Ford F-150 (2004-2008) :: 2007 - Cam Phaser Noise At Idle When Hot
I just got done with 2007 5.4 Triton with cam phaser noise. I replaced phaser, timing chains ,tensioner, oil pump, and it still made noise at idle when it was hot so a change the oil to 0w40 and my noise went away. 5w20 starts to brake down at temp of 180 but 0w40 works up to 212 ford will tell you all you need is 25psi of oil pressure what I have seen is you need at least 40psi of oil pressure so if you have noise try 0w40 mobil1....
View 2 RepliesFord F-150 (2004-2008) :: Knocking Noise From Engine - Cam Phaser?
I have a 2007 F-150 4x4 5.4L. I recently had a problem with my engine. It had the knocking noise thats known for the 5.4. My issue is i replaced the engine (it had 275,000 miles and was a work truck before i bought it) As well as all the timing components including the hydraulic tensioners, new phasers, new guides, new solenoid, and a new camshaft positioning sensor and it still isnt fixed.
View 3 RepliesFord A/C :: New Blower Motor But No Effect On Fan Speed?
I have an '02 F150 XL. 200k miles. My a/c blows cold, and I have every fan speed, but it just doesn't blow very hard. I replaced the blower motor thinking that would work, but that did nothing. I've been told to clean the evaporator core, but I don't know where that is. How to do that, as well as any other part causing the problem.
View 14 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Average Cam Phaser Life Expectancy?
I drive a 2008 5.4L F-250. How long do the average cam phasers last. I run full synthetic at 5K intervals and run WIX filters.
View 2 RepliesFord F-150 (2004-2008) :: Replacement Motor For 5.4 Vin V
I'm looking for a replacement motor for a 5.4 08 vin v. Do the 9-10 motor with the same vin code v. I know intake is different but the heads are the same.
View 6 RepliesFord F-150 (2004-2008) :: 2005 - Puking Oil On Top Of Motor?
I was driving my truck and smelled a bit of burning oil pulled over to see what it was when I stopped the truck died and said check gauges everything looked fine but I noticed that it had puked oil on top of the motor around the number 1&2 coil packs and also 5&6 coil packs.. 2005 f150 5.4 ...
View 4 RepliesFord F-150 (2004-2008) :: Engine Knocking Noise Out Of The Top Of Motor
I have an 04 F150 Lariat with the 5.4. I get alot of noise out of the top of the motor. I hear lots of stories of sludge issues, is that the problem or do I need to have the motor gone through? the knock is not horrible but when the motor is warm the noise is pretty apparent!
View 3 RepliesFord F-150 (2004-2008) :: 2006 - Replacing Motor Mount?
I need to replace the motor mounts on my truck. Is there any special tools or tricks I will need before I get half way into it and find myself in a bind? Oh yeah it's a 5.4L
View 1 RepliesFord F-150 (2004-2008) :: 2007 - Motor Start Running Rough At Low RPM
I have 07 sscrew with 5.4. 93,000 miles. At start up truck runs perfect. After 20-30 minutes of running motor will start to start running rough at low rpm. Diesel sound. I can rev up and motor clears up and idles fine. Should I replace VCT solenoids? Or phasers? Or both at one time??
View 14 RepliesFord F-150 (2004-2008) :: 2007 5.4L - Ticking Noise Coming From Somewhere Around The Motor
I have a question about my 2007 F150 4x4 with the 5.4L. It has a ticking noise sound coming from somewhere around the motor, but it's not there till the motor has warmed up. It almost sounds like a exhaust leak, but I'm not sure. What it might be, or what to look for?
View 11 RepliesFord F-150 (2004-2008) :: 2006 - Whine From Motor Which Gets Louder With Increased RPM
My truck seams to have developed a whine. It gets louder with increased RPM. Sounds like its coming from the motor, specifically the front of the motor, maybe one of the pulleys? Water pump??? Alternator??? Im not sure but Im about to head out on a 2800 mile round trip pulling a heavy load and want my truck to be ready for the trip...? It sounds like its gotten louder in the last couple weeks but I think its just because I had a new manifold installed on one side and the truck is quieter making this seam louder.... But I don't know if I should be worried about it.. I don't want to waste money (right before a big trip) chasing a noise if its not something that is an issue..
View 6 RepliesFord F-150 (2004-2008) :: 2006 4x4 Light Not Coming On - Actuator Motor Sticking
Just picked up a high mile f-150 (146,000) 4x4 light not coming on. Jumpered out the vacuum solenoid first, nothing. Then found out I could try to tap on the actuator motor at transfer case. it worked,. Just wondering if i keep exercising the actuator motor, if it will continue to work, sounds like the previous owner did not put it in 4x4 for a long time. Also, if needed, where is a good place to purchase the replacement actuator motor? If this truck has heated seats ( it is a lariat), where is it controlled from? .... Seems to ride a little rougher than I expected. New tires, but it seems a little harsh. I have an f-350 as well. It seems to ride just about as good.
View 3 RepliesFord F-150 (2004-2008) :: 2005 5.4 3v - Idle Rough And Knocking / Ticking In Motor
Getting these codes what they mean or need to do ..to get rid of them...p0022, p0171, p0174, p0183, p0340, p0300, p0316, p2006 did timing n plugs fuel filter n gas filter getting very bad gas mileage it runs good but here a ticking in motor at idle and more as u accelerate, running rough....
View 7 RepliesFord F-150 (2004-2008) :: Truck Froze Solid While Going Down The Highway - Blown Motor Replacement?
I am looking for info regarding motor swap. I blew the motor in my truck a couple weeks ago (5.4L Triton). She froze solid going down the HWY pulling my boat. I purchased a motor from a wrecking yard with~ 70k miles on it. I decided to do the swap myself and have run into a dilemma. In order to un-mate the trans from the motor the torque converter nuts need to be removed. There is an access port where you access the nuts one at a time. You must roll the engine over to bring each nut into view. This is where I am stuck. The motor is seized solid and will not turn over by hand even with a socket and a cheater bar on the main crank pulley. Do I need to remove the oil pan and/or the heads to figure out how it's stuck (pretty sure it ate a valve)?
View 1 RepliesFord F-150 (2004-2008) :: Engine Seafoamed - Motor Noise Upon Initial Startup After Oil Change
Today I decided to do some maintenance on the truck as it needed an oil change and some other unrelated misc stuff.
1. I seafoamed the engine thoroughly. I bought two cans of this stuff, half of a can went into the fuel, another half can in through the brake booster vacuum hose, and I dumped a full can of into the oil. Took it for a 30 minute drive, let the ol' gal smoke as it usually does on a seafoam, and then changed the oil. No noises, I noticed immediately improvement in acceleration.
2. Upon intial startup after the oil change, I thought the motor was coming apart. It was only for about two seconds, (i was counting to make sure) if it didn't have oil pressure and no noise by 3, I was shutting it off. It hasn't done it since.
Is it possible I just knocked some crap loose in the heads causing the oil drain a lot faster into the pan than I expected? I'll try it again in a few hours after everything has cooled off and oil has drained back into the pan, but I wanna make sure I didn't damage anything. Still drives good, no problems, no noises since.
The last oil change I did, I didn't do a Seafoam, but I figured with winter coming it's a good idea to get her running in top form. I used Pennzoil Platinum 5w20, with a Motorcraft oil filter for those wondering.
Truck has 133K on the clock, and it's had the slight cam phaser tick since I've purchased it, no other problems. I bought it almost a year ago.
Prius (2004-09) :: 2008 - Blower Motor Intermittent / Only Works When Spin It
blower motor was intermittent on my 08 prius, now only works when i spin it. Looking for a pdf or instructions on replacing it myself?
View 1 RepliesPrius (2004-09) :: Pulsing Effect When Turning Right - Severe Steering Wheel Shaking
This summer, my steering rack failed, and I had it replaced with a remanufacutured steering rack. All went well, until a few weeks ago I started feeling a pulsing effect when turning, usually when turning right. On a few occasions, the shaking has become severe. It is a back-and-forth effect, about three times a second. It is bad enough that it has triggered a power steering error on two occasions. I took it to the garage who installed the rack, asking them to have a look at it, and they found nothing. Because the effect is regular, I am assuming that I am feeling the 12V power assist malfunctioning or reacting to faulty input.
View 11 RepliesFord F-150 (2009-2014) :: Camshaft Phaser Knocking / Ticking Noise?
In the 2004-2008 forum there's a lot of topics concerning the camshaft phaser knocking/ticking issue but I don't see much in this forum. Was that issue taken care of by 2009 or do some still have the problem?
View 1 RepliesFord F-150 (2009-2014) :: 2 Second Clatter Sound On Cold Start - Cam Phaser?
It seems that my 09 F150 has developed a troubling noise... I'm looking for any cam phaser. I'm at 116,712mi. 5.4L motor of course.
On cold start, I hear about 2 seconds of "clatter" - sounds like something is "loose" on top of the motor. At hot idle, I hear the classic "diesel" idle, indicative of the cam phaser issue. In gear, the rattle intensifies and is very noticeable around 1000RPM.
Other than the noises, the truck runs great - like new.
Here's a video: [URL] ....
Under hood, under hood close up, driver's wheel well, interior, then interior in gear. You'll need to crank the volume to hear the last two.
Best I can tell, this is not an exhaust manifold issue. So, what say you? Cam phasers?