Ford Super Duty (1999-2016) :: 2000 F350 - Gauges / Speedometer And Tach Stopped Working
I have a 2000 F350 4x4 with 7.3L diesel and a manual transmission. While driving home yesterday my gauges (fuel, temp, volts, oil pres) stopped working. Within a couple min the speedometer and the tach also stopped working, but the truck was still running fine. Within a couple miles the engine stopped running, just like I had turned the engine off.
After having it towed home I checked all the fuses, none are blown, but there is no power to fuse #16 (15A, instrument cluster, high beam head lamp). Also in the fuse box under the hood, again, no fuses are blown, but fuse #9 (left head lamp low beam) and #11 (right head lamp low beam) have no power to them.
Ford Wiring/Electrical :: 1999 F350 - Alternator Over Charging And Gauges Stopped Working
We have a 1999 F-350 V10 super duty. The alt was over charging and the gauges stopped working. Replacing the alt, the guages still don't work, and the new thing is the charge light and selt belt light comes on. The fuses 29 (5amp)and 30(30Amp) which are supposed to be key on hot only are hot at the same time. With these on, it causes a drain killing the battery. Also if the truck is started, the lights go out, but when you try to turn the vehicle off, it stays running, one with the battery disconnected. The only way to shut it down is pull the fuse box power fuse, 50(amp)Some one had been in the dash before we got this vehicle and busted, burned out or removed the check engine light. I can read codes and their vehicle runs fair and does operate. Could this be a dash board? Also this problem appears when the truck is sitting, and the key removed nothing on. No fuses are blown either.
View 3 RepliesFord Wiring/Electrical :: All Gauges Stopped Working / Strong Burning Smell Inside Cabin
My father in-law gave us a 1996 explorer AWD with a 5.0 for my son who is 16. A couple of weeks later he's out learning with my wife and a very strong electrical smell took over the cabin. They came right home and when I got in I found all of the gauges not working. The instrument lights work, blinkers work, but all gauges do nothing. Pulled cluster and wires look O.K. behind it from what I can see. They saw no smoke, just smell, fuses look O.K.. What could cook on this vehicle that would wipe out just the gauges?
View 5 RepliesFord F-150 - 1997-2003 :: Radio Wiring Diagram?
Got myself a brand new old truck. No radio and all the wires had been cut. I just printed of a wiring diagram from web and went to work I am now on my second one and it has the same colors for two different speakers!! The first one was completely wrong. Looking for a good wiring diagram for a 97 f250 super cab.
View 1 RepliesFord F-150 - 1997-2003 :: Wiring Diagram For 4R70W?
Anyway, I'm gimped in my left shoulder for a while and I'm trying to do what i can with my 03 F150 Supercrew /4bt Cummins conversion. I am using a Dodge 47rh tranny and need to know the wiring for the 4R70W so I can hook up my 12 + ignition wire, back-up lights and neutral safety switch. I'd like to build my wiring harness.
View 6 RepliesFord F-150 - 1997-2003 :: 2000 - Key Less Entry Wiring Diagram?
I am trying to add a keyless entry to the already equip, power door locks but am having problems figuring the wiring schematic
View 8 RepliesFord F-150 - 1997-2003 :: 2000 - Brake Controller Wiring Diagram?
I just bought a 2000 Excursion limited v10 4x4. I'm going camping this weekend so trying to install my brake controller. I found the plug but noticed these wires dangling. I can't see the back of the harness. I'm afraid the PO may have cut them to install a universal harness. How to recognize them? I don't want to buy a ford specific harness if the wiring has been cut.
View 3 RepliesFord Excursion :: 2004 - Dash Lights / Gauges Stopped Working After 30 Minutes Of Driving
2004 Excursion 4x4 6.0. I just had the fuel injectors & wiring harness replaced and it runs great, but after 30 minutes of driving the complete dash lights/gauges stopped working. I found that the #45 10amp fuse had blown so replaced it and after 20 minutes the same thing happened. While it was working all of the lights & gauges seemed to be working okay. This doesn't effect anything else, still starts & runs okay, turn signals work, head lights work, but the head light auto on/off doesn't.
View 4 RepliesFord Excursion :: 2003 V10 - Gauges Stopped Working
2003 Excursion 4x4 Limited v-10 gasoline engine powered
gauges stopped working
gauges dead
gauges not working
gauges
Coming home tonight, I lost all the instrument cluster gauges. Speedometer, tachometer, fuel, oil, temperature and transmission temperature.
So the logical thing to do was check both instrument cluster fuses, fuse 35 and fuse 41. They were both OK.
Kept looking and found fuse #45 blown, it's the "Ignition switch Run/ Start feed" fuse. It was blown.
Popped in a new one and gauges came back to life. I don't know why fuse #45 controls power to the instrument cluster gauges. Strange.
Ford Wiring/Electrical :: Different Color Wires In Cab - Brake Light Not Working - Wiring Diagram?
Need a wire diagram. I have a connector in the cab that has red,blue,lt green,white wires. It's causing my brake lights not to work. I need a wire diagram that shows were they go. I can't find these wires in my Haynes manual.
View 3 RepliesFord F-150 - 1997-2003 :: 1998 - Gauges Not Working?
I have a 98 F150 with a 5.4 auto 4X4. All four of the guages are on the left side of the instrument cluster. Neither one of the 4 work. The gas gauge, the amp meter, the oil pressure, and temp gauge work. the all four just stay all the way down. I've checked all the fuses and the sending units. ONly fuse position number 6 and 30 pertain to the cluster. I took the cluster out too make sure it was plugged in and it was. I know there is gas in it and I know the oil pump is working.
View 4 RepliesFord F-150 - 1997-2003 :: No Lights To Gauges / Heater Controls Quit Working
I have a 2000 F-150 and my lights to my gauges and heater controls quit working. I checked all the fuses inside and under the hood. All good. I swapped a few relays around and no luck. I tried replacing the headlight switch and that did not work. I checked power to the gauges from the headlight switch and there is no power, I then ran a hot wire to the wire that powers the gauge lamps and they do light up, so it is not a bulb issue. I assume I am not getting power, but do not know where else to look?
View 14 RepliesFord - Taurus :: 1997 - Driving Itself / Stalling And High Idle - Tach Bouncing
'97 Taurus GL Wagon 197k: Some of this stuff has been going on for some time now (several months ... maybe even a year).
1.) Driving Itself:
Car seems to drive itself on my way home from work which is a long, flat road in the 45-55 mph speed range. Once I get into this range, I can take my foot off the gas pedal and the car pretty much maintains speed until I get to an upgrade. I've even noticed times when I'm not pressing the pedal but the car is slightly speeding up to the point where I have to keep tapping the brake to keep from getting too close to the car in front of me.
2.) Stalling/High Idle:
Sometimes when I come to a less than smooth stop at a light - say, a yellow light that quickly turns red and I have to stop quicker than I'd want, the car will stall out. This has only happened a couple of times in the last 6 months, but it had never done this at all up to this point, so it's a new phenomena. Otherwise, the idle is usually at 600 rpm (except recently I've been seeing high idles of 2000 rpm every so often, which is really weird!!). Also, it seems like if I park the car on an incline, the engine will turn over many more times trying to "catch" and start - and the whole start-up sequence just feels weak - like it's not getting enough gas.
3.) Tach Bouncing:
This one's got me the most concerned because I think it's the most serious (and potentially the most costly to fix). I completely transfused the tranny fluid a few months ago as a possible solution, by the way, so the fluid (Dexron Mercon IV) is fresh. At about 1500 rpm on the tach, the tach sometimes starts bouncing up and down on the scale and I can feel a metallic engagement/disengagement cycle. If I get above or below this area on the tach, however, no problem. Also, taking off from a standstill -even though I accelerate very slowly and smoothly because I KNOW the tranny is "soft" and will 'slip and slap' if I don't - I'm recently starting to feel a very very brief grinding-like slippage feeling that does not hinder acceleration much at all, but feels very unsettling. This is a new feeling and it only happens every now and then (so far).
You're gonna say the tranny's on its way out, right?
Ford Wiring/Electrical :: Radio / Gauges And Windows Not Working
My radio, all gauges and windows aren't working. Fuse 17 did not seem blown but I changed it anyway and still no luck.
View 2 RepliesFord Super Duty (1999-2016) :: 2002 4x4 - All Wheel Won't Working - Wiring Diagram?
My four wheel isn't working. I have a 2002 f250. When I turn my esof switch the dash light doesn't come on and when I turn on the lights the switch doesn't even light up. I'm going to check for power at the switch but I was wondering to get a diagram for the 4x4 so I can see if there's anything else I can check or look at.
View 9 RepliesFord Ranger / B-Series :: 1999 - 4 Wheel Drive Quit Working - Wiring Diagram?
My son has a 99 ranger and the 4 wheel drive quit working. Traced it to the front hubs not getting vacuum. If I jump around the vacuum solenoid(not sure if that's what it's called), the 4 wheel drive works. Looking for a wiring diagram that shows how this is supposed to work electrically?
View 5 RepliesFord Wiring/Electrical :: 2011 F150 Gauges Cycle Power Off And On While Driving
I have a 2011 Ford F150 FX4, And for a while now i have been having a issue with the gauge cluster.
while driving once in a while all of the gauge cluster turns off then back on within a couple of second. all the lights for the traction control, air bag, engine.... turn on and then turn off just like when you start the truck.
The issue only last for a couple of seconds. And it can go for a day before doing it. Brought it to the Ford dealership and they said unless the gauges are completely off there is nothing to go on by. Also once in awhile the check advancetrac comes on and will be off next time i start the truck. Same thing dealer said there was no codes and nothing then can do.
I checked all the connection at the fuse box, gauge cluster. and no issues. had the truck running and try wiggling all of the connectors, in the truck one by one with no success in duplicating the issue.
Also notice that once in awhile my signal light will flas extremely slow when having the blinker on.
Ford F-150 - 1997-2003 :: Factory Tach Needle Hanging Up
I've got a 97 f150 with 4.6l and my factory tach needle hangs up. Sometimes doesn't move at all and I can tap on the tach and it will work ok. Then I check it and it is stuck in the 2000 to 3000 rpm range. Can I take it apart and clean it or won't .....
View 2 RepliesFord Audio/Video System :: 2003 F250 - Wiring Diagram
Where I can get a radio wiring diagram for 2003 F250 Crew Cab?
View 1 Replies