Firebird - Pontiac :: 1994 - Tach Needle Drop To Zero With No Warning And Car Just Dies
My 1994 TransAm has 70k miles. As I';m driving, I'll notice the tach needle drop to zero with no warning, and the car just dies. Battery is fine, gas tank is full, and it soon starts again and works normally. Friends have suggested the timing belt (or chain?) may be the issue, and one day, it won't start again, or it will break and ruin the engine. She, like me, is an antique -- is it time to take her in to the repair shop, and if so, is it costly?
View 9 RepliesFord F-150 - 1997-2003 :: Gauges And Tach Stopped Working While Driving - Wiring Diagram?
I am working on my son's 1997 F-150, 2 wheel drive, 4/6L truck. He was driving it when the gauges and the tach stopped working. I replaced the cluster and it still blows the fuses. The five amp fuse that is specifically for the cluster doesn't blow. It is a twenty five amp fuse that also power the overdrive circuit, etc.
After replacing the gauge cluster I installed a new fuse and the overdrive button on the shifter started smoking. Where I could get a wiring diagram of this circuit so I can see how it is wired.
Ford F-150 - 1997-2003 :: 1998 - Vacuum Line Hanging Under Truck?
I noticed a vacuum line hanging under my 98 F 150 4x4 I traced it out to my front axle question is where does the other end go I have looked but no luck to where it goes.
View 5 RepliesFord F-150 - 1997-2003 :: How To Make Factory Radio Not Dim With Headlights On
Plain and simple. 97 F150 with factory radio and cd changer. Just wanna know what wire to cut on the factory harness to make the radio not dim when I turn on the headlights. Or is there more to it than that?
View 11 RepliesFord F-150 - 1997-2003 :: 2001 - Factory Sliding Rear Window Leaking
2001 F150 Supercrew Lariat, the back window is the factory sliding window, it is leaking around the top on the drivers side, leaks bad. Question is how easy is it to remove the window and replace the seal?
View 10 RepliesFord F-150 - 1997-2003 :: 1998 - Replace Factory Carpet With Diamond Plate?
I'm really not liking my carpet after 174k miles. I wanted to replace it with a vinyl one from rockauto. I've seen some trucks that had their carpet replaced with diamond plate, 1998 F150 Supercab. Unbolting the seats & bench and removing the carpet should be no problem for me, but the fabrication of the diamond plate floor seems to be difficult.
View 1 RepliesFord - Taurus :: 1997 - Driving Itself / Stalling And High Idle - Tach Bouncing
'97 Taurus GL Wagon 197k: Some of this stuff has been going on for some time now (several months ... maybe even a year).
1.) Driving Itself:
Car seems to drive itself on my way home from work which is a long, flat road in the 45-55 mph speed range. Once I get into this range, I can take my foot off the gas pedal and the car pretty much maintains speed until I get to an upgrade. I've even noticed times when I'm not pressing the pedal but the car is slightly speeding up to the point where I have to keep tapping the brake to keep from getting too close to the car in front of me.
2.) Stalling/High Idle:
Sometimes when I come to a less than smooth stop at a light - say, a yellow light that quickly turns red and I have to stop quicker than I'd want, the car will stall out. This has only happened a couple of times in the last 6 months, but it had never done this at all up to this point, so it's a new phenomena. Otherwise, the idle is usually at 600 rpm (except recently I've been seeing high idles of 2000 rpm every so often, which is really weird!!). Also, it seems like if I park the car on an incline, the engine will turn over many more times trying to "catch" and start - and the whole start-up sequence just feels weak - like it's not getting enough gas.
3.) Tach Bouncing:
This one's got me the most concerned because I think it's the most serious (and potentially the most costly to fix). I completely transfused the tranny fluid a few months ago as a possible solution, by the way, so the fluid (Dexron Mercon IV) is fresh. At about 1500 rpm on the tach, the tach sometimes starts bouncing up and down on the scale and I can feel a metallic engagement/disengagement cycle. If I get above or below this area on the tach, however, no problem. Also, taking off from a standstill -even though I accelerate very slowly and smoothly because I KNOW the tranny is "soft" and will 'slip and slap' if I don't - I'm recently starting to feel a very very brief grinding-like slippage feeling that does not hinder acceleration much at all, but feels very unsettling. This is a new feeling and it only happens every now and then (so far).
You're gonna say the tranny's on its way out, right?
Ford 7.3L Power Stroke (1999-2003) :: Tach Quit Working - Warning Lights Staying
Well today the tach was not working at all and the check gauge, check engine and glow plug lights are staying on. Truck runs and starts great, everything else seems to work except the trans temp gauge. Did a search for the GEM and could not find anything that indicates the GEM controls the tach and warning lights.
View 14 RepliesFord Aerostar :: 1997 - Factory AC System Staying On Defrost
97 Aerostar 3.0. Factory A/C system staying on defrost. Going to check and replace as necessary all under hood vacuum lines as soon as it cools down. I can already see some cracks in the plastic lines.
But. Just in case, where is the actuator for the door that directs the air flow either to the dash vents or defroster vents etc? Is it the one I can see from under the hood or in some impossible location?
Suburban :: 1997 Chevy LT - Where Factory Amplifier Can Be Found
Where the factory amplifier can be found in a 1997 Chevy Suburban LT? MY Suburban still has the original radio with tape deck and with the 1-disc CD player under the A/C controls. I have already replaced all 6 old '97 speakers with new ones, and I would also like to install a better aftermarket amp with a sub woofer.I looked inside the rear quarter panels, under all seats, underneath the middle console.
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Factory Radio Harness?
My dumb self cut my factory harness to install a radio and after hooking up said radio (which I know how to do) it popped a fuse. So to avoid any trouble I need to put another harness in but again with my stupidity I cut the wires too short. finding the correct harness
View 2 RepliesPassat (B5) :: 1997 - Boost Gauge Needle Is Jumping
I have a strange problem, my boost guage needle is jumping like crazy, there is no vacuum leak and the max boost i get is 0.5 bar, when the guage needle is not jumping I get a boost of 1.4 bar. I have mechanical boost control.
97' passat B5 1.8T AEB with FMIC,K04-15,2.75",chip (that was made for the original k03).
Ford 7.3L Power Stroke (1999-2003) :: Replacing Needle Bearing In Hub?
I need to replace the needle bearing in one of my hubs. I was wondering if the bearing needs pressed in or can it be hammered in with a large socket and a hammer?
View 2 RepliesLeSabre :: 1997 - Full Tank Of Gas But Gauge Needle Is Stuck On E
I am having problem with the gas gauge I have a full tank of gas but the gauge needle is stuck on E but when I unhook the battery and hook it back and start the car the gas gauge needle is on the full and its stays on full for like 3 days and then the gas gauge needle will drop back down to the E and stay there. This sound like something wrong in the fuel pump.
View 2 RepliesGmc - Jimmy :: 1997 - Gas Gauge Reading Incorrect And Needle Oscillates While Turning?
My '97 Jimmy has had an inaccurate gas gauge for several years now. Initially, it would read accurately until approximately 1/4 of the tank of fuel remained. After this point it would read full regardless of how much gas was in the tank. Over time this has progressed so the gauge only reads accurately until approximately 3/4 of the tank of fuel remains and most of the time the gauge reads full. I have simply been refilling every 200 miles during this time but I have forgotten a few times and been stranded so I would like to address it now. The gauge needle also oscillates in time with the turn signal when it is activated which may or may not be related. I am having no fuel supply issues so I don't think there is an issue with the fuel pump but I believe the pump and fuel sender are integrated in my model year so it may be necessary to replace it anyway.
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 1995 F250 - Factory Remote Keyless Entry Blowing Fuse
I have a 95 f-250 psd with factory remote keyless entry. about 3 weeks ago i had a fuse blow that powers the keyless entry module, speed control, and a number of other systems.
If I replaced the fuse it blew right away so i got my wiring diagrams out and started unplugging parts of the circuit and my last attempt was to unplug the keyless entry module. presto no blown fuse so i got a module from a junk yard fixed the problem and now it has happened again. same exact thing. unhook the module and no blown fuse. i took the first module apart and saw no burned parts and no visible damage but here i am blowing fuses with no door locks, dome light and a few other things.
The fuse that blows is fuse 8. I am a mechanic and have full access to anything I need. I have another module under warantee but I want to be sure that its not something other than the module causing problems.
Ford 7.3L Power Stroke (1999-2003) :: 2001 - Eliminating Factory Quick Connect Fuel Clamps On Output Side?
How can I eliminate the factory Ford (2001 7.3) quick connect fuel line clamp on the output side on my OEM fuel pump? Do I just cut off the factory quick connect and add some 5/15 fuel line? Is it that simple or is there something I need to know prior to cutting off the factory quick connect clamps?
View 6 RepliesCamry :: 2003 4cyl - When Turning RPM Meter Goes To 3 And Needle Comes Down To 1
My car has 219k miles and has been very loud and when i turn it on the rpm meter goes to 3 and gradually car quiets down and needle comes down to 1. While i drive the steering wheel vibrates too. I took it to the mechanic i was told that timing chain needs replacement as its about time. I was under the impression that timing chains do not need replacement.
The steering wheel vibrates (shakes) it makes light clicking sounds too. I have not been able to diagnose the problem by myself. I think these two things may not be related but engine is really loud. Does timing chain needs replacement? and if it does what else along with it should be replaced?
Ford Excursion :: 2001 V10 - No Tach Or Fuel Reading At Startup For A Minute Or So
Occasionally when i start my Ex, there will be NO tach reading (0 RPM) and NO fuel gauge reading (E). The Temp and Oil gauges will work fine though.
After a min or so, they come to life and move normally. This happens intermittently.
2001 V10 4x4 Limited.