Ford F-150 - 1997-2003 :: 4x4 Light On Lower Right Of Dash Pops On When Clutch Pedal Is Engaged
I have a 1997 F150 XLT 4.6, standard transmission. the problem is every time I push the clutch the 4x4 light on the lower right of the dash pops on the power windows and windshield wipers will not work, releasing the clutch everything and goes back to normal, I checked the relay that was clicking every time I push the clutch in and switched it out same problem. As of yesterday the problem has now reversed, when the clutch is released everything doesn't work and a 4x4 light pops on.
View 6 RepliesFord F-150 - 1997-2003 :: Transmission Shifts To Reverse And Drive But Park Engaged
I have a 2001 f150 crew cab 4x2 82k miles 4.6 with a 4r70w. Was pulling it over a curb and it popped now it will shift into reverse and load the motor like its pulling against a wall. In drive it will move some but still will lock up and stop moving. I assumed something in the rear had broken from the way it would roll a few feet and lock. Replaced the rear and still have same problem. Is there something I can replace to fix a stuck park or does the transmission need replaced or rebuilt?
View 1 RepliesFord F-150 - 1997-2003 :: Odd Shifting - Getting 1st Gear When Put It In Reverse
In my 1998 f150 4.6L 5 speed manual. When I go to put it in reverse I get 1st instead, but if I do a second shift to reverse I get reverse. This happens on an average of once a week.
I know this can happen in FWD cars where you put it in one gear and get a different gear instead. Something to do with the shifting cable. But the f150 is RWD, the shifting problem only happens in reverse. Is this problem someone without ASE certificates can do, or without dropping the transmission?
I'll add to this so I don't start yet another post. Ive thought of the problem and if it was really going into 1st instead of reverse the problem likely would be bad enough it would just stay in 1st. Its possible that I am getting 4th gear when I go into reverse which tells me the clutch grabs really well, and its a problem I really need to fix, I don't know that much about transmissions but I do know if it keeps getting 4th instead of reverse, the clutch wont be so good pretty fast.
Ford F-150 - 1997-2003 :: Slow Shifting Into Reverse / Shudder Under Load
I have a 03 f150 2wd with the 4.6l. Recently it has been slow shifting into reverse(about 2 full seconds) and when it finally gets in reverse it shudders when it comes under load. The fluid is full and not burnt...
View 1 RepliesFord F-150 - 1997-2003 :: Truck Not Moving In Reverse Like Clutch Is Still Disengaged
My truck was working fine and I drove it to school one day and I was driving and I noticed the RPM was high and the truck wasn't moving correctly luckily I made it home and parked it now it won't move at all I can shift into gears and I put it in first and reverse and let off the clutch and it doesn't move like the clutch is still disengaged. The Slave Cylinder is pressing against the pressure plate to disengage the clutch and then releasing. I have a single cab 1999 Ford F150 4.2 V6.
View 3 RepliesFord F-150 - 1997-2003 :: Truck Bucks Wildly Either In 1st Or Reverse When Feather The Clutch
97 F150 4.9 200xxx 5 Speed .....
I'm having an issue with my truck. It only seems to happen during warm 80+ weather. In the mornings, and during colder weather, the truck runs perfectly.
My problem is; Every time I go to get going and feather the clutch, either in 1st or reverse, my truck bucks wildly.
I changed the plug wires about 500 miles ago, and am about 4000 miles on a rebuilt engine (plugs as well) and new clutch/resurfaced flywheel. The clutch reservoir is full and I haven't noticed any leaks. There have been no codes thrown.
Could it be a possible fuel problem? I think I changed the fuel filter about 7k-10k miles ago.
I was also wondering if the Gotts mod could be causing it. I did the mod during the winter time, and this is my first summer with it on. My air filter is fine.
Golf IV / Jetta IV :: 2003 GLI - Air Compressor Clutch Will Not Getting Engaged
I have a 2003 2.8 GLI and my compressor clutch will not engaged i provided the clutch with a direct power and ground from the battery and it engaged. i also went to the junk yard and got a couple of Fan Control Module ($4 each) and it still does not engaged.
View 3 RepliesFord F-150 - 1997-2003 :: E-Brake Not Engaged But Light Lit Up On The Dash?
The e brake is not engaged but the light is on. how can i kill the light?
View 14 RepliesFord F-150 - 1997-2003 :: Low Whine Noise Between 45 To 55 Mph Only When Gas Pedal Is Being Engaged
I have a 2003 F150 4x4. There is a whining noise when going 45 to 55 mph (at least that's the only time I can hear it), but only when the gas pedal is engaged. I thought I'd work back to front and I took off the rear differential cover, cleaned it out and changed the rear differential fluid. That did not reduce the whining, but I think those spin when the wheels spin anyway. The whine only happens when the gas pedal is engaged.
View 2 RepliesFord F-150 - 1997-2003 :: Starter Stays Engaged Until Put In Gear
I might have a chance to pick up an 1997 F150 with a 4.6 pretty cheap. He has replaced the ignition switch and lock cylinder, Says it keeps turning over until you put in in gear. In my experience a solenoid that is sticking wont stop until you disconnect the battery, just wondering what people think it might be? I am thinking I will just put a push button stater to make it work if its a wiring issue.
View 3 RepliesFord F-150 - 1997-2003 :: 4 Wheel Drive Is Stuck Engaged
Can't drive the truck. Went through the how to fix 4x4 and no go. How to kick it out of four wheel dive?
View 6 RepliesSubaru - Legacy :: 2003 - Replaced Clutch Now Reverse Light Going Out - Clutch Not Smooth?
I had the car worked on a while back. They replaced the clutch and the viscous coupling in the transmission. ('03 Subaru Legacy manual transmission) Things seemed fine, then I realized my reverse light was acting like it was going out. Fuses are fine. A while later the car decided the clutch didn't need to respond as smoothly. Then: "Nope, you're funny to think you can drive me. I'm not budging." The car started grinding gears. I have to slam it into gear for it to work so I can drive it home and let it sit. The car will go into gear when off, no problem. New fluid has been put in. Bled. Then some sort of SUPER LUBE was put in and it still grinds. What might be happening? I really don't have the fundage in order to buy a new car at this time. But at the same time I hate feeling like I'm chasing a rabbit down a hole..
View 4 RepliesFord F-150 - 1997-2003 :: Transfer Case Engaged And Locked In 4wd While Driving At 45 Mph
97 F150 4x4 5.4L ... Just put this truck back on the road after being parked since 2008. While driving at 45 mph, transfer case engaged and is locked in 4wd lo. I did notice a pop about a minute after I started the truck. Drove approx. 5 miles. Transfer case engaged and chirped the back tires, slowed speed to about 5mph. Having it towed home. I'm thinking shift motor???
View 14 RepliesFord F-150 - 1997-2003 :: Compressor Still Engaged When Temp Control Switch Turned To Warm
1997 F150... What part of the control system tells the compressor to turn on and off? After not having air conditioning for a year or more I replaced the broken blend door.
When the a/c is turned on and the temp control switch is turned to cold, I get cold air. When I turn the temp control switch to warm, the air coming out of the vents is very warm. However when I do this I noticed that the compressor is still engaged. I think that at this point the compressor should disengage.
Ford Transmission :: 1997 F150 4x4 V8 Skidding / Clutch Is Not Holding At Times When Shifting Up Or Down While On Cruise And Slight Hills
This is an Auto/4z4/4.6 V-8. It's Skidding or a Clutch is not holding at times when shifting up or down while on Cruise and slight hills.
someone suggested changing oil and filter about two years ago. I did that and it didn't change a thing. $145 that time.
I'd like to know if its the clutch in the torque converter, or the Transmission? If I have to change something out, should I get both?
Ford A/C :: Clutch Always Engaged?
Just noticed that upon start up and idle ac blows ice cold. 5 miles down the road it starts to blow warmer. I've misplaced my manifold set. I did have a low pressure gauge from a long time ago.
Low pressure was would stay around 40psi then slowly over 5 seconds or so drop down to 20 hold for about 10 second and climb back up. All while just at idle.
That's after i added a can of refrigerant. After the second can it seems to have stabilized at around 40 psi. Which is still a little low for being almost 90* outside.
I know with just one reading its like reading a book and only reading every other page.
Here is my main question. Is the compressor suppose to cycle? I've always been under the impression it does. So i deemed a bad pressure switch possibly right off the bat. After doing a google search i see some are stating that it runs continuously.
The only time in a 15 min span my compressor kicked off is when i turned the control to "OFF" or when i unplugged the pressure switch. Is this right? Seems like i would burn up the compressor...
Ford A/C :: 1999 F150 - Clutch Is Always Engaged
I bought a 1999 F150 4.6 4x4 recently that is giving me some problems. The current one is the AC compressor. The system wasn't charged when I bought it a month or so ago and last week the compressor started smoking. I replaced it with a brand new one, including the clutch and pulley, accumulator and orifice tube. I never got the chance to charge the system because the first time I drove the truck the new compressor started freezing up. I took it back and exchanged it and put the new one in. This time I paid attention and the clutch engages as soon as I start the truck. The AC controls are off and there is no freon in the lines.
View 10 RepliesTaurus :: 1997 - Indicator Is Stuck While Shifting Into Reverse To Back Out
Lately I've had some issues with the indicator(the orange needle telling you what gear you're in). Often when I start my car, it would let me shift gears but the indicator would not move. I've never once had a problem shifting into whichever gear I want(knock on wood). Usually when this happened I would bring the gear selector back to park then try shifting it again. This would fix the issue and it would bring the indicator with it, but I knew I had to do something about it eventually.
Last night when I was on my way home, I started my car and shifted into reverse to back out. It didn't move the indicator, and nothing I could do(no back to park then trying again) would work. I eventually decided I'd just count gears to get home, then I'd have it looked at.
At home I decided to do some research as to find out the issue, and I thought I'd found it. I removed the panel under the steering wheel to look at the thumb-adjustment. Many posts I read said it's likely broken and I may need a new one (Or to fix it with zip-ties or glue). When I found it though it had not been broken. The white housing and the black wheel were both working fine, the wire doesn't seem cut. However when I put the parking brake on so I can shift gears and see what it's doing, the gear selector moves but the wire just acquires slack in it. It's still attached and I can't see a break in it anywhere, however it may be broken inside the jacket. I tried turning the black thumb-adjusting wheel both ways and got no success from that. It moved a little once but that was it.
The indicator needs to be replaced?
Ford :: Clutch Slightly Engaged At Stop Light
So I've had a habit of slightly engaging my clutch at stop lights so that the transition to the gas is easier and quicker. Never had a problem until today where I smelt the dreaded clutch burn odor. I think I had it too engaged since it was sorta lugging at a standstill for a bit, but in general is this a bad idea? If I don't go as aggressive as the lugging feeling but slightly release it, am I doing damage?
View 19 Replies