Ford F-150 (2009-2014) :: Heat Shield Under Oil Pan / Front Hole Ripped
This fiber material doesn't hold up to mud and sand very well. So much so, that the front hole ripped through. It won't stay fastened. I have all of the twist bolts still. Looking for a way to fix the shield so it will hold. I tried exposing a washer to it, but the epoxy doesn't like the material very well. I know the owners manual says to remove the shield if you are going to be off roading, but I hesitate to leave it off 100% of the time.
View 4 RepliesFord F-150 (2009-2014) :: Rattle Under Slow Movement / Sounds Like A Heat Shield Shaking
I have a 2010 F150 FX4 with the 5.4L, and lately under slow movement (less that 20km/h it is sounding like there is a rattle. I can try to get a video of the sound later, now I'm wondering if the universal bearings in the driveshaft would be making this noise or if it could be the 4wd actuators failing? Would either of these make a loud rattle? (Sounds like a heat shield shaking but all are tight). Had a Ranger up until last year so just learning the ins and outs of F150 life.
View 5 RepliesFord F-150 (2009-2014) :: 2012 - Substantial Opening In The Lower Center - Add Protection Shield?
On my '12 F-150 Ecoboost there is a substantial opening in the lower center of the vehicle. I know that you can purchase a small after-market grill insert for that area. Is it wise to do that, or is in fine the way it is?
View 3 RepliesCorolla / Matrix 2009-13 :: Rattling Catalytic Converter Heat Shield?
Got a rattle from the car, I think it's the catalytic converter heat shield. Looking for any pictures of what it looks like? I don't know if it is a full cover on our Toyota's, or a half cover. I will post a picture of what mine looks like now that it is rattling later today. Hoping it's an easy fix.
2009 Corolla CE 1.8L.
Ford - Focus :: 2000 - Heat Shield Was Loose
My heat shield was loose and my dealer said it should be fine, but then it stormed and driving home I ran over a branch and when I got home I noticed the heat shield was ripped and dragging on the ground. It is pretty torn up and I'm thinking of just taking it off. Am I allowed to take it off? If so how should I go about taking it off?
View 1 RepliesFord F-150 (2009-2014) :: Trans Noise Upon Acceleration
I have about 22,000 miles on the odometer. I bought it as a CPO with 2200 miles on it. Truck is all stock.
I have heard this noise only once before. I will accelerate up to about 45mph, back off to about 30-35 possibly less, then accelerate again. When I do, it downshifts and I hear a lout noise that sounds like a yelp a dog would make if startled.
Ford F-150 (2009-2014) :: Trans Temp Always Starts Out
Just noticed today that my trans temp always starts out from cold even after having driven it and it takes a little while to rise up to the temp I checked the other trans gauge same thing do I have a problem or does it really cool down that fast the truck sat for maybe 10 minutes.....
View 5 RepliesFord F-150 (2009-2014) :: No Heat Passenger Side Only
I have a 2010 F150 Lariat with dual heat controls. The passenger side has no heat, blows cold air. Doesn't matter if it is defrost, vent, floor and recirculate.
Search online, it appeared that the blend door actuator motor would be the problem. I have put in a new one, but nothing changes. What to look at next?
Ford F-150 (2009-2014) :: 2011 - Trans Would Not Shift Out Of 3rd Gear
My 2011 F150 limited started great bout 3 blocks away from home. The truck glitch. Then it wouldn't shift out of 3rd gear even at take off it was in 3rd. There was also a delay going from fwd to rev. With a clunk as it when in gear. I took it to the dealer ship. EVS Ford Random Lake WI. They were great fast and explained the prob to me. They had to reprogram the tranny. The temp sensor was wigged out n didn't know its own temp so it went into a fail safe mode.
View 1 RepliesFord F-150 (2009-2014) :: Trans Leaking - Stuck In 3rd Gear?
I have a 09 f 150 4wd that i took in for a trans flush, the electrical bulkhead connector on the rear of the trans appeared to be leaking so i got the replacement part and asked the service shop to throw that in if possible. Two valve bodies were partially removed and the said part was still not accessible. i said No!!! put it back together and do the flush! s
So the flush was done (by a ford tech) and now the back up lights, rear parking aid, and rear view camera are all out of commission!
It has been in the shop for 2 days now and the flush was done a second time for whatever reason, now it wont come out of third gear. the shop owner called me to say i bought the wrong filter... I don't have the part number handy but i got it from oreilly. they say it is the filter for the 6r80 trans with the 21 bolt pan. does that sound right?
Ford Exhaust :: 2001 F150 4.2L - Moving Heat Shield Right Front Cat Converter
I want to replace the auto trans coolant lines on my 2001 F150 4.2L. I discovered I can actually see the top coolant line flare nut from outside the right wheel well, with the wheel and wheel liner removed. The lower line is just a few inches below. See photo, it's a little off, so the line connector is not seen:
The heat shield is just a little bit in the way for my hands, I have to put one through the red circled area. A 1/2" hex head bolt holds the shield to the frame (circled in green). This was easy to remove from the wheel well. After that the heat shield could be moved slightly away from the points I need to access.
I would prefer to unfasten the shield & move it out of the way for my hands. I found another bolt holding the rear end of the shield down to the frame, wasn't able to remove this - the bolt fastens to a U-nut in the frame that broke off & has trapped the bolt. Are there any other bolts fastening the heat shield down?
I was able to remove the old flare nuts with a 5/8" flare nut wrench, but have not been able to start the new nuts into their fittings, just not quite enough visibility and access.
Ford F-150 (2009-2014) :: Trans Slamming / Shudder / Random Misfires
Well, just picked the truck up from the dealer. Had to pay for the shudder diagnosis which turned up a #8 misfire as well as lesser random misfires on the mode 6 test (no CEL) since it out of B2B warranty. Also brought up the transmission issue I have been having. Virtually every morning when I go to pull out of the driveway, when I put the truck in park it was quite violently slamming into gear, even if I let it idle long enough to drop the neutral RPM's.
Service writer was a bit baffled, but after touching base with their driveline technician, and verifying it was in no way similar to how any other F150 engages they were able to locate TSB 11-11-11 which, to me, seems primarily concerned with the harsh 1-2 and 2-3 shifting but also noted the harsh engagement.
Anyways, they squeezed me in over night and in 2 days had my parts in and installed (apparently on these trucks they have to physically get the numbers off the solenoids to be replaced as there are a couple options). 3 solenoids tested bad and were replaced under the powertrain warranty. Truck did not slam when I picked it up, looking forward to testing tomorrow morning!
The best part is that when the tech went to drive the truck in this morning to start working it not only slammed into gear for him (verifying my concern) but it also demonstrated the violent 1-2 upshift. Too bad they couldn't push a spark plug through warranty, guess I'll have to wait for my Rockauto order to come in
Ford F-150 (2009-2014) :: No Heat On Driver Side No Matter What Temperature Is Set
I have an '09 Plat SCREW with the dual zone climate control. No matter what temp I set I'm only getting cold air out of the drivers side IP & floor vents as well as the two rear facing vents in the top of the center console. Since I'm out of warranty I'm wondering if there's anything I can check or fix on my own without taking it into the dealer.
View 9 RepliesFord F-150 (2009-2014) :: Trans Leaking Only When Sitting / Big Puddle Of Fluid Under The Truck
I have a 2009 F150 that when I came home from Cabo Monday, had a big puddle of fluid under the truck. I took it to Ford and they said it was some type of bolt on the tranny that is nationally backordered for who knows how long. They topped off my fluid and told me I would be good to go till the part comes in.
View 14 RepliesFord F-150 (2009-2014) :: 2010 - Trans Was Not Shifting From 1st To 2nd Smoothly But Rather With A Jerk Or Bump
A couple months back I purchased a 2010 F150 XL with the 4.6 2V engine. It has about 112,500 miles on it as of today. The problem I am seeing is in the trans. Normally around town there is no issue other than it seems to shift from 1st to 2nd kinda quickly. That is of course you get on it harder, and then no issue at all. The real issue comes after driving for more than 30 to 40 mins. My wife and I took a little day trip that required about 45 mins of highway driving. The truck performed perfectly. Cruising at 75 to 80 there was no issue at all. When we reached our destination it was more stop and go type driving.
It was then I noticed that when pulling away from a light the trans was not shifting from 1st to 2nd smoothly, but rather with a jerk, or bump. Not horrible, but definitely noticeable. Again if I really put my foot in it it did not do it. All other shifts seem fine just 1st to 2nd. The trans temp gauge was steady in the normal range, and this was on a pretty hot day, in the 80s. Since I bought the truck used I cannot say with any certainty what servicing it has had, but judging from the condition it is in I would guess it was well taken care of.
Ford F-150 (2009-2014) :: Trans Occasionally Clunks In And Out Of Gear / Blue Smoke From Tailpipe
I purchased my 2013 Ford F150 3.5L Ecoboost screw in December 28th 2013. I now have 12,000 miles on my truck. My transmission occasionally clunks in and out of gear. Mostly in stop and go rush hour traffic around 20mph. Dealer applied a PCM/TCM software update in July. Still clunks... possible 'slip bump fix' required?
When I 'punch it', I see what looks like blue smoke blowing out of the tailpipe. Tailpipe has soot buildup. I've also noticed a slight drop in MPG. I have NOT noticed a loss of power. Wondering if my truck needs induction cleaning?
Golf VI R :: Heat Shield Noise After TBE Installation
Ordered my TBE couple of weeks ago, installed last week. I have been running the 100 octane tune for an entire week. Decided a couple of days ago to put it back to stock to see the difference. When I was running the 100 oct, I was pretty much on it the whole time. When I went back to stock I noticed some heat shield noise so I took it back to have them take a look. While on the lift I noticed a lot of soot in three different places.
View 19 RepliesGolf IV R32 :: Rattling Sound Like A Heat Shield
I have a major rattling sound from under my car... it sounds exactly like a heat shield. I have been up under my car 5 times and I can not find a loose shield anywhere. the cat insulator mesh is still in perfect condition and it now seems the sounds is coming from somewhere in the back of the car, perhaps the muffler area.
This car does have the flapper mod done... could there be something inside the muffler itself? the car only has 40k on the ODO and I have not hit anything or do not have a dented muffler. As a fellow VW'er I do not want to be the only one running around town rattling...
Golf/GTI VI :: Noise During Acceleration - Heat Shield?
I have what I think is a heat shield rattling at around 2500-2700 rpm. or maybe not? It's not that noticeable but it's driving me mad
Is there a more simple answer that it could be? Keep in mind I claim very very little mechanical knowledge.
I am going to my dealer tomorrow for something unrelated and I kinda want to get a head start when I go to talk to the service dudes.