2 Sensor Running Lean
I have a 1999 Ford f150 4.6L automatic. My check engine light had been on for awhile so I dug out my DTC code reader erased it, came back on 10-15 minutes later. I got the code P1131 sensor indicates lean which you would think is the O2 sensor a week later it won't start. Then randomly a couple days later it starts then that night it didn't. Hear is the parts that confused me. I don't believe an oxygen sensor would cause it not to start, it's cranking nice just won't turn over. And when you get the code P1131 I believe it bay 1 where the readings are off Well here's my readings.
Fuel system 1 CL-FaultCalc load 34.1%ECT 201.2 FSTFT B1 -1.6%LTFT B1 0.0 %STFT B2 -1.6%LEFT B2 0.0%ENG RPM 1101VEH SPEED 27 MPH
It looks like to me bay 1 and 2 are off? I'm not mechanically challenged, but not a mechanic either, I do most my own work on my vehicles..
Ford Super Duty (1999-2016) :: F150 Bumper Same As Of F250?
Do f150 bumper is the same as my 03 F250?
View 5 RepliesFord Super Duty (1999-2016) :: F250 Versus F150?
I'm trying to decide if I need a f250 diesel or to just get another f150. I will be pulling a car trailer a couple times a year with a 78 ford f150 with a 460 in it and the rest of the time it will just be a daily driver. The problem I'm having is that the truck weights I'm guessing some where in the 5500 to 6000 lb range not really sure. I live out in Colorado so I will have to drive through the mountains pulling the truck to different mud races and don't want to have to over work the f150.
View 10 Replies