Ford 7.3L Power Stroke (1999-2003) :: Pulling Engine To Redo Timing Cover
So I'm getting ready to pull my engine to redo my timing cover.. my engine has over 320000 miles on it and it runs strong, dyno'd 402 hp at the wheels recently.. I was considering dropping a reman in since im pulling the engine anyway... I heard you can test for blow by buy sitting your oil cap over the spout and seeing if the cap blows off.. well the engine tilts downward in the back so the cap just slides off but in the dark when i shine a flashlight you can see the fumes just billowing out... how do i know if this is too much... what else can i do EASILY to see if my engine has issues before i start taring it down?
View 10 RepliesFord F-150 - 1997-2003 :: Water Leak At Back Of Engine - Cracked Block?
Just did a tear out and rebuild, installed motor, filled with water. Water is leaking out of the back of the engine somewhere. Leaking as if it were coming out of a 1/4" diameter hole. 1997 V4.6L F150. I guess I have to pull it no matter what. Cracked block? Freeze plugs were all new and installed by machine shop. Initial reason for pulling was water in cylinders and I assumed blow head gasket.
View 1 RepliesEscort :: 1997 - Coolant Dripping Under Timing Cover
Recently the timing belt went on my '97 Escort. It had been dripping coolant from somewhere under the timing cover so I bought the timing belt/water pump kit thinking that this would solve the two problems. It only solved one. I'm still dripping coolant from somewhere under the timing cover.
Are there any freeze plugs or things that would leak under the cover? When I had it all apart, there were no visible leaks at least on the upper end that I could see easily.
Ford F-150 (2004-2008) :: All New Timing Components And Now Loud Squeal Behind Timing Cover
My daughters 2004 f150 5.4 3v. 130k miles. Had a broken timing chain guide on passenger side. Changed phasers, solenoids, timing chains, crank gear, tensioners, and oil pump. Pulled pan and cleaned it and the pickup tube of pieces of the old guide. Engine had zero sludge. Very clean inside.
Put it all back together. Left crank sensor unplugged to rotate engine until it had good oil pressure which only took a few seconds. Plugged sensor back in. Truck started right up. Runs perfect. Drove perfect. Idles with no noise. But as soon as I rev it up a little, there is a HORRENDOUS squealing from the lower left of the engine. Pulled serpentine belt and squealing is still there. Used a stethoscope to determine its in the lower left behind the timing cover.
I haven't pulled the cover back off yet but what this could be? Everything went back together fine so I can't imagine what it is.
HOWEVER, I did notice that my new tensioners only had an oil hole in one of them. The two I removed both had an oil hole. So one of the new tensioners does not have an oil hole in the center of the plunger. I see online, that many did not come with an oil hole. But I'm wondering if this could be the source of the squealing? Maybe not oiling the chain enough and the squeal that I hear is the chain on the plastic guide?
Honda - Accord :: 1997 - Oil Leak Behind Timing Belt Cover?
I have a 97 Honda Accord with V Tec engine, 2.2L. I have an oil leak that is coming from BEHIND the timing belt cover. I removed the cover and the belts to expose several seals. The oil leak is quite extensive and leaves a good puddle after running the engine, however, it will not leak once I clean up the mess, put the car up on jack stands and disassemble the engine. I cannot tell which seal is leaking and am wondering how to tell which seal is leaking. Is there a way to apply pressure to the engine with air, possibly through the oil dipstick hole to possibly expose the leaking seal?
View 9 RepliesFord F-150 - 1997-2003 :: No Check Engine Codes But At Idle Revs From 1 Down To 1/2 And Shuts Off?
PCV hose/grommet was rotted out with 1 inch hole but supposedly he spent a long time tracking down the problem. It was located way in the back middle (like underneath the wiper blades area).
2002 F150 XLT Crew Cab 4.6L 4x4 170K
What known issues would do this but not turn engine light on? Motor sounds excellent and runs excellent. Previously it was missing and engine code come up as random misfire, misfire cylinder #2 and #4. I replaced the coil packs on 2 and 4 and erased the code and there was a 1000% difference. Ran excellent (still does).
However, a week later I noticed a subtle shake in the motor, and at idle it would stay at 1...maybe slowly chirp just above 1, and then sputter a little down to 1/2 rpm. It will do this and stay running, but sometimes it will cut off.
What are the possible things that you think it could be considering no check engine codes? (Bad motor?)
Ford 7.3L Power Stroke (1999-2003) :: Coolant Leak From Behind Timing Cover?
I have a coolant leak from behind my timing cover found while doing a coolant system pressure test. I do not want to remove the engine. Looking for info on successful cover install with the engine still in the truck?
View 8 RepliesFord - Explorer :: 2003 - Valve Cover Oil Leak / Timing Chain Rattling
My 2003' Explorer XLT (4.0L V6) has an oil leak. I tracked it down to the passenger side, rear, bolt head on the valve cover (back by firewall). I took it to a guy who replaced the valve cover gaskets, but it is still leaking. He claimed when he had the cover off he looked for any cracks on it, but did not see any at the time.
Anyways, I was searching around and found several explorers leaking in or around the same area of the valve cover. And it turned out that there issue stemmed from bad timing chain guides, causing the valve cover to crack.
I do notice that on a cold start, I hear a rattling when I first start it up. It rattles for maybe that first 1-2 seconds when starting. Is this my timing chain rattling around? If that is the case, how much this could set a guy back on repairs?
I guess I don't know whether to just replace the valve cover, or if I should dig into it to see if the real issue is the timing chain guides/tensioner. Mileage is approximately 121,000....
Ford - Explorer :: 2003 SOHC - Timing Chain Cover Gasket Change
I have a 2003 Eddie Bauer explorer with the 4.0L SOHC . I have a coolant leak from the passenger side that is not a water pump issue.
When removing the timing chain cover with the engine in the car, do I need to remove any accessories ( power steering , alternator etc. ) or their brackets?
Ford 7.3L Power Stroke (1999-2003) :: Coolant Leak Between Block And Timing Cover - Fix?
Is this common? No coolant in the oil-YET........
Any way to fix it without pulling the cover?
Hyundai - Elantra :: Engine Shuts Down When Timing Belt Goes
To my knowledge, if the timing belt goes the engine shuts down. According to others on Hyundai forums, you can blow the engine in a Hyundai Elantra if the timing belt goes. Is the latter really the case?
View 9 RepliesFord 6.0L Power Stroke Diesel :: 2003 F250 Turns Over / Starts And Immediately Shuts Off
I have an 03 f250 that i think is getting air in the fuel line when it sits. It turns over starts and immediately shuts off. Then i have to crank it for a minute or so before it will start. After that it is good all day. Next day it might sputter on start but stays on. More than a day it shuts off immediately and needs cranking for a minute...
View 13 RepliesFord F-150 - 1997-2003 :: Passenger Side Exhaust Manifold Cracked
2003 F150 5.4 4x4 supercrew ,76k miles
Recently the passenger side exhaust manifold cracked on my truck. I bought this truck about two years ago with 58k on it and currently have 76k miles. I remember getting the carfax report and being relieved to see that it had exhaust manifold replaced in July of 2014 at 49K miles along with a new EGR tube. I called the shop that worked on the truck to see if he could confirm that both manifolds were replaced since carfax only said manifold & egr tube. The shop manager confirmed that both manifolds were replaced and he told me that they were most likely manifolds from napa according to the part number.
Now, my question is, what's the best brand to replace the manifolds with? Should I just go with OEM and spend the extra $130 per side? I know the manifolds are a common problem with these trucks but only lasting three years and 27K miles just seems ridiculous to me.
I'm hoping that when I get around to actually doing this that they wont be to bad because of how recently they were replaced. For now I just cleaned the area with a wire wheel and used the inferno metal repair. Seems to have done the job but I don't expect it to last long, just another month or two until I move to a place where I can actually work on my vehicles.
Ford - Bronco :: Start Up And Run Fine For A While Then Engine Gets Really Rough Starts Back Firing And Shuts Off
I Have a 93 bronco with a5.8 the truck will start up and run fine for a while and then the engine gets really ruff starts back firing and shuts off it only starts with starting fluid or after it sits for about 30 mins.
View 7 RepliesFord Ranger / B-Series :: 1992 - Engine Starts And Runs Couple Of Seconds Then Shuts Down
I have a '92 Ranger with a 2.3 liter engine. She starts and runs a couple of seconds and shuts down. I'm thinking maybe a fuel pump is not putting out thepressure needed. Gotta go to work tomorrow and gotta get the truck running today.
View 2 RepliesFord F-150 - 1997-2003 :: Exhaust Manifold Gasket Cracked - Ticking Sound?
If the exhaust manifold gasket is broke / cracked will it making a ticking sound?
View 5 RepliesFord F-150 - 1997-2003 :: How To Set Timing
how do you set the timing in a 97 f150 5.4 vin l windsor"triton"
View 14 RepliesPrius (2010-12) :: Engine Starts Up For Few Seconds Then Shuts Off
How do you warm up? I turn it on and it might start the engine for a few seconds then shut off... How do I know it's ready and warm?
View 9 RepliesGolf IV / Jetta IV :: When Turn The Key Engine Almost Starts For A Split Second And Then Shuts Off
When I go to turn my car on, I have to give it 3 or 4 tries. The try before it actually turns on goes like this: turn key, engine sounds like it wants to turn, almost starts for a split second, and then shuts off. After this I can usually turn it on.
Usually the rpm's would be around 1.3k on a cold start, but when I finally get it to start it automatically dips below 1k. Then when I go to drive it, it feels like it wants to shut off on that first throttle push. It started with just an issue in cold weather, but has gotten progressively worse. Battery is only a few months old.