Ford Super Duty (1999-2016) :: 2003 F250 V10 - Heat Shield Rattle That Sounds Like Exhaust Leak During Loaded Acceleration
I recently purchased this truck and have towed a couple of times with it. It has 98,000 miles and I do not know if the automatic transmission fluid has been changed. Should I have it flushed or drop the pan and change it? I have a lift so doing the change is no problem, although it might be worth it to pay a transmission shop to do it.
Also, I hear what appears to be like a heat shield rattle or something that sounds kinda like an exhaust leak during loaded acceleration. What to look for to locate the noise? One last question, the air bag light is on sometimes then off sometimes. Any known air bag light issues? I love the truck, hate the gas mileage!
Golf IV / Jetta IV :: Exhaust Heat Shield - Slight Creaking Noise That Sounds Similar To The Rattle
I've noticed that potentially my heat shield or whatever guard that is 1 step toward the front of the car from where the inlet pipe connects to the exhaust system may be the reason for my rattle at 2k and 3k rpms. i think its a heat shield but I am not sure. the thing is it seems properly mounted, nothing is cracked/broken/or loose. But when I do try and wiggle it it does make a slight creaking noise that sounds similar to the rattle I get. So I could foresee this as being my issue.
But, is there anyway to fix this rattle w/out just taking off the part? i figure its there for a reason and it looks like its held on in 2 places. But they're not nuts they almost look like spot welds or something. 1 on each side. What to do?
Something to get you all in here:
Ford F-150 (2009-2014) :: 2012 - Heat Shield Under Trans?
I have a 2012 screw 4x4 eb. I noticed under the truck there is some sort of heat shield under the transmission. The owners manual suggests removing this and the lower air dam before going off road. Can these items be removed permanently? Any effect on mpg's?
View 3 RepliesFord F-150 (2009-2014) :: Heat Shield Under Oil Pan / Front Hole Ripped
This fiber material doesn't hold up to mud and sand very well. So much so, that the front hole ripped through. It won't stay fastened. I have all of the twist bolts still. Looking for a way to fix the shield so it will hold. I tried exposing a washer to it, but the epoxy doesn't like the material very well. I know the owners manual says to remove the shield if you are going to be off roading, but I hesitate to leave it off 100% of the time.
View 4 RepliesGTI 337/20th Anniversary :: Rattle That Sounds Like A Shield In Low Revs
On my gti when in low revs, theres a rattle that sounds like a shield but I've check the one around that cat and the one under the turbo. but it still rattles. What this could be?
View 3 RepliesGolf IV R32 :: Catalytic Converter - Heat Shield Rattle
The catalytic converter shield is tack welded on the front end but free on the rear end. There was originally some braided wire packing at the rear to keep the shield from rattling against the pipes. Mine was deteriorated and had been damaged, I think, when I sustained some oil pan damage last summer -- big jolt to the system when running over a muffler on the highway.
The fix is simple. Bought a foot of 3/16" braided stainless steel cable. I used about 8 inches and layed in the lower bead line on the catalytic converter shield (see picture below). You can see a bit of the cable thru the gap in the upper/lower shield on the left side. (1/4" cable would be a better fit, but this will work for a long time.) Cost: $1.84
The local VW parts man dug out an exploded drawing of the system but it showed NO parts or packing for this problem.
Golf IV R32 :: Heat Shield Rattle Noise In 4th Gear
I am very mechanically inclined and up until now I can usually hear a noise and know exactly what the problem is, given enough time to listen..
The best I can describe the noise I am hearing, sounds like a cross between heat shield rattle or a syncro somehow stretched out and is loosely spinning around once in gear.. Hard to explain, but all gears shift perfectly..clutch was replaced at 102K and I am currently at 130K. Also I might be crazy but it sounds like I am starting to hear the noise in 3rd as well. I would post a sound clip, but its so faint it doesn't show up on my iphone..
The reason I am throwing it out there, is because half of the seriously trusted mechanics I know say it sounds like a bearing in the tranny going out, the other half, (3 of 6) can't even hear what I am talking about but its there.
Lexus GX 2004-09 :: Loose Heat Shield Like Rattle When Hitting Bumps
Hearing a loose heat shield like rattle when hitting bumps...checked everything underneath , can't find anything loose..? 09 GX-470 56K miles
View 11 RepliesGTI 337/20th Anniversary :: Loud And Annoying Rattle Coming From Heat Shield
Recently I have gotten a very loud and annoying rattle coming from my heat shield I think. I jacked the car up and tried to locate where the issue was but that wasn't successful. Do I need the heat shield by the muffler? And do you think it could be my cat rattling?
View 14 RepliesPassat (B5) :: Loose Heat Shield / Minor Rattle Occurring At 1200 - 1400 Rpm
I have a 2001 Passat GLS 1.8T Tip 34500 miles... Loose heat shields. Well, I couldn't find anything to fix, so I brought it to the dealer. They said that this was common on 2001 Passats with about 30k miles. All stock.
These were the symptoms that the car was exhibiting: At first it was a minor rattle that occurred at 1200-1400 rpm.......only when the engine was warm, and only when I was in drive. (I could not reproduce it in neutral)...
A few weeks later, it the engine rattled upon startup for half a second. I assumed that this was just the heat shield issue getting worse. Dealer says that I have a bad cam tensioner, and that they will replace it under warranty. However, I had to reschedule the repair for this week because they couldn't fit the 5 hour job in on Saturday.
He said that there is a spring backup for the hydraulic tensioner, but to get it fixed soon. Obviously I was going to have it fixed ASAP. What this cam tensioner does? Isn't there a chain that connects timing belt to cam shaft? Why does this need a tensioner? Does it change in tension?
Corolla / Matrix 2009-13 :: Rattling Catalytic Converter Heat Shield?
Got a rattle from the car, I think it's the catalytic converter heat shield. Looking for any pictures of what it looks like? I don't know if it is a full cover on our Toyota's, or a half cover. I will post a picture of what mine looks like now that it is rattling later today. Hoping it's an easy fix.
2009 Corolla CE 1.8L.
Ford F-150 (2009-2014) :: 2012 - Substantial Opening In The Lower Center - Add Protection Shield?
On my '12 F-150 Ecoboost there is a substantial opening in the lower center of the vehicle. I know that you can purchase a small after-market grill insert for that area. Is it wise to do that, or is in fine the way it is?
View 3 RepliesCamry :: 2009 LE - Popping Sounds When Turn The Wheel At Slow Speed
The car is at rest, engine on, when I turn the wheel (either sides), there is this popping sounds, coming out from the front suspension. It almost sounds like the Titanic moments before it fell apart... It also happens when I drive slow, like parking or backing out...etc. Doesn't happen at >10mph.
So I had my friend turned the wheel and I inspect it. I can feel the spring or something popping on the strut mount of the front wheels. SEE PICTURE.
I also uploaded a video with sound. I have sufficient tools to remove the struts and springs.
2009 LE
Video : [URL] ......
Corolla / Matrix 2009-13 :: Vibration And Shaking During Slow Moving?
Recently, my 09 corolla S starts shaking during slow moving . As I accelerate more, it start vibrating at high frequency. And I can hear the sound "kin kin kni.." I checked the tires, they all look fine. It has 60k miles on.
View 2 RepliesFord - Focus :: 2000 - Heat Shield Was Loose
My heat shield was loose and my dealer said it should be fine, but then it stormed and driving home I ran over a branch and when I got home I noticed the heat shield was ripped and dragging on the ground. It is pretty torn up and I'm thinking of just taking it off. Am I allowed to take it off? If so how should I go about taking it off?
View 1 RepliesFord F-150 (2009-2014) :: Hard To Start Then Sounds Like Rocks In A Tin Can Upon Accelerating
Ok, heres my issue. '11 crew cab f150, 4x4 5.0L. 108K miles Yesterday got in my truck to leave and it would crank, idle very rough with RPMs fluctuating then die. Did this several times til it stayed cranked long enough for me to press the accelerator to keep it cranked. Headed out down the road and it drove fine. Then upon accelerating I'd hear a noise like rocks in a tin can. Every time I accelerated it would do this. Drove to a mechanic. He drove it, heard it and told me to bring it back today because he was covered up. The rattle sound is similar to valves ticking, but worse.
I got up under it and looked for loose skid plates and loose exhaust components and could find nothing. Took it for another drive,engaged the 4x4 to 4H, drove it for a minute, went back to 2H and the sound was all but gone. Went ahead and filled up with premium gas. (had an 89 ranger that would only run on premium so thought i'd try it) Drove home. the noise was gone. Got up this morning. The truck hesitated to start. took three tries, then fired up normally. then drove it....no problems. no noise, everything normal. Don't wanna take it to the mechanic, if there is no apparent problem now. What's going on with my truck?
Ford F-150 (2009-2014) :: Sounds So Grumpy At Takeoff And Then So Quiet At Speed
I've been wondering why my 5.4L sounds so grumpy at take off and then so quiet at speed.
I'm assuming this ain't factory? Looks like a flowmaster but can't find any markings on it.
I want to get dual exhaust (yes I like the look) but can't figure if I want Magnaflow or Flowmaster.
What I'm looking for is performance (is there even such a thing--rhetorical) and pure-wood-developing raw rumbling noise! Not the kind of noise but the kind that if you want to pop the throttle a bit you let the awesome guy next to you know that this truck ain't no slum.
I'm trying to figure out tips and placement-- I'm thinking straight back is the best bet?
Ford F-150 (2009-2014) :: Truck Shaking When Pulling
I have pulled a pop up with my truck before with no problem. I bought a boat on Friday and pulled it too and from the lake ( 2.5 hours each way). The boat is 21 feet and weighs 3000 pounds empty, no gas. The trailer is a bumper pull. I was pulling no more then 4,000. Under 50 mph everything felt fine. At times when going over 50 the truck was shaking. It would happen and then stop. It does not seem to be coming from the engine.
It would happen up hill and down hill. I was thinking it was just the vibration from the boat, can a load that size make the whole truck shake?? Also the truck made a horrible clunk after backing the boat down the ramp and pulling it back up. It happened when I took the truck out of park into drive. This can be something other then the transmission???
Ford F-150 (2009-2014) :: 2013 Ecoboost Sounds Like A Diesel On Cold Start
I've got a 2013 ecoboost with 31,000 mile on it. Generally it's been good but at 30,000 mile it started sounding like a diesel on cold starts. Usually after sitting overnight the first start rattles like a 6.0 liter diesel for about 3-8 seconds then it's quiet. It won't do it again all day usually. The dealer says there's no codes so everything it all good. It never did this until I hit 30,000 miles.
View 11 Replies